Passat (B5) :: 2.8 V6 Shutter - Coil Pack Is Going Out Or Loose Connection To The Coil
Jan 25, 2012
B5 Passat, it has the 2.8 and it has been having moments of shuttering so I did a scan and hit 3 engine falts, I did do a clear and rescan so these are new faults.
3 Faults Found:
17801 - Ignition Coil Power Output 1
P1393 - 35-00 - Electrical Malfunction
17802 - Ignition Coil Power Output 2
P1394 - 35-00 - Electrical Malfunction
17803 - Ignition Coil Power Output 3
P1395 - 35-10 - Electrical Malfunction - Intermittent
Right now my guess is the coil pack is going out or loose connection to the coil, this coil is roughly 8 months old so it kinda has me at a loss and hoping its not the coil.
View 4 Replies
Advertisement
1.8 had recent coil pack problems? I recently had a coil pack fail in very hot weather 2 weeks ago. This week during another heat wave I believe the coil was again causing the engine to start missing. I know about VW's past reliability problems concerning coil packs and am now concerned that this may be surfacing again.
View 8 Replies
2004 passat 1.8t. How do I remove the coil packs on the top of the spark plugs, so I can repalce the plugs.
I unclipped the wire and unsure how to pull the coil pack off.
No bolts. can turn it and maybe pull, but doesn't budge and don't want to break.
View 3 Replies
I was removing the coil packs on my car in preparation for the new ones coming in. The far right coil pack came out very easily and was about half as long as I expected. The other half of the coil pack was at the bottom of the spark plug well. I reported a misfire yesterday. As the mechanic would say "now there's your problem". removing the bottom half of a coil pack?
View 24 Replies
I have a 2006 Grand Prix and the same coil pack has gone 3 times in one year. Each time i have my coil pack replaced i also get my spark plug replaced. Why does the same coil pack keep going bad and how can i fix it?
View 5 Replies
Need to replace coil pack on cylinder #3. What is the firing order? 2004 - V8, 52,000
View 1 Replies
I'm driving down the road yesterday, and going through a intersection, get through it i'm in 3rd gear, 20mph, and my car starts to misfire, so i am like crap coil pack, i changed them all with new plugs maybe 1000 miles ago. Well I slow down so i can turn around and head back to my place slowly a mile away. and it never happens again. Now the car had just had the complete exhaust replaced last week, and literally only 9 miles put on the car before this happened. I drove 35 miles to work today, and roughly 50 miles last night after this and it has not happened anymore. Am i doomed for coil pack failure again?
View 6 Replies
I had taken my engine into the shop and had to have to engine replaced, I would have done it myself and would have saved a bunch of money, however I did not have the time. So I had the same exact engine placed into my MK3 from an old Passet, the only issue I'm having now is the sounding of a misfire on one of the plugs..
Only thing is, all plugs and wires are brand new, so I'm thinking the Coil pack is on it's way out the door. The mechanic said it was the original coil pack so that would make sense. It's a 1997 2.8L 6cyl engine.. I'm looking into purchasing a new pack, and on a website that I had been using a lot lately, only had MK4 coil packs.. Can I replace an MK3 pack with an MK4? Would i have to change the plugs and wires again?
View 3 Replies
So before I go buying 10 new coil packs I will test them first.....How many ohms should they read when tested with the meter. I am finding ranges 1.1-1.3. Old or new they are all reading the same. So look my plugs are AWFUL...changing this for sure.
View 2 Replies
I seem to have a big loss of power. I just got my 337 last week and it was faster than expected with the GIAC chip. I drove down to mass in the rain last weekend and now it seems slow as hell. My question is does a bad coil pack cause a check engine light to go on? My car's check engine light is NOT on and I do have a boost gauge, and it seems to be boosting normal so I imagine it is not a boost leak. If it were misfiring I imagine I would really know it, but I've never had a misfire on a turbo car so I am not sure how bad it is affected.
View 10 Replies
I've been doing the 40k service to my R32, and was in the process of changing the spark plugs.
The first three went smooth with no problems, the next three however.... When I pulled the coil packs off, they were covered in rust and corrosion.
The inside of the block leading down to the spark plug (where the coil pack was) also had rust in it. I haven't pulled those three spark plugs out yet. What caused the rusting?
I assume I need to replace these three coil packs, and clean off the existing spark plugs before removing them. Is that a fair assessment?
I haven't had any trouble with misfiring or stalling. The car has been running great.
View 2 Replies
I have a 2004 Hyundai Santa Fe 3.5. I just changed the spark plugs and wires and now I hear a clicking coming from the middle coil pack. At first I could see it arcing on the bottom to the metal part that holds the plug wire. I removed it and added some dielectric grease and the arcing seemed to stop, but the clicking noise is still happening. Does this indicate a bad ignition coil or do I just need to add more dielectric grease? The idle is still a little rougher than I would like, but I don't want to just throw parts at it.
View 21 Replies
So, we have a CEL and we're experiencing the lack of power under WOL. Feels like the fuel is being shut off. Did a little research and I guess the computer sees the issue and will cut fuel if it recognizes an issue? Could be the reason its showing the "Fuel level too low"?
Vagcom shows as follows:
2 Faults Found:
000772 - Cylinder 4
P0304 - 000 - Misfire Detected - Intermittent - MIL ON
Freeze Frame:
Fault Status: 10100000
[Code] ....
My plan is to replace cylinder 4 coil pack and all the plugs.
View 1 Replies
I'm in the middle of replacing my VC gasket and while I was removing one of the hex bolts that holds it in it started sparking like crazy and turned the tip of the hex wrench glowing red. It didn't do this for the first bolt I took out. I also forgot to disconnect the battery before I started, could that have had anything to do with it?
View 6 Replies
I recently did a coil pack swap to determine if that was the cause for a cylinder 1 misfire. Left to right on my 2009 se tiguan, I changed 1 to 2, 2 to 1, 3 to 4 and 4 to 3. I recently ran into the cylinder misfire again, this time on cylinder 4. The problem is, I do not know which coil fires which cylinder. I've looked around quite a bit and can't seem to find it.
View 6 Replies
1998 Ford Explorer. Coil pack isn't putting out spark to that cylinder. Would the next step be to replace the pack, or might I check something else 1st?
View 5 Replies
I just bought a 2003 F-150 4.6 2valve truck. How bad is the spark plug breaking problem in this engine? I need to replace a coil pack #8 cylinder and thought I better changes plugs while I am in there. Has about 110,000 on it
View 14 Replies
I have a 2002 prius that threw a spark plug and loosened the coil pack. The mechanic just reinstalled the plug and tightened the coil pack and said it was fine. Why it would throw a spark plug?? It was running fine, no warning lights, i just heard an unusual slight noise and opened the hood to check it out, and notice the loose coil pack over the first spark plug
View 2 Replies
I'm looking around for coil packs and came across these: Granatelli Pro Series Extreme Coil Packs.....
View 12 Replies
first off this not my truck i am asking about it's my dads, he has a 2002 f150 xlt 4x4 5.4L and he replaces the coil packs all the time is there a way to prevent these from failing so often, and is there an easy way to get to the spark plug on the very back on the passenger side?
View 14 Replies
2001 MK4 GTI VR6 put brand new coil pack, wires and plugs in the car because it was misfiring. Was fine for about a week than I got a clogged cat code and could feel the affects. I now have no cat, no resonator, and no muffler. The car is finally driving good and then the check engine light came back. It says only a misfire in Cylinder #3 and when accelerate hard to speed up my check engine light starts to blink until I stop accelerating hard. So my guess is the clogged cat caused that cylinder to misfire but I do not know the actual solution to this. My EVAP hose is semi-pinched and when u squeeze it you can almost kill the engine. The weirdest thing of all is this: driving normal I shift in between 2000 and 3000 RPM and once i get into 4th gear about 2000 RPM......my car starts shaking badly and i feel like my engine is going to fall out. I have searched and the only thing i can think of is a bad injector...
View 3 Replies
