I picked up a Automatic 1999 Passat V6 with 15k on it and if I let the car sit out all night the car doesn't wanna shift outta 1st gear in the morning. Its fine if I let the car warm up 5 minutes but any earlier it has to think about it...
View 4 RepliesMy passat is a 1.8t automatic with roughly 170k on it and lately i have been encountering some issues with the tranny. I have had this problem for a while and as of late it seems to be getting worse (especially with the AC on????). After driving up a hill the car seems to have difficulties shifting into the next gear on its own, typically 2nd to 3rd but sometimes 1st to 2nd, sometimes I even have to switch over to the triptronic and up shift manually.
Also when i am driving along in 4th or 5th and encounter a hill the car doesn't want to downshift on its own without giving it some pedal play, or sometimes I have to play the same game and switch over to the triptronic and downshift manually (hoping to save to tourqe converter). I dont know much about the tranny on this car, but i do know that their not cheap!
My car is jerking from 2-3...whether in auto or in tip.
View 3 Replies16 se. When driving slowly, I feel my car shift into second gear, not very smooth, to other gears, it's butter smooth. I mean it's not bad at all but little harsh for a new car. I only have 700 miles on it. Is this kinda normal !?
View 9 RepliesI've been noticing that my 2012 Passat TDI with 125,000 miles, hasn't been shifting to 6th gear when driving down the highway. I've actually noticed it's one gear too low even when driving down city streets. We have been experiencing extreme cold weather in Pennsylvania, so perhaps that's a factor.
If I manually shift to 6th gear, it stays in gear, but it appears that the engine RPMs are a bit lower than usual as well, but I could be wrong there.
My sonata 2012 with 71K km on it just started hard shifting in the morning, after first start. It slamming in D from R very harsh and then shifts all other gears for ~3 minutes harshly (upshift / downshift) and then it gets fine and shifts gears with absolutely no problem throughout the day. Dealer of course was not able to reproduce the problem.
View 37 RepliesI have a 2007 Passat wagon 4 motion V6 and what the problem is I am getting a rough shift between 3-4 gear sometimes, usually on a slow acceleration. I have had the valve body replaced which worked for a couple of months until the problem returned. I then had the transmission replaced which worked a little but the rough shifting is still present at times. The car still has warranty and not even the dealership knows what to do?
View 12 RepliesMy 99 V6 with Tip just started to malfunction this past weekend. By malfunction, I mean when I shift over into Tip mode, the display remains on automatic and even shifting up and down will not change the tranny gear.
I was driving with the cruise on and shifted into Tip mode to slow down for a toll booth ( slow to 25 and not stop all the way). When I got through the booth, I hit resume on the cruise forgetting I had shifted into tip and the car revved back up to 65 mph in 3rd gear for about 5 seconds ( I had the stereo cranking and couldn't hear the engine)before I realized what I had done.
I tried to upshift in Tip but it wouldn't let me so I had to go back to full auto setting where it works fine.
Is it possible to burn out a fuse or circuit of some kind by doing a dipshizit maneuver like that? The car runs great otherwise and still is getting low to mid 20's mpg in spite of the ethanol crap.
BTW, just had the computer reflashed last week after putting a new battery in because the Throttle Body was not working properly.
I have a 1999 Mazda 626. Lately, it seems to shift into 2nd gear much too late - ~5000 rpm - regardless of acceleration. Is there a good place to start diagnosing this problem? I've heard everything from new tranny to neutral safety switch.
View 6 RepliesI have a 99 7.3 F350 with 5 speed manual with over 300,000 miles. Grinds bad shifting into 3rd, and nothing happens in 4th. I think it is a S5-47-ZF. Is a 6 speed manual comparable to bolt up to bell housing?
View 2 RepliesI have a 2012 F-250 ccsb lariat and the shift from 3 to 4 seems to be a bit prolonged as if the converter is slipping and wont go ahead and push it into 4 gear. Also it will want to downshift from 3 to 1 and feels like the car behind nailed you. I have read that the early 2011 had some of this problem and the dealer reflashed the tcm and it did not do much good but as mine being a 2012 mine should have been flashed with the lastest tcm flash from the get go?? Egr fell off and am running Kory Willis tunes through ez lynk so the stealership is probably out of the question. I have also read that changing a couple solenoids( dont remember which ones) will fix the problem.
View 11 RepliesThe tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 RepliesI bought my 2011 F250 FX4 about 2 months ago. A little about the truck: 6.2 liter gas. XL FX4. Manual 4x4. 6 speed auto. Supercab. Long bed. 42,000 miles. (1,000 of them mine.)
Until yesterday, the truck has performed absolutely flawlessly under all conditions. Then, randomly, I had what felt like a "missed shift" as I was leaving my dog's veteranarian yesterday. I pulled out onto the highway and as the truck attempted to shift into second gear, it didn't "catch" second. The gas just revved up and I had to take my foot off the gas pedal and put it back down to get second gear to engage. Most of my driving is stop and go around town and this has only happened once in probably well over a thousand stop and go situations. Should I be worried or was it just a fluke?
Also, FWIW, I did plenty of stop and go driving today without a single problem.
My friend has just brought a truck and has lost 3-4 gear in the auto trans. We have the PO782 code coming up. Is there something in particular we should look at first.
View 2 RepliesI have a 2000 F-550 w/7.3 and a 6 speed ZF transmission. My problem is that when you go to shift into any gear inc. reverse the transmission stays in 5th gear. I pulled the shifter and tried to do it from top of transmission it still stays in 5th. Any thoughts that I could possibly check?
View 1 RepliesI have Hyundai Santa Fe, 2009 (automatic). when I start engine in the morning everything is fine except the reverse gear. the reverse gear moves to position easily but the car does not move. After 5 minutes of starting engine, the reverse gear works again.
View 1 RepliesOK about 3 months ago I bought my first vw, a 99 Passat 1.8t. Car was great. Only problem at the time was a loud backfire while down shifting no clue on y either. Let me say this is my first turboed car too. Anyway after about 2-3 days my cel came on. I threw my scanner on it and got evap leak. I filled her up right after that and smelled real bad gas. Found a screw hole in the trunk patched it cleared the code an she ran great again. Well for a few days now after every fill up I have to keep my foot on the throttle or it stalls out. Keep getting same code. Also when I go to jump on it it'll like studdar an hesitate before going. No more gas smell either. The kid I bought her from did some work an I'm getting 15lbs of boost but at times will jump to 17-18 lbs. I have no problem doing the work to get just need some guidance on what to do. I've been told change charcoal canister, fuel filter charcoal canister purge valve, I guess there's 2 cause I was told to change both. I love this car, this is the best and my favorite car I've ever had. J wanna get her all nice and healthy.
View 3 RepliesNew truck 11000kms ago thats done medium amount of work but nothing heavy or sustained for long periods of time. I get the feeling of clutches slipping especially when truck is cold but also when normal temps. Doesnt make any weird noises or anything. I can really notice the difference in torque if in manual mode being much better, but still not perfect if i stomp on the gas pedal and go through the gears in manual mode will still slip. Also is really harsh shift if i come to a halt in 3rd manual mode with the brake pedal depressed push minus button the truck makes very loud clunk noise into gear 2 then 1. Took it to ford they couldnt find anything ? Thinking of trying another dealer.
View 2 RepliesMy 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
My camry has been great up until the last week. The weather has gotten extremely cold here and when I start driving in the morning or from any cold starts the transmission doesn't shift out of second gear. After I drive it a mile or so and slow almost to a stop it will shift normally until I park it.
It has 125000 miles on it and I hope this isn't a serious problem because it is a great car and has been well taken care of. Looks brand new on the inside and out and I've never had any problems until now.
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 Replies