Passat (B5) :: 1999 - Transmission Slip / Fails To Engage For About Half A Second After Hitting Throttle
Aug 26, 2009
Every once in a while (maybe once a week) I notice that my transmission will slip (fails to engage for about half a second after hitting the throttle). Usually this happens after I have slowed down to almost a stop and then accelerate. The last time this happened I was on a slight incline (maybe 4%).
Is this something to worry about? Any easy way to test if this is an indicator of a big problem coming up down the road? The car has about 130k miles on it now and the transmission fluid and filter was changed at about 90k, the fluid level was checked by a VW tech so I assume it is correct.
View 3 Replies
Advertisement
I have a 2000 Ford Explorer XLT. V6, 4x4
At very low speeds (5-10 mph), attempting to accelerate while turning (like coming out of a parking lot OR out of a curve) the transmission fails to engage. I hit the gas, the RPMs go up, but it doesn't get into gear. I will let off the gas, give it a couple seconds, hit the gas again and usually it engages. Sometimes I will have to repeat this step a second time. This problem started very slowly and has gradually gotten worse. It happens about once a day.
Concerned, I took it to the local Ford dealership and they have thus far changed/flushed the transmission fluid and replaced the filter. The mechanic said he found no metal shavings in the fluid, which might indicate grinding gears. They also said there were no codes coming up pointing to a transmission problem. It is still having the same exact issue however. The trouble now is they cannot "verify" the problem. The mechanics have put 40+ miles on it in similar driving scenarios and it will not act up for them.
After a couple weeks of back-and-forth, I'm really frustrated. My understanding is that they're "not sure" it is a transmission problem. They don't really want to open up the transmission case until they have a place to start. It should either be something mechanical with the transmission or a problem with the computer that controls the transmission, right? After getting off the phone with the mechanic today he said it might be a sticky throttle body?
View 14 Replies
2008 F-250XL, 5.4L V8, 5 speed auto, 3.73 rear.
Two/haul fails to engage and does not light up dash indicator light from time to time. After 4 or 5 tries it usually will engage normally. No codes.
View 2 Replies
My passat transmission is really starting to slip now. I have found a used transmission at a reputable salvage yard with 84,000 on it and its the same trans code and was told it shifted fine before they pulled it. I was just wanting to know what seals i should replace in the new transmission if any. I presume that with it being at a salvage yard all the fluid was drained from it so another question I have is how much transmission fluid should i buy when i do the swap not sure if 5 quarts is enough.
View 1 Replies
99 Passat1.8t auto, transmission doesn't engage into any gear ... Cluster shows that all gears selected ....
ATF level OK and VAGCOM doesn't show a ny codes/errors for trann When I put D or R - car revs up to 1200RPMs and thats it Checked ECU and TCU (tranny computer) no signs of water in them I don't really know history behind this vehicle but it had been sitting from 2009, had run before without problems (at least thats what previous owner told me) ...
View 7 Replies
98 AEB just rebuilt the engine completely, put a K04-15 turbo on it along with a FMIC and a forge diverter/BOV. Everything runs great idles great. when i try to get into it it bucks at 4500+ rpm. when i baby it she runs great smooth sailing. Is this a fuel issue?
View 16 Replies
I have a meticulously cared for 2003 Camry. When I got it a year ago it stalled at startup about 10% of the time, and it has increased to almost 50%. The engine light is on and off, but seems to have no bearing, nor does air or engine temperature. If I keep my foot on the gas even when stopped, I can drive it. Sometimes it warms up to idle, sometimes not. It stalls usually at start and always when going slow or stopping. Sometimes it succeeds in idling, sometimes it fails, but never something in between. Either it idles right at 1000rpm, or at 0.
Mechanic ran it through the computer, drove it around, tried it a bunch of times and found nothing.
View 4 Replies
I have a '99 passat 1.8t Tiptronic. 106,000 miles. Recently I've been getting a bad hesitation when accelerating from a stop. At half throttle the car kinda bogs down and hesitates then as the rpms get higher it seems to clear out and accelerate smoother. At the same time the car doesn't have the same sack it used to. I checked he plugs, found them very fouled. Replaced them and the problem got a little better, but definitely still there. There has to be a reason the plugs fouled. There is no CEL so I don't really know what to check first.
View 2 Replies
I have a 2005 Excursion with 6.0 PSD just turned 80,000 miles. About a year ago, the vacuum hubs on the ESOF system became intermittent, so I changed then out with WARN manual hubs, which proved to be 100% reliable. Today, I got in the truck to move it, and engaged 4x4 High, as it had snowed last night and my inclined driveway was slippery. The hubs are locked, I get a lighted "4x4" idiot light on the dash, but the front wheels are not providing any drive power at all. I can hear the transfer case shift motor moving the gears, and if I select Low Range, the transfer case does change over to Low, but still no drive coming from the front wheels. I'm under the impression that the only things left to fail would be for the propeller shaft to be lying on the ground (it's not), the differential is not working, or something is wrong with the spindle shafts. Nothing has happened to the truck, and I have not heard any strange noises. I parked it 3 days ago, and everything, including four wheel drive, worked fine at that time. What may be going on here?
View 8 Replies
My cruise fails to engage, sometimes first thing in the mornings, sometimes in the afternoon, cold engine or warm, fresh start or on resume. After the car is turned off for a few, something is resetting it and it then works fine. Wondering if this has something to do with a faulty switch, fuse, or whatever. I've tried the cruise switch on the stalk in turning it off for a while, keeping it pressed in, turning it back on, everything.
View 6 Replies
I have a 2005 Passat TDI with 2500 miles & this car was wrecked and I recently got it back from the body shop. Well I now have a transmission problem. When I first take off the car feels like it is in a high gear. Then the transmission will slip. I have taken the car to the local VW dealer and they have given me the following information.
-Incorrect Ratio 4th gear #Code P0736 & 17110
-Incorrect Ratio 5th gear #Code P0735 & 17118
This leaves me with two options according to VW.
1. Replace the transmission
2. Replace the computer
2005 Passat TDI? Which would be more obvious as a problem?
View 1 Replies
I have a 2005 Passat TDI with 2500 miles & this car was wrecked and I recently got it back from the body shop. Well I now have a transmission problem. When I first take off the car feels like it is in a high gear. Then the transmission will slip.
I have taken the car to the local VW dealer and they have given me the following information.
-Incorrect Ratio 4th gear #Code P0736 & 17110
-Incorrect Ratio 5th gear #Code P0735 & 17118
This leaves me with two options according to VW.
1. Replace the transmission
2. Replace the computer
View 8 Replies
Before the question, this is what I have, 2001 V6 4-motion, Automatic. So tonight I was driving home from work. As I started off, the car shifted 1st-2nd fine, then when it hit third it just revs, felt like it was slipping or missing then kick to forth or second hard, then lit up all the the PRND234 on the dash instead of being in just drive. When I pulled over and restarted my car it clear but did the same thing. What is going on??? It happened once before (for a split second) but has been fine ever since. I just bought the car 3 months ago and the car has ran solid since i purchased it.
View 3 Replies
I changed the Passenger side with no problem , the driver side bolt is hitting the transmission oil pan. I am thinking of loosening the mounts and try to jack the pan up to get that 1 clearance or worst case drain the transmission take the pan off remove the bolt and put in fluid in. If I drop the the transmission pan is there a filter in there? also how much transmission fluid does it hold.
[IMG] ....
View 2 Replies
I recently changed the rear diff fluid on my 1999 F250 Super Duty (180k) It was due plus I was getting some chattering when making turns from a stop. The Diff fluid had about 60k miles on it and seemed to be a little low even though I don't see any leaks. I paid to have it done last time so I can't say what kind of a job they did.
I used Motorcraft diff fluid and 8oz of friction modifier. Two weeks later and about 500 miles, today I noticed on two occasions when turning a moaning sound coming from the rear of the truck. Could this be a sign of too much friction modifier and the cluthes are slipping or is something else going on?
View 1 Replies
Drove the wife to work this morning. The turn off into town there was a lady stuck so I pulled over in the drifts. After putting in back in gear I had to get on it to get out of the drifts. Snow was blowing over the windshield, and I imagine throughout the engine bay.
After that it felt like it stayed in 2/3rd gear. I'd hit the pedal and it would redline and sort of accelerate jumping in and out of gears. So i slowed down to a stop. Accelerated slow and it was ok but when I got more on the pedal it would feel like it was slipping. Once I got in the driveway, she idled for about 15 mins while I shoveled out my spot. Once putting in gear again I had to rev it up for it to move.
Also reverse, had to rev it up to move it.
View 2 Replies
A few weeks ago I noticed what seemed like a "slip" in my automatic transmission. Only happened a couple of times and I thought maybe it was just me imagining it or I didn't have the shift selector lever firmly in "D"rive. Then I went on a 4,000 mile trip pulling about 3,500 lbs. on mostly flat roads but it did include some 7% grades in the hilly parts... the truck performed flawlessly.
This is probably not related but ... after I got home, the truck sat for a few days and then I noticed a coolant puddle under the truck. Traced it down to what appeared to be a slow drip from a bad squeeze clamp on the large, lower rad hose connection. Replaced the squeeze clamp with 2 worm drive clamps and no leaking issue since.
Then last night, the tranny seemed to "slip". My short run across town started out OK. However, when I arrived at my destination, the diesel motor would rev to around 2500 rpm but the truck barely moved forward. It eventually did shift into second but also with high revs. It was the same feeling as if it were a manual tranny and you were giving it lots of throttle but only letting out the clutch a little bit (i.e. riding the clutch). This happened a couple of times last night. Also at a stoplight with the brakes on firmly, the truck was gently and rhythmically "rocking forward" as if the tranny was not fully disengaged.
When I worked through the gears shifting manually, the problem seemed to disappear and the truck responded going through the gears normally. Upon restart about an hour later, tranny shifted fine both in the city and at highways speeds on the way home.
B-I-L commented "sounds like your clutch is slipping". Not exactly sure what he meant as I had to leave. I'm hoping this will be a simple fix/adjustment and not the dreaded mechanical diode failure leading to a replacement tranny. Truck only has about 75,000 miles on it.
I'm suppose to head out on my annual vacation next week carrying a 3,500 lbs. truck camper and pulling a 3,000 lbs. cargo trailer with our gear. Obviously if the truck is sick, this trip can't happen. I know some of you would dive right in and start taking the tranny apart to repair it ... What is wrong with my transmission and what I should be doing next?
View 10 Replies
So I stopped at a red light and when it turned green I pressed the gas the engine revved fine but the car went nowhere. Putting the car in park won't hold it either. It's like the transmission won't engage at all.
View 8 Replies
Alright so I've had this car for about six months now and the clutch was supposedly replaced by the dealer I got it at. The clutch usually grabs about half way up but sometimes it's higher. I replaced the master cylinder because it blew out, when changing my I take I noticed the slave was starting to leak so I replaced that about three weeks ago. Ever since then, the clutch seems to grab differently and seems to be taking longer to engage.
Now, I did the "slave mod" on the old one AND the new one so it's not that. Do you guys think the new slave is bad? I have high temp dot 3 in there (I try to only use the best fluids for my cars). It just doesn't seem to grab as hard as she used to. Like it takes a bit longer to engage. The clutch (should) only have 15k miles on it. The clutch parts are under warranty but I'd still have to pay for labor since it's a wear part. I'd like to avoid replacing it if it's that new u less it's definitely going.
View 9 Replies
I have a new to me 2000 F250 7.3 diesel with automatic. Truck has 185K miles and tranny is starting to slip occasionally. Do these trucks come with a OEM tranny cooler or do I need to add or upgrade the OEM one. Someone also told that there is something called "bulletproofing" the tranny on these trucks. BTW, what would be a reasonable cost to have a two wheel drive auto tranny done on my truck?
View 7 Replies
I recently purchased a 2002 Jetta VR6 GLX. It drives fine when the transmission is warm, but fails to go into reverse and has a hard time shifting out of first when it's cold. I took it to my german mechanic friend who specializes in transmissions and he said that both the valve body and transmission need to be replaced. Problem is I don't have the funds to replace both.
The current transmission has 131000 on it.
View 1 Replies
