Passat (B5) :: 1999 - Replacing Bulb On Temperature Control Panel?
Jun 19, 2008
The light behind the temp controls is out on my 99 Passat GLS. First time it went out, I had the dealer replace it. Now, it's out again. The instructions was to pull out the Temp Control Knob and you could see the bulb. I pulled off the Temp Knob on my 99 but did not see a bulb.
Where to find the bulb and how to get to it/replace it (and what bulb this would be).
The 02 bulb responders even said to use a vacuum or a rubber hose to remove. Even if I see a bulb in the center of the Temp Knob housing (which I didn't), I still can't figure out how to pull a bulb out unless I used a needlenose pliers (which will likely break the bulb).
View 5 Replies
Advertisement
Based on what I've gathered, this message means that I need to replace a bulb (and not the whole headlight, right?). I haven't looked in my manual yet...but is there a model number for the bulb if I were to purchase it somewhere (i.e., online) if I intend to replace it myself (and/or have someone other than the dealership replace it)?
I have a '06 Passat 2.0.
View 9 Replies
One of my interior bulbs had blown and all of the others was still working ! I replacement the blown bulb and now none of the work!!
I've had a look thought the manual and cannot find a fuse for this, how to sort this.
View 1 Replies
This has manual knobs - NOT CLIMATRONIC. This actually happened months ago, I bought a new bulb, pulled trim piece and it looked like a PITA. It appeared that I would have to remove the radio to pull the climate control module, but I didn't want to bother w that at the moment. I'm sorta hoping that it is like the B5 Passats in that the bulb is just behind one of the knobs and it's accessible by pulling the knob off. I wasn't sure though, so I didn't want to start pulling on stuff till it broke.
View 2 Replies
Had I to break into my gas cap, replacing the module? is it ok to buy a used one? My door locks quit working too. the same module right?
View 1 Replies
I have a question about the the rear vent. Which AC setting turns on and off the rear vent? I dont see a separate control for the rear vent. Secondly is the rear vent controlled by the driver temperature control or the passenger temperature? I don't see either of these addressed in the manual...
View 8 Replies
Is it possible to change/reprogram the "HIGH" temperature on the 2012 Passat SEL climate control? I generally like to keep the temperature a bit warmer during the summer than the climate control is able. The selected temperature changes to "HI" above 80 degrees and turns on the heater. What I would like is to change the point that the climate control rolls to "HI" by several degrees, say 85 degrees.
View 3 Replies
It was a cold winter in Boston in the last two months. And since then almost every time I started my 2005 Prius, the temperature was default to 75F. Also, the first time I start the car in a day, it almost show the outside temperature as Celsius instead of Fahrenheit unless I press the screen to display something else and then come back, then the Fahrenheit will come back.
View 9 Replies
I am getting to check engine codes and I can't figure out what is causing them, one is P1296 cooling system malfunction, the other is P1654 Check DTC Memory of control panel ECU, any clues as to why I'm getting these, I did have a bad thermostat i changed that and it's still on, I also used the new prestone antifreeze for all makes and models, cause I am about 200 miles away from a dealership for g12.
View 6 Replies
I have a 1999 Acura Legend and the temperature control slide came loose so to adjust the temperature I have to slip a small screwdriver inside the dash to slide the cable inside one way or the other. Has the cable come loose or did the plastic slide break? Any tips on how to remove the climate control console so I can get a look inside?
View 9 Replies
Driving to work this morning my 'please check lights' warning came on and sure enough my drivers side side light bulb seems to have failed.
Trying to look via search and many threads to see how much work is involved to replace this tiny bulb. The car is due a service shortly and i could get the VW dealer to sort this out but is this going to be something daft like 3hours labour/bumper removal or is it an easy DIY?
This is the first thing to 'fail' in 2.5 years of owenership and not one that needs immediate remedy but would like to sort it out. Presumably i can buy the bulb cheaply enough from VW or Halfords as its not HID etc.
View 2 Replies
I have a 2016. I'm waiting on some aftermarket headlights and they will look great with LED drl/high beam. Have you installed them in this location ? I'm worried about fitment with the led being too big to fit in there.
View 23 Replies
Looking to find out what size bulb goes in the red light located on the lower part of the front door panel.
View 2 Replies
The little mark on the control knob to select air flow is unlit at night with the headlights on in my 2007 Camry LE. Apparently there is a bulb in there somewhere which needs to be replaced. How to change that bulb and get an indicator at night so that I can position the knob in the correct position?
View 1 Replies
I need to replace the original driver side HID bulb on my '07 ES350. I intend on doing this myself. I found the thread that listed detailed steps which I'm sure will be very useful.
Any tips as far as getting to the actual bulb? It looks pretty cramped in that area.
I have the adaptive headlights that turn with the steering wheel. Any special steps needed for this headlight?
View 4 Replies
Got the cornering lamp failure (AFS) warning this morning. How easy this is to replace and what the bulb part number is. Did some searching and found that it might be an H7 bulb. Is that correct? Would like to avoid a trip to the dealer if this is pretty easy to replace.
View 7 Replies
So i was replacing my power steering box after the shaft broke on it and apparently i didn't have my steering wheel back to exact center. after putting everything back together and started to drive down the road a very thin flat wiring harness broke and got tangled around my steering column under the plastics of the column. I then lost my horn and my cruise control and i believe my airbag. I pulled the wiring harness out and it was very long with two white plugs on either end. I'm not sure what this part is called or where i would be able to buy another one. And if there's some kind of instructions on how or where this harness plugs into sense it was ripped out.
2000 ford f-350 lariat 7.3l diesel....
View 6 Replies
Is there any way to turn off the little green light bulb icon in the instrument panel? I run my dash light at minimum brightness and that little light bugs me.
View 3 Replies
I just finished replacing the instrument panel light bulbs on my 1997 Ranger XL, 2.3L, 2WD pickup. I wanted to share how I did this. First of all, if you never have done this before, go slow and take your time removing the dash panels as they are plastic molding and break easily. Allow yourself about an hour to complete the task. You will need smaller sized hand sockets to remove the screws. The very first thing you should do is remove the negative battery cable from the battery. This way you will not risk shorting out anything electrical as well as possibly triggering the airbag in the steering wheel column.
The key piece in starting the process is to remove the radio first and then central console panel that houses the radio. It pops out very easily by gently prying it out in the four corners. Once you get that piece out remove the screws the support the lower knee panel. In order to get that piece off you will have to remove the two screws the hold the hood release lever in place. Get under the dashboard and look up as you lay looking upward near the brake pedal. Pull the hood release lever and you will see the two gold screws. Remove them. This will free up the panel on the under side. The top side of the panel will pop out if you pry it gently on the top two corners.
Next, you will see a metal panel underneath the knee panel. Remove this metal panel as well. Now you will be able to remove the instrument cluster panel piece. There are some visible screws holding this in place, remove them and gently pry the cluster panel out. Once the cluster panel cover is out you will have to actually remove the gauge cluster itself by removing the the four screw bolts that secure it in place. After the screws are out, gently work it out of the dash slowly as you will need to disconnect three electric plug harnesses in the back.
After it is unplugged and out, on the backside of the instrument cluster you will see some round, black colored thumb screw bulb housings that house the light bulb. Just twist them and turn making sure to go in the right direction. Feel it out for the direction, I cannot remember which way it turns. The bulb housings are labeled "ILL" on the circuit overlay. I recommend you replace all the bulbs as you might not want to have to do this again in the near future. Once all the bulbs are tightly seated and installed just reverse the above process for installation. This is a fairly easy job and like I said it takes about an hour. Make sure you test the lights after finishing.
View 10 Replies
Replacing license plate bulb on a 3rd gen rx? I tried taking off the interior lining on the rear hatch but no luck. There's access covers for taillight & reverse, but none for license plate light. I also tried "popping" out the plate light cover right above the license plate... don't think they are designed to be popped out.
View 3 Replies
I was replacing the side marker lamp on the passenger side. It was super hard to get my hand in there to get it out! The problem is when I was trying to reinsert it, the bulb slipped out of the socket. I think it fell inside the housing. So it looks like I'm going to have remove the headlight housing to get it out.
View 13 Replies
