Passat (B5) :: 1999 - Car Will Go Into Rough Idle And Misfire When Put Foot On The Gas Occasionally
Jun 29, 2012
So, I just picked up a 99 1.8T Wagon with 158k miles a couple days ago and after driving it a bit, I've noticed a couple things.
1. The coolant temp isn't reading, I assume this is probably the coolant sensor.
2. Occasionally the car will go into a rough idle and misfire when I put my foot on the gas. Could this just be a spark plug issue or something bigger? The PO did mention that he just replaced the plugs and I've read in previous threads about the subject that the 1.8ts are picky about plugs.
View 24 Replies
Advertisement
I got an 800rpm rough idle, no serious lack of power, every time after filling up w/ gas she starts slowly (bout 3 secs) and then tries to die. she catches herself and revs from 400-1200 for about a minute, then drives away fine. Getting:
17544 - P1136 Bank 1 : System too lean
16825 - P0441 Evap ECS : Incorrect flow
16684 - Random/Multiple cyl misfire detected (intermittent)
16688 - Cylinder 4 : Misfire detected (intermittent)
Also have: 01039 - Coolant temp sensor(g2) : open or short to plus? (intermittent)
Doubt the last has anything to do with BIG problem, but my temp sensor on ly gets off 0 when i am moving and using A/C...is this going to cause issue now/later/ever?
View 11 Replies
So every once in a while I would start my car and get a rough idle but not too bad. I got a cel after a few times of this happening. I had a misfire on 1 and 4 and possible misfire on 2. It was ok for a a couple days. But during the last few days I'll start it up and it's fine. But then if I shut it off and restart it will have a rough idle again. Also today I got gas and then it rough idled and when I would shift or put it in neutral the rpm would stay up and drop slowly down. Like if I shifted gears I could almost do it without the rpms dropping at all. I've got 110k. ??
View 6 Replies
I purchased a 1999 F-150 Lariat 4x4 automatic transmission about a year ago. When I did, the previous owner told me about an idle issue that he has occasionally. He said that the issue was with the IAC. He claimed that he had replaced it several times but "it was hard to get a good aftermarket IAC that actually works". He said he tried several, but it never fixed the issue. That sounds like he wasn't replacing the defective part to me, but I don't know. This is my first truck to ever purchase.
Fast forward a bit (about a year), and I have had intermittent issues with idle and running rough since I bought the truck. I don't drive the truck that often, but they are becoming more common, so I want to get things fixed now.
Issues:
1. When running at idle, especially in park, the idle seems to fluctuate and never stay consistent. The idle drops as soon as I put it into drive, and the truck jerks a bit when going into drive because the idle was too high in park. It has never died while at idle, however.
2. When driving, especially up a slight or moderate hill, the power seems low and the truck starts to ping and jerk. The only way I can avoid the jerking is to stomp on the accelerator and go into a lower gear. And even when doing that, I still can notice an ever so slight jerk.
3. This past week, it was rough for an entire 40 mile journey on the interstate. Slight ping the entire ride home. When I pulled into the driveway, it was jerking until I turned it off. I haven't tried to drive it sense.
Potential issues:
1. IAC - maybe the previous owner was right. Maybe I should replace it again, or clean it with some carb cleaner.
2. Cam Phasers - I saw some posts about this on the forum.
3. EGR valve - Also saw some posts about this.
4. Maybe even the transmission? It doesn't seem to have an issue going into or out of gear, though.
View 3 Replies
My F53 motorhome has a rough idle and hard misfire but is not setting any codes. I've put new plugs in it and not change.
View 7 Replies
2006 F53 (motorhome) with 6.8L V10. Rcently noticed rough idle and midrange (under load) mis fire. Had codes on 2 coils. Replaced coils and put new spark plugs in. Did not improve and now detecting mild back fire.
Just completed compression test. 1=207psi, 2=200, 3=210, 4=190, 5=197, 6=200, 7=200, 8=170, 9=202, 10=208.
put some oil in #8 and retested at 225!
Other observations on #8. Engine has ticking noise chased with stethoscope to #8. THE new plug with 200miles, insulator going to electrode tip and everything inside combustion chamber is black. All 9 other plugs still look new out of box.
With the ticking noise I was suspecting valve but the compression test with oil jumped way up.
View 14 Replies
2001 f250 v10 6.8l runs a little rough at idle, low rpm is ok between 1700 and 3000 rpm but around 3 it starts to shudder while driving let off gas get back on its fine, new plugs 1,000 miles ago has throttle body spacer and cold air intake, stock everything else..
View 8 Replies
I have an 04 elantra 2.0. Seems to idle rough when in D and foot on brake at the the lights etc. Put it into N roughness goes away.
View 15 Replies
2006 F53 (motorhome) with 6.8L V10. Rcently noticed rough idle and midrange (under load) mis fire. Had codes on 2 coils. Replaced coils and put new spark plugs in. Did not improve and now detecting mild back fire.
Just completed compression test. 1=207psi, 2=200, 3=210, 4=190, 5=197, 6=200, 7=200, 8=170, 9=202, 10=208.
put some oil in #8 and retested at 225!
Other observations on #8. Engine has ticking noise chased with stethoscope to #8. THE new plug with 200miles, insulator going to electrode tip and everything inside combustion chamber is black. All 9 other plugs still look new out of box.
With the ticking noise I was suspecting valve but the compression test with oil jumped way up.
View 8 Replies
I have a 2002 F250 CCSB Lariat 4x4 with the Triton V10, I'm up to 232,000 miles so far and fairly happy with the old girl. Just this weekend, I noticed some hesitation when at idle and even more rough running when under slight load. The misfire/hesitation is worst when going up a slight hill, when the truck is accelerating at low RPMs.
I am getting zero trouble codes or freeze frame conditions on my scanner. What should be my order of diagnosis? Vacuum test at line from PCV to TB, COP test? EGR inspection? Plug inspection? Also, how do you test a coil if resistance is not a reliable method?
View 5 Replies
I've got a 1998 Jeep Grand Cherokee, 6 cyl. engine, ~145k miles. A few weeks ago, I noticed the engine would occasionally run rough at idle, dropping down to a low rpm (~500 rpm, but erratic) for a few seconds before stalling. This usually happens when in park or stopped at a stoplight, but it's occasionally happened at low speed while coasting to a stop (never while accelerating, or while traveling above 20 mph or so). Generally, the car will restart right away, though sometimes I have wait a few seconds to a minute (I was a real popular guy at that intersection).
At first, no codes came up, so I changed the plugs and wires (I was due anyway). That didn't work. (The plugs, while worn, looked normal to me-no residue). I've since had a P0351 code pop up. Before I throw parts at this code (ignition coil, I believe), is there anything else I should be looking into?
View 19 Replies
Trying to clean the throttle body on my 09 sonata 2.4L due to rough idle occasionally (throwing P0106, replaced MAF sensor still same problem), one quick question, is it okay to force the valve open (with connector disconnected of course), and is "re-learning" necessary and what's the proper way to do it?
View 2 Replies
The engine on my camry 2007 was overheated and I had the headgasket replaced but now it has misfire codes and rough idle this is a 2.4 engine I replaced 2 of the coils but still it has a rough idle... when the car is running it runs pretty good.
View 5 Replies
This is my first new car, but I am assuming the idle should be pretty smooth. I feel my idle and it feels sort of rough. Almost like there is a slight misfire but not that intense.
One more question, car burning oil?
@ 7500 miles I was down a little more than a quart and now @ 14,100 I am down almost a quart. That is slightly alarming.
View 1 Replies
My windstar 3.8 engine has idle problems and engine light comes on at times. Code po305 (misfire #5). When I add sea-form to tank and drive awhile, the engine light goes out and the engine idle's normal. Is this an eva problem and what should I look for?
View 11 Replies
I got a 97 f150 4.2l from my neighbor. he takes good care of his vehicles. he sold it to me cuz it started to idle very rough like a misfire. it is hard to start when cold spits sputters and pops. once started idles like it wants to stall, then will idle normally then back to rough. back and forth like that. runs like a champ when going down the road . check engine light was on took it to auto store they checked codes . said bad o2 sensors so i changed them. still same issue. neighbor changed coil packs checked spark plugs and wire. every thing fires good. i changed iac. still didn't fix problem. could this be a bad egr valve or sensor? if so how can i diagnose this? he also thought was a clogged cat and bored it out. tight budget can't afford to take it to a mechanic. Was told spray carb cleaner spray around engine to check for leaks that did nothing at all...
View 14 Replies
I hopped in my truck this morning, fired it up, and it idled nicely. I drove around the corner, and noticed that the truck was barely responding to the throttle. Then things got shaky. It was a very rough idle, almost like a misfire. But I managed to get the gas to respond and got the revs up to about 3K and it seemed to run smooth.
No CEL either. Currently, I have no place to really look at my truck as I don't have a garage, or driveway for that matter. I don't have a scanner that can read live data either. I'm limited in my tools currently as well.
View 3 Replies
We have a 1999 Audi A6 Avant (wagon) with about 190,000 miles. Best car we've ever owned, and want to keep her running until the wheels fall off (so to speak). We split our time between sea level and a ski town at 7000' (yes, that may be relevant).
Last spring our Trusty (sea-level) Mechanic repaired the exhaust system; both tailpipes were shot (car sounded like a tank). Rather than replace with Audi parts (was going to be a full exhaust system replacement - $000s) they spliced in some new tailpipe. Car ran quietly after that.
However, immediately thereafter (like, on my drive home from Trusty Mechanic's shop) and ever since the car will occasionally stumble (misfire) and throw a check-engine light. Typical scenario is after having been off the throttle while going downhill and then tipping into the throttle at the bottom of the hill, the car will stumble and on comes the CEL. Stumbling lasts 5-10 seconds then gradually subsides. Light stays on, though. Not 100% reproduceable under those circumstances (but doesn't really happen under other scenarios), but happens often enough to be disconcerting.
We recently decamped from sea level to spend the summer up in the mountains (great bicycling), and while the car misbehaved a couple of times on the way out of town, by the time we got to 5000 ft or so, the CEL was no longer illuminated. The car has not misfired once while at altitude despite plenty of situations that would presumably have triggered the issue, were we at sea level.
Trusty Mechanic has replaced some injectors, some coil packs, and the spark plug cables. No behavior change.
View 11 Replies
'02 TB w/ code P0300 / Random misfire. Started the other day when it was very damp out, FWIW. Feels like ur driving on rumble strips during acceleration. Rough idle also. It does not do this continually though as after a while (minute) it clears up and runs smooth for a while then runs rough & light will again for a while. I seafoamed it today since it been about 60k since last seafoam. I thought that might have worked until I drove about 20 mile and it went rough again. I also cleaned the oil out of the cam sensor elect connector, since that caused rough running before, although it didn't throw that code. It seems to be very intermittent. '02 TB, 185k miles, orig plugs changed at 125k. Is it actually just going in & out of a limp-mode? O2 since it's random ???
View 14 Replies
I own a 2007 prius, it has about 320,000 miles. It has recently been diagnosed with a #2 and #4 cylinder misfire. The car severely idles rough, but when getting in the gas it goes away. I have replaced the spark plugs, the old plugs were very white(lean), replaced fuel injectors, used fuel injector cleaner. I've sprayed carb cleaner around the intake to see if I might a leak--no leak. The motor uses about a quart of oil every 1,000 miles since about 100,000 miles. I'm just guessing, could it simply be low compression causing this? I pulled the new spark plugs after about 5,000 miles and they where white also.
View 9 Replies
I bought a 2005 3rd gen about 8 weeks ago and I love it except for one problem, a really bad idle/vibration through the cabin when cold starting, it improves when the engine is warm but is still noticeable.
It went back to the dealer where I got it and they gave it a full service, new plugs, oils and filters and replaced the transmission oil too after the check vsc and engine management lights came on.
The codes pulled showed a misfire on cylinder 2, the dealer said the service would cure all and sure enough no more vsc lights but the rough idle and vibration are persistent.
The car has only 78000 miles and I'm pretty certain a Lexus isn't supposed to behave like this.
View 9 Replies
