Passat (B5) :: 1998 - Got Code P0422 - Rattling Cat - Intermittent Low Power
Feb 24, 2010
I have a 1998 1.8T Passat, Manual, with a P0422 DTC which always comes back after resetting. I don't have a Ross Tech since I own an older Mac. I have also sensed a more than usual odor from the exhaust and I have had a very noticeable loss in power at times.
The mechanic took a look at it and said that the cat was rattling and possibly partially plugging the exhaust system. He has ordered a new one for me - it will be here in couple of days. About 15 mins after I drove away from the shop (check engine light still on), I was accelerating away from the light and I felt a gentle jerk in the car and the power and acceleration and power that we all love in the 1.8T came totally back. It feels like a new car again. You really don't realize what you had missing until it comes back.
Does this make sense? Is this consistent with a the "plugging/unplugging" of an exhaust system by a bad cat? I just want to make sure the mechanic is doing the right thing.
View 2 Replies
Advertisement
I have been trowing a P0422 code which is main catalyst below efficiency.
I recently changed the rear o2 sensor and about 60 miles later the same code came back.
Logic dictates that the Cat is bad or there is an air fuel issue. No other codes have been thrown.
The car is a 1999 Jetta 2.0L AEG engine but it only has 51k miles on it. Would the cat go bad in 51k miles?
What else could I be looking at?
View 12 Replies
My 2000 Hyundai Accent Hatchback (manual) is tripping the code P0422 (Main Catalyst Efficiency Below Threshold (Bank 1)). If i clear the code it will pop back up after about 40-60 miles of driving. I hooked my OBDII sensor to it and look at the voltage output from the two O2 sensors and the front one oscillates between .2 to .7V and the downstream one does as well switching about at the rate. From my understanding the downstream O2 sensor should stay fairly steady or at least switch much slower than the upstream one. I get pretty good gas mileage, typ. ~30mpg. Luckily my state does not have emission testing. Is it actually the catalytic converter, the downstream O2 sensor or something else?
View 10 Replies
A few months ago I had multiple misfires due to a failed coil. When it happened I drove it enough to get to an Advance auto to have the code checked that came up. After I replaced the coil the car ran fine, but then the engine light came on with the P0422 bank 1 code. Does this mean the manifold cat converter is shot? The car runs fine except for what feels like the transmission trying to decide where it wants to be around 40mph (like it's shifting back and forth, don't know if it's related). I have a flex pipe that is leaking and needs replaced. I haven't noticed any loss in MPGs (consistently 26mpg city since I started checking). I have 133k miles.
View 8 Replies
Has around 173,000 miles, with a fresh cat installed a couple hundred miles ago. I was getting this code before, that is why I had a new cat installed. The code finally came back, and just recently I had to replace the crankshaft position sensor. After the sensor change, it was running great. The CEL came back on during a rainy day, I cleared it and was good for a few days. Then it rained again, and it came back. I couldn't afford a new OEM cat, I grabbed the best rated one I could from Amazon and had a shop install it. I know non OEM can be an issue, but I hope it is just an O2 sensor going bad.
View 2 Replies
Got this engine code error, how to proceed?
I have a '00 accent, just purchased a few days ago from a private party, when I bought it, I had a mechanic look it over, gave me the OK and said it passed inspection, no mechanical or obvious running problems with the car.
So I was driving around yesterday and the check engine light came on, took it to get the oil changed because I wasn't sure last time it was done, had the oil changed, light stayed on.
So I took it to auto zone to read the error code, was given this information. How to proceed?
View 1 Replies
I have a 1998 Passat 1.8 T with 137k miles on it that has been throwing the P0422 code. I've reset it at Schuck's and it has come back. Car is running fine and no rattle in the catalytic converter. Although it could still be the cat, it could just as well be something with the O2 sensors. Don't have a VAG-COM tool to check them directly. Is there some way other way to determine which O2 sensor it might be and/or if it is really the cat?
View 8 Replies
I have a 99 Tiburon 2.0 DOHC that I cant seem to get through emissions. The code, p0422 main catalyst efficiency below threshold bank 1 keeps popping up even after replacing the cat converter (twice) and replacing both 02 sensors. What else could be triggering this code and how to fix it?
View 2 Replies
I bought the little car to get off my motorcycle and its done great. But, after a couple trips around town my check engine light came on, and I imiditely noticed a change in my idle and engine performance. Im assuming my engine changed the air/fuel ratio to account for the sensor indications. My initial code read came back with four codes which said something about spark, and O2 sensor, and emissions. I went ahead put new spark plugs, gaped them as well as replaced the first O2 sensor.
After that I reconnected my battery and sure enough no engine light and my idle felt even better than before. (by the way my old plugs looked normal) But shortly down the road the light came on again. My idle did become a little different but not like my first encounter with the engine light. My power too seems a bit degraded, as well as the engine's sound. As of right now I am only reading one code P0422, which I do not see in the manual. I read online that its probably my catalytic converter or my engine is running at an improper air/fuel ratio. I am praying that it is not my catalytic converter and just my engine computer throwing things off.
Other things which may serve as clues:
Slight valve cover gasket leak (I will change the gasket when I do my timing belt job along with other seal and probably the water pump)
When pumping gas I can get about 90 cents in at a time, now more like 40 cents since the Saudis lowered our gas prices. Assuming I've got some kind of venting problem.
Car has 107K manual shift.
View 9 Replies
I recently purchased an 06 f150 fx4 5.4L with 60K miles. Just recently my check engine light came on and I've noticed a slight rough idle in park. I took it to autozone and the code read P0422 evap emission leak. Bought a new fuel cap but didn't work... EGR valve?
View 2 Replies
My 1999 VW Passat has a check engine P0411, P0422, so I looked for any damaged vacuum lines and found one that was all melted coming out of the blue vacuum reservoir tank in the front left lower bumper area. The line was broken off and I cannot figure out where this line is supposed to go.
View 1 Replies
I have a 1999 passat gls 1.8t with an intermittent ABS light code 1203. i cant find a description for it anywhere. Many passats are infamous for abs modules going bad but this is an intermittent problem that the code is not always set so I am trying to pin point it down.
View 1 Replies
I've gotten the P0442 "small leak - intermittent" code and "service now" warnings on my 2007 2.0T Passat. I have also occasionally gotten the "check gas cap" warning and icon on the dash, but it always goes away quickly. The car runs fine. The VCDS scan shows as follows:
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 3C0 907 115 S HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: --H14--- Serial number: VWZCZ000000000
Coding: 0404010A19070160
Shop #: WSC 24125 444 85663
VCID: 3041CBF8A31AF19890B
1 Fault Found:
001090 - EVAP Emission Control Sys
P0442 - 001 - Small Leak - Intermittent
[Code] ....
If I clear this code, it comes back within a day or two of driving, but not immediately. I have already replaced the gas cap and N80 valve. The other component I'm aware of possibly failing is the check valve. It's just downstream of the N80 valve, circled in red here:.
I put a vacuum on this part, and it had a very slow leak, losing about 3psi (starting from 20psi) every minute. That seems too small a leak for this to be a problem? Is this thing supposed to be absolutely air tight? Since this part is more expensive ($80) and bit more hassle to replace than the N80 valve, I'd like to know more about this before I just blindly replace it.
If this check valve isn't the problem, then what to check? Although the car runs fine, I need an inspection and would prefer to not have to clear the codes and hope for the best just before taking it in.
View 7 Replies
VW passat 1.8 tubo 20v 1998 R/reg automatic/triptonic I have a misfire/stutter when accelerating, have fault code 00529, changed plugs/maf/air filter/checked coils, cleaned throttle body, and still the car has the problem, it goes to the dealer on Saturday, I have told them I dont want the car back until this problem has been sorted.
Also been told it is the ECU for the gearbox! Picked the car up from the dealers after the oil service and inspection this is what they found. play in nsf track rod end. fault with engine control unit. fault with tci unit on top of the air cleaner?. could the tci unit be the cause of the problem that I have been getting! They also washed and vacuumed my car and left me a nice tin of mints.
View 1 Replies
I'm trying to find out what the check engine code PO455 Evap Emission Control System Leak (Large) means exactly.
View 1 Replies
My mother has the code to the radio, but when she was entering it she did it wrong. It now says "2 SAFE" or something similar and won't allow any other info entry. We even disconnected the power again and it still says the same thing. How do yo uget it baack to the point of allowing the 4 digit code to be entered?
View 2 Replies
So i got a 98 passat sedan used and was told it read a p0411 code. The person at autozone told him it was a cam sensor. The sensor was replaced. I know now from the manual that codes reads for sec. Air injection system , incorrect flow. It could be the vacuum lines. Now lets say it is the vacuum lines. Their is a misfire on cylinders 1-3.
View 4 Replies
Been working on a 2005 6.0 with 218kish miles on it. When I got the truck it had a contribution 2 code stored, no check engine light, just could see the code on the code reader.
Truck idled like crap, lacked power, so I replaced the injector. Truck improved but still had a miss, this time it had a stored code of injector 6.
Ordered another injector, got it installed today. Fired the truck up, ran perfectly, drove it around, absolutely 0 issues ran like a dream. Parked it for a few minutes before starting it again to wash it. Rough idle, not horrible, not noticeable. Cylinder 6 contribution code stored again, no check engine light.
So I drove it, I drove the hell out of it for about 15 minutes with the AC at full blast, WOT, etc etc. By the time I was done, truck was back to running smoothly.
Just walked outside after dinner to see if it would still perform well, or if it would idle poorly again, sure enough, 6 contribution, rough idle.
I just changed fuel filters with OEM, air filter is new. I just cleaned the EGR valve- although maybe it's not clean enough?? Oil change is tomorrow (had to wait for the filter to get shipped in).
I'm at a little bit of a loss on how to cure this miss, unless it's possibly an oil pressure issue from bad/old oil causing it?
View 12 Replies
My 02 f250 w/ 7.3 won't start. Cranks and nothing. No smoke or anything. For the last year It has had a intermittent starting problem, where I would drive it for 15-20 mins. If I shut it off like I would if I was at the fuel pump and then restart it, it wouldn't. I'd have to wait 30 minutes with a hood open and then it may start. Other times I would have to wait hours.
I tried replacing the crank position sensor, the fuel pump and filter.I did all this in the Last 300 mile . There's No change. After a week or two of sitting it won't start. What can I check and what can I try.
To add more info. Since I am not the original owner I pulled the computer that is located behind the ebrake to see if someone else had installed a chip, as I've heard that if that chip goes bad then the truck won't start. I disconnected that battery and pulled it. Negative on any chip. Put it all back together and tried again. No start. I borrowed a code reader tonight and pulled a P1280 code. I'm back to square one.
View 14 Replies
For the last couple months I've been messing with a P1118 code. Started a few months ago when I noticed my fuel mileage was down 1-2MPG. Also sometimes a rough seeming idle (hard to tell with the diesel). Then it threw a P1118, so I replaced the temp sensor under the turbo. The code went away for a while then came back, fuel mileage didn't change. So I replaced the temp sensor in the air filter box.
The code went away AND my fuel mileage seems to have come back to normal. Now, code thrown again. Search on P1118 hasn't been super useful. Seems like replacing the sensor under the turbo is the trick. Also seems to come up in combination with a bunch of other codes with battery problems. I suppose it's possible I have some sort of electrical gremlin. It throws the code on startup and stays on until I shut it off. Doesn't come on every time, is off more often than on.
View 2 Replies
I have a 2006 6.0 F350 that has started stalling intermittently. Truck starts right up after a few minutes and otherwise runs great. I'm getting trouble code p2617 (crankshaft position sensor). Reading on some of these forums it sounds like it could be a whole array of things causing this. Would this sensor be a logical place to start or what, if anything, should I look at before getting any parts?
View 2 Replies
