Park Avenue :: 2001 Starts Normally After Turning Key 3 To 5 Times
Feb 9, 2016
2001 Park Avenue has an issue that manifests itself every now and then. When I try to start engine nothing happens. Sometimes after turning key 3, 4 or 5 times it will start normally. I'm a little worried that one day it isn't going to start.... Using the original key, so I don't think that it's a problem with that. Have read that a faulty BCM can be responsible for a no-start condition, but that wouldn't be an intermittent occurrence would it?
View 6 Replies
Advertisement
The car seems to start accelerating on it own. Say cruise control is set you notice acceleration for no reason. Now cruise control does not work and acceleration at times still happens. It's not like you are flooring it just keeps going faster slowly. Don't know if this could be related I did replace the fuel pump recently and the crankshaft position sensor. I was looking to see if there is a re learn procedure for the crank sensor. I have replaced them in the past and don't remember having to do a relearn.
View 10 Replies
I have had the LF strut mount fail three times in the last three months. The strut has pushed through the upper mount. The guy a bought the car from said he had the struts replaced about a year ago. Could it be a bad strut?
View 1 Replies
Cruise control engages normally, holds the set speed, but after a few minutes it disengages. It feels that same as when you lightly tap the brake pedal to disconnect the cruise. Bad brake switch or something else?
View 1 Replies
Windshield wipers quit working. Wiper fluid still squirts. Fuse is good. Looking for any information for troubleshooting further.
View 7 Replies
Car has been stalling when stopped sitting in driveway or when slowing down for a red light or stop sign. Sometimes starts right away others takes 20 minutes. No codes no service engine light. Being told camshaft sensor crankshaft sensor egr valve. Got all data at library did egr test all indicate it is good. Did not have enough time to print out info on the sensors
View 2 Replies
I have a 2001 park avenue. Runs great but when you take your foot off the gas it feels as if the engine shakes or moves. This happens if driving or just parked. Maybe worn motor mount?
View 3 Replies
Front passenger will not open. It sounds like it unlocks but won't open. I was able to get door panel partially off. But i can not see the latch assembly. Not sure if I should try to muscle the panel off more probably destroying it so I can get to latch assembly or try to make a hook of some kind to put down next to window to try to pull rod for door latch. I was able to get my hand inside trying to pull on the arms to open but it never worked. Trying to see if I can get more access to spray it with something to free it up.
View 3 Replies
109,000 miles car shakes thru the steering wheel and the seat on highway driving from appox 60 mph and higher. Needed new tires anyways thought it was tire balance problem. Put on 4 new tires, road force balanced all four still shaking. Road force again, still shaking. So I am ruling out the tires. All front end parts are fine, rear end parts are fine. Struts have 30000 miles on them, but the strut bearings are shot. Alignment was done 12000 miles ago when I replaced the outer tie rod ends on both sides up front. Not getting any bearing noises with car on hoist and hand turning the wheels. Where to go next? I need to change the strut bearings out and do another alignment. Any thing else to look at? Just trying to get the ride back.
View 13 Replies
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
View 2 Replies
PA Base 149,000 miles . My car doesn't start every time. Sometimes I have to wait for a few minutes before it does, meaning, when I turn the key, it does nothing. There's no cluttering or blinking of lights or anything else that would indicate a bad starter, bad battery or electrical issue.
I've had the battery, starter and alternator checked and my mechanic says that everything is good. He thinks its the ignition key or the security system is going bad.
I purchased a new key two weeks ago and it started up every time until earlier today.
In the speedometer and odometer section, specifically the 'Park, R, N, D, 2, 1' section, there's an orange pin-like indicator that moves when you change gears. Mine is stuck between the '2 and 1', even when I place the car in park, reverse or drive. Could this be any cause to my vehicle not starting?
View 5 Replies
I just purchased a 2001 Park Ave Base. The DIC, A/C and Radio lights will randomly dim so low that they cant be seen during the day and I have no cluster lights at all. I have checked the fuses and ensured that the dimmer is all the way up (just before clicking on the interior lights which do come on) and have found nothing.
View 4 Replies
When I try to start my 96 Park Avenue sometimes it will not start until I back off the key just a little bit. I have replaced both ignition switches,starter and starter relay. along with new ignition key with the correct pellet resistance. The problem still persists. I really can not use a volt meter to check for voltage at starter terminals since the issue is very intermittent. I have checked and cleaned the battery terminals and the battery is ok, only one year old. I have head lights that do not dim when problem occurs. The only thing left I believe is the related wiring.
View 1 Replies
Where I could get a front driver side window regulator I am having a problem finding one and tired of the window going up and down slow due to the window ending up on the wrong side of the rubber.
View 6 Replies
92 PA Base
It's that time again for vehicle inspection and my horn has been blowing fuses. I had it diagnosed by the dealership and they stated the horn pad inside the steering wheel is bad. They also stated the horn pads for my model of PA has been discontinued and that I should install an aftermarket horn. If I don't have this horn installed I'll fail the inspection.
View 3 Replies
92 PA, 134,000 miles
I'm constantly getting a 'Code 41' and now my fuel economy is almost 100 miles less than usual on a full tank. I was wondering what could be causing the decrease of fuel economy?
Also, direct me to the location of the cam sensor and the directions for replacing. I've tried the AutoZone site to locate it but it was difficult to decipher.
View 14 Replies
Yesterday all four of my power windows stopped working in my 99 PA. The radio also has no power. I checked all the fuses in both fuse boxes (under the rear seat and in engine compartment.) Everything checks out... what am I missing?
View 3 Replies
I have an '85 Buick Electra. The "check engine soon" light comes on when I brake, stays on for awhile after I stop braking, and then goes on. There have been a couple of times when it just comes on but the majority of the time, it's when I brake.
View 5 Replies
92 PA Base
146,000 miles
I noticed that the coolant in the reservoir has been going low and I've been having to replenish it, in addition to the many different locations of small puddles of fluid under my car. Obviously there must be a leak somewhere. I conducted a pressure test on the radiator and detected a leak on a hose connected to the engine near the water pump was not tight. After tightening I pumped 16 lbs. of pressure and found the second leak; up between the rear valve cover and upper manifold.
My question is can coolant leak from the valve covers or is it coming from the manifold? I'm going to change the valve cover gaskets anyway since repairs need to be done in that area.
What are estimates if taken to a master tech: if manifold is leaking and replacing it along with the valve cover gaskets, or just replacing valve cover gaskets. Located in Indy.
View 1 Replies
I saw there was a service bulletin for this problem but could not access the bulletin. What can I do to tighten this mirror up.It does not have a screw just a clip. I tried bending the clip but no dice. Can I wedge something in there to tighten it up? This is the one on the windshield.
View 1 Replies
92 PA Base ... Attempting to replace water pump. Is a hydraulic jack required to hold up the engine when removing the engine mount? The engine mount (passenger side front) is covering the right portion of the water pump. Although the engine mount has two holes for the remainder bolts of the water pump, there's no room to fit a ratchet or anything to remove the remaining two bolts. It appears the mount must be removed to replace the water pump. Is this so? How to correctly remove the engine mount.
View 1 Replies
