Park Avenue :: 2001 - Car Shakes Through The Steering Wheel And Seat On Highway Driving
Nov 5, 2010
109,000 miles car shakes thru the steering wheel and the seat on highway driving from appox 60 mph and higher. Needed new tires anyways thought it was tire balance problem. Put on 4 new tires, road force balanced all four still shaking. Road force again, still shaking. So I am ruling out the tires. All front end parts are fine, rear end parts are fine. Struts have 30000 miles on them, but the strut bearings are shot. Alignment was done 12000 miles ago when I replaced the outer tie rod ends on both sides up front. Not getting any bearing noises with car on hoist and hand turning the wheels. Where to go next? I need to change the strut bearings out and do another alignment. Any thing else to look at? Just trying to get the ride back.
View 13 Replies
Advertisement
I have a 2001 park avenue. Runs great but when you take your foot off the gas it feels as if the engine shakes or moves. This happens if driving or just parked. Maybe worn motor mount?
View 3 Replies
I recently acquired a 1992 Buick Park Ave. My problem is that she shakes as i slow down and stalls when I stop. Usually about 10 minutes or so of driving. It doesn't stall every time but less when i baby the brake (i think) Its getting worse quickly and I've changed the spark plug wires and that didn't work also the previous owner recently changed the Cam sensor yet I'm getting a code 41.
View 14 Replies
I have driven my Hyundai for 79,880 miles. I brought it new in 2005. I had the front brakes replaced and afterwards felt a vibration through the gas pedal, steering wheel and seat. Both driver side and passenger sides had the vibration. You can feel the vibration at any speed. Sometimes it feels as if there is a part spinning unbalanced and bumping against something.
I replaced both front wheel bearings, both CV joints, and both front struts. These were all the original parts and they were all in need of replacement. The struts were so bad that they had no gas to resist a simple push at one end. I had all four tires high speed balanced.
I lifted the front end and stepped on the gas to get the tires going. I did it at high speed and my friend tells me he could hear a rattling of what he thinks are steel ball bearings coming from the drivers side of the automatic transmission. He thinks that there may be a bad bearing(s) in the transmission. I simply don't know. What the cause of the vibration might be? Could my warranty cover the repair?
View 1 Replies
My accent just crossed 180K mark. From last year the steering wheel shakes quite a bit at highway speeds ,say 70MPH. It's especially bad when I accelerates . Took the car to a shop, they told me two things, the CV axle of passenger side needs replacement, and the wheel hub bearings are bad(both front wheels). They quoted me $200 for replacing the cv axle, and $400 for replacing both front wheel bearings. Since I don't even think the car worth $600 right now(given high mileage), I told them I'll just do the axle(I know how to do it myself but don't have the time, plus it won't be that much cheaper DIY anyway). They said fine, but if you don't replace the bearings you may have the wheel fly off one day and that's dangerous.
They replaced the axle, and the car drives a lot better now. There's still a little bit of shaking at high speed but 75% of that shake has gone away. My question is, does the worn out bearing causes car to tremble at high speed? I heard other people told me there should be a grinding or loud hawling sound if the bearings are bad, but I don't hear that. I searched the internet and some people say, to determine if the hub bearings are bad, just drive it for 10 minutes then feel the hub. If it's barely warm, the bearings are good. If it's warm to hot, then the bearings are bad. I felt it and it's warm, but not too hot to touch. I tried the rear wheels and those are barely warm indeed.
So from this method it seems the front wheel hub bearings are indeed bad. I wonder how long I can keep driving this without endanger myself. $400 is not cheap for this car and I don't have a machine to press in the bearings myself. I can disassemble the rotor and hub that's not a big deal, but I don't know how to get the old bearing out and the new bearing in. Is there a machine shop that just do the pressing? Or, is there any shop selling the hub assembly with bearing already in place? this way I just remove the old hub assembly and replace it with the new assembly, a lot easier. I searched the internet but can only find pre-assembled hub w/ bearing for the rear wheel of this car. I need the front ones.
View 4 Replies
Noticed the steering wheel shakes just slightly at highway speeds. Happens to me when I'm at around 65-70mph and above. It's just very slight, so I really wasn't thinking its an alignment issue at all. I didn't know if this was a bit normal for these B7s or what. I've had alignment issues in cars before and this just doesn't feel that bad, but its enough to give me pause.
View 7 Replies
2300k engine. Car stopped running on highway during a rain storm. Checked spark and its ok.checked compression and its ok. Fuel is at 45 psi at port. Changed crankshaft positioning sensor. Dont know what else to check? Still wont start!
View 14 Replies
I've been noticing my steering wheel shakes if i normally brake going on the highway at high speed. My friend said that it's probably your brakes and rotors. Get them replaced and resurface and that should fix the problem. Can i get some confirmation before i do this?
1. I just had my tires replace at 55k and bought this car new back in feb 09. it has 62k.
2. also i've been reading up on camries fail water pump. i'm thinking of doing this over the weekend or should i just wait until i notice some leaks?
3. lastly, any major thing i need to be aware of. i've done the normal engine oil and filter change, cabin and engine air filter change, that's about it. i hope these camries are bullet proof like the old school (92-95).
View 14 Replies
I have a small amount of play in my steering wheel. Very noticeable on the highway at high speeds. The steering wheel shakes in my hand.
1. Checked the tires for balance.
2. Checked the tie rods.
3. Brand new stabilizer bars on both sides.
Is there something I am missing or overlooked.
View 4 Replies
2001 Park Avenue has an issue that manifests itself every now and then. When I try to start engine nothing happens. Sometimes after turning key 3, 4 or 5 times it will start normally. I'm a little worried that one day it isn't going to start.... Using the original key, so I don't think that it's a problem with that. Have read that a faulty BCM can be responsible for a no-start condition, but that wouldn't be an intermittent occurrence would it?
View 6 Replies
Cruise control engages normally, holds the set speed, but after a few minutes it disengages. It feels that same as when you lightly tap the brake pedal to disconnect the cruise. Bad brake switch or something else?
View 1 Replies
Windshield wipers quit working. Wiper fluid still squirts. Fuse is good. Looking for any information for troubleshooting further.
View 7 Replies
Car has been stalling when stopped sitting in driveway or when slowing down for a red light or stop sign. Sometimes starts right away others takes 20 minutes. No codes no service engine light. Being told camshaft sensor crankshaft sensor egr valve. Got all data at library did egr test all indicate it is good. Did not have enough time to print out info on the sensors
View 2 Replies
Front passenger will not open. It sounds like it unlocks but won't open. I was able to get door panel partially off. But i can not see the latch assembly. Not sure if I should try to muscle the panel off more probably destroying it so I can get to latch assembly or try to make a hook of some kind to put down next to window to try to pull rod for door latch. I was able to get my hand inside trying to pull on the arms to open but it never worked. Trying to see if I can get more access to spray it with something to free it up.
View 3 Replies
The car seems to start accelerating on it own. Say cruise control is set you notice acceleration for no reason. Now cruise control does not work and acceleration at times still happens. It's not like you are flooring it just keeps going faster slowly. Don't know if this could be related I did replace the fuel pump recently and the crankshaft position sensor. I was looking to see if there is a re learn procedure for the crank sensor. I have replaced them in the past and don't remember having to do a relearn.
View 10 Replies
As I'm driving down the highway my steering wheel tends to shake a little bit. My tires are fine but are offly loud . They are balanced and all but just sound loud u can hear them rolling inside the cab sounds maybe like if I had mud tires but I don't they are all terrains. . I was told maybe the bearings but I don't know.
View 1 Replies
Would bad harmonic dampener cause vibration when in park or when in gear but idling? Highway speeds no vibration..
View 2 Replies
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
View 2 Replies
Just had new front tires installed today and drove home. Car felt fine driving at 60 kph. Drove tonight on the highway and felt a bit of shaking. Its not as severe but can be felt sightly. Didn't feel this (slight) shaking with my old worn tires at highway speeds. What could it be? Btw, bought the car used last year at my local dealer and I haven't done an alignment yet since then.
View 7 Replies
My 2003 Sante Fe (3.5L) steering wheel twitches right and left when driving. On hot days its much less than colder days. The drivers side tire is worn on the inside much more than the outside of the tire. The brake rotor towards its outside is silver, perhaps half an inch. The rest of the rotor towards the inner hub has a little surface rust on it as though the pads are not fully grabbing. The car has 45,000 miles on it.
View 1 Replies
got an issue with my 01 excursion. When driving the steering wheel with vibrate or shimmy. As in if the rotor maybe warped or tire has a small bubble in it. Here is the kicker. It does not do it all the time. Some times I can drive it and it drives just as smooth as can be and I can go all the way to town and back. Then sometimes I can drive it to town and either turn a curve or hit a bump and then it will start doing it. Then I will come back home. Then the next time i jump in it and start driving down the road and it is just fine. I just had the brakes and rotors were just changed.
View 6 Replies
