Park Avenue :: 1992 - Hard To Shift Into Park From Other Gears
Aug 22, 2004
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
View 2 Replies
Advertisement
92 PA, 134,000 miles
I'm constantly getting a 'Code 41' and now my fuel economy is almost 100 miles less than usual on a full tank. I was wondering what could be causing the decrease of fuel economy?
Also, direct me to the location of the cam sensor and the directions for replacing. I've tried the AutoZone site to locate it but it was difficult to decipher.
View 14 Replies
92 PA Base ... Attempting to replace water pump. Is a hydraulic jack required to hold up the engine when removing the engine mount? The engine mount (passenger side front) is covering the right portion of the water pump. Although the engine mount has two holes for the remainder bolts of the water pump, there's no room to fit a ratchet or anything to remove the remaining two bolts. It appears the mount must be removed to replace the water pump. Is this so? How to correctly remove the engine mount.
View 1 Replies
I have a 92 Park Ave and the right front brake caliper will squeeze then release pressure even while holding the brake pedal down, which does not go to the floor, the left front brake is doing most of the stopping. I have bleed that caliper but still same problem. Is the ABS module proportioning wrong? By the way, the brake pads are brand new.
View 5 Replies
I recently acquired a 1992 Buick Park Ave. My problem is that she shakes as i slow down and stalls when I stop. Usually about 10 minutes or so of driving. It doesn't stall every time but less when i baby the brake (i think) Its getting worse quickly and I've changed the spark plug wires and that didn't work also the previous owner recently changed the Cam sensor yet I'm getting a code 41.
View 14 Replies
Gears won't shift from park. What's wrong? Is it the neutral safety switch?
View 5 Replies
i've got an accord 4 cylinder with an automatic transmission that does not engage any of the other gears when i shift it out of park. all indicator lights are out except for the park position on the dash.
View 1 Replies
The past couple of weeks I have noticed my car is hard to shift out of park when I first start it after a few hours. After I get it out of park it is good until the next time I let it cool off for a little bit. It will sometime thump too when I shift to reverse no matter if im on an incline to parked flat. I have changed the transmission fluid twice and I have 60k on it so I don't think that would have anything to do with it. Also, is this something that could cause serious damage because if it isn't I don't really care about it but if it does I would like to fix it.
View 4 Replies
What causes this? I have to mess with the brake pedal for a while for it to finally register that i have my foot on the brake and let me shift out of park.
View 5 Replies
I am planning to buy this 2012 Camry LE (38k), automatic, I am on the test run and realized that the car's shifting from park to reverse is harder than shifting from reverse to drive. What I mean is, it is really hard to move the selector from Park to Reverse.
View 6 Replies
I have a 2007 Honda Civic with an automatic transmission that started acting up tonight. I am having difficulty getting it to shift out of park. Once I finally get it out of park, it shifts to everything else fine. It's not because the wheel is locked (checked that already). What could be the problem and how cheap can I get it fixed? I just got socked nearly $800 for an alternator and battery when I broke down in Indianapolis during my vacation and was lead to believe, by the garage that repaired it, that my serpentine belt was going to go at any time. In any event, it's the only car my family has, it has 177,777 miles on it (roughly) and we can't afford to trade it in for another vehicle. We have to keep it running.
View 3 Replies
My wife called today after arriving at work letting me know she was having trouble shifting the car from D(drive) to P(park). I know the Gear box is set up in a stepped configuration. Sometimes its smooth shifting up to park and other times its not.
2011 Elantra Gls
Silver w/tinted windows
View 3 Replies
I have a 95 Aerostar that when in park it is hard to shift into reverse, drive etc. It is an automatic, 3.0 liter.
View 7 Replies
As it's progressively grown colder (which may or may not be related), my truck has grown all but impossible to shift from park into reverse neutral or drive with the engine running when the truck is cold. I often have to shut the engine off, and once I do it immediately is very easy to shift out of park into neutral, and then I can restart the engine. Once the truck has been driven some, it's not hard to get out of park, but if it's shut off for some time (an hour maybe) it will be difficult to shift out of park again. I don't know how to begin troubleshooting this.
View 8 Replies
PA Base 149,000 miles . My car doesn't start every time. Sometimes I have to wait for a few minutes before it does, meaning, when I turn the key, it does nothing. There's no cluttering or blinking of lights or anything else that would indicate a bad starter, bad battery or electrical issue.
I've had the battery, starter and alternator checked and my mechanic says that everything is good. He thinks its the ignition key or the security system is going bad.
I purchased a new key two weeks ago and it started up every time until earlier today.
In the speedometer and odometer section, specifically the 'Park, R, N, D, 2, 1' section, there's an orange pin-like indicator that moves when you change gears. Mine is stuck between the '2 and 1', even when I place the car in park, reverse or drive. Could this be any cause to my vehicle not starting?
View 5 Replies
I just purchased a 2001 Park Ave Base. The DIC, A/C and Radio lights will randomly dim so low that they cant be seen during the day and I have no cluster lights at all. I have checked the fuses and ensured that the dimmer is all the way up (just before clicking on the interior lights which do come on) and have found nothing.
View 4 Replies
When I try to start my 96 Park Avenue sometimes it will not start until I back off the key just a little bit. I have replaced both ignition switches,starter and starter relay. along with new ignition key with the correct pellet resistance. The problem still persists. I really can not use a volt meter to check for voltage at starter terminals since the issue is very intermittent. I have checked and cleaned the battery terminals and the battery is ok, only one year old. I have head lights that do not dim when problem occurs. The only thing left I believe is the related wiring.
View 1 Replies
My 2012 Toyota Camry SE V6. 37,500 miles. Occasionally when I'm parked shifting down to reverse it's so tight/put effort to shift & it literally thumps the entire car.. I heard to put the E-BRAKE/PARKING BRAKE down BEFORE shifting it to park & it worked but occasionally even with the E-BRAKE/PARKING BRAKE it still jerks the entire car going from PARK to REVERSE.
Also going from REVERSE to NEUTRAL it gives off a little vibration underneath me ALL THE TIME going from REVERSE to NEUTRAL.. I know these are so many questions that are probably a no-brainer answer but I'm looking to see if any one here had/has or heard of a similar or exact problem. Is the trans fluid low or dirty? I saw the CARFAX I didn't see the services he's done it's only been 1 owner on this car I'm the second. Previous owner leased it brand new.
View 7 Replies
2007 Chevrolet Impala 1LT3.5L Flex Fuel EngineAuto Transmission with shift lever on the steering column29,980 miles
Bought new Nov 2006 so is now four and a half years oldThe drive train is still under warranty (6 years or 60,000 miles). All recommended service per the manufacturers manual has been done. Book calls for first transmission service at 50,000 miles
NOTE: Previously at 19,600 miles the transmission cooler line fittings were replaced due to a small leak. Currently no evidence of a leak; no fluid on garage floor and the transmission fluid level on the stick shows right on the mark. Fluid still clean pale red and has no odor.
Majority of my driving is short hops with multiple stops, so the car gets heavy use shifted into and out of park gear. I do use the "parking brake" applying it after shifted into park and released before shifting out of park. I always have my foot on the brake pedal when shifting out of park.
PROBLEM: Having trouble shifting out of park on a cold engine or if the car has been sitting for an hour or more since turned off and put into park gear. Oddly enough, if I'm running a series of errands where the car has been in park for only 5 to 30 minutes, there is no problem shifting out of park gear. But if the car sits long enough for the engine to cool then it becomes hard to shift. The longer the time it sits in park the harder it is to shift out of park when the car is started.
View 11 Replies
Where I could get a front driver side window regulator I am having a problem finding one and tired of the window going up and down slow due to the window ending up on the wrong side of the rubber.
View 6 Replies
92 PA Base
It's that time again for vehicle inspection and my horn has been blowing fuses. I had it diagnosed by the dealership and they stated the horn pad inside the steering wheel is bad. They also stated the horn pads for my model of PA has been discontinued and that I should install an aftermarket horn. If I don't have this horn installed I'll fail the inspection.
View 3 Replies
