Park Avenue :: 1992 Buick Shakes As Slow Down And Stalls When Stopped - Code 41
Jul 20, 2004
I recently acquired a 1992 Buick Park Ave. My problem is that she shakes as i slow down and stalls when I stop. Usually about 10 minutes or so of driving. It doesn't stall every time but less when i baby the brake (i think) Its getting worse quickly and I've changed the spark plug wires and that didn't work also the previous owner recently changed the Cam sensor yet I'm getting a code 41.
View 14 Replies
Advertisement
92 PA, 134,000 miles
I'm constantly getting a 'Code 41' and now my fuel economy is almost 100 miles less than usual on a full tank. I was wondering what could be causing the decrease of fuel economy?
Also, direct me to the location of the cam sensor and the directions for replacing. I've tried the AutoZone site to locate it but it was difficult to decipher.
View 14 Replies
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
View 2 Replies
I have a 2001 park avenue. Runs great but when you take your foot off the gas it feels as if the engine shakes or moves. This happens if driving or just parked. Maybe worn motor mount?
View 3 Replies
Where I could get a front driver side window regulator I am having a problem finding one and tired of the window going up and down slow due to the window ending up on the wrong side of the rubber.
View 6 Replies
92 PA Base ... Attempting to replace water pump. Is a hydraulic jack required to hold up the engine when removing the engine mount? The engine mount (passenger side front) is covering the right portion of the water pump. Although the engine mount has two holes for the remainder bolts of the water pump, there's no room to fit a ratchet or anything to remove the remaining two bolts. It appears the mount must be removed to replace the water pump. Is this so? How to correctly remove the engine mount.
View 1 Replies
109,000 miles car shakes thru the steering wheel and the seat on highway driving from appox 60 mph and higher. Needed new tires anyways thought it was tire balance problem. Put on 4 new tires, road force balanced all four still shaking. Road force again, still shaking. So I am ruling out the tires. All front end parts are fine, rear end parts are fine. Struts have 30000 miles on them, but the strut bearings are shot. Alignment was done 12000 miles ago when I replaced the outer tie rod ends on both sides up front. Not getting any bearing noises with car on hoist and hand turning the wheels. Where to go next? I need to change the strut bearings out and do another alignment. Any thing else to look at? Just trying to get the ride back.
View 13 Replies
I have a 1988 Buick PA Electra. Car idles rough and shaky at a stop light. When warmed up service engine light comes on for a few seconds then goes off. I've changed ignition coil box, wires, plugs, ignition module, fuel injectors, fuel filter. It seems like there may be a vacuum leak. Car has only 114,000 miles on it and I don't want to give up on her. Before this she was running smooth.
View 4 Replies
I have a 92 Park Ave and the right front brake caliper will squeeze then release pressure even while holding the brake pedal down, which does not go to the floor, the left front brake is doing most of the stopping. I have bleed that caliper but still same problem. Is the ABS module proportioning wrong? By the way, the brake pads are brand new.
View 5 Replies
I purchased this vehicle this week.69k miles..driving 25 miles to my home the temp. control beeped...near my home...my son added near 1 gal of anti freeze....that night there seemed to be a small amount of leakage under the radiator (but none since that date 11/24/14 or 2 + days ago ).. the coolant level in the radiator appeared down 1 inch on one check. On the last check after running and then off...the radiator level was up to the top and the reservoir level was at 1 inch. My son thought there might be a fine/mist spraying in the area near the left lower side of the radiator..since that time with the motor running I placed a piece of file folder down near where he thought there was a mist and saw none on the folder... this car was owed my an elderly person and likely was not driven often of late.
View 4 Replies
Ok, here is the problem: 1997 Buick Park Ave driver's door will not open from inside or outside. It will not unlock. The inside lock/unlock button will not move to unlock position. Using the key from outside will not unlock the door. This happened on the coldest day of the year (15 degrees). I'd love to take off the door panel to look inside but I can't open the door! I'm getting tired of entering and exiting the car from the passenger door!
View 3 Replies
Yesterday all four of my power windows stopped working in my 99 PA. The radio also has no power. I checked all the fuses in both fuse boxes (under the rear seat and in engine compartment.) Everything checks out... what am I missing?
View 3 Replies
2300k engine. Car stopped running on highway during a rain storm. Checked spark and its ok.checked compression and its ok. Fuel is at 45 psi at port. Changed crankshaft positioning sensor. Dont know what else to check? Still wont start!
View 14 Replies
Car has been stalling when stopped sitting in driveway or when slowing down for a red light or stop sign. Sometimes starts right away others takes 20 minutes. No codes no service engine light. Being told camshaft sensor crankshaft sensor egr valve. Got all data at library did egr test all indicate it is good. Did not have enough time to print out info on the sensors
View 2 Replies
My 1992 Buick Century frequently shuts down when coming to a stop or slowing down to make a sharp corner. I'm always able to restart it. I thought it was a torque converter lockup problem, but my transmission specialist said the transmission is okay. Last month, after the car died completely, I had the crankshaft sensor and harmonic balancer replaced by Firestone. Could it be the same parts that malfunctioned? Or, could it be another issue?
View 12 Replies
My truck starts right up, then immediately almost stalls or stalls completely. It also shakes a little when idling while its in Park. I just recently had my egr valve, pcv valve, spark plugs&wires, and fuel filter replaced. it has 104,000 miles on it. What could be causing it to do this?
View 9 Replies
SO, my Buick has given the code for bad TPS, and it was replaced a little over a year ago...and now after the same symptoms, replaced again.. However, this time, right after replacing, it gave the code again, and still stalls out /doesn't want to stay running especially when put in gear. My regular mechanic also recently just put on a new catalytic converter and a new fuel pump and fuel filter. I'm at a loss, and desperately need my car back.
A little back history...about 3 years ago a 'friend' was to work on my car to install the thermostat and power washed the engine...which shortly after started having all kinds of electrical issues. Right after that, my mechanic had to install a coil, spark plugs, new ignition panel and the 1st tps.
View 8 Replies
Have a '92 Olds Cutlass Ciera 6 cyl 3300 engine. After 20-30 mins of driving it dies when I have to stop for a light. Depressing the brake kills the engine. Starts right up after but as soon as I put it in drive, it dies. If the car sits for 20 mins or so after problem begins it's okay. If I get to an intersection and have to stop, I put it in neutral. When I have to go again I rev the engine, let it die down some and then put it in drive (hard on the car, I know, but it's only way to get going again. Once I'm moving, I can accelerate and it's okay. What is wrong with my car?
View 3 Replies
PA Base 149,000 miles . My car doesn't start every time. Sometimes I have to wait for a few minutes before it does, meaning, when I turn the key, it does nothing. There's no cluttering or blinking of lights or anything else that would indicate a bad starter, bad battery or electrical issue.
I've had the battery, starter and alternator checked and my mechanic says that everything is good. He thinks its the ignition key or the security system is going bad.
I purchased a new key two weeks ago and it started up every time until earlier today.
In the speedometer and odometer section, specifically the 'Park, R, N, D, 2, 1' section, there's an orange pin-like indicator that moves when you change gears. Mine is stuck between the '2 and 1', even when I place the car in park, reverse or drive. Could this be any cause to my vehicle not starting?
View 5 Replies
I just purchased a 2001 Park Ave Base. The DIC, A/C and Radio lights will randomly dim so low that they cant be seen during the day and I have no cluster lights at all. I have checked the fuses and ensured that the dimmer is all the way up (just before clicking on the interior lights which do come on) and have found nothing.
View 4 Replies
When I try to start my 96 Park Avenue sometimes it will not start until I back off the key just a little bit. I have replaced both ignition switches,starter and starter relay. along with new ignition key with the correct pellet resistance. The problem still persists. I really can not use a volt meter to check for voltage at starter terminals since the issue is very intermittent. I have checked and cleaned the battery terminals and the battery is ok, only one year old. I have head lights that do not dim when problem occurs. The only thing left I believe is the related wiring.
View 1 Replies
