I have a 91 park ave it wont start all the lights come on the dash . If I run jumper to starter it turns wont stay running unless I pour gas in line. appears to not be getting power to starter and fuel system. What controls both of these?
View 14 RepliesYesterday all four of my power windows stopped working in my 99 PA. The radio also has no power. I checked all the fuses in both fuse boxes (under the rear seat and in engine compartment.) Everything checks out... what am I missing?
View 3 RepliesI just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.
Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.
Where should I start to find out my problem with the fuel system?
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
1991 F150XLT, 5.0, E4OD....Should the EFI system bump up the idle speed when the AC system is operating to compensate for the compressor load? Obviously I'm asking because mine sure doesn't. With AC on, the idle speed will drop to around 300rpm in Drive, like when sitting at a red light for example. Surely this isn't normal operation...is it?
View 4 RepliesI just bought a 1991 F150 with a 302 (5.0). It idles at around 2600-2800 RPMs. The previous owners replaced the TPS and IAC, but it still idles fast. Ford dealership told them it was a vacuum leak. Are all the vacuum lines close to each other? How easy is it to locate/fix the problem?
View 2 RepliesPA Base 149,000 miles . My car doesn't start every time. Sometimes I have to wait for a few minutes before it does, meaning, when I turn the key, it does nothing. There's no cluttering or blinking of lights or anything else that would indicate a bad starter, bad battery or electrical issue.
I've had the battery, starter and alternator checked and my mechanic says that everything is good. He thinks its the ignition key or the security system is going bad.
I purchased a new key two weeks ago and it started up every time until earlier today.
In the speedometer and odometer section, specifically the 'Park, R, N, D, 2, 1' section, there's an orange pin-like indicator that moves when you change gears. Mine is stuck between the '2 and 1', even when I place the car in park, reverse or drive. Could this be any cause to my vehicle not starting?
I just purchased a 2001 Park Ave Base. The DIC, A/C and Radio lights will randomly dim so low that they cant be seen during the day and I have no cluster lights at all. I have checked the fuses and ensured that the dimmer is all the way up (just before clicking on the interior lights which do come on) and have found nothing.
View 4 RepliesWhen I try to start my 96 Park Avenue sometimes it will not start until I back off the key just a little bit. I have replaced both ignition switches,starter and starter relay. along with new ignition key with the correct pellet resistance. The problem still persists. I really can not use a volt meter to check for voltage at starter terminals since the issue is very intermittent. I have checked and cleaned the battery terminals and the battery is ok, only one year old. I have head lights that do not dim when problem occurs. The only thing left I believe is the related wiring.
View 1 RepliesWhere I could get a front driver side window regulator I am having a problem finding one and tired of the window going up and down slow due to the window ending up on the wrong side of the rubber.
View 6 Replies92 PA Base
It's that time again for vehicle inspection and my horn has been blowing fuses. I had it diagnosed by the dealership and they stated the horn pad inside the steering wheel is bad. They also stated the horn pads for my model of PA has been discontinued and that I should install an aftermarket horn. If I don't have this horn installed I'll fail the inspection.
92 PA, 134,000 miles
I'm constantly getting a 'Code 41' and now my fuel economy is almost 100 miles less than usual on a full tank. I was wondering what could be causing the decrease of fuel economy?
Also, direct me to the location of the cam sensor and the directions for replacing. I've tried the AutoZone site to locate it but it was difficult to decipher.
I have an '85 Buick Electra. The "check engine soon" light comes on when I brake, stays on for awhile after I stop braking, and then goes on. There have been a couple of times when it just comes on but the majority of the time, it's when I brake.
View 5 Replies92 PA Base
146,000 miles
I noticed that the coolant in the reservoir has been going low and I've been having to replenish it, in addition to the many different locations of small puddles of fluid under my car. Obviously there must be a leak somewhere. I conducted a pressure test on the radiator and detected a leak on a hose connected to the engine near the water pump was not tight. After tightening I pumped 16 lbs. of pressure and found the second leak; up between the rear valve cover and upper manifold.
My question is can coolant leak from the valve covers or is it coming from the manifold? I'm going to change the valve cover gaskets anyway since repairs need to be done in that area.
What are estimates if taken to a master tech: if manifold is leaking and replacing it along with the valve cover gaskets, or just replacing valve cover gaskets. Located in Indy.
I saw there was a service bulletin for this problem but could not access the bulletin. What can I do to tighten this mirror up.It does not have a screw just a clip. I tried bending the clip but no dice. Can I wedge something in there to tighten it up? This is the one on the windshield.
View 1 Replies92 PA Base ... Attempting to replace water pump. Is a hydraulic jack required to hold up the engine when removing the engine mount? The engine mount (passenger side front) is covering the right portion of the water pump. Although the engine mount has two holes for the remainder bolts of the water pump, there's no room to fit a ratchet or anything to remove the remaining two bolts. It appears the mount must be removed to replace the water pump. Is this so? How to correctly remove the engine mount.
View 1 RepliesMy interior lights are staying on all the time, What is the part number for the switch that I need?
View 1 Replies2001 Park Avenue has an issue that manifests itself every now and then. When I try to start engine nothing happens. Sometimes after turning key 3, 4 or 5 times it will start normally. I'm a little worried that one day it isn't going to start.... Using the original key, so I don't think that it's a problem with that. Have read that a faulty BCM can be responsible for a no-start condition, but that wouldn't be an intermittent occurrence would it?
View 6 RepliesMy 1986 Ranger 2.9 starts only when I spray starter fluid into the air intake. It does stay running and it drives fine. The engine will not fire up unless I do this process. I have cleaned out the fuel rail, fuel injectors, purchased new fuel filter, and tested fuel pressure (which is good).
View 9 RepliesI have had the LF strut mount fail three times in the last three months. The strut has pushed through the upper mount. The guy a bought the car from said he had the struts replaced about a year ago. Could it be a bad strut?
View 1 Replies2300k engine. Car stopped running on highway during a rain storm. Checked spark and its ok.checked compression and its ok. Fuel is at 45 psi at port. Changed crankshaft positioning sensor. Dont know what else to check? Still wont start!
View 14 Replies