Nissan - Pickup :: 1997 - Cylinder 2 Misfiring / Change Whole Distributor?
Mar 22, 2015
my mechanic is stump have a 1997 Nissan pickup 2.4 liter auto tranny. number 2 cylinder misfiring.my mechanic say it have fuel, spark. and he did a compression check say compression is good. code (p. o 302) keep coming on. he change spark plug and wire and distributor cap and rotor. but light keep coming on. he say the only other thing he can think may be is. to change the whole distributor he say the cam sensor is in the distributor. tuck have 264,000 mile on it.
View 5 Replies
Advertisement
Where can I purchase a distributor for a 2003 Dodge Neon SE?
The engine is running rough, the gas mileage has degraded, and the Check-Engine light is ON.We went to an AutoParts Store to have them read the car's computer output to tell us why the Check-Engine light is ON.The results said that the No. 4 Cylinder was not firing consistently.We replaced all four spark plugs and the spark plug wires. It ran a little better but the Check-Engine light is still ON and the engine still runs rough. I think we should replace the distributor or maybe just the distributor cap (if possible?).
View 19 Replies
have a 1997 nissan pickup 2.4 liter engine check engine light came on code say number 2 cylinder misfiring put in shop. they say that they can't get to misfire.truck run great.just that light keep coming on with code (p o 302)
View 11 Replies
I have a 2002 Nissan Maxima GLE. I had had problems with it misfiring. It said it was misfiring on cylinder 6. Put all new spark plugs on it, same problem. Put new ignition coils, still same problem. Had it checked by several mechanics. NONE of them could find why it wasn't getting power. Then about 2 weeks ago I was driving it home & it died. Got it started & it drove less than a mile & died again. when it died that time, I suddenly had NO POWER to anything in the car. Lights don't work, no horn, no radio, no beeping when key is inserted--NOTHING. if I let it sit for a day or two, it will start clicking & then interior lights will come on--until I put the key in it & turn it over. Then I am back to no power. It does not crank or anything when I turn the key over. I have had the battery checked and they said it is still good, had 100% charge--even after being off the car for over 24 hours. I have been wondering if it is the ignition switch or starter...
View 19 Replies
(code p.o.302) number 2 cylinder misfiring. 1997 nissian pickup 2.4 liter automatic. when I take truck out on highway check engine light come on with code p.0.302.when I get back to town. and cut truck off for maybe 20 minute. check engine light go off automatic I do not have to use a scan tool to erase. As long as I am in town light. say off. when I get back on highway check engine light come back on. have had 3 mechanic look at this they can't get it to misfire. they tell me the fuel and spark are doing what they support to do..do you think maybe computer bad. has 255,000 miles
View 5 Replies
I have a 4 cylinder, 2002 Nissan Altima with about 170,000 miles on it. About 2 months ago, the car starting misfiring while driving and the engine light came on. I went to autozone, used their diagnostic tool and it said I needed to replace the fourth cylinder's ignition coil. I ended up just replacing the spark plugs at that point. After replacing the spark plugs, the misfiring seemed to stop, but the check engine light was still on although the car ran great in comparison.
Then, about 2 weeks ago, the car started smelling like gas and slightly misfiring again. I bought set of ignition coils and changed them out. I started it up, the car seemed to work great. I went to the store about an hour later and the car worked better all the way there with no problems. Then, as I was about to leave the store, I started the car up and it started sputtering and misfiring and you could visibly see the engine shaking like crazy when I popped the hood. It stopped shaking, evened itself out, after about a minute. Then, I felt the top each of the coils and the first three were fine, but the fourth had a rapid tapping coming from it that was obviously not right.
I gave it a couple of days, but the car didn't stop smelling like gas or misfiring when starting up, so I pulled out the ignition coils and the spark plugs. The fourth spark plug was brown and burnt from the bottom to the halfway point, unlike the other still-clean spark plugs. My first hopeful thought was, maybe it wasn't tight enough and that was letting gas or oil inside to burn. I tightened it up, put everything back and it seemed to be alright, even the tapping from the coil stopped.
However, within the last couple days, the car has been smelling like gas and feels like it sputters and misfires once I start it up. The misfiring seems to stop after I rev the engine a little bit, but sometimes when I'm idling, you can still smell the gas and sometimes audibly hear a sputtering.
So my question is: what the hell could be wrong? Faulty wires, a stuck valve, bad compression, what? Remember, the fourth cylinder's spark plug was only burnt on the bottom half if that's useful.
View 19 Replies
My AC blows cold for a little while, then it blows warm. If I wait and turn it back on the cycle repeats it self. I had the freon filled. Not sure what to do? 1997 nissan pickup....
View 3 Replies
97 Nissan Pick Up, 5 speed manual, 192k. The specified oil is 75w90. When it was new, I drained to factory fill out and refilled it with Mobil one 75w90 synthetic and a bottle of Slick 50 for Manual Transmissions (I do not use Slick 50 in the motor). This has worked very well for me in past transmissions. Anyway, at around 160k, I would hear an occasional whine when at a steady 55 mph on level ground. If the road grade changed or I changed speed, it would go away.
At the 180k oil change, I decided to check the the transmission oil level. It was bone dry. The capacity is 2.1 qts and it took 2.1 qts to fill it. I filled it with Mobil One 75w90 again. I have checked it at each oil change and so far, it hasn't lost any oil since I filled it. I still have the whine at 55 mph on level ground and it still goes away with any pitch or speed change.
Now my question, would there be any benefit to switching to a synthetic 75w140 or a conventional 85w140? I'm thinking that the 75w140 wouldn't change anything but the 85w140 might.
View 16 Replies
1997 King Cab XE Pickup... Over the last couple of years, a noise comes from the dash of my pickup at speeds above about 30MPH, especially during acceleration. It is especially bad when I drop from 5th to 4th gear to pass someone (worse on a hill, extra load) but quiets some when going back to 5th gear (never completely goes away). What is making this noise??
View 6 Replies
1997 Nissan pickup 2.4 liter auto.gas gauge drop to all most empty when driving.then i can hit a bump in the road and it will go back to normal.
View 2 Replies
Trucks throwing codes for cylinder 3 and 8 misfire. I pulled the plugs and both were covered in oil and cylinder 8s electrode was literally gone. so I replaced the plugs and within 5 miles it was missing again. so I replaced all plugs, all wires and coil packs. cylinder 8 plug had fouled out. Its a 4.6l 99. I have a mild exhaust leak where the manifold connects to the downpipe. but not bad enough I feel it should matter. it runs rough until about 3k rpm and then it kinda straightens out.
View 14 Replies
Ok I got this truck from my mother-in-law for free with a blown head gasket cylinder 6 driver side. I did the replacement had the heads machined put it all back together by the book. Now I can't get it to fire on all 6 cylinders only 5 I think. Thought maybe bad gas (it sat since late November) put 5 gallons (over double the gas) fresh gas and half a bottle of b-12 chem tool. Dubble checked all plugs wires connections (coils plugs wires all new). I drove for about 10 miles oil pressure and temperature stayed perfect but no change in running truck shakes a lot and no real power. Don't sputter or backfire no engine codes other than imcr bank 2 open. Engine is 4.2l v-6 170k miles.
View 2 Replies
I have a misfire on the number 2 cylinder on my 97 Nissan Maxima 5spd. The computer has been changed 3 times, and it'll work for a short time after the new computer is installed, but then the problem resumes. What would cause this to happen? The coil has also been changed.
View 7 Replies
I have a 95 nissan pickup V6 hardbody and speedometer goes in and out when it is out i just pound on dash and it will work. I took it apart and put white gauges on it and cleaned the connectors with electric spray. Put back together and it's still doing the same thing. But now when I hit dash it dosent work. Check engine light does come on if it don't work. But it did before till I pounded the dash then it went out.
View 1 Replies
Coolant temperature gauge bounce up and down.
View 6 Replies
We have a Nissan Pickup that anytime (in every gear) that the truck reaches 2700 rpm it begins to jerk-feels like you're trying to start it in 3rd gear instead of first. We have had it in a shop with someone who just repairs Nissan's and have been unable to find the problem for over a year. Have looked at the catalytic converter, fuel pump, and air flow meter...nothing has worked...
View 2 Replies
I have a 95 nissan pickup V6. The speedometer stopped working today and engine light came on. truck sat there while I was working and went back out to it. Started truck back up and engine light was still on. As soon as I put it into gear the engine light went off and speedometer started working again. What it could be. It's a 2wd not 4wd
View 7 Replies
I have an 86 Nissan pickup with a z24 motor in it, yes the weird 4 cyl. With 8 plugs. It has been lurching when I let off the throttle or sometimes when I accelerate. Its been doing it for a year and won't do it all the time it is intermittent but does it more then it doesn't.
View 2 Replies
I have a 91 Nissan pick up that is just making a clicking noise upon trying to start it. I replaced the battery. The inside light works, radio works, dash clock works, but still just clicking upon trying to start. Is there a clutch safety switch that could cause this, or starter, or ???
View 8 Replies
1995 pickup truck 2.4 liter 4 cal 4WD. I have a new problem- I drove out to a favorite spot in the mountains (up a dusty road) and when I got to the end of the road my truck was suddenly idling REALLY rough. I was able to drive it home and it runs "OK" as long as you stay on the gas (I say OK but it does want to die and especially wants to die after it warms up and then harder to restart until it cools)- as soon as you let off the gas the idle is on the extreme side of rough. It did not act like a fuel filter has historically (hesitate when giving gas), but I had a filter so I replaced the fuel filter anyway.
I also pulled the air duct work and cleaned it all out, put a new air filter in and used CRC MAF sensor cleaner on the MAF sensor. I did pour in a Chevron fuel system cleaner but it would likely take a tank full at least to work and it does not run good enough to run a tank full through. I put in all new plugs (gapped) and checked resistance on the plug wires and cap- all seems to be acceptable. I checked all the vacuum lines and did replace a couple that were dry and crumbly. I am now at a loss,
View 7 Replies
I work for for a non-profic organization. We have a 95 nissan 2.4L pickup, and one of the guys drove a fair distance while overheating because of a coolant leak. He did not quite make if back before the truck died. At first I offered to do the work on it thinking maybe it just needed a new head gasket and some machining on the head surface. But I did a compression test and 2 cylinders were around 30 and the other 2 around 40psi. Also there is coolant in the oil.
Given that the pressure is so low do you think there is much of a chance that the head is not completely warped and needs to be replaced. Is it unlikely that there would be damage to the bottom of the engine, cylinder walls, pistons or warped block? I know one cannot say for sure until the head is removed but I would like to avoid wasting the time because if the truck needs a new head or worse they are gonna just junk it.
View 6 Replies
