Nissan - Maxima :: Replace Catalytic Converter / MAF Sensor
Jan 16, 2015
I've been having issues with my car, i took it to Orielly's & they ran diagnostics, one of the codes said a recommended fix was replace the MAF sensor. Today I took it by an auto shop for them to look at, and the guy said it was my catalytic converter, and I mentioned the MAF sensor, he said fixing the CC would take care of the MAF sensor malfunction. So I have a couple questions...
1. Is what he said correct?
2. If you have a bad CC, does it ever NOT smell bad?
Bc I've never smelled anything other than stinky exhaust, never any rotten egg smell.
It's a 98 Nissan Maxima, 6 cyl. it has 265K miles.
View 19 Replies
Advertisement
My 2000 Nissan Maxima has a PO430 code for the catalytic converter that has been going on and off for over 1 year now. My ? is, how would I know that the converter needs replacing? Someone said there wouldn't be any smell necessarily, someone else said I would be leaking qts. of oil in between changes and someone else said it would get bad mileage. Each one debunks the others comments etc. Also just for info., this car had the ses light come on at 57K miles, my brother replaced 2 of the O2 sensors and I replaced 2 also, one duplicate one and a mass air flow as well.
View 1 Replies
The check engine light came on so I took my car in. My mechanic whom I've used for years told me the following: the catalytic converted had started to come off, in the process it pushed the oxygen sensor up against the body of the car and shorted it out. The total damage is that the O2 sensor and the cat has to be replaced. The line-item estimate was $104 for a sensor and $650 for a cat, plus labor. Total: $1000. Now, I'm looking online and seeing cats that work on my car for far less ($200-400 depending). I talked to another mechanic on the phone who verified cats don't have to be $650. My mechanic said they only use top quality parts with warranty, etc. But the other mechanic said that for a car that he wants to get moving again, a cat is a cat and any new part will, of course, come with a warranty. So... what should I do? Is $1000 too much? If I go with the mechanic who says he can get me down to $700, will that be cheap work on my car? It has 108K miles, and I'd like to get at least another few years out of it.
View 19 Replies
ill be replacing my muffler here soon, its rusted out blows smoke out all the rust holes, and so on. gonna replace with a nice flo master. Question is, when is it time to replace the catalytic converter? 15 years old and 93000 miles, it still seems like its in good shape, but could it be getting clogged? just from the sounds of the exhaust the past few months, it almost sounds like the truck is somewhat congested. The power from the engine is kinda week, but that's the engine itself. I have no real problems getting up to speed. my hesitation issues from before turned out to be water in the gas tank. Figured since im down there does it make sense just to bite the bullet and throw a new catalytic converter on?
View 8 Replies
My 2000 Forester has 96,000 miles on it. A few months ago, the CEL came on. At first it would turn off every couple of days but would eventually pop back on. I first thought it was tied to putting gas in the car, now I think it was just a coincidence.
Over the past two months, I have replaced the catalytic converter with a aftermarket piece (done by a mom and pop muffler shop) and replaced the front o2 sensor three times. The first two times, I used Bosch sensors from an auto parts store and had the code cleared. After about 50 miles the CEL came back on. Just yesterday, I picked my car up from the dealership where they installed a Subaru fron o2. After about 30 miles, the light is back on again. Code is P0133 - heated oxygen sensor, bank 1 sensor 1, circuit slow response.
Now, the dealership is suggesting I need to replace the catalytic converter with a Subaru converter before they can source the issue.
View 19 Replies
My wife's car has the check engine light on and she was told by her mechanic that it was the catalytic converter going out, to ignore it. I am thinking that I ought to be able to build a jumper for the sensor and fool it into thinking that it is working, reset the check engine light and wait till it starts to fall apart before replacing it. I'm tired of driving with the check engine light on, maybe missing something else that needs attention rather than the cat. it has 140k on this car but is in great condition. I am a diesel mechanic, no real experience with gas vehicles in a long time. oh, and we just got married. Or maybe I just ought to stay late at work and get this thing up on the rack and look into it. Put the scope on it myself??
View 19 Replies
I live in CA and recently my car passed the smog test, but failed inspection because the check engine light on the board was on. When the diagnostic test was done, it said there's a problem with the catalytic converter. It's so frustrating because the car's emissions are within limits. , I was thinking... Is there a way to get the catalytic converter to run cleaner without replacing it? If it can run long enough to pass the diagnostic test, my car could pass inspection.
View 3 Replies
Where do I start. I have a 2001 Nissan Sentra. 128,000 miles. In Aug. of last year, the engine detonated, so I had it replaced along with other parts. Shortly after that, I noticed a burning plastic smell coming from the car after driving it for a while. I confirmed that that the smell wasn't coming from a plastic bag. Fast forward to Dec 2011, my check engine light comes on. I go to Autozone, have the code read; it's the dreaded 420 code. I go to have it checked out, was told my cat went bad and probably because of the old engine and that the smell is probably coming from that.
The check engine light went off on Christmas day. Fast forward to last month, the light comes on again and I pony up the cash to have the cat replaced since inspection is coming up in June. Now, I had an engine diagnostic run right before I got the cat replaced and it came up fine. The cat was replaced on 4/20. Everything seemed fine. The burning plastic smell went a way, but lo and behold, it came back this week. I don't know what to do. I did a little search on the net and it seems that burning plastic smell indicates there is something going on with engine and possible misfire.
View 2 Replies
2001 sub forrester. In 2009 it was intermittently stuttering: tuneup, new coil, finally O2 sensor (both) replaced which fixed it. In Oct started to do the same thing. First the back then the front sensor replaced but they commented the flow was low on the catalytic converter but wouldn't say it could be the cause of the sensor issue. Now the O2 sensors are on either end of the converter and the car is starting with early signs already. Is is reasonable that it is the catalytic converter? I am wrestling with just having them do the full tuneup and replace the converter or am I crazy?
View 7 Replies
I wanted to get some input about lowering my 2010 Corolla LE. I wanted to go about 3 inches, but have been told i will need to replace some extra parts. Not sure where to begin, but i'm not afraid to ask questions or get dirty. I hear a lot of different things and i'm on over load with info.
View 7 Replies
I have a 2006 Jeep Liberty with 135,000 miles. My check engine light is mostly on. Sometimes it is off. One mechanic tested the car and said the catalytic converter is bad. Another mechanic said that test can often be false positive and it might only be the O2 sensor. The difference between the two is about $1,000. Which mechanic is correct? My car is registered in a state that doesn't do car inspections.
View 19 Replies
I just failed inspection because check engine light is on. The codes state that catalytic converter and O2 sensor are "not ready". I understand it has to do with the computer but not much else. Someone on Mazda 6 message board provided a complicated sequence of driving instructions including maintaining various speeds and RPMs for specific lengths of time which they said would reset the computer. My mechanic is at a loss. This car is a lemon and I would just like to get the inspection done so I can trade it in and get something that doesn't keep breaking.
View 6 Replies
The car wouldn't start ( just cranked a lot) I had the car towed to a local mechanic. He replaced the MAP sensor and now I've noticed 2 new problems.
1) engine idle rpms are erratic. When the car is started RPMs are at 1,500 after a few minutes they drop to normal range of 700 to 900 RPMs sometimes they drop too low and the car stalls. sometimes the RPMs surge up and down from 800 to 1,200 rpms.
2) very hard shift from 1st to 2nd gear. All the other shifts are normal. He said that he adjusted the RPMs because they were too high. I don't know how he did that because I thought that you couldn't adjust them because they are controlled by the computer.
Some other info, it has an exhaust leak (which Im going to fix) upstream of the O2 sensor, where the resonator connects to the headers. I replaced a rear brake line and while bleeding the lines I got brake fluid on the ABS wheel speed sensors. I replaced the coolant bypass hose and got water all over part of the engine compartment. It was immediately after I replaced that hose that the car wouldn't start.
Could the exhaust leak be the cause of the erratic idle rpms? Could water have gotten in a wire connector or shorted something out when I replaced the bypass hose? The bypass hose is directly above the transmission. My biggest concern is the hard shifting from 1st to 2nd gear.
View 15 Replies
I recently had my catalytic converter replaced with a non-OEM cat. The check engine light came on and a different shop (different from the shop that replaced the cat) said that it will keep coming on because I had the cat replaced with a non-OEM cat.
View 3 Replies
I have a 2001 VT GTI with 155K miles on it. It is in very good condition. I have loved the car except for the high maintenance costs that typically seem to be associated with VWs.
I found out this week after my check engine light came on that the car needs a new catalytic converter and a new new secondary air pump.
Let's assume that this diagnosis is correct and the repair is accurate for the sake of this posting (and I have no doubt it is). In other words, I don't want to get my question derailed on that issue.
The car has new Michelin tires on it and runs well. The problem is that it will fail the state emissions test I am required to take next December, and I will either be forced to have the car repaired or will not be able to get updated license tabs (isn't that sweet?!).
It seems that I have a few options:
1. Get the repair done (ouch) and keep driving the car for a few more years. Repair cost is about what the market value of the car is (from what I have seen).
2. Sell the car "as-is" between now and December and see what cash I can get out of it. Any buyer will discount the value of the vehicle based on the repairs needed. Of course, then I'll need a replacement vehicle of some sort.
View 16 Replies
See related guides and technical advice from our community experts:
How to Replace a Catalytic Converter
Step by step instructions for do-it-yourself repairs
Browse all: Air Intake and Exhaust Guides
View 9 Replies
I have a 2000 Lincoln Town Car with a single exhaust system, part of/attached to the frontal area of the exhaust "Y" pipe are two lumps with heat shields, the muffler is obvious in the mid-section of the car, but are those "lumps" the catalytic converters, and if so, why two when the older cars had only one?
View 2 Replies
Someone put sugar in my gas tank so I had it worked on at the Dodge place they replaced my fuel pump..fuel filter cleaned the tank..flushed the lines cleaned my injectors and replaced the plugs..I went to pick it up I barely made it a mile down the road I had no power and a lady flagged me down to tell me to pull over because I had sparks coming from the bottom of my van I looked under the van and the catalytic converter was red like hit coals the Dodge place is telling me its my flex plate? I think they are misdiagnosing the issue because before the sugar issue I had no problems with my van?
View 14 Replies
I have a 2002 Toyota Prius that is currently in limp mode...
Took it to the dealer for diagnostics and they said the Catalytic Converter has failed...So I went online, bought a new one and replaced it. The symptoms prior the Cat replacement were still there...mpg loss, power loss, and exhaust air was not exiting the end of the pipe but actually leaking out the connection point where the Cat and the manifold met.
View 7 Replies
So this morning (Kind of Cold) I went out site and started my car. I heard some noise under the car and I noticed that the noise bad been coming from the Catalytic Converter area and there was water dripping off of it.
My guess is that it was just warming up and the water was from the cold. Is it normal?
I have a GLX V6 ...
View 2 Replies
I own a 2004 Acura RSX that I purchased new nearly 10 years ago. The car currently has 182,000 miles on it. Two years ago (approx. 130,000 miles), I had to replace the catalytic converter and both O2 sensors. This lightened my wallet to the tune of $1,200 (aftermarket franchise, OEM replacement). A few weeks ago, the "check engine" light came on. I used my scanner, and got the dreaded P0420 code, and had it verified by another shop. O2 sensors were OK. What REALLY shocked me was that replacement catalytic converters are only warranted for 5 years/25,000 miles (50k in CA). The first replacement piece lasted 52,000 miles (less than half the miles/years of the original part)
Here are THE QUESTIONS: What killed this catalytic converter? What can I do to prolong the life of this part? My car has the base powertrain that (according to the owner's manual) recommends 87 octane fuel. That's all I've ever used. The mechanic suggested moving up to mid-grade fuel, though he admitted that he wasn't sure.
View 19 Replies
