I have a 2003 Nissan maxima and at first it used to shake at around 50mph, took it to the shop they looked into the suspension, did wheel balance, changed 2 front tires and wheel alignment and they said it should be fixed. A week later, it started shacking at around 70 mph, what else should I do to get ride of this problem?
View 1 RepliesIt is a '90 Nissan Maxima. I just replaced my drivers side axle (cv joint was clicking), and now my car vibrates at highway speeds when turning right. I am pretty sure I seated the axle correctly....could it be a bad axle? I heard that turning the axle 90 degrees and reinstalling may work? I got a new axle (Empi brand).
View 2 RepliesI own a 2003 Nissan Maxima SE with a 6-speed manual transmission. The car has just under 113,000 miles on it. I've religiously maintained the vehicle per the owner's manual and overall it is in excellent condition. In particular, we change the oil on a regular basis per the maintenance schedule. However, on several occasions we have started to hear rattling coming from the engine. The rattling occurs at all engine speeds and in all gears and it doesn't matter whether the car has just been started or if the engine has been running for a while.
When the rattling has gotten more prominent, we've taken the car to the dealership and also to our local oil change place and on both of those occasions, they've told us that the engine oil was VERY low. Also on both of those occasions, we were well within the recommended range in between oil changes (<3000-3500 miles). We have not noticed leaking oil in our driveway or in our garage. I am wondering about the potential reasons why we could be losing oil, and if we aren't seeing any in our driveway where it's going? I've mentioned this to friends and they've said it's 'burning oil' - but we're not noticing any strange smells or smoke. The car is ~10 years old but it's fun to drive and in great condition.
My GX470 steering wheel shakes/vibrates when I hit speeds over 50mph. What is causing it?
View 12 RepliesI am having an issue with the car not feeling stable on the highway or at speeds over 50mph when I am on a curve and go over a roadwork patch. The cabin of the car seems to float way too much to the side, almost like hydroplaining although the wheels stay put on the road.
After describing this to a mechanic, he said it sounds like my lower control arm bushings are gone. He looked at them and confirmed it, the rubber bushings that control the side to side action are cracked and worn out. He said that he is unable to just replace the bushing and has to special order the whole arm from the dealer (approx 200$ each arm).
I went to get a second opinion and another mechanic basically told me the same thing except the price on the part went down to 175 per arm with 2-3 hours labor.
Had upper and lower ball joints replaced a few hundred miles ago and the truck had run just fine. Just replaced the the front bearings, axle seals, left axle shaft (Spicer brand) and right U-joint. Now at highway speeds if I hit just the right bump the front of the truck will start to shake and within a few seconds the shaking is violent, almost have to come to a complete stop for shaking to stop. What is causing this?
View 1 RepliesI just bought the car a less then a month highway speeds car shakes at 120km/h. I just complained to Toyota dealer ship and they put on brand new front rotors and did alignment at highway speeds the car still is shaking and it pulls to the left can it just be tires alone or back rotors because they didn't replace those.
View 6 RepliesNoticed the seat shaking when at highway speeds or when you go over bumps in the road? When my seats are empty, they shake and make an annoying rattle, shakey noise. I had them looked at by Hyundai and was told that there was nothing that Hyundai was going to do to fix them. After battling that for a while, Hyundai did reimburse me a car payment for me to "live with it" and, quite frankly, to shut me up.
View 5 RepliesI have a 2010 F150 XLT crew cab, and I'm the second owner. Ever since I have owned the truck, it has had a pretty bad shake/vibration at highway speeds, that gets worse with higher speed. I have checked the alignment multiple times, rotated tires, had them re-balanced, and I still cannot figure out what is causing this. What else should I be checking?
View 14 RepliesOur Pathfinder shakes side to side around 60mph and quits after 65 or 70 (We live in New Mexico and commute through Texas where speeds are much higher than back East). We have changed shocks, struts & mounts, tires, and alignments. Most of these have been changed multiple times over the years, especially tires.
We have been driving this way since May of 2005 (129,916 miles). We have TRIED to get it fixed. We have had it in shops all across the country (we travel a bit). We talk it up to people we meet who know cars. We have taken it to Nissan, with no results. NO ONE has solved the problem and we are out lots of money.
We are now at 205,000 miles. I would really like to get this fixed! We cannot afford to just buy a new car. Mechanics across the country have not solved this issue!
The ac compressor on my 2003 Maxima keeps going out. Mechanic says the replacements are refurbrished, as the new ones are hard to find and expensive. 143,000 on the car.
View 1 Replies I drive a 2004 chevy Tahoe and have had this problem for about 8 months. It started out very faint and occasional, but has now escalated to loud and consistent. So it ONLY happens when turning right. I've tried to replicate it when turning left and had no success. It happens when I am turning fairly hard at a decent speed. ex. Pulling into my driveway. I've already checked the wheel bearings and Ball joints.
Another thing is that the ABS light is on sometimes when i start the car and comes on every time i turn the steering wheel all the way to the right. It also has a problem where it will shake almost uncontrollably when driving at 65+MPH after hitting a bump or sometimes just randomly on a smooth surface. We just got new tires and balanced them. It did the same with the previous set we had. I know I'm asking for a lot, but where to start?
Two years ago a purchased a 2011 Nissan Frontier mid-sized pick-up, V-6, A/T, 4WD, long-bed (6’), crew cab four door. I drove it for a little over a year and it was all good, then I put an 800 lb. pop-up cab-over camper on it. When folded down, the top of the camper is about one foot above the top of the truck cab, with about a four inch space between the bottom of the cab-over and the top of the cab, and with the cab-over extending over the back two-thirds of the cab, so the whole thing creates quite a bit of wind resistance.
After installing the camper, I noticed a front-to-back jerking motion when driving the truck at highway speeds, sort of like when topping a steep hill and beginning to descend, some vehicles will lurch front-to-back until the drive train synchs up. It was cyclic – jerk 7 or 8 times, smooth out, then do it again. It wasn’t bad enough to cause vehicle control issues. I took it to the dealer and the initial diagnosis was that the automatic trans. was going in and out of lock-up. Then I drove the service manager around in it with his laptop scope plugged in to the engine, and he said he couldn’t see anything wrong with the drive train. He suggested running the rear tires at maximum pressure of 44 lbs., which I tried but which didn’t work.
I then had airbags installed to beef up the rear suspension, but that didn’t work. Finally I built a fairing/wind deflector and installed it on top of the cab, sloping at a 45 degree angle from the trailing edge of the windshield to the leading edge of the top of the camper. That didn’t work either, which surprised me because I had first experimented with the concept by duct-taping a sheet of cardboard in the same position as the fairing would ultimately be installed, and that seemed to work. The same jerking sensation can be felt when overdrive is engaged and when it is locked out, and it also occurs at slower speeds when decelerating. Is there anything I can do to smooth out the ride?
I have a 2003 Nissan xterra se with 93,0000 mi. When i reach speeds greater than 60 mph it makes this rapid somewhat clicking noise. the dealer suggest to replace the belts. Of course that did not resolved the issue. then they claimed it was coming from the exhaust so they tinkered with it. it was gone for awhile but now it has return.
View 2 RepliesOkay so I have a 2003 Nissan Maxima 150k and the problem that I'm experiencing is that when the vehicle is in drive my foot on the brake for example at a red light and I have the AC on the engine will begin to stumble similar to a misfire however no check engine light will be displayed if I were to turn the AC off and sit at a red light in here with my foot on the brake the car idles fine and smooth the car currentl drives fine accelerates fine idles fine it's only when I'm stopped with my foot on the brake and the car and in drive with the AC on that the engine stumbles accelerating or cruising any speed above idle with a/c the runs smooth its only at idle and the simple is not predictable it happens often but at random intervals
What I've done so far 1.5 years ago I put in iridium spark plugs Recently cleaned the throttle body its a electronic throttle body Fuel pump and filter were replace in March 2016I tested the alternator put a load on it to see if the engine would stumble but it didn't
My a/C blows cold air and everything in the car works.
Okay so I recently replace the rear shock absorbers and now every time I take a corner or when I'm going on a surface that's not flat or just if I go over a bump too quick. I here squeaking sounds I replace the shock absorber as well as the strut mount to no avail I've found the noise I've located location of the squeak if where coil meets the mount. I don't want to replace the coil it does look like it might need some replacing the protective metal sheet is gone on the top some of the bare metal is exposed but I would hate to replace the spring and have noise again
Car is a 2003 nissan maxima with 144k ....
I recently bought a 2003 nissan maxima 134k and i bought it with the p0300 check engine light on a looked at the engine and though it was an air box problem because they had previously installed a K&n filter so I went to the junk yard and got a 2000 nissan maxima air box and new filter i changed the oil and checked the spark plugs they look new and the dates on the coils are 2012 and 2013 and still its misfiring. i bought it to a mechanic and he discovered a vacuum tank had previously broke and they glued back together so i replace that with a factory one today same problem still misfiring but it got better but now its a p0306 then i erased the code and p0304 came back i erased it then p0302 came back then i change the cam sensors, and the crankshaft sensor and now it get a p0300.
Symptoms:
*when sitting for a long time HARD TO START ( takes multiple cranks to start it ) but once i leave it off for short time like 30 min it starts right up no problem
* when stop at a stop light in drive i can feel small little explosions sounds like my car is beat boxing
*performance is strong good acceleration no problem on that i just don't want it misfiring
I just recently replaced all 4 struts on a 2003 Nissan maxima with 144k and the front are fine its just the back drivers side it makes a clunk every time I hit a big pot hole or a medium sized bump the shocks are doing there job the car feels great its just I have excessive noise the top strut mount nuts were torqued in place and so was the bottom. When I put my hands on the rear driver side quarter panel and start bouncing the car it makes no sounds its only when I start driving. The strut came with the bump stop the only thing I reused was the spring and mount and bushings in between but I took pics of the strut before I compressed it and took it a apart everything is where it supposed to be I'm puzzled...
View 1 Repliesmy 1990 Nissan 300zx with 136,000 miles often surges at highway speeds for several seconds then drops back down to normal. the surge is usually 1000 rpm. does not happen if not in overdrive, and will not happen unless having been driving for 15 minutes or so. also seems to occur more on hot days (80 degree +) than on cool days. mechanic has looked at this several times but not yet able to determine why.
View 2 RepliesI bought a 2003 nissan maxima with 135k and it had a p0300 it had a performance k&n filter on it so i though someone might have installed it wrong or what ever so i bought the car cheap. i have replace the k&n filter with a stock 2000 nissan maxima air box with new filter i got from the junkyard it worked for the misfire calm down a little then i bought the car to a mechanic and he said because of my hard starting it could be a cam senor or crank senors so I've replaced that still no luck then he pulled out the spark plugs and they were sooty black but when i bought the car i checked and they were brand new so i swap them out with ngk platinum spark plugs then work a little but still same problem. i had a p0302,p0304,p0306 when i clear the p0300 but usually its all ways a p0300, its been a month and I am still driving like this.
SYMPTOMS:
Hard starting after 20 mins of sitting
I can smell gas from the driver seat when i start the car and open the window
Exhaust air isn't smooth but in pops
Getting like 14-15 mpg in city
When stopped at a stop light i can feel the car misfiring
WHAT I HAVE REPLACED:
Front bay 3 ngk spark plugs cylinders 2,4,6
Cylinder 4 coil
Air box
Cam sensor and crankshaft senor
Coolant temperature sensor
Battery
[URL] ....
While accelerating onto the highway we get a slight vibration at just about 50mph, minor but noticeable. Something to worry about? Also, there is a water leak in the right rear tail light.
View 13 Replies