My 1999 Nissan Altima. Has a check engine light code P 1447. Car stalled needed a jump to get started. Left it by the mechanic running and stalled again what could it be?
View 1 RepliesI have a Nissan Altima 2000 with about 98,000 miles. The "check engine" light has been on. This happened once before and eventually the light went off, but now it is on again. I read the manual and it said that the gas cap isn't on tight enough. Checked that and it is fine - but the light never went off. Should I bring it in to a mechanic?
View 5 Replieslast fall, the check engine light came on- Autozone states the knock sensor is bad. At the same time, odometer/cruise would work off and on. Now as months have gone by, the odometer RARELY works. Could all the electrical issues be connected? Is odometer controlled by Speed Sensor on the transmission or somewhere else?
View 2 RepliesMy wife has a problem with the check engine light coming on and staying on. The dealer has replaced the fuel pump twice (which they say is the problem) but it keeps happening.
View 4 Replies(This is a continuation of a previous thread: [URL] ..... )
I have a 2005 Nissan Sentra with 75,000 miles on it. Several months ago (see above link) the check engine light came on with a P0304 cylinder 4 misfire code. The only symptom appears to be a rough idle/shaking every 3rd or 4th start for the first 10-15 seconds, but runs smoothly afterwards. My mechanic replaced all my spark plugs (I had new plugs put it at 50,000 miles for the same issue) of which the one from cylinder 4 was worn down much more than the rest. The problem persisted so they replaced my fuel pump and fuel filter and switched the spark coils from cylinder 4 to a different cylinder, but the code still read cylinder 4 so it wasn't the coil. That was back in October.
I took my car back in last week for the same problem and without starting my car (because the problem is worst on the first start) they pushed my car into the bay and did a smoke test, no leaks in the fuel lines. Then they checked the cylinder and said that there was "excess" fuel in the cylinder and replaced the fuel injector. Then after ~3 days the check engine came back on with the same P0304 misfire code. Previous repairs/diagnostics rule out spark plugs, coils, fuel pressure, and injectors.
I have a 2005 Nissan Altima with a SERVICE ENGINE light that refuses to stay off. Initially, upon hooking the car up to my mechanics computer, the code indicated a faulty crankcase sensor. I purchased the sensor and it was installed. I was then told to drive 30 or 40 miles at various speeds, stop and go traffic without shutting off the engine to reset the computer. This was done twice without success. The light remains on . The inspection was due in December and this is becoming very frustrating not to mention illegal to drive these 40 mile circuits. I have even disconnected the battery, reconnected (light off!), and drove ANOTHER 40 miles. The light stayed off while driving but came back on after restarting. 3 times , 2 different mechanics reset the cars computer with theirs. 4 different computers still diagnose a faulty crankcase sensor. The sensor has been replaced twice. Everyone is stumped and I really don't want to take the car to a dealer.
View 18 RepliesI have a 4 cylinder, 2002 Nissan Altima with about 170,000 miles on it. About 2 months ago, the car starting misfiring while driving and the engine light came on. I went to autozone, used their diagnostic tool and it said I needed to replace the fourth cylinder's ignition coil. I ended up just replacing the spark plugs at that point. After replacing the spark plugs, the misfiring seemed to stop, but the check engine light was still on although the car ran great in comparison.
Then, about 2 weeks ago, the car started smelling like gas and slightly misfiring again. I bought set of ignition coils and changed them out. I started it up, the car seemed to work great. I went to the store about an hour later and the car worked better all the way there with no problems. Then, as I was about to leave the store, I started the car up and it started sputtering and misfiring and you could visibly see the engine shaking like crazy when I popped the hood. It stopped shaking, evened itself out, after about a minute. Then, I felt the top each of the coils and the first three were fine, but the fourth had a rapid tapping coming from it that was obviously not right.
I gave it a couple of days, but the car didn't stop smelling like gas or misfiring when starting up, so I pulled out the ignition coils and the spark plugs. The fourth spark plug was brown and burnt from the bottom to the halfway point, unlike the other still-clean spark plugs. My first hopeful thought was, maybe it wasn't tight enough and that was letting gas or oil inside to burn. I tightened it up, put everything back and it seemed to be alright, even the tapping from the coil stopped.
However, within the last couple days, the car has been smelling like gas and feels like it sputters and misfires once I start it up. The misfiring seems to stop after I rev the engine a little bit, but sometimes when I'm idling, you can still smell the gas and sometimes audibly hear a sputtering.
So my question is: what the hell could be wrong? Faulty wires, a stuck valve, bad compression, what? Remember, the fourth cylinder's spark plug was only burnt on the bottom half if that's useful.
This code keeps coming up on my OBD reader, hat to look for to repair this code. I read on this other forum that it could be vacuum leaks etc.,
View 7 RepliesMy 2003 Altima (generally trouble-free!) recently lost power ... it would just putter along at 5mph. I parked, and the engine revved up fine. Waited a bit, put in drive and and same issue. I punched the accelerator, it sort of backfired and then ran OK. Next day, I called the local auto center who thought it could be catalytic converter blockage. They ran test for error codes and one stated check engine light was out of order and that instrument cluster should be replaced. They admitted it was bizarre, so I declined the repair and have driven just a handful of miles in the few days since. Today, power lost again, same 5 mph-only issue. I park, turn off engine and wait a bit. Then it wouldn't turn over... some blinking lights in the instrument cluster. So... it's been towed and tomorrow the same auto center will investigate.
View 12 RepliesMy wife's 2003 Altima has been stalling. The MIL came on P0335 Crankshaft Position Sensor Circuit. I did a little research and it seems that it is pretty common for that sensor to go bad, so I bought a new one. The problem is I can't get the wires off the old one. It is in such a ridiculous place. There is no line of sight anywhere. It has to be done completely by feel. Supposedly, I should be able to push the button until it clicks and then remove the connector. When I push the button, it definitely clicks - but it doesn't stay clicked. It clicks right back out before I can pull on the connector. How can I keep that button clicked in when I can't see anything and I can just barely get one hand down in there?
View 19 RepliesI recently purchased a 1999 vw passat gls 1.8t. Initially the guy I bought it off of told me that when he was rebuilding the turbo he stripped the main shaft bolt, so it needed a new turbo. So I bought a k-04 off of ebay and installed it. The battery was dead so I replaced the battery as well. When I first tried to start the car it would start for a second kind of chugging and then die. I went to my local auto parts store and rented a scan tool and it gave me 2 codes. The first code was P1545 and the other was P1818. As far as how many miles the engine has on it I don't know for sure as the engine has been replaced and apparently no one knows how many miles it actually has.
View 2 RepliesI have a 99 Ford Explorer - w/217k miles. (2nd owner) .. I got an oil change 3 weeks ago, tune up 2 mos ago, and new brakes/tires within the last 6 mos, oh, and Brother-In-Law just recharged my a/c last week.
Runs well, and I hope to keep it for another few years, but having problem lately.
Check Engine light keeps coming on - I've taken it in, and they read the code, and it comes up with a misfire. Mechanic resets it, and it will stay off for a few days/weeks, and then comes back on.
What this code means. What can I do to fix this problem.
1999 ford ranger xlt ext cab...
2003 Nissan Altima 2.5 SL automatic - starts fine when the engine is cold but won't when the engine is hot. It acts flooded. I've changed the camshaft and crankshaft sensors, spark plugs, one spark plug coil, radiator, valve cover and the coolant temperature sensor. The car will turn over but will not start - sometimes it will after 5-10 minutes of trying.
View 1 Replies99 Ford Ranger 4-cyl. Check engine light is on; pulled fault code: "catalyst efficiency below threshold, bank 1." Cat converter is new as is rest of exhaust, o2 sensors are new, and its been recently tuned up.
View 6 RepliesSo yesterday I decided to wash my truck and after taking care of that I took it for a short drive and the tranny started acting funny. Check engine light comes on and the code is P0500 . It calls for a VSS but I cant locate it. Also the fact that it did after washing the truck is making me think its a wiring issue... F250 SD 5.4 4x4 ....
View 5 RepliesIt ran out of gas with the previous owner and they say the steering is new and the hybrid battery is new and the 12 volt is new but when I got it I had to get the 12volt battery trickle charge which it charge to 80 percent and it still didn't start only goings from lock, acc, then on never say ready no sound but when I pull the IGCT relay the fans come on but it don't start what is this relay?is this car just like Toyota primis. What could be the problem of this mechanism to get it running I have the only one in my town which no one knows how to work on It.
View 4 RepliesMy 2007 Nissan Altima Hybrid has had this recurring problem since I purchased it used and I learned the original owner had the same recurring issue and other owners on the internet also. Typically when I go to start my car in the morning, after my car has sat in the garage over night, I depress the brake and the ignition button and **ALL** the warning lights come on including the EV mode ready and Service Engine light but the car has no power steering and the gas engine won't start at all. The car is drivable for about 30 seconds in EV mode then dies. When the car is at the dealer the car starts fine and they can't replicate the issue but find the following DTC's: UOO73, UO100 ECM 211, UO100 ECM 530, UO123, UO124, U0126, U0129 BRAKE 220, UO293,UO131 EPS 433, UO121 EPS 434, U1020, U1022. Nissan replaced the hybrid battery, the hybrid harness and the main car harness and now they say there is nothing more they can do to fix the problem. The problem remains. Have you had the same or a similar issue?
View 8 RepliesStarted my car the other morning to go to work (4:45 AM) with no problem and drove about one mile. Not wet weather. The engine dies, all lights that come on at start up (engine, alt, etc.) come on and I glided to the side. Tried starting it again - engine tried but did not catch. Tried a few more times and called AAA.
Towed it to a mechanic. Waited about 2 hours for them to open. They were able to drive it the rest of the day with no problem but they had the same thing happen the next morning (yesterday). Then it didn't happen to them today. One more try tomorrow and I hope they can identify it then.
2000 Nissan Altima w/150K miles, gas was less than 1/4 mark, no system lights on.
My 2003 Nissan Altima recently started giving me trouble where I will drive for at least 20 minutes, stop to run an errand, come back, and the engine won't turn over. The first time this happened my check engine light came on. I brought it into the shop and had the cam sensors replaced. I'm still having the same problem. The engine cranks and the battery checked out okay. Car has 93,000 miles on it. I can usually get it to start after 5-10 minutes by cranking and pushing the gas to the floor. Could this be a fuel issue?
View 3 RepliesI recently purchased a prev. owned Nissan Altima (2006) 113,000 miles from the Honda dealer. Two months later I took it to the Nissan dealer to have something checked and they told me the car was two & half qts. low on oil. I had only driven it to the store and back; not on the interstate. I allowed them to fix motor mount and replace seals and fill oil. I took it back 1 mo. later; everything ok. Again went back to have it checked. before driving it from PNS to S. Fl. Got the go ahead! Off I went thinking they had fixed the problem, when I noticed the rpm's were between 3 & 4 at 60 mph on interstate.
I kept the needle on 3 , to & from. Upon return, I heard a rattle under the hood, oil lt. came on. Next day, took it to Nissan dealer who said there was 1 qt. oil left in it. They examined the engine thoroughly this time. The verdict: a bad catalytic converter (neglected by prev. owner) engine sucked up micro gaskets...used a term 'combust blow out', and recommended I sell the car or get a rebuilt engine. I signed off on a dozen papers at the honda dealer; 'as is'. they showed me a carfax but I did not receive a copy.