I have a engine code for evap sensor sometimes this can be ignored but this is causing me to keep cranking my car in order to start up what should I look for I know there's solenoid and charcoal canister and gas cap which one could be keeping my car from starting the first time.
View 1 RepliesI have a 2003 Dodge Neon with 110k miles. When starting my car and putting it into gear, I have to rev the engine in order for my car to jump into gear. It also does it when I come to a light. I could be at a complete stop and the car will either jump forward or I will have to rev the engine in order for it to slip into gear. What could be the problem?
View 3 RepliesIn the process of moving to a new house our Neon SE (2.0L, SOHC) sat for about a week without being driven. When my wife goes to start it (5am Monday morning: FUN), it turns but won't actually start. I throw on the code reader and get a P0508, Idle Air Control valve sense circuit Low. At this point, I've put on a new IAC valve, note: the throttle body looked good and in working order, and spliced on a new OEM wiring harness, but the pos still won't fire up. When tracing the wires, there was no indication of them being frayed or short-circuiting. The next step, following this code P0508, would be to change out the PCM. From my research, if the PCM is truly bad, there's usually one or several codes indicating as much; i.e. I'd be getting a lot more than just a P0508.
Could the P0508 been a red herring? I generally associated a bad starter or starter solenoid with a clicking noise, but would this still be worth checking out? On that same note, could the culprit be a bad ignition coil even without any codes showing for IC-related problems?
Dad's 97 dodge neon still showing a CEL and a code for a misfire but according to code reader it has something with the fuel line that is causing not enough fuel to get to engine. Car has a new fuel pump (about 6 months old) and it runs fine for a while then will sputter then will run fine for a while and back and forth. What it might be?
View 1 RepliesDad's 97 dodge neon still showing a CEL and a code for a misfire but according to code reader it has something with the fuel line that is causing not enough fuel to get to engine. Car has a new fuel pump (about 6 months old) and it runs fine for a while then will sputter then will run fine for a while and back and forth. What it might be?
View 3 RepliesIt just so happens that I got my letter from the DMV telling me I needed to get my new tags, and this is an emissions test year for my car. I was buys the last few weeks so I figured this would be a good week to do it. Yesterday.......check engine light comes on. How does that happen???
So now I'm on a time crunch. I went to Advanced Auto this morning and they checked the code. It's P0440, an Evaporative Emissions code. Any thought on what that me be, or any checklist as to what to check first? I'm fairly handy, but know nothing about cars. I'm sure I can figure it out with some instructions.
Summary: Got a check engine code of P0440, Evaporative Emissions. On a time crunch because I need to get an emissions test done. I can probably fix it myself with some direction.
Check engine light was on for some time when I had filler neck and cap replaced. Computer sensors did not re-set until 501 mile mark, when light came on again. Checking the web, I find that some who appear to have knowledge of problem say it could be hoses, sensors, valves, or evap canister--the charcoal canister.
Mechanic who did original smoke test and recommended replacement of filler tube wants to replace evap canister without checking anything else. What should I do? At wits end, and car needed to pass inspection 2 days ago. Car has 157,000 miles or so...
I drive a 2004 Dodge Neon, 2.0 base-model that has had zero problems since I bought it, and regular maintenance has religiously been maintained. Yesterday, after having already driven once without any problems, I went to leave again, and it would not start.
When I turned the key, it started to start but just stopped, but my dash lights and radio all came on (and still come on) fine.
I called out AAA and they tried jumping it just in case, but to no avail. My friend then took out the starter AND the battery and took them to get tested- both were perfectly fine.
There is no wire corrosion, either, and no noise at all when I turn the key. Instead, everything else comes on except the car itself.
See the log (with videos): [URL] .....
Every time the mechanic tried to start it worked just fine. It appeared to happen more under the following circumstances: drove day before, hot the day of, cooled down and then won't start. I just recently picked it back up and it's been starting fine...which leads to the theory that it's connected to hot weather...but I expect to have problems in the future and the fear of getting stranded is not nice.
PS. Car has 90K miles, regular oil changes but not sure what else (a "hand-me-down" that got lined up with the others in my parent's driveway to change the oil - I don't know if my sisters did any major work on it and we've all switched cars so much it's hard to remember what had what done.)
My 2003 Dodge Neon started overheating. We replaced the thermostat, temperature sending unit, flushed the radiator, checked for blockages, cleaned the radiator, changed the head gasket and water pump.It can run for about 10-15 minutes driving or 30 minutes idling before it overheats. The fans will kick on. The thermostat opens up. Pressure builds up on the radiator hose. When it gets hot, it boils back into the reservoir.I've been careful not to let it get into the red since the head gasket change.We sent the head off and had it planed.
View 9 RepliesI've had problems recently with my 03 Neon:
1) The CMP sensor throws codes constantly and the car is really hard to start at times. I replaced it a year or two ago with a generic part. From what I've read elsewhere, Neons hate non-Mopar parts for this so I just got a Mopar replacement and will drop it in when I get the valve cover back on. Does it make sense that a replacement could go bad w/in 20k miles or so?
2) Cylinder 1 misfired pretty hard. I accelerated on the highway and heard a thunk or thud w/ a loss of power. As the only code I got was a misfire I drove it home slowly (about a mile). Could this be caused by fouled plugs from the repeated hard starting? (I lived with the CMP sensor being bad through the MN winter cause I didn't want to replace it until it was warm). Should I look into this more? The thunk really worries me...
3) Last spring at about 95k miles I noticed what felt like my clutch slipping a lot. It would almost always slip under even partial acceleration at highway speeds and occasionally at lower speeds. I'd notice the rev increase w/o increasing tire speed. I took it to a major chain and they took a week to replace the clutch... but ever since then I've felt occasional slips. Did they do their job? Or is there something else here? I don't have a tach but I have a scan gauge ii hooked up which does show rpm increasing significantly w/o speed increasing.
My stepson's 2005 Dodge Neon sometimes won't start. Turn the key, the dash lights and radio and electric stuff respond, but other than a click there is nothing of an engine start up going on. He'll turn the key a few times, he pumps the gas pedal, does what he thinks might wake it up. Usually it will start after a few tries. He thinks it gets worse in the cold weather, but not much worse.
He also notes that if he does a lot of short trips, like running errands, this problem comes up more often. The car may run fine for weeks, and then the problem hits. Of course, it never does this when the mechanic has it. The mechanic has no idea what to do, since the car works when they test it. I was wondering if I used a voltmeter could I check some key nodes when the problem comes up. Also, if it really does get worse at cold, can I spray some suspicious locations with freeze spray to try and instigate the problem?
I need to know the Fire order for the 2011 toyota camry se 2.5 L engine. so I can find which oxygen sensor I need to change. I m getting a P0137 code and it said is the bank 1 sensor 2. I think that is the one after the catalytic converter but need to find out for sure.
View 1 RepliesI have a 2003 Dodge SX 2.0 and the gauges all stop working from time to time. Everything else works fine except the gauges...
View 5 RepliesMy daughter's 2003 Dodge Neon overheated. We tried to add antifreeze to the reservoir but it leaked out from the reservoir. Once the car cooled down we were able to drive it to Firestone. They replaced the reservoir, thermostat, radiator cap, and flushed the radiator and replaced coolant. The next week the car overheated again. This time we put water in the (new) reservoir and it leaked again. The mechanics tell me this is how those reservoirs are made. Is this true?
View 6 RepliesI have 1995 Dodge Neon (automatic). Lately, after long trips and on the highway the "check engine" light will come on. Then, the car seems to struggle shifting. I will be cruising along at like 68 MPH, then ease my foot off the gas to slow down, and the engine/car awkwardly jerks 2-3 times as it slows down. Trying to stay in the 60-70 MPH range is hard because is keeps hesitating and jerking as my speed changes, not HEAVILY but enough to make driving unpleasant. My cruise control stopped working about a year ago, I have not had it looked at yet, but I thought I should mention it. When I let the car rest overnight, the light goes off, and there is not problem until I go on a long trip again (around 200 miles.) This only happens at higher speeds, around town there is not a problem.
View 4 RepliesThe engine idles beautifully. However, the engine hesitates upon acceleration. Once the engine reaches approximately 2000 rpms the engine smooths out and runs well. This is even more noticeable when the AC is running.
View 5 RepliesMy dodge neon started to accelerate by its self and stays accelerated. My brakes can barely stop it. The check engine light is on. And it says it is a pinched solenoid sensor for the emissions. But to my knowledge that won't cause my car to accelerate like crazy and remain accelerated to 40mp and remains there.
I did some research and i keep coming up with IAC valve (Idle Air Control Valve). Not sure if this is the problem. There could be numerous problems. I am replacing IAC valve this week.
It has gotten colder & my 2003 Dodge Neon SXT (140,000+miles) started having trouble & seems to stall transitioning from park to reverse then into drive. It sometimes seems to shift out of the gear and then will stall/engine revs when gas applied but won't move into drive until warmed. Once the car runs/warms up it seems to be ok. Is this a bigger issue (transmission, spark plugs, etc) than just needing to let car warm up longer?
View 5 RepliesTurns out the crank shaft position sensor only fixed the cars ability to start and stop and did not cure the acceleration issue. What happens? The symptoms occur during the following conditions.
1. Hard acceleration
2. Going up hills
3. With heavy loads
Basically the car loses power and sounds like it is getting muffled. Then it just picks up rapidly and takes off.I have tested out the throttle position sensor and it checks out fine. The car never completely stops.If I feather the throttle, it picks up and keeps moving forward.
Haven't tried the EGR valve, fuel filter or fuel pump.
Strange thing though.The car was sitting for about two months until I replaced the crank shaft position sensor. Then it started up fine, and ran without problems.The tank went low, and I filled it with gas.AFter that, the car started having problems. The only thing I can think of is two things.
1. When I filled it up is raised sediment and somehow clogged something.
2. The excessive pressure in the tank is causing issues.
My '05 Dodge Neon's engine just quit when I was stopped at an intersection. All the lights, etc worked. When I turned the key the engine would sound like it started for a brief moment, but it always died a second later and didn't respond to pressure on the gas pedal. I took it to a shop that replaced the alternator, throttle sensor, and "idle air control mtr". A few days later, the car died the exact same way when I was driving down the road. I took it to a second mechanic who looked it over the next day, and it was running. He couldn't find the issue, and it didn't die when he drove it. I don't know if these symptoms are related, but a few minutes before it broke down the first time it jerked and the gauges went crazy. I had a check engine light for "not reading fuel level" or something like that after the first repair but before the second break down, which my first mechanic dismissed as not really important when I asked him about it. My lights also flicker a lot. Battery was replaced last year.
View 4 Replies