Mercury - Mystique :: 1996 - Rumbly Idle - Vibrates - But Giving It Gas Smooths It Out
Sep 29, 2014
This is something my car has been doing for a while but it seems like it's gotten gradually worse, or at least I've been noticing it more. The car's a 1996 Mercury Mystique 2.0L 4-cyl, 74000 miles. The issue arises when I am idling in drive (like at a red light). There is a distinct rumbling that you can feel through the seat and the steering wheel, and see if you look at the wheel or dashboard. It's not visible from outside the car, though.
The vibration is worst when the car is idling low -- typically around 500 rpm. When I'm driving, the vibration is not noticeable. Also, when idling, the rpms "pulse" upwards to about 700 rpm, and the vibration goes away. It will be rough for about 5 seconds, then bump up to 700 rpm for a second or so and smooth out. If the car is in neutral or park, the vibration goes away.
So I suppose there's two issues: 1) the low idle that "pulses" upwards, and 2) the vibration itself. Is the vibration just an effect of idling too low, and raising the idle might fix the problem? What would cause a low idle? Or, if the idle does not seem too low, what would cause vibration that is dependent on RPMs?
The scheduled maintenance is up to date, but the car is due for 75K maintenance next weekend. The PCV system was cleaned and valve replaced, air filter replaced, and spark plugs and wires replaced 12000 miles (~1 yr) ago. The idle air control valve was replaced at around 55000 miles (~2 yrs ago), I believe (the previous owner, a friend of mine, had had trouble with the car stalling at idle, and replacing the IACV seemed to fix it).
View 10 Replies
Advertisement
Brakes on 1998 1/2 Mercury Mystique pull to the right. Everything except the master cylinder has been replaced. Online info from people with similar problems,show replacing master cylinder has not worked. Appears to be a lot of people with the same problem yet they cannot find the root of the problem. No recall has been issued. I have been to the dealership and several repair shops and I am sinking money into a problem that has yet to be resolved.
View 2 Replies
Temperature gauge stuck past hot since my engine overheated once due to a broken water pump belt...
How can I fix a stuck coolant temperature gauge?
Its on a 1998 Mercury Mystique.
View 2 Replies
I have a 2000 Accord with a 2.3L 4 cylinder and manual transmission. I just changed the timing belt, balancer belt, water pump, tensioner wheels and other external belts. I now get a bad engine vibration at idle and when backing up and pulling forward. The vibration is quite noticeable in the steering wheel. Revving the engine smooths it out at certain RPM's. I know this isn't right and its got to be limited to something I just did. I followed the instructions in the Honda service manual and thought that everything went back to gather correctly. I double checked the timing and balancer alignments. The motor mount on the drivers side is simple and all went back together correctly. Is there a way to verify correct timing belt and balancer belt alignments without tearing it all down again?
View 13 Replies
This is a 1996 Toyota Tacoma, 2WD, 2.4L. When I apply the brakes I get a very heavy vibration in the front end, almost like a wobble. The vehicle otherwise stops fine. No noises. The vibration occurs at pretty much any speed over 20 mph. The frequency does not seem tied to the actual speed but it's hard to tell for sure. It does not do it when I apply the emergency brake only.
I replaced the front disk brake pads, with new clips and shims. There were worn down pretty far and needed replacing. Unfortunately that did not make any difference in the vibration. Rotor runout and minumum thickness were checked while changing the disk brake pads and both were within specs. I did a quick inspection of the ball joints and tie rod ends by trying to move the tire and everything seems tight enough.
I'm not very proficient on suspension issues. What else can I look for.
View 19 Replies
After I've driven the van for some 10-20 miles it vibrates through out the whole van when I turn left/right at low speeds. There is no problem at any speeds while going straight however. I've replaced both sides upper/lower ball joints, front wheel bearings, driver caliper, all the inner/outer tie rods, adjusting sleeve..etc, both rotors, u-joints(previous owner replaced them twice) new diff fluid, both rear drums with new pads. All 4 tires have signs of dry rot, but good amount of tread still on due to a lot of sitting. The van was sold as a 3.54 limited slip diff, but testing says its a possing traction. What am I missing?
View 1 Replies
Bought this car, drove it home, when I went to restart it nothing happened. Put in a new battery and still nothing. The starter will arc with a screwdriver but not engage. All the lights and and electrical work so I am thinking its either the neutral safety or the ignition. Is there a way to figure out which one it is with out buying both of them?
View 4 Replies
I have a 95 Impreza with the 1.8 motor, this thing is hesitating when you give it too much gas at once. I got the car this way so I don't know when it started. I put in new plugs, the wires tested ok, and the ignition coil tested ok too. The only code the engine was throwing was 21 the coolant temp sensor and that has been replaced. I also put in new o2 sensor, maf sensor has been cleaned. Checked for vacuum leaks and there are no leaks, also did a compression test and got 180 on all 4. Where to look next, I don't want to just replace sensors without knowing what is wrong. The car did run better with the tps sensor unplugged but still running very bad.
View 2 Replies
96 Mercury Villager: moaning sound, breaking effect at same time..what? Everything is well maintained. There is obviously something that has been missed.
View 1 Replies
I have a 1999 F250 Super Duty 5.4L, 118,000miles...engine seems to idle somewhat rough but tach doesn't seem to move off 1000rpm & when giving slight acceleration seems to act like its missing, shaking . But under acceleration moderate or high purrs like a kitten! Always starts good , few cranks. Any hints on the what issue might be?
View 2 Replies
I have a 2000 Ford Focus that vibrates more at idle. The previous owner replaced the top passenger side motor mount when I bought it in Nov. I just replaced the bottom and then the other top drivers side mount two days later. 75% improvement but I wonder if there is some thing in the engine like an adjustment of some kind. I have only had it a couple months so I don't know when the last time it had a tune up. I can replace the spark plugs my self but would need a computer diagnosis to determine if there is something else that needs some adjustment of replacement.
View 2 Replies
I just got a 2010 Hyundai Sonata, and it drives fine, but when idling there is an ever so subtle (but noticeable) vibration that seems to be coming from the engine. I read that there was a BBB arbitration case that ruled that some Hyundais had a defective motor mount, but I'm not sure. Should I go get it checked out? The dealers at the lot I purchased it from just told me it was normal and that it'll just be that way for a 4 cylinder car sometimes, but I think they're just trying to sell cars...
View 2 Replies
I just replaced the front and back motor mounts on my 02, 1.6 automatic accent. The front replacement mount was 1/2 inch too wide at where the bolt goes through, but made do. Now, the idle, but that's it. Before, it was vibrating somewhat at idle and lots of steering wheel vibration at highway speed. Now, I have no vibration of the wheel at highway speed, so it's like I eliminated one problem and made the other worse. I am hoping that the mount being too wide is the problem as I ordered the correct one. While taking it apart, I also noted the bolt through the front motor mount is incredibly small compared to the hole and this was true on both the original and the too big replacement. Why is this? Assuming that I swap out the too big mount for the proper and it still vibrates, than what?
View 1 Replies
I just bought a 2008 Sonata GLS 2.4L, 4-cyl., automatic, 74000 miles.
I found that the steering wheel, sometimes the seat, vibrates at idle in "D" and "R". And the vibration reduces a lot in "N".
Is this common for this model? If it's not common, how to repair this problem?
View 5 Replies
just replaced the timing belt and water pump on my '97 Acura TL. (80k mi), It now vibrates in gear at idle,but runs like a champ above 1000 RPMs. Didn't do it when I took it in. Our trusted mechanic says it's the motor mounts. I say "how do motor mounts go bad overnight?" There are small drips on my driveway under the car.
View 19 Replies
1996 Ranger 2.3 140 CID XLT 126,000 Miles. When coming to a stoplight or stopping the engine idle is low and causing engine to almost die. Engine has been stuck at high idle a couple of times. It started with the engine idle slowly coming down and now it its too low. I suspect the Idle air control valve.
View 1 Replies
So I had been noticing a bit of wheel hop in third gear before my UM flash. Just got the flash a few days ago, and I love it. But since then two things have arisen:
- When sitting at idle, the car vibrates. I can feel it through the brake/gas pedals and steering wheel. I didn't notice it prior to the UM tune. It's like an undulating feeling even more than a vibration.
- When upshifting, I now seem to get a clanging sound/feeling if I upshift anywhere less than about 3200 RPMs. It doesn't always happen, and it won't happen if I'm really fast with engaging the clutch after taking my foot off the gas. But it is disconcerting.
Prior to the tune, I had gotten used to the sort of bucking and whatnot when you let off the gas and learned how to shift to minimize it. But now it isn't as easy to do a mellow, smooth upshift under 3000 RPM's...i.e. if I just want to pull away slowly from a stop. My question is, do these sound like symptoms of bad motor mounts? The car has just under 25k miles on it. The mounts are all stock. I was wondering if the UM tune was just enough extra power to put one or more of them over the edge.
View 11 Replies
I have a 2009 Camry which has the well known very bad vibration at idle when in drive at a light. My Ultragauge shows the RPM are very low when it vibrates. Sometimes it drops to around 425-450 rpm when at a stop light in drive (automatic car). Then it sometimes moves up to around 625-675 rpm and that is when the vibration completely disappears and it is nice and smooth. This issue is intermittent but happens everyday.
Most people think it is due to a bad engine mount and spend money doing that and get no results.
I have done a lot of research and feel it is due to a dirty throttle body and IAC valve and want to test my theory. I will post results once I do the job. What is the easiest and most thorough way to clean both?
View 6 Replies
I have a 95 honda accord 2.2L, 135,000 miles. One day while sitting at a light the car started vibrating due to a rough idle problem. The idle speed is ok at about 750 rpm.
View 1 Replies
I drive a 2005 Jetta IV 1.8T R-line. The engine shakes/vibrates at Idle and when I drive.
Also when if I drive at high speeds when I stopped the engine just switches off when idling.
What could be the cause?
View 13 Replies
My truck has done this since I got it and it's pretty damn annoying. While at idle the rear view mirror vibrates slightly and drives me nuts. If you give it any gas at all it stops. Like I said its super slight but it's enough to notice for sure and makes stuff look blurry if your looking through it.
View 5 Replies