Mercury - Monterey :: Rough Ride / Check Engine Light Blinking
Dec 26, 2015
Our 05 mercury monterey is riding rough and the check engine light is blinking all of a sudden. Two days back while driving home it was raining and we accidentally drove through a puddle, did not notice due to night time. After that it suddenly the light started to blink and engine felt rough. Checked the code yesterday morning and it showed cylinder 3 misfiring, no other codes came up. No one was available to check it yesterday and today. Have not started it again. Anything can be done before taking to the mechanic? I believe the number 3 cylinder is at the back side and not accessible easily. What could have happened?
View 19 Replies
Advertisement
This is for our 2005 Mercury Monterey. The check engine light is on and the code says P0193, Fuel rail pressure sensor circuit high input. Last week we were waiiting in he car with it running on idle and heat running, about 5-10 min, later the the light came on and has remained on, so checked for the code and above code displayed. Possible causes/fixes could be broad as per the sheet printed at ORailey's for this vehicle, but based on above info can it be narrowed down? How urgent the repair is, needed to show right away? What could be done at home before taking it in? car has around 108k on it.
View 5 Replies
I've got a '96 Sierra manual transmission with 215K that's been running fine. I just ran it 400 miles without a problem. Recently I downshifted into fourth to go up a hill and I had a sudden loss of power and a rough ride like I had a flat tire. The harder I press the gas the rougher the ride and it idles almost normally. The check engine light came on and blinks 12 times.
View 1 Replies
Our R32 has 2428 miles- and today the check engine light came on and it started to run pretty rough, babied it home and the the light was blinking when I turned into the driveway.. I know that booklet 3.2 in the owners manual is diagnosing catalytic converter issues...I have always used super unleaded, it hasn't even reached the halfway point of the first service.
View 10 Replies
Today I went to the gas station and after I gased up and turned the car on my car started idling rough, almost to the point of cutting out. I started out on the road and my check engine light started blinking. After some time it stopped and just stayed on. The whole front end shakes pretty bad when at idle. The car has trouble accelerating till roughly 35-40 mph then seems to ride ok. I'm not very car knowledgeable, but I do take care of my car. I know I need to replace some of my hoses and spark plugs soon, but am worried that it may be more serious.
What I would like to know is: 1. What could possibly cause these issues and 2.
2003 Mazda Protege
View 2 Replies
My van was pulling to the right so I had it aligned. It drove great for a couple of weeks with only minor drifting to the right when I took my hand off the steering wheel. I also had the tires balanced and rotated at the same time and the guy said that it may pull because of the wear on the tires. Now, which is about 2 1/2 months after, if I take my hand off the steering wheel the van will immediately veer to the right. I have to keep my hand on the steering wheel at all times. Also, the tires are roaring. Of course I figured they would roar a little being rotated but 2 1/2 months later??? What in the world could be causing all of this?
View 5 Replies
Our 05 Monterey has this problem at around 45-50mph speeds. At this speed when we step on gas the we feel the vibrations of slow jerking like misfiring and some rough driving experience. This does not occur when cruising around 60/70mph. But if you have to brake and the speed drops below 45, then while accelerating the above problem is experienced. The car also does not accelerate fast enough. The car has around 110k on it. What kind of maintenance does this need? Is it very serious and need repairs right away? It was not a daily driver car, but now has become one (30 miles) for work.
View 8 Replies
I have owned 64 Mercury Monterey since new. Power steering control valve was leaking. I replaced the original, control valve, power cylinder, pump and hoses with new parts. I bled system and now I do not have power steering at low speed as in when trying to park the car. Parts store exchanged new parts thinking one may hjave been defective and still same problem except this time the control valve leaked all the fluid from the cap that covers the spool adjusting nut. I don't know what to do??
View 2 Replies
Last week, on our mercury monterey, we found that the level of power steering fluid had dropped and steering was making squeaking noise while turning. Filled up the fluid and it worked. Today when checked again, i am seeing drop in level again. So certainly there is some leak. Can we find it at home? Also is it safe to fill the fluid and drive or should we get it fixed asap?
View 6 Replies
For years, intermittently, my Check Engine Light was on steady. The Ford dealer tried four times (at a cost to me of nearly $400) but was never able to fix the problem. I was always able to get it smogged because I took it in during those periods when the light was functioning normally. But now I've got to get the car smogged again and the light is dead. Could be the bulb or something else. Should I take it to an electric shop or a regular mechanic? I understand that CEL issues are common to Fords of this vintage, but the Ford dealers haven't been useful.
View 15 Replies
I have a 2001 Mercury Grand Marquis. The check engine light came on and AutoZone diagnosed it as a misfire on Cyl. #4. I changed all the plugs but I do not know how to turn off the light to see if I fixed the problem. How to turn the light off.
View 3 Replies
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 Replies
It's a 2010 vw jetta. Check engine light is blinking and the epc light is on the car is not paid off yet have no.
View 19 Replies
My Girlfriend just got a 2003 Hyundai Elantra and everything was running great on it the first month she had it BUT the check engine light was on.. After about a month she called me up while driving and said that the check engine light was blinking and the car would hardly move. So I got to the car and looked at it and I noticed the oil filter was a little loose so I tightened it good this time and added a little bit of oil. It actually moved but it would hesitate. So we had it towed to a shop and they read the codes from the check engine light and told us it was leaking oil from the motor some where (not specific) and it also needed a new O2 sensor.
So I replaced the catalytic converter underneath the car and also a new sensor along with a new set of spark plugs. It ran alot better and I left it at that. Now about a week later she was coming home and noticed that when she turned left or right that the battery light and brake light on the dash came on. She drove it home and when she turned in the driveway the car went dead. It started right back up and we got it to the house and left it over night. I went out this morning and again it started right up. but when I lifted the hood I noticed the belts on the pulleys were all spinning very slowly. I'm not sure if it could be a timing chain or if it just needs new pulleys.
View 6 Replies
When I was driving to school this morning my check engine light went on and I noticed that my car is running very rough (suddenly). I also noticed that the check engine light would blink when accelerating at a stop light then go solid again when driving. I drive long distances between school and work and I think I won't be making it to work later due to this issue. This is a Saturn Ion II 2005 and gets regular maintenance on time.
View 15 Replies
So I am on my way to the store this morning and the check engine light starts blinking. After I get out of the store I try to start the car so I can drive the mile back home and then have it towed to the dealer. The car is only able to drive at like 1-3mph. I changed the cam follower 6k ago and the car only has 43k.
I'm thinking this seems like a fuel delivery/cam follower type of issue. At the moment my plan is to have AAA tow the car home so I can see if its a follower issue. If it is I think I'm going to have to take off my downpipe and put the stock one back on. When I put the car in neutral and step on the throttle I get no revs at all.
View 4 Replies
My check engine lights been on forever, like every VW, but now it's blinking fast, and the car isn't running right. It's messed up AGAIN, it's running really bad, like misfiring and not making power. It's shaky feeling in the throttle and power, almost like it's going to stall but it doesn't. What the problem is?
View 5 Replies
'99 Passat GLS - 79,000 miles - no mods ... Solid Check Engine Light was on for about 2 weeks...last time it was on, it was a fuel cap issue so I took my time with it. Well, all of the sudden on 4/14/03, on my way to work, (less than 5 minutes after starting the car) the car starts to ride hard (like going over grated pavement)...check engine light starts to blink! I pulled over. Eventually the light went back to solid.
Tonight (on 4th ignition sequence since picking up the car this AM) - the solid Check Engine Light came on again.
I had a friend who went through this with a 2000 Passat GLS - different dealer claimed it was the MAF, then the O2 sensors, then....she eventually took it to carmax to unload it.
View 13 Replies
This morning on my drive to work my car would choke whenever I hit 3000 rpm right when the car is sucking the most air from my intake, and especially on 3rd gear and up. After being on the road for quite some time my check engine light came on blinking but went away right after I stop pushing the car to 3000 rpm to switch gears.
The car is on APR Stage 1 with AEM Filter + Nuespeed Intake + BSH Inlet Pipe.
Recently added was a VW Diverter Valve D Version due to an oil leaking from my Old Diverter Valvue G version.
View 5 Replies
I have a 2013 Elantra GLS with almost 200k on it. I am the original owner. I have only had a few small problems with it just replacing lights and had to replace the passengers side wheel bearing twice. the rest has just m=been replacing wear and tear parts. the check engine light is on because it needs 02 sensors. They are back ordered. The car started idling roughly and driving horribly on the way from Rhode Island to New York on Christmas day. A friend had a diagnostic machine and the code read misfire cylinder 3 p0303..I am assuming it damaged the catalytic converter and that I now need both the sensors and the convertor. I live about 7 miles from my garage. should I tow it ? or drive a t a low speed? Have to bring it in first thing in the morning. What else could be wrong?
View 3 Replies
2004 VW jetta 2.0 ... So my vehicle stalled on me i replaced the battery, the alt, and then when i started it after installing the new alternator it didn't sound right so i checked it out and saw a spark plug wire was in very bad condition and was causing a spark where the spark plug and the spark plug wire connect so i bought a new set of spark plug wires and swapped the old ones for the new ones. Now when i start my vehicle the check engine light is blinking and the car definitely does not sound right. i am positive i did everything correct when swapping the spark plug wires but i am lost as to what could be the issue.
View 1 Replies
