Mazda :: 2006 - Won't Clamp Even How Hard To Pull?
Feb 15, 2012
The 3rd row seat in my 2006 Mazda MPV doesn't secure itself to the two clamps on either side no matter how hard I pull on the back strap. What to do?
View 1 Replies
Feb 15, 2012
Advertisement
Ford 6.0L Power Stroke Diesel :: 2006 Truck Shuts Off In A Hard Pull
I have a 2006 that shuts off in a hard pull, if I wait 3 minutes it starts again. I hooked up my scan tool and when it dies and I crank it it only builds 200psi oil pressure, let it sit it builds enough pressure to run fine. If I dont push it over 3500psi for more than minute it wont die pull a hill it dies again. Is it the hpop or an o-ring.
View 10 RepliesMazda - CX9 :: Locked But Window Opens When Pull Door Handle
So when I get out oft Mazda cx9 I lock the doors and then check if the doors are locked by pulling the door handle. And then the windows roll down by themselves. It freaks me out because what if someone else comes up to the car and is able to open the window? So I went to the car repairman and they say nothing is wrong and it's not possible to make the window roll down from the outside. What am I supposed to do?
View 7 RepliesPassat (B6) :: Backfire After Doing A Hard Pull In 3rd But Never In 2nd
Wanted to ask B6 owners first, from time to time I hear what I think is a backfire after doing a hard pull in 3rd but never in 2nd. Now I'm not sure its a backfire but after I shift to 4th I hear a small pop from the back of the wagon. Don't know if this will happen in 4th after a pull, have not had enough road or balls to do this. ( In Oregon you get a huge ticket and license pulled for 30 days for anything over 100.) Everything runs fine, I only have the Neuspeed intake for the autos and thats it. Any thoughts you B6 owners have B4 I go to the 2.0 fsi page would be great. Here are some pics from the big snow storm we had here in Portland back during xmas. The Thule chains worked great when I was not high centered.
View 3 RepliesLexus GX 2004-09 :: Truck Wants To Pull Right When Braking Hard
When I brake hard. My truck wants to veer right. It drives straight otherwise.
I recently had my front shock replaced and prior tp that my truck did the same thing, although it was much worse since my left front shock was leaking. Originally I thought it was pulling because of the bad shock but now that thet've been replaced I am not to sure.
Alignment issue or something else entirely? Coud bad rear shocks cause the issue?
Elantra XD (2001-06) :: Hand Brake Very Hard To Pull Up
On my wife's '06 Elantra, the hand brake is very hard to pull up, barely getting one click from it. I've done some looking around and have not been able to find a solution to the problem.
View 2 RepliesGolf/GTI VI :: ESP / Wheel Slip On A Hard 2nd Gear Pull
Last night it was just below freezing and the roads were a little damp so I figured I'd see at what point ESP would kick in on a hard 2nd gear pull. Sure enough power cuts off at around 4000-4500 rpm.
Turn "off" ESP, try another hard 2nd gear pull expecting some nice tire squeal but I get nothing and obviously still no traction from 4500-6000 rpm. Was my clutch slipping? Is ESP capable of knowing when the clutch is slipping (I would think it had nothing to do with it)? Maybe it was just damp enough that the rubber was spinning in one place but it wasn't making any/limited amount of noise?
Car: GTI, Manual, Stage 1, Winter Tires.
Ford Excursion :: Occasional Hard Pull To Right Under Braking
If I brake hard a dozen times, 8 or 9 will be normal, a couple times it will pull to the right but as long as your hands are on the wheel you can barely tell, and maybe once it will pull really hard. I have Hawk super duty pads and Ebc rotors with less than 5k on them and I just replaced the front calipers and hardware because I thought that was the problem.
It's not even consistent. Could possibly be rear calipers (rear also has new Hawk pads and Ebc rotors with less than 3k on them) but I don't think it would pull that hard. Tire pressure is even between sides btw.
Golf IV / Jetta IV :: Pull Up Really Hard To Get Parking Brake To Hold?
I have to pull up really hard to get the parking brake to hold. If I'm on a hill forget it, I yank up really hard and then leave it in gear just in case. I have installed new cables and pads. I have also have the lever adjusted so it starts to catch when you pull it up about 2-3 inches. I've never driven another mk4 so I don't have any other reference to how well the parking brake should hold but I would think that I wouldn't have to pull up this hard to get it to habe any real holding power.
Any other vehicle I've driven with a hand brake I could easily lock up the rear tires. I'm lucky to get mine to lock while pulling so hard I think I'm going to break something. I've searched around and have only come up with threads about replacing cables and adjusting the lever. I couldn't find anything like the problem I'm having. Is this normal operation for a mk4 or is there something wrong with my calipers that needs to be addressed? My regular brakes work fine and the parking brake arms on the calipers allear to be functioning properly. They contract then spring back on their own
Golf IV / Jetta IV :: 2003 - Hard Left Pull Under Acceleration
I have a 2003 Volkswagen Golf 2.0L 5 speed manual. Over the last 10,000 miles a problem started where on the highway in 5th gear, if i try to speed up by putting the pedal down, the steering wheel moves itself to the left and the car steers to the left. The wheel returns to the original position when i let off of the gas. its scary at high speeds and has become so bad that I can feel it accelerating at low speeds too.
The alignment is off and the steering wheel slightly to the right. when I put the gas down and it goes perfectly straight and when i release it goes back to the right. it has 126,000 miles on it. I know it needs tires, shocks and an alignment job but don't think that those factors are causing my problem. Could it be the motor mounts?
Golf IV / Jetta IV :: Engine Temperature Rises When Heat Is Turned Off / Hard Pull
I have a 1.8T with 152kmiles
Recently, both the coolant reservoir 'Y' connector and the driver side coolant flange cracked and I was shooting G12 all over the engine. I've replaced both of the parts and the coolant temp sensor with a "green top". Reservoir was refilled with the proper ratio of G12 to distilled water, ran for a bit and topped off accordingly.
This morning I started my drive to work and the engine temp was at 0 for a minute or so and started to climb slowly to 190. It stayed at 190 until I took the exit to the highway and the temp slowly started to rise while I was at 60mph. I immediately turned around and went back home with the heat cranked to high. With the heat on, the engine temp would slowly go down but then rise again if I, A. turned the heat off or B. made a hard pull up to ~55+mph.
I popped the hood and the coolant was not boiling and I couldn't see/smell/hear any leak. could this be the thermostat or is this a water pump issue? I plan on taking the thermostat off and checking the pump empellars for any shards. I'm not sure but I do believe the water pump was replaced by my parents while I was on deployment.
Ford Super Duty (1999-2016) :: 2003 F350 - Gear Shifter Very Tight And Hard To Pull Down
I'm looking at purchasing a 2003 F-350 from a Ford Dealer, Drove the Vehicle last night and the Gear shiftier was very tight and hard to pull down. Is this a real concern? The Sales guys said its better to be stiff rather than sloppy. But they will say anything, right. The vehicle is a deal and so I'm looking to find out why.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 F250 Runs Out Of Fuel On Hard Pull / Long Hills
Every time I hit a hill, loaded or empty, or get on the truck on level ground after about 15 seconds it acts like it's running out of fuel. The pump starts getting noisy like it has air in it, but it'll straighten out eventually. If you don't let off the fuel it'll eventually stall out. No check engine light, no codes. Truck has a ts chip but it does it on all settings. New fuel filter, changed oil with hot shots secret, new air filter, hutch mod done. I'm at a loss for what to do. Good fuel pressure also.
View 8 RepliesFord - Focus :: 2003 - Steering Wheel Malfunction - Hard Pull To The Left After Very Linear Steering Feel
The problem makes the car unsafe to drive. The quickest way to describe it is a hard pull to the left after a very linear steering feel. My perception is almost as something is holding on and then just fails and lets go and the car quite abruptly shoots left in a very unsafe manner. Here are the things I have done to remedy the situation, I replaced the struts with factory replacements 15,000 miles ago. At the same time i replaced the left and right axles, drove the car with the problem then last weekend, I replaced the upper tie rod arms, and lower tie rod ends, the sway bar bushings, and the control arms on both sides. I literally feel as though it is a darn near new front end.
Just yesterday I had 4 new Goodyear eagle tires and an alignment done and the problem became more pronounced and worst. I really like this car and want it to be a joy to drive as I know from others these little hatchbacks are a real joy on winding mountain roads.
Mazda - Miatamx-5 :: Hard To Get The Car Into Reverse, 1st And 2nd Gears
I have a 1995 Mazda Miata with a manual transmission. Lately it has been getting harder and harder to get the car into reverse, 1st, and 2nd gears, and this morning it was impossible for me to get the car into reverse. Do I need to replace the clutch? Is it something else?
View 1 RepliesMazda :: 1999 - Overheating When Accelerate Too Hard
I have a 99 Mazda Protege LX. That is only overheating when I accelerate too hard. Like getting on the the highway. I have replaced the radiator and the thermostat and also got the system flushed, but it is still overheating!
View 3 RepliesHyundai - Tucson :: 2006 Shuts Off Sometimes When Pull Into Driveway
2006 Tucson shuts off sometimes when I pull into my driveway. It starts right back up and it doesn't happen all the time. I have replaced the cam and crank shaft sensors with no luck.
View 6 RepliesMazda - Mpv :: 1998 - Hard To Start When Engine Warmed Up
Been having this problem since this past Easter when our mechanic installed new valve cover gaskets.
When the van is hot (normal operating temperature) and you turn it off just for a minute, like to get gas, and try and restart it acts like it’s not getting enough gas. It will cough and sputter and balk. It will finally start though and after 30 second all will calm down and it will run fine.
One big problem is, is that is intermittent – meaning it won’t mess up for the mechanic and putting it on the computer shows nothing wrong.
One mechanic said it was a cracked distributor. Replaced that for $400. and same problem. I’ve also cleaned the Mas Air Flow sensor and changed the fuel filter.
Mazda :: Hard To Shift From Neutral To First After About 20 Minutes Of Driving
In hot weather or even warm / humid weather, my very low mileage Mazda 626 (2002) becomes almost impossible to shift, especially from neutral to first, after about 20 minutes of driving. If I stop driving and the car cools off, it's okay again, until another 20 minutes of driving. It's fine in cool weather. This problem started in the summer of 2010.
View 4 RepliesFord - Freestyle :: 2006 - While Accelerating There Is A Slight Pull To Left
I have a 06 Ford Freestyle with roughly 121,000 miles that I purchased 2 months ago. I love the car. Only issue I am noticing is when accelerating at take off, once the car gets up to speed I notice a slight, quick pull to the left and then its fine. I sometime feel this pull when turning to right(like around curves).
View 2 RepliesMazda :: 2004 - Misfire Or Skip When Accelerating Hard Below 3000 Rpm
I have a 2004 mazda6 v6 3.0 and it is throwing codes for o2 sensors. No cat but there is a code for heated o2 sensor. Not to Familiar with Mazda's but when accelerating hard below 3000 rpm it seems to misfire or skip. Only when accelerating hard though. If just barley pressing the pedal and slowly creeping through low rpms it runs fine. Anything above 3000 rpm it accelerates great.
View 8 Replies