Malibu :: 2005 - Constantly Making Turn Signal Clicking Noise
May 2, 2015
My 05 Malibu classic is making the turn signal clicking noise constantly which then causes the warning chime to start going off. I have replaced the turn signal assembly three times and each time it fixes it for a short time then it starts again.
View 4 Replies
Advertisement
I have been reading threads all day. Noone seems to have exactly the same issue so I'm just looking for some clarification. Turn signals dont work but lights work as "parking lamps" and internal climate lights are not illuminating either. Also, my blinkers making the clicking noise but much faster when the turn signal bulbs are not flashing. I had a radio issue but that is resolved. Where do I start? Do I go right for the hazard relay? I read somewhere there was an ignition relay that could potentially be causing all of this?
View 7 Replies
When I brake I get a rhythmic noise that starts like a quiet chirp and by the time I have completely put the brake pedal down it sounds like a loud grinding noise. It is a rhythmic pulsing noise, not continuous. I recently got new rear drum brakes, and 2 garages said my front brakes were fine. One guy said it could be the wheel bearing but I looked online and it says that happens when you accelerate, not when you brake. It only happens when I brake at relatively low speeds. In other words if I'm on the hiway and brake to slow down from 70 to 60 or 40 to 30, it won't happen. I also feel vibration in the brake pedal, but only when I have almost completely stopped.
View 1 Replies
New owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
View 9 Replies
It makes a noise as if I have my turn signal on, although when the turn signal aren't on, the ticking sound continues. I replaced the whole unit, and it did not fix it. My Dad says it has to be a bad Turn Signal Relay, but where do I find one in my car? How will i know that it's that? Is there a diagram of relays anywhere online?
View 2 Replies
While running some errands with my wife the other day she made a comment like "One thing I don't like about this car (my C4) is that the turn signal indicators don't make any noise when they're on". I said "You're joking, right? Even I can hear the clicking." Interestingly enough, my 27 yr. old daughter made a similar comment when I was driving her somewhere a week or so ago.
Well, the funny thing is that I'm finally starting to admit to myself that I'm losing my hearing. Everyone else around me has been aware of it for a while and puts up with my constantly asking them to repeat things. And yes, I should do something about it. But that's a story for another time.
View 8 Replies
So the other day driving to work i was driving my car to work, i put my turn signal on and after i turn it off it still kept doing the clicking noise. At first i thought i was just hearing stuff cause it was early and i was tired, so after work i checked it out again i sure enough it was doing it. It even does it sometimes without even first putting the turn signal on. My buddy and i thought it was a relay or a fuse. Is that right?
View 7 Replies
I have a mazda 3 and i just tried to start it but its just making a clicking noise. The radio works so does that rule battery out....
View 4 Replies
Example, if I'm turning the wheel to the left with the left turn signal on there will be a LOUD click, click, click ect. sound from the column. The sound is louder than the turn signal relay and can be heard with the radio on.
Today is the third time I've brought it in to have fixed and now they tell me it is "normal". They came to the conclusion that it is "normal" because two other trucks on their lot make a noticeable clicking sound and one is just as loud as mine. However, My truck JUST STARTED making the noise a few months ago and was quiet when I originally bought it.
I know this is not a big problem ,but it is annoying and I want it fixed. Anyways, my Ford dealer had bailed out on me so how do I fix it myself?
Can you hear the column switch clicking ALOUD in your truck?
View 14 Replies
My daughter recently bought a 2004 chevy malibu. she had it checked by a mechanic, who said it was a decent car for the price. the turn signal does not work when she has the brake on.
View 4 Replies
This is hard to believe but...the engine was making a freaky clicking noise. It started to getting a little louder and then the car suddenly lost acceleration on us. We took it in and the mechanic said that a spark plug broke off inside the cylinder and chewed things up badly. The threads in the block are bored out also. He states he can "band aid" it with some kit, but then recommends selling in and buying new. My question - Should I go that route or is engine replacement a better option? 90K miles, 6 years old. Not sure what engine replacement would cost...
View 12 Replies
Took my car in for 10k mile service and let them know there has been some clicking noise coming from the front suspension when making a left/right turn...
I dropped off my car on September 21st and they have yet to complete my car... I've called them every single day since but, I don't get a good explanation from the dealer...
View 10 Replies
I drive a 94 Saturn SL1 as a part-time delivery driver for a pizza shop. Recently I bottomed out on someone's driveway. I could hear the bottom of my car scraping against the asphalt. It took several tries (in my 5-speed) to free myself from this trap. Since then I've been hearing a pretty loud "clicking" noise from the passenger side of the car every time I make a turn, where a small turn or a big turn. My mechanic replaced the left axle and the right boot, saying that both were defective. However I still hear the noise. What can I do??
View 3 Replies
I have a 99 dakota. The truck wont turn over, headlights/doom lights nothing in side works. But when i open the door the glove boxes starts making a clicking noise ? it happened once before and once i pushed it down a little drive way everything turned back on ? What could cause this problem ?
View 3 Replies
I have 2005 Chevy Malibu that has been making slightly metallic thud noises while turning. The car does not need to be in motion, but will make the noise in both forward or reverse in both directions. The noise is gradually increasing in loudness. I have inspected the CV boots and verified that this car has electric power steering assist. The dealer would not look at it, stating that the "Malibu's do this". Additionally the service rep stated that "if he had it checked out they would not find anything anyway." This noise does not sound like anything that should be ignored and sounds like major failure / safety issue pending. I can find no consensus on what might be wrong?
View 4 Replies
My 2005 Jeta GLI is making some crazy noise when i turn to the left from the driver side I tough the problem was the axle so I had the front part replaced and the noise still there I don't know what else needs to be replaced ....
View 10 Replies
My turn signal relay clicking and stuttering randomly. When turn or warning signal used it operates normally with absolutely no problem and sounds healthy. But when not used and supposed to be quite - it goes again. When stuttering - there is absolutely no indication other than clicking sound that something is wrong.
View 11 Replies
Long story: I have a 2005 Chevy Malibu base. About more than a month ago I was driving home from work my car stalled about 3 times. I was able to finally get home I checked the oil and to my shock there was none. I quickly put some in and my car started just fine didn't stall again. I drove it the next day nothing. Then the day after that I drove it to Walmart on the way back it stalled like 7 times and after that last time it wouldn't turn on. I got it towed to a shop where my car remained for over a month. The crank position sensor was replaced, the battery, and the ignition switch. I was told it was fixed, picked it up drove it to a town 30 minutes away it was fine, then drove it back it started stalling every 5 minutes.
Managed to take it back to the shop, they couldn't figure out why it was shutting off so they got a second opinion at a Chevy dealership nearby and they replaced the ignition control module. I picked up my car drove it around for awhile and the check engine light came on I was near pepboys they checked the code which said I needed to get the catalytic converter check/replaced. So I drove my car home. Next day drove it all day it stayed on, thought my problem was solved. Then that evening turned it on and within a few minutes the engine shut off and now it won't start at all. The mechanics that I took it to obviously don't know what the issue is nor do the mechanics at Chevy. It is not the fuel pump that's one things that can be crossed out. Or is my car done and should be junked?
View 8 Replies
Where the flashers are located? I turned my turn signals on to find the clicking sound, but I couldn't see anything under the dash.
View 9 Replies
I installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
View 14 Replies
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 Replies