Lumina :: 1996 / 3.1 - Turn Key Wait 2 Minutes For Fuel Pump Then Start?
Oct 7, 2015
I have a 1996 Lumina 3.1. For the last few years, every now and then I would turn on the key, all electrical systems, lights, windows, radio, etc. would work but it wouldn't turn over. If I waited about 4 minutes it would start perfectly and it wouldn't happen again for up to a month. Last week it did it and after I waited and tried it again it turned over once then everything went dead. A mechanic (friend) installed a new battery and it started. He took it to his shop and installed a new computer. Everything read fine, but now when you turn on the key it will turn over fine but not start. Leave the key on and wait about 2 minutes till you hear the fuel pump start and the engine will start fine. If you stop for a few minutes it will start but if you stop for more than 5 or 10 minutes you have to wait for the fuel pump to come on again.
View 7 Replies
Advertisement
I drive a 1996 F-150, 188,000+ miles. Sometimes when you turn the key in the ignition, nothing happens. Absolutely nothing. But if you wait about 2 minutes, the truck starts O.K. This has occurred a couple of times when I was starting out and killed the motor by not giving it enough gas. But it's also occurred when the truck has been sitting for a number of hours or even overnight. It never fails to start after about a 2 minute wait. What's going on here? I've had the truck in the garage, but they couldn't replicate the problem and didn't do anything.
View 2 Replies
Intermittent fuel pump problems in '96 Dodge ram resulted in new fuel pump 50,000 miles ago. Happened again 100 miles ago, so another new fuel pump. Now to start car must turn the ignition on several times before going to the start position. It appears the latest new pump may have defective one way check valve, so the pressure is depleting after turn off. Any favorite brand of fuel pump for the Dodge "pump in the gas tank" arrangement? Or solutions such as installing an external pump to do the work of pumping the fuel?
View 1 Replies
My 2014 Sonata GLS has definite air conditioner problems. It takes some time for it to get cold. I had no problems with my 2011 Elantra - I never had to turn the air conditioner to its highest level. In addition, it cooled almost immediately. However, I have to turn on the Sonata's air conditioner to full capacity and wait several minutes before I get some cool air. When it's 95 degrees out here in Florida, a few minutes can seem like a long time.
Haven't had my car checked yet.
View 33 Replies
I been working on this car for several weeks now. I have change,
1. The starter.
2. New Battery, New Plugs, New Crankshaft sensor.
I even change the belt tensioner because is was going bad (Broken). In fact I can hear the full pump running. After doing all this the car still not turn on. there is full in the full injector.
View 2 Replies
I have a 2000 Chevy Impala and it seems that every now and then when I try to start the car the security feature activates and I have to wait 10 mins to try to start it again. On some occasions when the 10 mins are up and I try to start it the feature reactivates and I wait another 10 mins. This actually happened on a ferry ride and I held up the offloading of vehicles. My question is, Will a remote starter installation alleviate this issue? If not. What can I do?
View 5 Replies
vue would crank, not start. 5 min later it started. done this 3 times in 1 month. changed original fuel filter. am leaning towards fuel. vs spark. no codes. I see pump assy's for $175. or a pump alone for $30. if I remove tank and pump assy, would there be any issue with changing pump alone? not paying shop so its my effort the last gm pump assy I did had a working pump but corrosion on leads to pump inside tank. I replaced assy because I had already bought assy.
View 13 Replies
I was driving to work and lost all power (during rush hour) I was able to coast to a exit. Had it towed home, when I turn the key the starter engages but nothing after that, the engine will not turn over. I checked the battery and has a full 12 volts.
I removed the belt and front plugs to see if I could manually turn the engine over but it will not budge. How can I tell if this engine is really locked up or if maybe something else is happening?
3.1 V6 engine .....
View 7 Replies
I have a 1996 Pontiac Trans Sport 3.4L (without Passkey anti-theft) which on occasion won't start after being parked. The fault only happens when the vehicle has been sitting, it does not die while being driven (so far). The engine cranks normally but does not fire. The peculiar and significant thing about the fault is that the fuel pump relay (driven directly by the PCM), chatters at about a 10 Hz rate. Instead of receiving a steady 12VDC to keep it energized, it is receiving a pulse stream from the PCM.
The first few times this occurred, I heard the relay "chattering " under the hood , and was able to start the van by unplugging the relay and shorting the connector terminals for the contacts together with a wire jumper ( these terminals connect "hot at all times" 12VDC from the PCM fuse (orange wire) through the relay contacts to the fuel pump +ve). The electric pump would run and I could start the engine easily. By the time I arrived at my destination, the fuel pump relay 'drive' would be normal and I could plug the relay back in and continue normal operation.
The last few times this problem occurred, the van would not fire -- no spark as long as the relay drive was pulsing. When it would finally go back to normal operation of the relay, the engine would start OK.
Last Spring in cold weather I had the van towed 2 blocks to a Pontiac dealer with this problem. The problem resolved before they inspected it; however after the Technician's inspection the Service Advisor said there was no fuel pressure at the test port and that the pump must be deffective (shorted), overloading the relay causing it to chatter. That diagnosis made no sense to me. They wanted to replace the fuel pump as the solution ($600). I got past the Service Advisor and asked the mechanic to show me the fuel pressure -- the car started on the hoist when I tried it, and fuel pressure was normal (>30psi). I left with just the relay changed, as they thought the original would have burned -up contacts from excessive current to the pump. (I cut it open later and found its' contacts to be perfect). While at the dealership I asked the S.A. if he knew of any TSBs, or other incidences of this problem; he said he had not heard of this problem before.
I had the same problem one week later, but not again all summer until this Fall's cold and wet weather. I had to have the vehicle towed home and it still wouldn't start the next day. As soon as I accessed the PCM behind the glove box and jiggled it the relay chattering stopped and car could start. However, later the same day, still in the driveway, the fault was back and no amount of jiggling or other manipulations had any effect. Later still I went out to test for spark, and the fault was gone. (Cold, wet weather all day).
Vibration seems to have little effect. I have checked the PCM connectors' security and pulled, twisted and wiggled the wires coming from it, as mentioned above, to no effect. I suspect the fault is inside the PCM and is thermally induced by cold weather. The next time it happens I will try a warm hair dryer on the aluminum housing of the PCM. I wonder if there is a fix for this (repair a cracked solder joint, etc.) other than replacing the PCM. I work in electronics, and will open the PCM up and inspect it before forking out for a new one.
View 3 Replies
Without key even in ignition, fuel pump relay clicks constantly every 8 seconds with the gauge lights illuminating during this 8 seconds. The only lights that function are the gauge lights. Upon turning on the headlight switch only the gauge lights illumin8. Absolutely no headlights, dome light or brake lights. No fuel pump sense/pulse. No radio, key on or in accessories.
Multi-function switch was not the issue. How would I troubleshoot this one?
View 3 Replies
Because my car would intermittently start with the key (it would run fine if I jumped the relay at the starter) I just put in a new Autozone lock/cylinder in my old '96 Lumina LS. Prior to the install, I took the new lock/key and old key to the locksmith, who told me he has the tool to read the resistance on the key which corresponds to the computer in my car and I wouldn't need to go to GM. Also, the brake lights weren't working right so while I had the steering wheel off I replaced the turn signal switch too.
I went to check to make sure the turn signals/brake lights worked before buttoning everything back up so I reattached the battery, with the key in the new lock; the dash lights came on, the chime went off as they should. I then put the ignition key in the 'run' position and the chime died and the lock mechanism will no longer turn and I get no lights at the dash. The car won't shift and I'm effectively screwed! FYI - The headlights and brake lights both now work but I can't turn the key in the ignition. Did I just get locked out? Did my locksmith hand me a line of bull?
View 5 Replies
Got done with replacing head gaskets and intake gaskets, Van started fine and I backed it out of the garage. Left it running and put down ramps and drove up on them so I could get under and connect the exhaust. Got that done and then got back in it and all it will do is crank and it will not start now. It also has a new cam shaft sensor( wire broke on old one). I can hear the fuel pump when I turn the key. It is like now there is no fire to start it. What could be wrong? What do I check? What causes it to fire? If something was connected wrong, would it have still started and then wont do anything but crank? Got dark on me and started raining so I say tomorrow is another day. I feel it is something simple.
View 4 Replies
when I turn key I should hear fuel pump, I don't. I can jump pump & it will run but it still won't start. I reset inertia switch, switched pumps (new one) still won't start. What next????
View 1 Replies
My 1999 4.0L v6 Ranger (auto trans) is having some issues. Recently the fuel pump won't turn on as normal when I turn my key. I have to turn the ignition on and off 10-20 times before I hear the pump kick on and I can start it. I already checked the relay and fuel pump shut-off switch. Neither was the bad.
View 10 Replies
I am thinking that maybe my ignition switch is bad and needs replaced. When i turn the key on sometimes the pump wont turn on and thus wont start (brand new pump couple weeks ago)
all my fuses are good
its only done this once but today it started fine ran for maybe 2 or 3 seconds and then died just like i turned the key off no sputtering or anything but started right up again and was fine
sometimes it feels like its lost power and burning alot more gas then it should and every now and then at higher rpm it will miss but only once and it very rarely does that
relay is good
ground to fuel pump is good
View 14 Replies
I have just replaced a fuel pump on my 98 neon and it started up and then shut off after about 5 minutes. there is electricity running to the pump just not kicking it over what could be the problem
View 9 Replies
We will start with the history. I recently purchased this car knowing of a long list of issues which have been worked out for the most part. The related piece would be random misfires which I believed were based on a faulty Ignition Coil (common on this 420a [2.0 NA] motor.) I have replace the coil but the issue persists.
Now what is happening is after about 20-30 minutes (or miles) of driving the fuel pump will overheat and the car will stall. I can get it to turn back over most of the time but it will stall out if attempting to drive. I have to leave it sitting for about 15 minutes to be able to move it.
What codes am I getting from the CEL? Nothing. (No CEL)What have I tried so far? - Fuel pump has been replaced- Fuel filter has been replaced- Fuel lines have been verified (no noticeable leaks, unwanted bends, pinches or breaks)(I also verified that this is not an issue with the PCV valve or EGR [electric in this car] valve)
I know... I thought relay or wiring also - but all lines and the relay are cool to the touch so they are not overheating. 1998 Eclipse GS....
View 8 Replies
I have a '96 Dodge Stratus that keeps blowing fuse #20, which is for the fuel pump and the ignition. How to isolate the problem? This happens as soon as the key is turned on. The car has 140,000 miles and runs excellent otherwise.
View 3 Replies
My 1996 Ford Ranger's Fuel Pump- Fuse keeps on blowing... (Fuel pump is new)... We need to find where the short is coming from!
View 2 Replies
Have a 95 Bronco with 5.8, I turn the key on and fuel pump doesn`t shut off. Changed fuel pressure regulator still no shut off. Changed relays, no luck. Have 38 pounds pressure with key on, but no start. Checked spark just in case, and have fire. Don't know what to try next.
View 10 Replies
Having an intermittent strange sound coming from the fuel pump from its normal whine at start up to a gurgling sound almost like you are blowing back through the fuel line back into the tank. Going on a 300 mile trip, should I hold off?
Btw: it's a 1996 Aerostar 3.0L
View 9 Replies
