Lexus SC430 :: Transmission Cooler Line Location?
Oct 7, 2014
What is the location of the Transmission Cooler Line? Is it by the radiator?
View 12 RepliesWhat is the location of the Transmission Cooler Line? Is it by the radiator?
View 12 RepliesI've just (a couple of weeks ago) purchased an 03 Santa Fe. I noticed some trans fluid on my driveway a week later, and not a small amount. I took the lower cover off of the engine, and the leak is coming from the transmission oil cooler area. I had hopes that it would be something fairly straightforward to repair, so I got a replacement oil cooler and some spare hose, just in case it was just a hose. After getting the front bumper off, I found that the bottom of the oil cooler is clean and dry-- not the issue. It looks as though the leak is coming from what they're calling the Trans oil cooler "tube assembly", as illustrated on the Hyundai Parts Department trans cooler page as item number 5, part number 2547126011. Am I correct in assuming that I'm going to have to remove the entire radiator to get to this thing to replace it? It appears to be fixed in place, but I can't see any hardware to remove it.
View 10 RepliesI have a 2007 Ford Explorer Sport Trac v-6. This truck has been the bane of my existence since I bought it back in September, but I finally fixed all of the issues I was having and it's been great. But, today I discovered that during the most recent work, the transmission cooler line ( Ford part # 7L2Z7890A) was left unsecured against the tensioner pulley. Needless to say, today a hole appeared that gushed tranny fluid everywhere.
I have two questions please- First, need to find the hose diameter so I can do a quick fix insert long enough to drive 1 hr. home? Second, I read online that there is a fluid fill point on the passenger side of the transmission case, is this correct and do I need to be aware of anything else to add enough fluid to safely drive the 80 miles home?
I haven't lost enough fluid that my driving is becoming sluggish and hesitant, but I can tell it is very low.
Transmission oil cooler line, lower one, is leaking. I think to use pvf, black ones, brake line instead of new transmission oil cooler line. I did replaced upper one with new transmission oil cooler line before a few years and it is rusty already as those line are only zinc plated as opposed to plastified brake lines.
View 12 RepliesHad a small leak on show up in my transmission cooler line at the radiator connection. After replacing the o-ring, which was pinched, I had lost some fluid up to about 3-4 oz. I had stopped by the local VW dealer and picked up a liter of ATF fluid and noticed the colors of the fluid differed from what drained out from the cooler line. Fluid that drained out was a cloudy darker green/grey and the new ATF fluid had a clear yellowish tint. Is this vehicle equipped with a closed loop cooling system or does it use the actual ATF fluid as the cooling medium?
View 2 RepliesAs explained in the photo annotations, I can't figure out how to remove this line from the radiator so I can remove the radiator for cleaning.
View 7 RepliesI've a 2000 Chevy Monte Carol, 110K miles, 3.4L. How to remove the transmission cooler line that connects to the radiator. Can't seem to break the bolt loose that screws into the radiator. Not sure whether this is a quick connect fitting or not! it definitely doesn't seems like it. Also having problems removing the fan shroud. It doesn't seem to want to come out. Should this be remove prior to removing the cooler line?
View 12 RepliesI bought a 2003 F250 7.3 Powerstroke from a buddy of mine with 99,500 miles. It is a former Michigan truck and has some significant rust issues. Oil pan and drivers door will need to be replaced in the not too distant future. And probably bed rails later too.
In any case, I noticed a puddle of tranny fluid on the driveway when I got home today. The passenger side line at the fitting into the bottom of the radiator has corroded through. The fitting into the radiator is pretty rusty, and the line fitting is darn near destroyed. The line itself actually has a hole in it.
I see the same part numbers on different sites with different descriptions. Driver side here, passenger side there, inlet here, outlet there. For the same number.
As near as I can tell, Dorman number 624-059 is the outlet line from the tranny to the passenger side radiator fitting, and should be the part I need. Correct? Dorman 624-058 seems to be the line from the OTA auxiliary cooler and back to the tranny. What I cant find is the line from driver side radiator to the OTA cooler. That fitting is corroded bad too, and I may as well do both of them.
So my 2000 f350 is leaking transmission fluid from the cooler line. It goes to the rear of the transmission, but where does it go to from there?
View 5 RepliesI have a 2008 Ford F250 V-10 Superduty and recently I had a transmission cooler line start to leak. I ordered replacement lines and the tool for the quick disconnect. The line that's leaking is from the radiator to the quick disconnect. I was able to replace the one line, however the second line (problem area) has been a nightmare. The line cracked right at the quick disconnect fitting.
The hard line is tight in the fitting and corroded. broke the tool trying to remove from disconnect. The line is flush with the quick disconnect. How to get that out of the fitting? or another method of fix? Its a hard 1/2 line going into connect crimped to rubber line going to transmission.
Have a 2007 V10 and I want to put in a Magnafine tranny filter. Instructions say to plumb it in to the return line. Which one is this, top or bottom?
View 11 RepliesLately I have been working a lot with my cold air intake. One of the vacuum lines keeps popping off. Today I got a check engine light and VSC and VSC off light. Is that due to the tough idle caused by the disconnected vacuum line. I erased the code and so far it has not returned.
View 1 RepliesWhat is the location of the Thermostat the for 2002 SC430. Any pictures and/or diagrams ....
View 1 RepliesWhat is the location of the Coolant Temperature Sensor? I search but I couldn't find a picture or diagram for our car.
View 2 RepliesReplacing the beeper for the lock/unlock? I'd like one not like every other car in the lot. I always look around when another car beeps. Is it located in a good (accessible) place like the horns?
View 1 RepliesWhere is the fuse located for our OEM radio head unit? I have no power coming in for the head unit and hopefully it's just a blown fuse!
View 1 RepliesThis line is rusted out on my V10 and leaking fluid.
How hard/expensive is this to fix?
I'm in the middle of doing my exhaust manifolds right now, so I'm hoping it's a simple bolt-on fix.
I live out in the sticks, and leaked out a lot of tranny fluid. the fill plug in the pan is rusted bad. can I add fluid using the cooler line and a pump? so i can drive it to the repair shop.
View 4 RepliesI picked up this 2004 Chevy Venture for my daughter and it has a power steering fluid leak coming out of the power steering cooler line that runs along the frame in front. I know that the procedure to replace this line calls for disconnecting the intermediate shaft of the steering and lowering the subframe to gain access to the line connections on the rack. My question is, is it possible to replace that line without lowering the subframe? I ordered the new line and it's on its way. I wanna do the job right.
View 3 RepliesI have 2002 F150 5.4L gas 4X4 Lariat FX4. Last winter when it got to -30C here in Manitoba one of the lines near the power steering cooler began to leak. I had just bought this truck and upon investigating found that the original line had been replaced and reattached with hose clamps. I had this "farmer fix" redone but then this winter when it hit -30C it blew apart. Obviously something happened to this line before I got it, so I am curious if there is an issue with these power steering cooler lines when it gets really cold. Should I just get factory lines installed and hope for the best?
View 3 RepliesThe oil cooler mounted above the oil filter on my 2002 Explorer 4.0L V6 has a major coolant leak on one of the external line/hose bib elbow. I've googled Explorer oil coolers and I've searched this forum with no luck. Can you bypass it without any problems mechanically or electronically (throwing error codes)? I have already purchased a new cooler and the lower oil cooler line. I'm just wondering if I should return the parts and bypass it. If I go through the replacement, I noticed the cooler is mounted by a pass through threaded tube with a hex head molded into it for fastening/loosening purposes. What size hex head socket it is?
View 12 Replies