Lexus RX 2010-15 :: Slip Indicator Is On And Flashing When Stop On Traffic Light
May 8, 2009
When stopping on traffic light, my Slip Indicator is on and flashing...
The Owner's Manual says: If the vehicle is in danger of slipping or rolling backward when starting on an incline, or if any of the drive wheels spins, the slip indicator light flashes to indicate that the VSC/TRAC systems are operating.
Luckily, it only happened once... otherwise, I'll roll back to the dealership in the very first day I picked up my car...
View 10 Replies
Advertisement
My RX350 2012/13 model AWD check system and slip indicator warning light are permanently ON on the dashboard. The car is driving normal. How to clear the indications because I am very uncomfortable with it.
View 1 Replies
I have a 2011 Corolla LE, about 58k miles. The latest work I did was replace the brake pads, rotate the tires and changed the oil a little over 2 weeks ago. Everything was normal so far. Yesterday I drove for about an hour, again everything was fine, but after stopping at a gas station and starting I have several indicator lights come on.
- Slip indicator, flashing
- TRAC OFF, constant
- ABS, flashing
- Electric power steering warning light, flashes but turns off after about 30 seconds.
I tried my OBD scanner with no luck, but figures since there was no Check Engine light.
View 1 Replies
2010 ES350... Was detailing interior of car, and didn't realize headlights were on. Eventually, battery drained and car would not start. Had OEM, original battery installed at the time. No dashboard lights lit prior to this.
From what I recall, shortly after replacing the battery and getting vehicle started, my slip indicator was solidly lit on dashboard. No other lights are illuminated, and vehicle appears to behave the same.
Fast forward to today, my OBD II scanner (Innova) does not pick up any current DTC's. There are readiness codes stored, but I understand that these are merely emmission related. However, there are historical codes stored which I am concerned may be possibly contributing to the dashboard light. The codes are P1604 and B2799. These appear to be related to the immobilizer system on my ES. I've tried to clear these codes, but they won't go away, so I suspect something is still tripping this. Keys are fine, just changed the FOB battery out a couple of times. I may try my second set of keys to see if it fixes this mess.
Since my OBD scanner doesn't support ABS, I'd like to see if AutoZone or something of the like can detect if there are any codes being thrown by the ABS system. Not sure if this is what is tripping the SLIP light.
View 4 Replies
So I noticed this has happened a few times.. If I press on the brake pedal too hard, the indicator light will come on and then turn off a few moments after I depress the brake pedal. This has happened when the car is stationary as well as when I was coming to a stop, it's happened maybe 5 times since I picked the car up a few weeks ago. Is this normal behavior or an indication of a problem? Just an FYI, I'm not talking about when the indicators light up when first starting the car.. This is tied strictly to pressing the brake pedal hard.
View 8 Replies
2010 Prius V owner as of last week. All has been going well and got into the car this morning and all of the above noted lights are on at start-up and stay on as I drive. Have made appointment with the dealer but they cannot get me in until late next week. I did make a short drive this morning and all seemed fine with handling and braking. Searched a few threads here and answers are very varied and none that I saw had all of above lights on. I don't think that it is the Hill Start Assist. Safe to drive until we can get into the dealership?
View 14 Replies
GX470 2007-31K. Today was stopped on a hill, when loose brake and I pressed the accelerator starts to sound a noise of hits by the area of the pedals and pull the slip light starts to Flash and until not for flashing the car does not accelerate.
View 7 Replies
All of a sudden while I was driving the Tpm light came on flashing for a while and then it went "On" solid on my Rx350 2013. It does that every time I use my car now. Tire pressure is fine on all 4 wheels, tried a reset but nothing happened.(hidden button).
View 14 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
2007 3GS 350 awd.
While I'm driving my car ( at a rolling speed 5mph-20mph) I get a clicking sound from front driver side when I hit a small bump, stop, and stop and go at a traffic light. Mainly clicking noise when I hit bumps, but when traveling at highway speeds and I hit a bump I do not hear the clicking noise. ITS VERY ANNOYING, and I have never heard this noise after the brutal snow we just got here in MA. Also I should add, I am currently on BC Racing BR type coil overs which I bought brand new and installed in October. Its not clunking like ball joints, or banging like a blown strut mount.
My question; Where to start? Something needs lubrication?
View 9 Replies
I recently purchased a used GS350 AWD.After purchasing it, I replaced all of the wheel bearing hub assemblies. The rear ones were grinding, and I decided to just do all 4 at the same time.
After swapping the hub assemblies, the slip indicator light comes on when I go 55+ mph. It's usually when I push on the accelerator. It's not always on. It goes on, then turns off for a while. Sometimes when accelerating it doesn't come on at all. When the light turns on, I loose power for a few seconds but I don't hear or feel any braking.
I have tried an alignment, reset the YAW sensor, etc. The mechanic had a very expensive snap on diagnostic computer and he said everything seems to check out. The steering angle is good, acceleration looks good.
I'm thinking that either one of the hub assemblies has a slight defect that affects the ABS sensors, my VSC computer needs replacing, or YAW sensor starting to go bad.
View 3 Replies
My car, a 2014 Prius TWO, was towed and recovered, but now the slip indicator light is always on (also the steering wheel is way out of alignment). Driving home, the car felt perfectly fine, except for the steering wheel being at a weird angle. What's going on? Can I get this fixed at a mechanic when they fix the wheel alignment, or do I have to take this in to a dealership?
View 6 Replies
I have been very happy with Prius 2012 I got in February. But I have started noticing that the slip indicator light turns on briefly when I start the car. Is it something I need to worry about? It does go off in a second or two.
View 4 Replies
My 2011 Camry LE 4-cyl has 48k miles. Today I was driving on the highway during very heavy rain. My vehicle slip indicator light came on, along with my check engine light. I stopped at Advanced Auto for a diagnostic check. They said they couldn't be sure if it was a sensor, or maybe a wiring issue.
View 3 Replies
I had my oil and air filter changed and tires rotated yesterday. within an hour of driving time my slip indicator light and check engine light are on! What the problem is?
View 3 Replies
Refilled the wiper fluid on my fiance's 2011 Camry LE today and low and behold the ABS + Slip Indicator lights came on in the dash next time she started the car.
No codes are throwing from the ECU and it drives fine. Only thing I can think to do is Drive it full tilt and see if I lose the back end and/or try braking aggressively from 40+ mph. Just to see if the ABS/Trac Control systems are hosed. Don't want to go to the dealer to have them try the same thing and me pay for it...
View 2 Replies
Anyways, I was driving to school today. Going about 45mph on on off ramp that curves slightly when my Slip indicator light turned on and blinked maybe 10 times or so. I'm taking it to the shop tomorrow as the manual suggest. My car only has 7,500 miles.
View 8 Replies
I have a 2013 GS350 F-Sport. Every so often (maybe once every other week), I'll observe the VSC indicator appear after I slow down to a complete stop, such as at a traffic light. The indicator light remains on while I'm stopped. Once the traffic light turns green and I take my foot from the brake pedal to the accelerator, the car hesitates for a moment, as if trying to figure out how to gain traction, but I then get going, and the VSC light disappears and that's the end of it (usually until it happens again a few days or a couple weeks later). Whenever this happens, the road is flat and dry, so traction should be normal and no problem.
The only other piece of information that might be relevant is that I now believe I can reproduce similar behavior: if I'm at a traffic light, or even just parked, and I simply step down hard on the brake pedal, I observe that the VSC indicator light appears. Perhaps this is simply what is happening in the instances I have observed this when stopping at a traffic light. Still, I don't understand why pressing down on the brake pedal with a little extra pressure when parked would cause the VSC light to appear. Is this normal behavior? Only the VSC light appears in these instances, no other indicators or warnings appear.
View 7 Replies
My Prius touring had 4 205/55/16 tires. I had the mechanic change the front two tires to 205/50/16 and now, whenever I drive over 60mph, the slip indicator light flashes continuously. When I slow down, it goes away.
Is it because the front and rear tires are mismatched? If so, I'll have the mechanic change the rear to 205/50/16 as well.
View 16 Replies
I have a 2007 prius and when I pass 30 miles per hr the slip indicator light start blinking and a beeping sound. What is going on and I have a vsc light on too
View 4 Replies
I just have my 2013 Prius C3 for two months and few days back I noticed that the Slip Indicator light blink a few time when I went through pot hole/uneven road (low speed, ~20mph). In the same time, I can hear as if there is a piece of metal sheet somewhere in the car vibrated. Is this normal?
View 10 Replies
