Lexus RX 2010-15 :: Rubber / Felt Window Molding Pops Out On RX350
Jul 14, 2014
Our new (got April 2014) RX350 seems to have an issue with the rubber/felt window molding getting caught between the glass and metal incorrectly. "Pinched".
View 1 Replies
Advertisement
I have noticed that the rubber window moldings around both front doors is deteriorating. Both are torn and falling apart. There is no wind noise yet but they need to be replaced.
View 2 Replies
The rubber molding at the bottom of my wife's driver's window (2007 Prius) has separated. Is replacing this molding a DIY job or do I need to pay the dealer? If I can do it myself, are there any tips for removing the old molding & installing the new?
View 5 Replies
I would like to remove the chrome window molding around the front and rear doors of my 2010 Camry. Is it difficult to remove? More importantly, when I go to reinstall it - is it difficult to get straight like OEM fit and finish?
View 3 Replies
Twice now I have taken my 2011 Avalon to a drive-thru car wash and had the roof molding pop out of the channel. The first time I had this problem was when I went to a car wash that had large roller brushes that contact the vehicle. When I exited the car wash I saw that the driver's side roof molding had popped out. It was a quick fix to just pop it back in but of course the concern is that it could come all the ways out and be lost either on the road or in the wash bay.
So, for the next wash I took it to a "touchless" wash and when I pulled out the bay I saw that the passenger's side roof molding had popped out of its channel. So, I am guessing that since there are no brushes contacting the car that it is either the power of the blow dryer or the power of the water spray or a combination of all the above that is causing them to pop out.
View 2 Replies
The door molding has come loose at the front corners of both my doors on my 2002 S-10 pickup. I tried weldwood contact cement (the kind you use on laminating Formica counter tops), but it only lasted a couple of days. I put a spot of super glue on it to see if that might work. It looks promising but that little spot that I tried was not enough surface area to hold it for more than a day. I don't want to ruin the trim by super gluing the whole thing if it won't work. How to do this? The trim seems fine otherwise. It is not cracking or anything like that. I think super glue would hold it if I glued the entire length of about a foot or so. Also the driver side door seems to be a bit out of line an eighth of inch or so at the front corner. It does not appear to be adjustable. It has never been in an accident. It does not seem to be leaking into the cab yet with the door closed.
View 2 Replies
I recently discovered that my lower side molding on my front passenger side door was loose while cleaning away some of the salt stains from the winter storm . how to fix it or do I need a replacement.
View 11 Replies
I read through all the discussions on this topic scattered across a number of threads, and finally pulled the trigger. Just wanted to share the simple steps I took and some pictures.
The overriding conclusion is: it is easy; you can do it without drilling holes!
OK, let's start with a few photos of the parts. Note the "infamous" clips and double-sided tapes in the third picture.
View 12 Replies
My GX pops up message to require service, the car just on 14,500 miles. I checked one dealer website, the service does not even include oil change. So the question is what service should I do for 15k?
View 14 Replies
Long story short, the tint shop burned my exterior door pillar when I got it tinted like 8 months ago. Just now felt like dealing with it, so I got the new part in. How to replace it? The back has a lot of what looks like double sided tape and only 1 clip. In order to get the other one off it looks like I have to take off the chrome strip at the bottom since the black molding goes underneath the chrome...
Pic of how the molding is on the car ....
Pic of the back of the new one ....
View 8 Replies
I find it a little concerning that I can actually drive off in our RX350 without the key fob in it. I know there is a warning on the dash, but that doesn't stop someone from stealing it. May be a park lock out would be a better solution.
View 14 Replies
Looking for a new luxury SUV - had a 2001 RX-300 and put 230,000 miles on it and gave it to my daughter. The local Lexus dealer seems to have only AWD models and is not real useful in getting a FWD stripper (don't want nav, etc.) The local Acura dealer has several base MDX's in FWD and seems more useful. Drove both AWD versions and thought the Acura was much better handler and better road feel. Am leaning towards Acura but don't know about service costs and long term reliability - we will keep either car for 12 years probably. What say you? Doesn't seem to be a decent Acura MDX forum out there.
View 14 Replies
A C-note for those 2 pieces of nothing seems ridiculous. Considering sanding and painting instead.
View 2 Replies
I'd like to mount my passport 9500ix neatly in my new RX (CPO 2011)... I use a Blendmount and Mirrortap in my C6 Corvette, but I can't find a similar solution for the RX. Who has a Radar Detector mounted to the mirror in the RX
View 5 Replies
I have HID low beams and Halogen high beams on my 2015 RX 350. I'd like to set the HID low beams just a touch higher. The manual shows where the adjustment screws are located, but does not indicate which way (clockwise or counter-clockwise) to turn the screw to raise the position of the headlight. Yes I could just start turning one way or the other to figure it out...
View 14 Replies
While doing regular checkup on my car, I noticed that both radiator fans (left and right) are on when the engine is on even though the A/C is not running. Is this normal? Is this a minor issue that needs to be resolved? No faults on the dashboard btw.
View 11 Replies
I noticed it in my 2014 RX last weekend. I've only had it for a month!
View 1 Replies
2015 Rx350 AWD 7200 miles. Transmission started leaking.
View 4 Replies
I heard noises like a small pump noise and a hissing air sound above the muffler area. The car had been sitting for hours and no key fob close to it. I was climbing under it looking at something else when I heard it. Sounds like a tiny electric motor running with an air hiss. Passenger side. Just bought the vehicle last week. It has 27k miles on it. Had to replace battery the other day. Said battery was replaced a year ago. Wonder if this is hurting the battery? Start great in the morning. Vapor fuel pump?
View 4 Replies
I purchased a used 2012 RX 350 with 35K miles a month ago and just realized that when I come to a stop, the idle is pretty rough (or loud?). I also noticed that it's definitely rougher when the AC is on. As soon as I take my foot of the break and press the gas, the "roughness" goes away..
View 10 Replies
We have a 2010 RX 350 and have had it for about 5 months. Recently, we noticed that when we stop we hear one beep and then when we put it into park, we get two beeps. It has just started doing this ..
View 3 Replies