My less than 7000 miles RX started making noise when I pushed the brake pedal. Evidently it sounded like the "LS brake squawk" according to service foreman. Not sure if the actuator is same in all RXs.
View 3 RepliesLately, when first starting my car and after it’s been sitting for a while the gas pedal seems to be stuck.
When I push on it slightly it doesn’t move; but if I push a little harder it will make a noise and become free and movable. No further problems until it sits for a while or the next morning. Then the same stuck pedal. Exert a little pressure and it frees up.
I tried squirting WD40 on the linkage but it does no good. What could cause it to bind up? 2001 Mazda Protege LX 2.0 ....
I want to replace the center brake light in my 2010 RX450h. Any step-by-step instructions on how to do this?
View 2 RepliesI traded my 2007 Prius for the 2010 III Prius on 5/30. I had 5 wonderful days with it and on the 6th day, it started.
There is a loud creaking noise when the brake pedal is pushed and released.
The dealership contacted Toyota and did everything that was suggested to correct the problem and no luck.
I brought our 2010 Rx450h to the dealership several months ago due to an occasional clicking noise in the upper steering column, behind the steering wheel area. The repetitive clicking was most noticeable at slower speeds while turning the steering wheel.
The dealership had the car for about 3 days saying it was a loose cable and then told me when I picked up the car, that sound was the way it was supposed to be, part of the electric assist steering. So the clicking noise continued.
Now the steering is getting stiffer. Some days much stiffer. This happens more when turning the wheel slowly.
My new GX460 has 120 miles now, and starting today, I heard noise when pushing the brake pedal. After get the parking lot, I turned off engine, and used hand to push the brake pedal, I can hear same noise, which like a air or gas squeeze out. Seems not big deal to me, just like to see do you GX460 owner have similar thing or I need to to dealer again.
View 8 RepliesOur 2013 RX350 has a brake pedal that makes a pretty loud noise when it snaps back after you depress it a little harder and take your foot off. I complained to my SA, and they told me it's normal. It's not a big deal, but any other car I have owned, I have never noticed such a thing.
View 12 RepliesWe purchased the vehicle (2013 GX460) in September 2012, and had the car for 6 weeks before my wife was hit by an oncoming car who missed a stop sign. 8 weeks later and 23k of repairable damage to driver fender, front bumper, grille, hood, frame, and all components within those major areas, we received our vehicle.
The vehicle is wonderful and a joy to drive. When the brake pedal is depressed at low speeds (i.e., maneuvering in parking lot, entering driveway), there is a slight vibration to the pedal (similar to the vibration from a cell phone) and a noise that suggests an electric motor is working. The vibration is not like ABS; ABS is a profound vibration. The vibration we experience is very slight. The vibration is not apparent at highway speeds.
I do not recall either the vibration or the noise prior to the accident, and I suspect that this is a result from the accident or from the repairs. I have already brought the GX back to the dealer for this problem and they were quick to dismiss it, but I am really concerned that this is a real problem, and I want the dealer to re-assess.
My father purchased the 2015 GX460 this past January and the car currently has 4,500 miles. The first complementary oil change was completed in July. I feel that the brake of his GX460 is not sensitive enough, and I have to step on the brake very hard to feel the truck stopping. Does every GX460 owner feel the same way? I told my father about this, and he said I'm just not used to it. I'm thinking about taking his truck back to Lexus to check it out.
The dashboard so far doesn't indicate any ABS problem. By the way, I'm an owner of a 2014 IS350 F-Sports, and my 350's brakes are much better in my opinion. I'm not sure whether my experience of my 350, which has larger brake calipers for its size, has influenced me to draw such conclusion about the GX460 brakes.
Also, I notice that when I step on/release the GX460 pedals, I hear some noise that sounds like air. Did some research about this on the forum, and some of you have that too. I still don't understand this issue.
I got into our car (2013 RX 450h) and the seat was completely pushed back. I had been the last (and only ) driver of our car and had not adjusted the seat. I managed to reach the brake pedal, started the car, pushed the L1 seating position and my seat re-adjusted. I then put the car into Drive and when I stepped on the accelerator, it would not move.
The parking brake was not on, there was nothing obstructing the car. I turned it off, turned it on again and it was then fine. I had last driven it 3 days prior, the battery was fine, the outside temperature was registered as 30 degrees, so not excessively cold. We park in a garage although it is not entirely closed off from the outside air.
Experienced this with the car no moving despite being in drive and stepping on accelerator?
Is it all the lexus rx350 had that noise? From the day I noticed hissing noise when I gentally press the brake pedal down and release it . And same noise can be heard when drive slowly and release gas pedal.
View 10 RepliesBut when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 RepliesLately my cars been shaking pretty bad and making a thumping noise when i have the brake pedal about halfway down. Doesn't seem good. What it could be? also it makes a pretty loud whining type noise when the cars on think its a pulley or water pump but not too sure.
View 3 RepliesA mechanic recently replaced the pads of the front brakes. After the service, the break makes squeaking noise when I release the break pedal. According to the mechanic, it is normal, and I better ignore the noise. Is it true?
View 1 RepliesMy brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
Ok so I have done a complete brake overhaul with rebuilt calipers, new pads and rotors and a new master cylinder. Brakes stop on a dime and are solid when pressed firmly. When coming to a stop at a slow speed (5 mph) pedal gives in with slight clicking grinding noise. I have exhausted searches on google and here with no soild answers any clue what causes this or how to fix it?
View 24 RepliesIs it normal on the 2.0T that when you are driving and stop at a red light to get vibration that you can feel in the car and hear in the motor? As soon as you let off the break it stops and the engine stops the noise. I don't drive the car enough really (my wifes) to know if it is normal or if this just started. It is an 07 and just turned 12k on the weekend trip. Also, having a problem on Sat radio with there being a high pitch hum in the back ground? [IMG] [URL] ...
View 13 RepliesI noticed this strange behavior this afternoon on my SantaFe DM. Every time I press the break pedal, the front position lights turn on during daylight. Light switch is set on Auto.
View 2 RepliesLet me tell you a story ‘bout my daughter’s 2008 Chrysler Sebring 2.4L…
We have owned the car since 2009. Recently the car has begun to start intermittently. Generally it starts normally. Other times it won’t. It can be driven for a month with no problem and then BAM! It won’t start. No dead battery sound, no clicking, no starter trying to engage NUTT’N!
AND… the brake pedal is firm! The brake pedal is firm and cannot be pushed down!
The car has been to the Dodge dealer several times. They have replaced the starter because a couple of teeth were missing, flashed the computer and replaced the alternator. The car started fine for a few days and then wouldn’t start again.
The Dodge boys kept the car for a week and of course, it started fine while they had it. One of the service managers told me to pull out a certain fuse to reset the computer. They also told me that they usually see these types of problems if the car was jump started wrong (the jumper cables were hooked up backwards I guess).
Just wondering if there is any difference between the RX350 and RX450h wheels. Given that the RX450h is a hybrid, the wheels should be lighter for better fuel performance.
View 1 Replies