Lexus RX 2010-15 :: How To Replace Bulb On RX350 Headlight
Nov 17, 2015
How to change out 2015 RX350 headlight bulb? How to replace the bulb on the 2015 RX?
View 12 RepliesHow to change out 2015 RX350 headlight bulb? How to replace the bulb on the 2015 RX?
View 12 RepliesReplacing license plate bulb on a 3rd gen rx? I tried taking off the interior lining on the rear hatch but no luck. There's access covers for taillight & reverse, but none for license plate light. I also tried "popping" out the plate light cover right above the license plate... don't think they are designed to be popped out.
View 3 RepliesI am trying to adjust the vertical (up) AFS headlight aim on my 2010 RX 350. They currently point too low and do not illuminate the roads well enough at night. Note that the vehicle has the AFS HID headlights that are located next to the front grill.
The owner's manual provides do-it-yourself (DIY) instructions. Electronic version may be linked here: [URL] .....
I found adjustment bolt A elsewhere. Adjustment bolt B was found as illustrated.
Following these instructions on p. 512, I have tried adjusting the two silver bolts for the left and right AFS headlights by manually turning each pair of bolts on both sides with my fingers rather than a Phillips screwdriver, but no effort appears to affect the AFS headlight aim either vertically or horizontally.
The instructions also recommend taking the vehicle into the dealer if the headlights cannot be adjusted this way.
I finally purchased an RX30 for my wife. The Halogen headlight isn't all that bad, but I am used to drive with HID. Therefore, I am buying HID kits for my RX350 Headlight. Whenever it is shipped to me, I will take pictures of the progress.
1/ Link to buy HID kits, OEM is 55W (no need for extra Hardnes) and 6000k is common factory color.
This will come with everything needed to convert your light bulbs into HID white colors. For more Colors please check out the guide on the website.
I recommend this site, because I have used it, purchased it, and have had no problem with it so far.
2/ According to Manual Book
****Low Beam is H11****
Fog Lights is *****H11*****
****High Beam is H9*****
**** 55W *****
3/ The installation should be Relatively Easy
--Take off engine plastic cover on both side--
--Access the Light Bulb--
--Use the OEM Plugs into the Ballasts input of the HID KID--
--Mount the Ballasts at a convenience locations, I had great success with Plastic ties--
--There is a Plugs output from the Ballast, Plug it into the HID Bulbs--
*****If the lights don't turn on after installation, try to switch Polary, or turn the original plugs around
****** Halogen doesn't care about Polary, but HID Ballast does.
--Install the HID Bulbs the same as regular Halogen Bulb--
--Check the HID carefully, make sure that both will work--
First time Installer common trouble shoots.
1/ Only 1 light is working......Switching the bulbs, or Polary will solve your problem
2/ Lights common for a short time then turn off, until engine restart......You will need the Hardness Relay, which should not occur in our car. The factory hardness is good for 55W
3/ Bulb Visually contain Contaminants, or White particle inside.......HID Bulbs has Special Salt in it, which is required for a longer life in the Bulbs. This is the way the bulbs are.
Where can I buy the bulb and what is the model number/size of the bulb? My headlines aren't customized or fancy. It's regular. I need to replace the right/passenger side. And how do you replace it? I'd like to save money. I read somewhere that micro clamps are necessary (for 2003 model at least) because it's hard to get in or out? If there's a DIY tutorial with pictures, that'd be great... I drive a 99 1.8 Passat...
View 3 RepliesI have searched high and low, and I cannot find how to replace the factory low beam projector style headlight bulb on my wife's 2013 Tiguan SEL. It came with the factory LED style HID lights. There were a ton of videos and how to's for the regular Tiguan headlight replacement, and for aftermarket Ebay LED ones, but I can find anything about how to replace the factory low beam projector bulb, other than "take it to a dealer". My thinking is 'if the dealer can do it, so can I'! There has got to be a way. I can't get the wire bulb retainer loose, or get the bulb out of the headlight housing.
View 2 RepliesLooking for instructions on how to replace the LS460's low beam HID bulb ?? its quite crowded around the headlight ...
View 3 RepliesHow to replace low beam bulbs? all info i found was talk about whether they were covered under warranty or not? I got extended maintenance warranty to 100k miles, but bulbs, I don't think so. I just noticed today that both were out on low beam, high beam are fine. Should I take car to dealer? or is this something I can do myself?
View 3 RepliesI have had 5 bulbs burnout in 2 months. I'm not touching the bulb and I am using grease. I've tried the higher end sylvania bulbs and they still don't last. What might be causing this?
View 12 RepliesI have seen many mods to headlights in the 2012 Prius, many of them have upgraded to HIDS and what not. My question is the little bulb in the top of the headlight housing i see is like a blue or LED color, yet i cannot find anything about them anywhere. Love the look and would match my HID kit once i get installed this weekend......
View 19 RepliesLooking for instruction on how to change the headlight bulb?
View 14 RepliesAbout a month ago I replaced both of the main headlights in my Gen 3. I've noticed since that the light from both seemed a little skewed and thought maybe I didn't lock them back in fully. i finally checked them today and was able to get the left side light straightened out, but when I went to check the right hand (passenger) side one (which isn't working again), i realized that it must have come out.
Essentially the light bulb is shattered/exploded and it melted part of the cable next to it, and is now stuck to that cable. Besides being partially melted, the cable also has some exposed wires. i don't know what those wires do, but I can't imagine it's a good thing to leave it exposed next to a live circuit from the headlight.
See the attached picture. What that cable is that melted and if it's possible to replace it myself, or do I need to take it in?
One of my headlight is burned out and I would like to replace. I don't want to go with OEM. Looking something better and brighter. 2008 GX....
View 1 RepliesOne of the small bulbs in the corner of the headlight assembly is burned out. does any one know how to replace it?
View 1 RepliesRecently my 05 RX330 had the driver side low beam bulb go out. I took it to a few places and they said take it to the dealership as they have special tools to change it. Of course I took it there and they were ready to charge me an arm and a leg to get 1 little bulb replaced. My question is do you have recommendations as to what I should do to get this fixed and not have my wallet get destroyed?
View 8 RepliesAbout 3 weeks ago i have noticed that the right headlight doesn't work. I assumed its the bulb and bought a set from kbcarstuff. Installed them today and it still doesn't work. I tried to swap the bulbs and non of them worked in the right headlight and all of them worked fine in the left one. I assumed it is a fuse and went to check it out(number 80 and 81 fuses, 15A are all sweet). Is it the ballast or something also?
View 6 RepliesMy driver's side bulb at times will just go completely off. Is it the bulb or the ballast shooting craps?
View 7 RepliesMy driver's side headlight bulb started malfunctioning.
Here's the situation so far: Whenever I turned my headlights on, the driver's side bulb would turn off after 5 minutes.
Replaced both bulbs
Drivers side bulb stayed on for about 20 - 25 minutes at first then started going off after just a few minutes
Replaced ballast (new) on drivers side but same results as above where light stayed on for about 20 - 25 minutes at first then going off again after a few minutes. Each time light stayed on for a shorter period of time
Bought 2 more bulbs and replaced both again in case first set was bad. Same thing still happens and bulb tends to flicker at times.
I am at a loss as to why the drivers side light will not stay on after changing the ballast and the bulbs twice. Also, I've noticed that the drivers side bulb is noticeably dimmer than the passenger side bulb even though both bulbs are brand new.
What the problem might be? I'm at a loss now and not sure what to do next.
I find it a little concerning that I can actually drive off in our RX350 without the key fob in it. I know there is a warning on the dash, but that doesn't stop someone from stealing it. May be a park lock out would be a better solution.
View 14 RepliesLooking for a new luxury SUV - had a 2001 RX-300 and put 230,000 miles on it and gave it to my daughter. The local Lexus dealer seems to have only AWD models and is not real useful in getting a FWD stripper (don't want nav, etc.) The local Acura dealer has several base MDX's in FWD and seems more useful. Drove both AWD versions and thought the Acura was much better handler and better road feel. Am leaning towards Acura but don't know about service costs and long term reliability - we will keep either car for 12 years probably. What say you? Doesn't seem to be a decent Acura MDX forum out there.
View 14 RepliesI'd like to mount my passport 9500ix neatly in my new RX (CPO 2011)... I use a Blendmount and Mirrortap in my C6 Corvette, but I can't find a similar solution for the RX. Who has a Radar Detector mounted to the mirror in the RX
View 5 Replies