Lexus RX 2010-15 :: How To Remove Front Bumper
Mar 6, 2013
I was hoping there were instructions on how to remove the 2010 RX350 front bumper cover somewhere? We had a little fender-bender, and I was planning on trying to replace some of the items myself. I'm handy, but always prefer instructions over trial/error!
View 6 Replies
Advertisement
I have took off the screws in below pictures. But the bumper seems still stick on the car body. Any screws are missing? Or other issue?
View 4 Replies
As owner of the Phaeton diesel v6, 3.0D... I need to remove the bumper in order to have full access to the headlight unit.
View 4 Replies
Just got the 2010 and put 100 miles on it and found the front bumper loose on the passenger side. Difficult to see but it looked loose right by the headlight housing, a little pull and it popped up. Looked like the fastener was never there.
View 14 Replies
I need to replace the center mesh grill on the front bumper. Is there anything I need to be careful with or watch out for. when I pull on the old grill or when I push the new one back into place? Does it come out easily or is it tricky?
View 4 Replies
I have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 Replies
I studied various email threads about replacing the internal light bulbs with led and I was able to replace all but the front dome light (not yet attempted rear dome). When I tried removing the front dome panel using a credit card I couldn't insert it. On the side toward the sunroof there is enough room to insert the credit card but it has only one tab. The other sides are so tight that I couldn't get the credit card in.
View 8 Replies
So I washed my car today.. was wiping it a little and noticed that the right side of front bumper was loose.. then a closer inspection showed that I can lift it! I didn't collide into anything whatsoever, maybe from speed bumps or potholes?
Image Uploaded .....
View 22 Replies
The front bumper on my L is a bit loose. It looks like there's suppose to be a clip there that may have broke off. What this part is? I'm assuming I have to take the entire bumper off to fix it?
View 7 Replies
What sensors are in the front bumper? I slid out on black ice into a snow bank and it crushed in the bottom grille and as I'm clearing out the snow I noticed a sensor dangling with a broken harness that I was wondering what it was for. I have a nonFsport bumper with LED fog lights and both fog lights are operational.
Drivers side close to the fog lights
View 5 Replies
I bought the car from dealer, there are now FOUR! holes on the front bumper. I don't understand why they couldn't just use the existing holes to put the license plate holder. Now I'm stuck with these holes and I'm looking for a cheap alternative to fill them. I like the clean look of the front end without the plates and don't want to spend a fortune at a body shop, but I also don't want 4 dots either. What I can do/use?
View 3 Replies
I have a Matrix XR 2010 with front bumper sporty look . I like to change the front bumper to regular bumper and the reason is that for the last two winter seasons I have broken the spoilers and basically wreck the bumper.
View 2 Replies
Wondered if others have had a problem with spots of paint peeling off front bumper? Bought car new and have 42,000 miles, rest of paint is in great shape. It is not terrible, but like keeping car nice, would be nice if covered under warranty. Been this way for awhile, maybe should have taken it in, haven't even mentioned it to Hyundai.
View 5 Replies
My front bumper has its paint peeling off very fast, I could get whole bumper painted but is there anything that I can do at home ...
Attaching pictures ...
View 8 Replies
Replacing bumper cover, is there anything I would need to replace underneath it or is it just a simple swap out?
View 4 Replies
Replace the front bumber cover on gx? Mine has a crack and I can get another one but wasn't sure how difficult it would be to swap it out, I guess the toughest part would seem to be the fog lights.
View 6 Replies
How the black trim on the bottom of the front bumper of a 2011 Elantra GLS is removed . I am talking about the black lip or air dam in the center. Does it just pull off or are there clips or something.
View 1 Replies
So my gf parked at the mall and when she pulled out the front bumper got stuck on the parking divider and came off on the left side. One of the fastening holes appears to be torn and it appears the bumper just needs to be put back in place.
View 8 Replies
Dealer did repair work on front bumper. Now, after reinstalling a new front bumper, I noticed water starting to form inside the fog light assembly after it has rained. Dealer says this is normal due to our tropical weather. This has never happened prior to the repair work that was done.
View 12 Replies
So I've seen a lot of people on here wrapping the mid section of the front bumper black to give it a more aggressive look.
For those that have done this, will I need to cut a hole for the sensors or will the sensors still work with the wrap covering them?
View 9 Replies
I had a low impact accident with my 2010 LS460 where the body shop replaced the bumper cover, collision cushion behind the bumper and a new grill. Below are the picture from their finished work, however I know my car should look better than this. What could be wrong/missing to cause the grill and bumper to not align correctly with my car?
View 7 Replies