I have a 2015 RX350 with 25k. New tires, two road force balance by two different dealers and I'm still getting a high frequency vibration mostly in the seats above 60mph. Dealer cannot find any issues.
View 6 RepliesMy Prius v has 1300 miles. I didn't notice at first but now I notice a constant high frequency vibration in the car, especially at highway speeds. Took car to a tire shop and had tires dynamically balanced, same problem. I think it must be the toyo low profile tires or its in the drive train and just inherent to the hybrid system. Seems to be the same whether in eco mode or ev. Vibration is the same on smooth or rough roads. Dealer service manager says he is not aware of any problems. Suggests bring car in for a test drive and compare with another new one.
View 7 RepliesAfter driving for 30 minutes on the freeway, my Sonoma develops a high freq vibration that seems to increase after it starts. lessens a little as I slow, but does not go away until after the car has been parked for a while, but not as noticeable under about 30.. I have experienced this the last three days on my commute to and from work. Did have the breaks checked. I did have a clunk sound when i released the brakes at a stop, but that went away after the first brake check where they did not find anything, but just cleaned out the dust and readjusted. The vibe is pretty strong and makes me nervous to drive.
View 2 RepliesJust got my 2014 SCREW 6.5bed with eco boost. Truck has a high frequency vibration very noticeable at 45-55 MPH. So bad the rear view mirror is blurry. Took it to the dealer and they said the e-brake was dragging and fixed that and said the vibration was gone. Not gone. Did some searches and found a number people reporting vibration issues possibly related to drive shaft issues.
Took this video of the slip yoke at the T-case idling in first gear, sent it to the dealer and they said that's normal. I don't think that looks normal. Does that looks normal?
Slip Yoke at T-Case ...
2014 Camry, 4 cyl. 65K ... Wife's car has developed a vibration that is going to be hard to get a dealership service group to troubleshoot due to randomness. I drove it for 30-45 mins today and have this description:
-Vibration, either described as a 'buzz' or a 'high frequency vibration'
-Happens in the 28-38mph range (different points)
-Under very slight acceleration. (hard acceleration efforts produce nothing)
-Can't swear to it, but feel like it is always in 'high' gear
-feel it in 'seat of pants', NOT through the steering wheel
-Is faint on sound, but you can hear something
-Is typically only a second or two
-Is very hard to 'create', but then happens unexpectedly.
-My wife first reported it to me, and I took my son on the test drive today and he could feel it as well when it hit, but couldn't pinpoint it as it comes and goes so quickly, but again, you feel it in the seat/butt more than anywhere else.
I've checked lug nuts to try to eliminate something easy and they are fine.
Since it is relatively slow speeds and under very slight acceleration, can there be a 'solenoid' that is creating a false shift effort, but just vibrates the trans instead? Without any info other than what I have stated above, I'm leaning toward transmission, but again, probably not enough info to go on....
This has been happening for the past 6 months or so. I recently had new ball joints, 4 wheel alignment, and 4 wheel balance. Even with this I'm noticing a very slight high frequency vibration at highway speeds. I noticed on one of the front wheels that a weight fell off, so this might explain the high speed vibration.
However - When I'm starting at 0mph, and accelerate to say 50mph for example, the car vibrates rather substantially as the speedometer moves from around 25mph to just past 30mph. After those speeds it goes away.
I've also noticed that it tends to be worse if I'm going up hill, which, according to the laws of physics, would tell me that going uphill would put more pressure on the front end, given it's heavier with the engine there. If I'm going downhill it vibrates much less.
When I drive I tend to not accelerate quickly, meaning, I don't 'punch' it, and accelerate gradually instead. If I'm driving on a level, well-paved road, and accelerate quicker than regular, the vibration seems to not be as heavy.
Any other tests for this? Struts, control arm, steering knuckle, drive shaft ?
So I'm at my wits end trying to locate (and fix) a loud, high frequency rattle noise inside the engine compartment.
It can be heard when applying the gas pedal a certain amount. In other words, I can "find" the noise and maintain it at a certain rpm.
The noise is coming from the back of the engine near the firewall. It feels and sounds like it's coming from the throttle body plate and vibrating the gas pedal. I cleaned the plate and it isn't loose.
The issue doesn't seem to be affecting engine performance.
The sound is noticeable while driving (under load). When in park, I can find an rpm where the throttle body seems to take a heavy wave of vibration from the engine and hum (but not nearly as loud as while driving). Issue existed before I put on new motor mounts, and still persists after replacing all 4 (although the vibration and noise are reduced).
2010 RX 350 NAP ... Brand New and OEM where it would apply : Tires (Conti's LX20s)
Brakes / Rotors (had same shake before replacing and did not improve after replacement but maybe I am dealing with a bad caliper here)
Tie Rod Ends
Stab Links
Lower Control Arm Ball Joint
None of which have solved a vibration issue thus far. Strut feels solid and the corner push test had the car settle out in less than 2 bounces.
If car has sat a while the driver front (where the issue lies) feels like a imbalanced tire/bent rim (rotated the wheels just to be sure it didn't follow the wheel/tire) or like a broken belt. The tires are almost brand new and only put them on because I was trying to eliminate the point of issue.
When braking, a light touch to the brake pedal makes a almost light clank sound (like weight shift is causing the clank or perhaps a sign of a bad caliper (although pad wear looks even but didn't have rotors rechecked but even with brand new rotors it was there so I don't feel it's a warped rotor plus the vibration is there even when not applying the brakes.
There is only one control arm and the bushing didn't look cracked beyond the normal surface cracking I have seen on most rubber bushing. The upper support is from the strut so perhaps a bad strut or maybe strut support/cap/bearing?
At a total loss as the local garages cannot find anything wrong. My thought was a bad wheel bearing, although there is not any grinding sound that you typically hear when a hub is going bad.
Could also be the CV Joint but not sure how to tell if that really issue the issue unless I replace all the other parts first (hub, caliper, strut/support/bearing).
My Prius just reached 200000 km this week. I bought it at 180000 km 2 years ago, I don't drive it that much simply because I work from home.
Today, a sunny day, 0 degrees, the check engine just lit-up. I opened the hood and checked fluid levels, all OK. I started it and listened to the engine, running as usual. However, when the motor stopped (hybrid ON), I can hear a high frequency noise. I don't remember hearing this noise, but I don't think I ever opened the hood with the engine Off but powered On.
How can I get the check engine code ? I assume I need a connector, right ?
I purchased a set of new LTX MS2 tires back in October and a week ago a got a nail on the right front tire, specifically the side wall so they couldn't fix it so they replaced the tire with a new one. Now when I step on the brakes at 60 mph, the steering wheel vibrates. Can the new tire be causing that? I looked at the weights and one set of weights is taped kind of crooked, can the balancing cause it too?
View 14 RepliesI bought a 2010 toyota camry se. I have the most annoying vibration in the steering wheel, seats, gas pedal. Have taken it to several places, including a Toyota dealer.. They seem to not be able to find the cause. I've had wheels checked, balance, aligned, rotated. There is also an annoying clonking noise coming from the front passenger assembly. It's very sporadic as in only goes away when trying to have a technician hear it.
View 8 RepliesI recently leased a new 13RX350. Something I find really annoying is switching the radio between FM/AM/XM. When I press "mode" on the steering wheel to change from one frequency to the next, the pre-set stations do not follow. What is I mean is if i am listening to XM Radio, and then I press "mode" to switch to FM and want to press the up/down to change the channel, I still get the XM Radio channel. The pre-set list does not change to FM and its such a hassle having to use the control console and scroll up 6 lists of pre-sets to get to FM. I'm wondering why Lexus did not make this more intuitive?
View 6 RepliesCan they be replaced or are they part of the actual seat?? Mine was ripped in accident so just see if they can fix that one part or does the seat need to be replaced which seems a little extreme to me.
View 13 RepliesThe driver and passenger hip bolster (side facing the door) had a fold under the leather... When I took it in for warranty they said the heating element in the seats came loose. It's probably from getting in and out of the car, and they replaced the entire element, but the GX only had about 12k miles and is 2 years old.
View 1 RepliesI took this picture from the rear seat while leaning over the front seats. The two white arrows indicate where our front seats are rubbing the center console while we are seated. The rubbing makes a noise and will eventually leave a wear mark on the leather, the console or both. Any way to quiet the noise and to cushion the contact between the leather and the center console?
I'm looking for a product that is safe for leather that will decrease friction in this area so that the rubbing won't cause noise or leave wear marks on the leather. I'm only interested in treating the area of the seat that contacts the console so as not to change the overall appearance of the leather. Alternatively, I could treat the center console with a product that will make it more slippery.
We're looking to buy a 2013 or 2014 RX350 and have a couple questions about equipment. Specifically, is blind spot monitoring standard equipment for either year 2013 or 2014 or is this an option?
If heated seats are listed as an option for an RX does this mean that "cooled" or Ventilated seats are automatically included for years 2013 or 2014? I ask because I've seen "heated" seats listed on Autotrader, but the controllers pictured include heated and cooled. Of the cars, we've looked at they only had both heated/cooled or nothing. We haven't seen heated only.
If the RX does NOT have heated seats, is the leather still perforated for 2013/2014 models or is it solid like previous years?
So last couple days over the 4th, the heat was over 95.
AC Blowing out of the vent is cold but the rear seats passenger feels warm.
Even with the blower on the higher and temp on the lowest 65 (or lowest setting).
I put my hand towards the rear seat and I feel warm air. Near the vents are cool but its like the AC can't keep up with the heat ?
2010 @ 51k ... 450h ...
I need some speaker upgrade recommendations that'll fit into the door cards - specifically the subwoofers - I've replaced an OEM speaker in the driver side once already and it's doing the same thing as before it has a weird vibration/rattle noise with certain freqs. It may very well be the way it's sitting in there but I doubt it.
View 23 RepliesHad a long trip with the X this week and noticed a weird vibration up at speed. Anything before 65 mph and the truck was smooth, higher than that a medium vibration developed. Its frequency increased with speed. Never got the truck over 70, but the vibration was there enough to rattle change in the cup holder and the rear view mirror. What it might be? I was thinking a hub bearing... 2000 Limited 4x4 PSD ....
View 14 RepliesI own a 99 Toyota Camry w/ 122k miles on it. About a year and a half ago I started hearing a low frequency vibration coming from left rear. A few mechanics said it was a worn bearing and I may want to get that fixed in near future. Well here it is 2011, I can't stand the sound anymore and am concerned what other damage (if any) I may have put on my car.
View 4 RepliesI have a relatively new to me Excursion. It seems to run well and shift well but recently I've become very aware of a strange hum, thrum, and vibration in the floor boards. The sound and vibration have a definite cadence/pulse.
Here is what I have observed trying to source the sound. Occurs around 2500 rpm and continues up to 4000 haven't really gone past 4k to know about after that.
Occurs in Park, neutral and drive and is more noticeable under load especially when towing. It is not really noticeable under my normal driving style it gets lost in the running gear until the X is at around 3600 RPM's which typically doesn't happen unless I'm pulling a long grade with a trailer. It was only after testing at a standstill in park and neutral that I realized it actually starts at approximately 2500.
Other than the vibration and low frequency hum starting at 2500 there are no real indicators of reduced performance or other problems but it's got me nervous.