Lexus RX 2004-09 :: Reverse Light Wiring Location
Aug 24, 2011
My trailer has surge brakes so I need to tap into the reverse light circuit to convert the 4 wire trailer harness to 5 wire. The reverse light wiring runs in the lower cargo area anywhere...trying to avoid having to trace it from the hatch into the headliner.
View 11 Replies
Advertisement
I need locating a wiring diagram for the GX 460 to accomplish the following.
(The wire must be connected to a point that is at ground voltage when the turn signal is ON. You must find a point that is ground when the turn signals are on to make the unit work.)
View 14 Replies
I have an 04 gx with a check engine light on I had the code read at auto zone. That tells me o2 sensor bank 2 sensor 1. I have already changed the sensor they said it was and still have the code. What is the correct location of this sensor?
View 2 Replies
Where the this ecu is located. I believe it's behind the glove box, but I want to be sure before I take it out again, wasn't sure which connector it belonged to. 2006 GS300.
View 2 Replies
Where is the camera for the back-up screen located? Occasionally we have gotten splashed and when I put the car in reverse, it is very difficult to see because the splashes are obscuring the view. If I knew the location of the camera, I could try to clean it.
By the way, had my first opportunity to drive our 450h In the snow. The snow was coming down hard, it was night time, back roads in New England, taking our daughter back to boarding school. The roads were very dark, not yet plowed. I was so focused on seeing the road ahead that I didn't even notice how steady the car had been (no skidding or 'fish-tailing') until we got back to our hotel.
View 3 Replies
[2008 SE I4 no JBL no factory nav]
Picked up a new head unit from ottonavi and am trying to finalize the install, but I can't figure out how to connect the unit to the reverse light wire so the backup camera comes on automatically when you shift to reverse. I've searched the forum and seems like the answers were PM'ed and emailed in most cases... Someone mentioned behind the glovebox?
What I've tried so far:
There are two white connectors at the base of the shifter, and while in reverse, I unplugged each (individually and together), and the reverse lights were still on! I tried the connectors I could get to behind the glovebox (on the side and middle top) with the same result.
View 14 Replies
I'm looking to wire in a AUX light to my reverse lights. As an option, I want to be able to turn the AUX light on without putting the car into reverse as well. This is what I have setup currently and it allows the AUX light to turn on when in reverse with no issues but I can't get the switch to activate the light separately from putting the car into reverse. Every time I flip the switch, it blows the fuse near the 12v input source and never fires up the AUX light. I was wondering if I have the wrong relays or even the wrong switch.
View 18 Replies
I'm getting ready to put in my new double din and it said to hook the wire for the camera up to the reverse light wire. Which one this is on the harness coming out of the column?
View 14 Replies
I've searched all over and can't seem to find the answer. When I pull the tail light out of my 12 F150 there is a blue/wht wire and a black wire going to the back up light. I assume the blue wire is the positive and black is the ground. Is that correct?
View 8 Replies
My hazard, reverse don't work. The over all instruments panel light doesn't light up (the small bulbs work). Gauges with needles work. I'm putting every thing back into the truck. I left the steering wheel resting on the floor while cleaning and also left the wiring in. Everything else came out because I had to clean out the smell of mice. After I installed the instrument panel I started the truck, there was no hazard lights. I checked all the fuses under the dash. I checked all the fuses under the hood.
I did have a bent brake plug blade to bend straight. I need to replace a bad key cylinder, you can turn it without a key. I believe there were three plugs I unplug to lower the steering wheel. Park brake, brake pedal and a plug under the steering wheel. Wipers, interior ceiling light work. I believe there's a switch on the column (?) that includes the wiper arm. Should it also operate the hazard lights ? The steering column is installed, I can drive it around. Outside cargo lights won't go off, even with the light switch pushed in. Everything worked before.
View 7 Replies
I would like to hook up some auxiliary reverse lights, I want to use a relay. And activate the relay when I put my truck in reverse. I would like the relay to be in my custom relay/fuse box under my hood near my battery. I'm looking for a wire I can tap into, to use to active the relay as close to the battery as possible. Or at least a wire on the outside of the cab near the engine compartment. Maybe there's one coming from the tranny? I have a 2011 f250 super duty. XL, I think, its a very base model truck no power windows or locks, only fm/am radio, no NAV system, no remote unlock, no nothing, 2 wheel drive.
View 9 Replies
I am wanting to wire my 03 f250 cargo (3rd brake light area) lights to come on when i put my truck in reverse.
View 1 Replies
I just had a headache rack built for my truck. Looking to wire in 2 very bright reverse lights, 2 not so bright lights to deal with stuff in the bed of the truck at night, and also mounted a receiver hitch so I can hook a winch up back there when needed. looking for opinions on wiring for all of this. Never wired stuff like this so I'm shooting in the dark. My wiring skills are adequate but not great.
View 7 Replies
What I am trying to do it put in 2 led spot light for added backing up light. What i want to do is have them turn on when put into reverse but also have a switch i can use to turn them on when not in reverse. Just need to know what relay I need and if it even can be done.
I was also thinking of just taping into the wiring harness and adding a wire that goes to the spot lights and another wire that goes to a switch that I could turn on and supply power to the light when not in reverse (I know it will light the revers light also) but is it ok to do that?
View 5 Replies
I looked in the trunk of my GS350 when my car was parked in the garage and it looked pretty dark in there. I shut off the garage lights and the trunk was just as black as everything else.
Is there supposed to be a trunk light in this car? Every car I have ever owned, Hondas, Nissans, and my other Lexus had trunk lights, so I think this is pretty weird if they didn't include a trunk light.
If there is a trunk light then where it's located so I can check it out?
View 7 Replies
I just picked up my 2015 Gx460 last month. The TPMS light stays on after I changed the snow tires. where the reset button for TPMS is located?
View 14 Replies
Looking for the low pressure switch, (back towards fire wall, black cap on it passenger side) I think I found it, but when I hook up the AC pro that gauge doesn't register any psi, when I hooked up same AC pro to our Acura TL the gauge registered and I was a little down so I added some In.
So any tips on what's up? Wife's car blows cold air just wanted to see where it's at and if I need to check for leaks or just add some 134a ...
View 1 Replies
Where is it. Probably under some shroud, but before I start taking things off, where it is from the perspective of standing in front of the grill.
View 2 Replies
What is the domelight wire color and location in an 07 LS460?
View 5 Replies
Long story short, my truck's front turn signals and rear turn signals/tail lights won't work. I am thinking that the relay is burnt. Whenever I look in the manual I can't seem to find the location for this relay. Is is built into the flasher?
Also, I am just assuming because the rear turn signals and tail lights are the same bulb that fixing this should clear up both problems. Am I right in thinking that?
I have already checked all of the fuses. Also, the Hazards don't work either.
View 5 Replies
Where it is located in a 97 F150 XLT Automatic with the ESOF?
Transfer Case Shift Relay Module
If it goes bad, would it be possible to still select 4L just no 4H?
View 10 Replies