Lexus RX 2004-09 :: Code P0037 - Check Engine And VSC Lights On
Feb 10, 2015
On the road today and out of no where I see the 2 lights on. So I get home and find the port for the scanner. plug it in and retrieve the P0037 code.
I cleared the code and I'm hoping it will not come back. What exactly does the code mean? What might I be looking at in my near future?
Car has 109K and I have not had it serviced since 85K except oil changes. I use shell 93 octane gas. car sees lots of highway when I'm using it. 2004 RX 330 AWD.
View 6 Replies
Advertisement
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 Replies
Tonight, during a short ride, all the sudden the VSC TRAC, VSC OFF and Check Engine came on. Atfter home, I got the P0057 code from a OBDII scanner. The P0057 code indicates O2 sensor on bank 2 lower sensor. However, the interesting thing is I also lost the power seat adjustment on the seat memory. When I switched between L1 and L2 , the mirrors and the steering position changes and the seat did not. However, the adjustment buttons on the seat itself work correctly. I wonder if this problem associates with P0057?
View 4 Replies
went to have an oil change. Standard procedure. Wife drives the 330 away and the check engine and VSC lights come on. I figure it's the maintenance indicator needing reset, but no..... the reset didn't work. Went back to my local mechanic who changed the oil to run codes and see what the problem is. Code P0157 = bad O2 sensor.
Now, I questioned him as to why these lights would come on DIRECTLY after they changed my oil. Is there any correlation there? NO, he says. No reason why these lights would come on immediately after the oil change and we've never seen these two lights come on at the same time before.
I've read every post and thread I can, but it seems like every issue is different. Some times it's a loose gas cap or gas cap that needs replacing. I have to drive 60 miles to the dealer some time soon to have a recall performed, but until then should I worry about this O2 sensor and these lights staying on?
View 9 Replies
I have 2006 Lexus GS300 with 95K miles. My check engine, check VSC and traction lights came on. I get an error code: "P2757 Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance or Stuck Off ". I was given the following different solutions that may work: replace the solenoid, service the transmission or replace transmission.
View 14 Replies
I just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 Replies
Vsc and check engine lights are on. Took it to the dealer. He indicated that there is corrosion in electrical harness underneath car and suggested to replace the harness !! It is a 2004 with over 100 k miles ...
View 5 Replies
My 2004 Lexus RX 330 with 116,000 miles has a check engine light on. The code was P2198, the problem: Bank2 Sensor1. I replaced the O2 sensor myself, easy, at $180. I erased the code and the check engine was back on the next day. Not sure what to do next.
View 9 Replies
It all started after I refueled at Mobil after a rainstorm a month ago. Could be coincidence, but right after that the car started jerking wildly and making a howling wind noise from the front. Thought it was the transmission. Brought to Lexus dealership, they told me nothing was wrong as I had low mileage on the car. There are NO Check Engine lights on the dashboard. Car "quieted down" after that, but the noise remains EXCEPT at high speed when it's quiet.
In addition to that, the jerking / misfiring continues at stops, reversing, and slower speeds on occasion only.
I tried Techron FI cleaner, but it has not made a difference. Filled up several times since then.
What's wrong?
View 14 Replies
where best place to start looking for what's causing p0442 code on my 2005 rx330? and its not the gas cap... also have a "c" code identified for the VSC light, states that its wheel speed sensor. evidently wrote the wrong code down, i had it listed as a c1290 but in looking them up i couldn't find that one.
View 6 Replies
What can be done regarding these faults? P0037 and P0057
Description:
Oxygen Sensor Heater Control Circuit Low (Bank 1, Sensor 2)
Oxygen Sensor Heater Control Circuit Low (Bank 2, Sensor 2)
The catalytic converters have been removed but the fault was present before that anyway. All I want is the VSC function to work again and the lights to go off. I have heard you can put dummy sensors in.
View 3 Replies
A few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
View 8 Replies
08 RX350 with ~100K miles. Two weeks ago the Check Engine/TRAC light were on, VSC light blinks, so I tightened the gas cap, and pull the negative and cleared the code. Hoping this is just a gas cap issue.
2 weeks later all those lights are back again, so my mechanic pulled the code and came up with P0128. He told me it should be the problem with the Coolant Temperature Sensor. The water pump, thermostat was replaced last year and coolant level is OK. No issue with coolant temperature and the car drives like normal. My mechanic cleared the code and told me to drive it again until the lights come back and he will pull the code again.
08 RX350 AWD
08 Avalon Touring
View 5 Replies
I got the Check VSC light on today along with the Skid Light and the Emission light. I got garage to read code said P0158 High Voltage on O2 sensor Bank 2 Sensor2.
He said O2 Sensor looks like its gone he Knocked it off and it has not returned as yet but the car still run right
However it went into service at Lexus Sheffield UK about 2 month ago and they said there is a crack in the rear exhaust pipe at the Y junction i said cant you weld it he said no you need new rear boxes as they are one unit.
I have noticed it is starting to blow a little now could this affect the o2 readings
GS300 Gen 3 2006 82000 mls serviced every 12 month...
View 2 Replies
My car is a Prius Plus 2012.
One day, I decided to go to a mechanic to clean the EGR pipe. Only the pipe, not the whole EGR. It was an extremely simple operation a mechanical one, not electrical etc. Starting from that day, when I go with the car, from time to time, check engine lights up. For a fraction of a second to up to 2 seconds then it disappear.
The car behave itself without a problem. But still the on-off check engine is really annoying.
So a went to the dealer. Put the car on tester.
Result: no code error !
I went to another garage , put another tester on the car, no error..
How can I actually see what the error is if nothing is stocked in the ECU of the car?
View 4 Replies
I had the 2010 Camry I-4 in the dealer last week for the 40K service. They told me I needed fuel injector cleaning and a throttle body housing cleaning which I had done. This afternoon the check engine light came on and at the same time the Slip Indicator light came on.
I ran by Auto-Zone to have them pull the code for the check engine light and it was P0101 which AZ says is Mass or Volume Airflow circuit range and listed probable causes as:Open or short circuit condition, MAF/VAF sensor failure, or Faulty ECM. I called the dealer for an appointment Thursday morning and told him the story and asked if the throttle body or injector cleaning could cause the mass air flow problem. He said "probably not". He also told me that when the Check Engine light comes on the Slip indicator light automatically comes on to show that the VSC is not working while the check engine light is on.
My question is, could the cleaning cause the P0101 and if so what info do I need to argue the case with the dealer? Or, are they unrelated systems?
View 2 Replies
Check engine and VSC lights came on wife's car, took to dealer, they hooked up computer and now stating that the Evap system has a leak. They want to replace the Charcoal Canister and they are quoting $900.00.
View 5 Replies
1999 Lexus ES 300. 120k miles.Check engine light. Gives code 0420. Mechanic says it's ethanol gas combined with narrow tolerances of these models. Thing is, I think I recall this on my 03 Avalon happening and eventually turning out to be an oxygen sensor. However, my memory could easily have this mixed up.
View 9 Replies
I have an '09 LS SWB AWD with 86k miles on it. A few days ago the check engine light came on with a message on the dash for me to check the VSC system. The next day the check engine light and VSC warning went away on their own. A day after that they came back on. I pulled the ODB codes and got the following:
P0012 - "A" Camshaft Position - Timing Over-Retarded Bank 1
I took it to my local Lexus dealership and they determined that my VVT-i motor assembly needed replacing. Total cost would be $1,222. Apparently this part regulate the camshaft for variable valve timing. I asked if I should notice a performance dropoff since it's related to valve timing but they said no. They said I wouldn't make it worse by driving it so I took my car back and they would order the part for me.
The next day the check engine light and VSC warning went away on their own again and have not come back on for 3 days now. I don't understand why the warning and check engine lights keep going off on their own if this motor assembly needs replacing. Once again it has been 3 days now and no lights have come on.
View 9 Replies
I am the proud owner of a 2008 LS600hl with 141,000 miles. The check engine light is now on permanently and the estimated repair charge from my lexus dealership is outrageously expensive. Here is the official diagnosis and recommendation.
"Code P1083 - HCAC Valve Stuck Open in Bank 2 .
Recommend Replacing Y- Pipe With HC Adsorber .
Possibly May Need Exhaust 2 Sensors.
View 8 Replies
Its strange this code came up 02 sensor circuit low voltage bank 2 sensor what does that mean? what causes that?
View 6 Replies
