Lexus LX 2008+ :: How To Remove Cooler Box
Aug 10, 2015
I need to clean the cooler,some juice leaked inside ,need to remove it,anybody done it before?
View 2 Replies
Aug 10, 2015
Advertisement
Lexus LX 2008+ :: Seat Cooler Will Cool Slightly For Few Minutes When Turned On
I have observed if I turn my seat's cooler on, it will cool "slightly" for few minutes (~15min) but then it will heat to a point as if I am turning the heating mode not the cooling mode.. Or is there a right way to use this feature such as I must turn it on minutes before I sit ..
View 13 RepliesFord 7.3L Power Stroke (1999-2003) :: How To Remove Transmission Cooler Line
As explained in the photo annotations, I can't figure out how to remove this line from the radiator so I can remove the radiator for cleaning.
View 7 RepliesFord 6.0L Power Stroke Diesel :: Possible Plugged Oil Cooler Or EGR Cooler?
I have a 04 that has 153k on it. 4" cat back exhaust with no cat. SCT tuner running a custom street tune. New FMIC with the extra tune on it. Head gaskets where done at 90k along with ARP studs. EGR cooler, The oil cooler was cleaned, New coolant tank. 1-new head and The cooling system was flushed at 90K. All done by the dealer along with some other items. Installed a bypass coolant filter at least 60k miles ago.
I have been having a no heat issue sometimes at idle this past winter and a mystery loss of coolant. I replaced the cap with a OEM one. I did a vacuum test on the coolant it held at 25 inches for well over a 1/2 hour. Pulled the egr valve it looked somewhat like tar inside not 100% dry. At startup it sometimes blows some white smoke and other times it's black smoke. I've had the scan gauge on for the last week to check my deltas.
Running 65mph the deltas stayed around 10 degrees diff.
Running 70mph the deltas stayed around 14-16 degrees diff.
Yesterday just running around rural roads 55mph and under the deltas stayed around 10 degrees diff.
I have not found a lower pressure gauge to do a coolant pressure test.
It does look as though it has burped the cap. Because of the deltas I'm thinking a plugged oil cooler my be the problem.
Ford Escape / Hybrid :: 2008 - Transmission Cooler Install Possible
My girl has a 2008 Escape 3.0L FWD auto trans. Is it possible to install a transmission cooler? She wants to pull a small trailer/camper.
View 2 RepliesLexus SC430 :: Transmission Cooler Line Location?
What is the location of the Transmission Cooler Line? Is it by the radiator?
View 12 RepliesLexus GX 2010+ :: Buzzing From Glove Box Area In Cooler Mornings
I picked up my 460 a couple of months ago with 26K miles (2013 base model), and I have noticed on cooler mornings a buzzing sound coming from the glove box area.
The odd thing is that the volume of the sound is related to how hard I am accelerating (step on it harder, it gets louder).
My first thought was that it was climate control related (seems to only happen on mornings below 60 degrees - cold for California SF bay area), but turning that off while the sound is happening makes no difference. Also not part of the sound system.
The sound itself goes away after about 1 mile of driving (I assume the engine has warmed up enough by then?), and never happens in the afternoon, or if it is a warmer morning.
Chevy - Impala :: 2008 - Oil Leak At Rubber Hose Crimp Point To The Metal End At The Oil Cooler Unit
my mom's car is a 2008 chevy impala police car. This police car has an extra oil cooler unit. the rubber hose is leaking oil right at the point where the rubber is crimped to the metal end connection nut. since this is a police car the rubber hose is very expensive at the dealer (over $300 for the part only). Is there a cheap way to seal this leak with some form of heat resistant tape or glue compound ? or, can I cut the existing rubber hose and remove the leaking end & replace with a 3rd party rubber hose with the correct end and then join the two rubber hoses at the cut portion together with some creative scheme like a metal tube insert with metal tie wrap clamps? Any creative solution that i can deploy to stop this oil leak.
View 6 RepliesFord Super Duty (1999-2016) :: 2008 - Thermostat Can Stop Flow To The Trans Cooler?
I have read that the torqshift 5 speed in my 08 f350 he a thermostat in it that opens around 165-170. Is this thermostat to limit/stop the flow to the trans cooler? Does the trans fluid still move freely in the trans (pan, torque converter, valve body, ect), or does the thermostat restrict fluid movement inside the trans?
View 3 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Transmission Cooler Line Start To Leak
I have a 2008 Ford F250 V-10 Superduty and recently I had a transmission cooler line start to leak. I ordered replacement lines and the tool for the quick disconnect. The line that's leaking is from the radiator to the quick disconnect. I was able to replace the one line, however the second line (problem area) has been a nightmare. The line cracked right at the quick disconnect fitting.
The hard line is tight in the fitting and corroded. broke the tool trying to remove from disconnect. The line is flush with the quick disconnect. How to get that out of the fitting? or another method of fix? Its a hard 1/2 line going into connect crimped to rubber line going to transmission.
Ford Super Duty (1999-2016) :: 2008 - High Oil Temps / Cooler Is Fully Or Partially Clogged
2008 6.4L .... My ECT 191-197 and EOT 220-230 high side on interstate no load on truck air temp 70 degrees. Is this a sign thermostat failing. Is there a certain temp to determine if your cooler is fully clogged or just partially clogged? I plan on doing a flush with restore then restore plus. Is there any point in using restore with temps this high. Or do I have to break down and buy the half kit to bypass OEM oil cooler? I need this fixed ASAP hauling the RZR to arkansas in a week. I know ill mess something up if i try to pull a load with those temps.
View 2 RepliesSanta Fe (CM - 2007-12) :: 2008 - How To Remove The Backseat
I've been trying to find information on how to remove the backseat to my 2008 Santa Fe?
Its really dirty back there where my vacuum can't reach, and I'd like to clean it.
Sierra :: 2008 GMC - How To Remove Brake Pads And Rotors
How to remove the front brakes pads and rotors on my GMC Sierra 2008 - 1500 - crew cab - 4X4.
View 2 RepliesCamry :: Remove Center Dash Air Vent On 2008 TCH
How to remove the center dash air vent on a 2008 TCH?
View 2 RepliesIS F (2008-2014) :: Aeroworks CF Splitter Installation - How To Remove The Bumper
Finally got the Aeroworks CF splitters and spent some time to install it. Took me about 3 hours but I also took the time to put on some adhesive velcro for protection. And re-sealed one of my headlights
First I took off the bumpers. follow this guide
How to remove the bumper from a Lexus IS250 / IS350 to install Lite-Eyes CCFL Halos / Angel Eyes - YouTube
Then the rest is easy. Make sure to clamp or put a bucket under the washer fluid hose if you have the headlight cleaner option. Fitment of these splitters are almost 100%. right side was perfect, left side has a slight gap but its like 1mm ... very small.
Just line it up, and drill 3 holes on the bottom and 1 on the side. The splitters came with screws and some fasteners. Easy to install. I put some 3M adhesive tape as well just in case . I stuck some Heavy Duty industrial velcro strips on the underside in case i rub.
Ford F-150 (2004-2008) :: Remove Ignition Lock Cylinder?
How do I remove ignition lock cylinder to take and get new set up?
View 4 RepliesFord F-150 (2004-2008) :: How To Remove Seized Exhausts Clamps
I just got my new roush catback exhaust and I seem to have run into a wall in the installation. I cant seem to take out the factory hangers.
View 2 RepliesFord F-150 (2004-2008) :: Remove The Defrost Vent Covers?
is there an way to remove the defrost vent covers? i think my license slid down the front of the defrost covers. its probably somewhere down under the dash. I would like to start removing the covers up top before I yank the dash. I am 1400 miles from home so I cant run and get a replacement.
View 6 RepliesFord F-150 (2004-2008) :: Remove Rear Brake Rotors?
I'm having a hard time trying to remove one of my rear brake rotors.
I thought these simply pull straight out and off, but mine might be rusted in place. I soaked the front facing area around the axle with Kroil and then tried jolting it out by tapping it with a rubber mallet. No success
What's the trick?
Ford F-150 (2004-2008) :: Door Chime Won't Stop When Remove Key
Recently the key chime will not stop when I remove the ignition key. It doesn't do it all the time but is getting more frequent. Usually I can reinsert the key and remove it once or twice and it will stop . How to remedy this issue? Is there something inside the ignition that can be repaired or am I looking at replacing the entire thing?
View 14 RepliesFord F-150 (2004-2008) :: 2007 XLT - How To Remove Floor Console
I recently got myself a 2007 F150 XLT Supercab, love the truck, but I find myself needing to make a few mods. First up is the floor console. This is the small console sits atop the hump between the jump seat and the dash. It contains two cup holders and the 4x4 floor shifter.
First how does one remove the 4x4 shift, you need to in order to get the floor console off, the console itself lifts straight up, but the boot for the shifter is attached to it, so the only way I can see to remove it. However I can't for the life of me figure out how to remove it.