I have my mirrors set to tilt when I am in reverse but now they are no longer going back to their initial position when I shift from R to D. They always end up too low and require further adjustment. Is there a way to reset/recalibrate the mirrors?
View 6 RepliesMy 07 GS350 after coming out of Reverse the mirrors don't tilt back to the original position and sometimes it don't tilt down far when put in reverse.
View 12 RepliesWhen shifting from reverse to park or drive, the mirror tilts back up but not in the position it was prior. It is actually quite irritating because I would start driving and have to adjust the mirrors back to the desired setting. I've also just sat there and shifted from park -> reverse -> park and recalled the memory setting and I will see it make the adjustments.
View 8 RepliesMy old LS430 allowed me to close the mirrors when I turned off the car. My 2007 only lets me close the mirrors when I lock the car outside. Can these mirrors be reprogrammed to close when I shut my car off like my 2005 LS430 did?
View 9 RepliesI have a 07 GS 350 and my side mirrors don't point down all the way in reverse than when I put it in drive the mirrors don't adjust to my preset.
View 4 RepliesHow to remove the side mirrors to access the puddle lights underneath. I ordered some white HID Led replacement bulbs but not sure how to remove the side mirror.
View 14 RepliesI have a 2016 GS 350 with the Luxury package so there are quite a few adjustments for the seats which is nice. However, every now and then, the memory positions I have programmed go away and I have to be in Park and select the memory positions again. I turned off the easy exit option because every now and then the seat would just go down to the floor on its own. No one else has been driving the car.
I go into the dealer for the 5,000 mile check up in a couple of months and will have them look at it but thought I would check with this group as well.
We have an Acura MDS as well and on that forum, there was a technician that would post service bulletins which was very handy when taking the car in while under warranty. Did a quick search for service bulletins but did not see anything. Is there a thread for the service bulletin list?
Can the 4GS be programmed to automatically lock the doors at a preset speed like 10 miles per hour?
View 6 RepliesWhenever I start the car at the moment, the rear view and wing mirrors are both in the dimmed position and I have to press the button under the rear view mirror to clear them to normal operation. Why this is happening? I can't find anything in the FAQ which covers it.
View 2 RepliesHow I can go about programming my smart key remotes to the memory positions of the vehicle? I had it all set up from the dealer and since then they had to disconnect the battery for something and now I don't have that feature. It was setup where I can walk up to the car and unlock it by the remote or door handle and it would put the memory position to that remote?
View 4 RepliesOn my LS 600 HL- there are two buttons on the rear door handle. One is C and other is M.
One lights up, when pressed. What is the function of each?
I would prefer to leave the back seats in reclined position permanently but I find that they go back to erect position often (I didn't particularly test this function). What is the function of the C and M buttons?
2007 Lexus ES350 with 177k miles. Getting a P0368 (Camshaft Position Sensor B Circuit High Bank 1) Error. I can't seem to find online where this sensor is located at.
View 2 RepliesI recently purchased a '09 LS460 SWB. I noticed the driver side windshield wiper arm sitting up high enough to be in my field of vision.
I'm aware that there is a "winter mode" that allows you to raise the arm up a few inches, but from everything I've read....usually the driver and passenger side arm raise together.
In my case, my passenger side arm sits nice and low near the hood, while the dirver is sitting an inch or two higher.
I tried pushing the driver arm down (with success), but after cycling the windshield wipers once, the driver side arm goes back to the higher position.
I am having a problem with my rear suspension. The indicator lights on the dash (for the rear suspension control) are working correctly as are the controls on the center console, however the rear of my vehicle is stuck in a high position.
View 14 RepliesI have a 2007 ES350 with 90k miles. Purchased in August. I had ignition coil go out and decided to change them all and the spark plugs. When changing cylinder 5's coil and plug, I tried to push the wiring harness out of the way to remove the coil. Result, I moved the wiring harness too far and disconnected the 3 wires (black, yellow and red) that were connected to the cam position sensor connector. (I should've just removed the sensor SMH) I disassembled the connector, got it down the internal pins, soldered the pins to the wires, placed the pins back in the connector and reassembled it with the wires in the order that they appeared to originally be.
Plugged it back in and put everything back in place. Started the car and code P0352 was cleared but replaced with code P0365 Camshaft Position Sensor B - Bank 1 Circuit Malfunction. I'm thinking, either I put that pins back in the wrong order or one of the wires isn't properly soldered in. Either way, I ordered another connector and it should be here tomorrow. I need Either a wiring diagram or a picture of the camshaft position sensor closest to cylinder 5 connected with the wires in the proper order .
Having issue with a moon roof rattle in the up position, sounds as if the glass is loose. If I slightly close the rattle stops. Not sure if I want lexus taking apart the moon roof/ head liner to repair. I may just live with it, but would like to get it looked at. 2011 LS 460 sport.
View 8 RepliesBought some power tow mirrows, aftermarket, any special on installing?
2011 F150 Echoboost, 4 x 4
I'm replacing tow mirrors on my 2004 F250 with 2008 mirrors. Both are factory Ford mirrors. Need wiring diagram since connectors and wires are different. They both have power mirrors, turn signals, heated mirrors, but are not power retract or fold.
View 1 RepliesJust picked up my ES. Noticed when backing out of a parking spot and when a car is coming from the left my right side, mirror lights up. I would think if the car is coming from the left the left mirror should light up.
View 4 RepliesI just got an XLT with basic power door mirrors, I'd like to swap to power mirrors with the blinkers. The million dollar question is, does the truck already have the correct wiring harness for a "plug-and-play" or is the wiring not there for the blinkers?
View 3 RepliesMy dealer said the windows on my 250 F sport executive pkg (Canada) should tilt down when the car is in reverse. They said the control must be either on the Lh or Rh position for it to work. I have tried both positions and it doesn't tilt when in reverse? The windows are currently locked out from the switch on the drivers door due to the tint being fresh (they said to wait a few days before rolling down the windows).
View 14 Replies