Where the turn signal relay is located? I want to change my stock turn signals to LED. However, I don't want to use those "load resistors" or "cancelers". iJDMtoy sells an LED relay for the 14' IS (confirmed). After looking through the manual and at all 3 fuse/relay locations I can't locate it.
View 3 RepliesI cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
Long story short, my truck's front turn signals and rear turn signals/tail lights won't work. I am thinking that the relay is burnt. Whenever I look in the manual I can't seem to find the location for this relay. Is is built into the flasher?
Also, I am just assuming because the rear turn signals and tail lights are the same bulb that fixing this should clear up both problems. Am I right in thinking that?
I have already checked all of the fuses. Also, the Hazards don't work either.
I need to know the Location of the turn signal relay, my left front bilnker is super dim, and the rear left blinker is normal brightness as well as they blink rapidly. I've replaced both front and back bulbs as well as the flasher and turn signal fuses, so I am assuming the last and final one is the turn signal relay.
View 2 RepliesI need locating a wiring diagram for the GX 460 to accomplish the following.
(The wire must be connected to a point that is at ground voltage when the turn signal is ON. You must find a point that is ground when the turn signals are on to make the unit work.)
Where is the signal flasher relay located. I can hear it but can't track it down.
View 5 RepliesIs there a way to make the running lights flash yellow for signaling a turn like many other makes and models? Would it require aftermarket lights? If I wasn't mistaken, I think I saw an RC doing this today.
Also if this is a thing does that mean I could get the amber out of the headlight? My car is 2015, if that makes a difference.
My left turn signal stopped working all together after months of toggling the hazards to get it to work. I attempted to solder the combination relay myself but bridged two contacts together. I guess I didn't do a good job separating them again cause when I plugged it back in, neither signal worked and it must have burnt out the #20 10a fuse cause the heater control had no power, neither did the heated seats. Also found the #26 15a fuse was blown too. But before I replaced the fuses I got a used combination relay I pulled from a jeep at a junk yard (free). Plugged that in (nothing changed) but then replaced the fuses. Heater control and heated seats came back, had hazards but no directionals. Took used relay out and heated that one up to reactivate the solder, plugged it back in and had a left signal but now no right. Tried to reflow the solder second time but still just the left. Dropped $58 on a new relay at the dealer, plugged that in but still no right signal!! I tried other fuses in those to spots I replaced, pulled everyone of the others and checked them, checked the fuses under the hood and still no right.
View 1 RepliesMy turn signal relay clicking and stuttering randomly. When turn or warning signal used it operates normally with absolutely no problem and sounds healthy. But when not used and supposed to be quite - it goes again. When stuttering - there is absolutely no indication other than clicking sound that something is wrong.
View 11 RepliesI've changed out all of my external lights for led's, including the turn signals. I had planned on replacing the turn signal relays with led comparable versions but have been unable to find the relays in the fuse boxes. The box that does the actual clicking under the dash seems like it could be it but it looks completely proprietary to this model, and not readily available in the compatible version.
I ended up installing resistors for now but that's caused other problems with my lights. Now when I turn my high beams on all 4 turn signals light up solid and I am unable to use them until I turn the highs off.
So, I would love to know if I do have a relay replacement option for my 2012 Santa Fe...
Is the turn signal relay the same in my 97 Mountaineer as in my 97 Ranger? If so, what does it look like, and where might I find it?
View 11 RepliesI installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
What is the relay location for the power folding mirror in a 2010 F150 FX4 ?
View 8 RepliesThe turn signal lights in my brother's 2000 passat are staying lit when he turns the signals on. They work sometimes, for a few clicks, but then stop working.
1. is it the turn signal relay. It sounds like its in the middle of the dash.
2. how do you get to that relay?
Have to remove the HVAC controls? if so, how the heck do you do it?
[URL] ....
I have an issue with my 2003 Prius. The reverse lights do not turn on when I put the vehicle in R. Checked the bulbs and they are fine. Checked all the relay (fuse) boxes and didn't find any burnt fuses.
I have a Haynes Manual and other than a circuit diagram, there is nothing that I could find about the location of the backup light relay. By the diagram I can tell that it is connected to a "HOT IN RUN or START" circuit and a 10 A fuse. Although it is useful for showing the wire routing, it doesn't tell me where it is!!
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 Replies2015 prius package 5 w tech package and HUD display, I found a flasher mounted up between the fuse box/ module assembly mounted on a clip! I have a led replacement flasher, but clip mounts and pin locations don't line up? I watch the video but I have nothing in area! Or I just need to install the resistors? Or it could be a combination circuit assembly where multiple function module all in one ?
View 1 RepliesOk so my fire station has a 2003 f550 rescue truck with a rescue body with the round tail lights, we recently upgraded them to the LED ones that are much brighter but of course it flashes at the speed of sound. The question I have is:
1. the relay {flasher} is located on the driver side inner fender? I think....
2. does the same EP-27 relay/flasher fix the problem?
Jumped in the truck this evening to go to the store and when I stared it up the left turn signal was blinking. Lifted the arm as usual to cancel and it does not cancel. Cannot get the left signal off unless I hold the turn signal up for the right signal. The right signal does not activate, but the left does go out as long as I hold the arm up. Let go and the left starts blinking again. Tried driving around to see if it would cancel and no luck. The bulbs are all good. I checked the relays in the fuse panel and they are good. Dang thing just won't shut off. It is a 2011 F150 SCREW Platinum w/5.0.
View 4 RepliesExactly where that part is, pictures would be useful. Pretty much just had my whole dash apart with no luck. Switched to leds, and can't stand hyper flash like I thought I could. Trying to pull it to make sure I order the right part to correct it.
View 11 RepliesSo with 172,000 miles my truck has started a new trick. When I turn on the turn signals theyll flash or interrupt normally for a few times then stop. After I turn the signal lever off and back on again they start to flash again only to stop after several times. This happens to both the left and right hand sides. The emergency flashers seem to work alright. Is this a function of the indicator flasher SF631? If so, were exactly is it located?
View 5 Replies