Lexus IS 2014+ :: OEM Bumper Cover Come With Sensor Holes Pre-drilled?
Aug 15, 2014
I'm having the bumper cover replaced on my 350 (stupid mistake on a number of fronts it's starting to look like...) and the indy shop that I chose in my town to do the job (Lexus dealer is 100 miles away and this shop was recommended by the guys that take care of all the Lambos/Ferraris/Porsches etc) told me that they had to drill the holes in the bumper cover to retro fit the sensors. Is this correct?
View 2 Replies
Advertisement
I bought the car from dealer, there are now FOUR! holes on the front bumper. I don't understand why they couldn't just use the existing holes to put the license plate holder. Now I'm stuck with these holes and I'm looking for a cheap alternative to fill them. I like the clean look of the front end without the plates and don't want to spend a fortune at a body shop, but I also don't want 4 dots either. What I can do/use?
View 3 Replies
replacing the entire front bumper.I have removed the front license plate holder, and would like to fill the holes where it was screwed into the front bumper.
View 8 Replies
Replacing bumper cover, is there anything I would need to replace underneath it or is it just a simple swap out?
View 4 Replies
Replace the front bumber cover on gx? Mine has a crack and I can get another one but wasn't sure how difficult it would be to swap it out, I guess the toughest part would seem to be the fog lights.
View 6 Replies
I had a low impact accident with my 2010 LS460 where the body shop replaced the bumper cover, collision cushion behind the bumper and a new grill. Below are the picture from their finished work, however I know my car should look better than this. What could be wrong/missing to cause the grill and bumper to not align correctly with my car?
View 7 Replies
I need to put a front license plate on my Prius. I notice there are a couple little indents on my front bumper but no holes . Do I need to drill holes or something else here to mount a plate ?
View 13 Replies
What I should use to fill the holes on my front bumper? I know how to get paint to make it blend in but what should I use as a filler?
View 1 Replies
How do I get rid of license plate holes on my front bumper? I took my front plate off and now I am stuck with annoying holes drilled into my front bumper. Its not noticeable but i know its there so it irritates me.
View 4 Replies
I just bought a 2011 GTI in Steel Gray Metallic. The first thing I did was remove the front license plate holder.
Doing that revealed 3 large holes (about 8mm), and 2 small screw holes. I'd like to repair this myself or have a shop do it.
Is there a relatively easy way to fix this myself (other than putting the holder back on)?
View 8 Replies
I have a 2011 F-350 that came with the 5th wheel prep package which has rubber, two piece hole covers. Every time I slide something out of the bed across these covers they pop off or come partly off. I don't have a 5th wheel trailer and no plans to get one. Having trouble with the covers and come up with a better cover that would stay on when sliding cargo in and out. I hate just leaving the holes open to collect things. I wonder if some sort of galvanized electrical box cover would work with some sort of mount system under it?
View 14 Replies
So when I was washing my car for the first time I noticed that the bumper was damaged. It can be fixed or does the bumper need to be replaced?
View 14 Replies
What sensors are in the front bumper? I slid out on black ice into a snow bank and it crushed in the bottom grille and as I'm clearing out the snow I noticed a sensor dangling with a broken harness that I was wondering what it was for. I have a nonFsport bumper with LED fog lights and both fog lights are operational.
Drivers side close to the fog lights
View 5 Replies
DIY on removing the bumper on the 3IS-F sport
I just received my fog lights from IJDMtoy, but i have no clue how to remove the bumper!
View 2 Replies
Do you need to take off the bumper?
View 2 Replies
Remove rear bumper on IS? Wanting to install a rear diffuser myself but don't know where to start in removing the bumper.
View 5 Replies
Have trouble with the drivers side not seating in the bumper pocket? Mine pops out on one corner weekly. I'm not sure if it would come out completely.
View 14 Replies
So my gf parked at the mall and when she pulled out the front bumper got stuck on the parking divider and came off on the left side. One of the fastening holes appears to be torn and it appears the bumper just needs to be put back in place.
View 8 Replies
I recently got my UW F-Sport roof vinyl wrapped with gloss black. A local shop didn't want to wrap the antenna cover and recommended I get an obsidian black cover instead. So, I went to the dealership, ordered the part and now I have the cover. I looked up threads here on CL thinking it'd be an easy 5 minute DIY but apparently that's not the case. One member said he had to remove the interior c-pillar trims, part of the headliner etc. etc. Another said to just remove the rear seat light dome and someone else said the a dealership just prys it off. I tried the light dome, all I was able to get to were the bulbs.
View 4 Replies
how to remove it.My wife backed into my truck and put a dent in the corner of it so I am hoping i can pop it out.
View 4 Replies
Have an '04 Prius and banged up the front bumper cover. Wanted to know if a Toyota Matrix front bumper cover from the same year would fit on it (without extensive mods, I know anything could fit, but would it bolt right up?).
View 4 Replies