Lexus IS 2014+ :: Front Brakes Sounded Like Grinding On Something When Speed Reaches Below 15 Mph
Dec 3, 2015
I was recently experiencing problems with my front brakes. It sounded like it was grinding on something (it doesn't screech) whenever the speed reaches below 15 mph. I called up my dealer to take a look and upon investigation they told me that i needed to do the front brakes job but they could save the rotor (they charged me around $300). Is this common ? It is a daily driven car and i mostly drive on highways. I drive the 2014 RWD IS-350 F-sport model and just recently hit 17.8K miles.
View 14 Replies
Advertisement
I have a grinding sound comes from the front of my car when the speed reaches 60 miles, what can cause this sound.also i have a popping sound when putting the gear in reverse is that related?
View 1 Replies
I have a grinding noise coming from what I believe are the front brakes. It happens when I apply the brakes and sounds like the brake pad is worn out and there's metal-on-metal contact but when I checked the pads, they are at 80-90% (rears have about the same amount left). I hear it the loudest just before coming to a full stop, from about 20 mph down to stop. I thought it was caused by rust on the brakes but after I wore off the rust, the sound is still there.
View 14 Replies
Just got a 2013 IS-F. Loving this car, but discovered an annoying issue. Grinding noise coming from front brakes when slowly coming to a stop below 5 mph. Is this normal?
View 9 Replies
So I'm new to the all time awd car thing. I came from a 4x4 truck which 4x4 was never engaged on pavement or in tight cornering. When maneuvering my is250 awd in tight spots ie. parking lots and the front wheels are at full lock in either forward or reverse there is a slight binding/grinding feeling or faint noise. Is this normal on an awd car or Lexus specific??? Did a quick search and didn't find much about this issue. I'm pretty sure its not tire rub.....stock set up.
View 10 Replies
My car is making this noise from the driver's front wheel when applying the brakes and EVEN CLUELESS AND SURPRISINGLY the noise shows up when cruising at low speed (haven't try freeway speed yet) without stepping on the brakes.
This just happened to me tonight, car is around 10,000 miles, I'm going to take it into the dealer to see what the hell is with Lexus. I suspect it might be the rotors and built in brake dusts, I just don't know, but the noise is unusual enough to be concern about.
I doubt it's the built in brake dusts because previously I've not washed my car/ wheel for a longer period of time, but I'm not sure. Could it just be that my rotor is done?
I know the front brakes need a replacement soon, but it shouldn't be my brakes since the noise still shows up even when I don't step on the brake pedal, unless the car brakes for me itself......
I cant take it into the dealer until weekend, hopefully it's safe to drive around within the next 2 days.
View 13 Replies
It's like a tire grinding or shuffling at low parking lot speed, hard right or left turn, more evident when slowly braking during the turn. Dealership claims the negative camber contributes to this phenomenon and that nothing can be done about it.
I realize we have about a 1.5-degree negative camber in 2011-and on IS-F (I have no mods and still running with stock Potenza RE-050s), perhaps this contributes to the feel of the tires at parking speeds.
View 9 Replies
2013 Platinum. See sig for details. 37,000 miles. 1 owner. Truck has been basically parked since June. However I take it out for a quick spin every 3 week for 10 miles or so. Currently has storage insurance on it.
When backing out of the garage the brakes are grinding and squealing bad. Also getting feedback through the steering wheel for the first couple miles which leads me to believe it's one or both the front brakes.
View 6 Replies
I have a 2002 Camry (4 cylinders). About two weeks ago, I started to notice vibration on the passenger side of the car, front side, when the car reaches a certain speed (around 30-40 mph). At first I thought it was a wheel inbalance, so I took it to the Toyota Dealership and have them re-balance the wheels.
The problem, however, did not go away. I remember a while back after I got an oil change, the maintenance guy at the dealership mentioned that the motor mounts were going bad. Is it possible that bad/worn motor mount can cause vibration at certain speeds? The problem only occurs on the passenger side.
I do not notice vibration at idle (I think). I will have to drive the car again to double check this. But vibration is much more apparent when the car hits 30 mph+.
View 2 Replies
I was driving to work last night and too many things went wrong simultaneously leaving my MK4 stranded.
2000 Jetta 2.0
185,000
Automatic
No check engine lights or warnings
-The engine sounded like there was a hole in the exhaust at highway speed. There wasn't because it's a new system
-Low coolant light came on. The flange connector at the firewall was torn off resulting in a stream of coolant pouring out
-It was dark but the engine almost seemed cockeyed by a degree or two
-Upon parking, the motor. sounded "clunky". Driving forward seemed OK. When shifting into reverse there was a pronounced clunk and the drivetrain wasn't happy.
-I turned the ignition off and that was the last time the car started. It turns over now but will not fire up. The video I attached is my last attempt at starting it before giving up.
My car is my job and I'm at a total loss on how to proceed???
View 13 Replies
Is it possible to disable the automatic door locking when the car reaches speed via VCDS. So the actuators don't wear out so quickly.
View 4 Replies
I have a 05 Touareg V6. When coming to a stop (when speed reaches 5 mph or less) there is a slight vibration felt in the steering wheel. What causes this? What can I do to correct this? (I had new rotors and brakes put on about 2K miles ago.
View 1 Replies
So yet I found out about another common issue but not that publicized. This is the grinding sound when turning at full lock (left or right) in slow speed. I've read several people in the forum who has encountered this. I read different remedies but the most common one is to have the CV boots lubricated.
I have a 2014 Wolfsburg with almost 5k miles. I am really now worrying about my water pump crapping out on me but I heard this grinding sound yesterday.
View 12 Replies
I had a couple people in the bed of my new F150 SCrew with the 5.5 ft. bed and it sounded like the metal was cracking as they walked around in the bed. Is that normal? It didn't sound good.
View 7 Replies
Coming to a left turn signal I was anticipating it turning red on me, and I drove into the turn lane briskly 30mph and then applied brakes as I made a u-turn. It sounded like a cross between dragging the front air dam and metal on metal brake grinding as I made the turn. Stopped immediately and did not scrap the air dam and all front end components checked out, okay. Car is driving just fine now, has only done this once.
View 18 Replies
I took my 2010 Sonata GLS (86K miles) into the shop last Thursday for an alignment and new front brakes since the old ones were on the wear indicators and doing some squealing/squeaking on soft left turns. Got a call from the mechanic who said the rotors were also shot, so I had them replaced as well.
On my normal commute on Monday and Tuesday this week (approx 10 miles, 95% highway), I noticed that when the car was moving at 15mph or less in a straight line both front wheels were making a noticeable high-pitched squeal/squeak, which went away with increased speed and when braking. I figured it might be a break-in issue but when it hadn't improved by yesterday I made an appointment to have the car checked out by the mechanic again today.
Got the car back today and the same sound is still happening, though now it's in the 60mph range and seems to come and go regardless of wheel direction. The mechanic said he took the brakes apart, found no issues but cleaned and lubed everything as a precaution.
I'm starting to wonder if its the bearings that are shot, but the sound hasn't remained constant as I would expect with a bearing issue. All the parts used are under warranty, so the next step I have available here is to have the brakes and rotors replaced.
View 4 Replies
Back in December i purchased a 2003 Impala LS. It has about 103,000 miles on it now. Overall the car runs and drives great. However on very rare occasions I have noticed if I have to slam on the brakes or really break hard I hear a grinding sound. Now I have only heard it maybe 3 times in the time since buying the car and never hear anything under normal braking. I had the brakes checked and was told they didn't see anything wrong, but what might cause this grinding sound I have heard a few times?
View 6 Replies
Replaced both rear calipers about 4 months ago, both were frozen. A few weeks ago I started getting some bad squeaking from the front brakes. The front calipers seemed fine when I did the rears.
Tonight I had even more fun with the beast. Drove to my sons baseball game and felt an odd "grinding" when braking. *Seems* to be coming from the front. On the way home, the grinding was worse and then the fun really started. Hit the brakes and the wheels started hopping enough to shake the whole friggin' truck. Leaving from a light, you could feel the brakes stick and then release, next stop was more shake n bake.
Not sure where to start on this one.
View 10 Replies
I have an 08 explorer 4x4 with 90k. I have a front end grinding noise. Noise is loudest at lower speeds and doesn't change with braking or turning. I have read that tires could cause this. I have the spare tire and rim on the front at the moment until I can afford a new tire. My other tires are all pretty new... And the spare is a different size rim but a brand new different brand tire. I'm going to check for play in the bearings tonight and maybe swap the spare to the rear .
View 4 Replies
Driving in snow, braking in this car routinely handles poorly and brakes make a loud grinding sound. It sounds like the front brakes. I just had a brake job from a trusted dealer. I read the thread here on the Honda Accord that reported the same sort of brake problem. The issue is the brakes, NOT tires as that thread suggests. Braking strength is greatly impaired under these conditions. I am very apprehensive about driving in snow, and ready to trade in what is otherwise a fine car.
View 7 Replies
1950 cadillac - standard drums on all 4 corners.
I put new wheel cylinders on each drum, and replaced the drivers front hose, as it was clogged. The passenger side I left because it works and doesnt leak. I've cleaned all the brake surfaces, shoes and drums, and bled everything.
When I brake, and only when I brake, the front right makes a grinding noise and the car pulls to the right.
I tried tightening the star wheel today to bring the shoes inward in hopes that would equalize brake pressure up front, but when trying again today, I got that grinding sound still.
There is no scoring or gouges on the shoes, drum, and the inner and outer ball bearings seem fine - round chrome balls with no discoloration, no gouges on the spindles. Granted I don't drive this far at all, especially now that I have this grinding.
How can I really tell if its the ball bearings? It only makes the grind when I am on the brakes.
View 19 Replies
