Lexus GX 2010+ :: Transmission Not Wanting To Engage After Being Put In Drive
Jul 6, 2014
We recently had an issue with our 2011 GX460. My wife first experienced the transmission not wanting to engage after being put in drive. Once it did engage there was a loud bang/pop noise, then no issues afterwards. The same thing happened to me this weekend. It was weird, like the brakes had frozen up then suddenly released and the transmission slammed into gear. We bought the vehicle used a couple months ago with 39k miles. With factory warranty remaining it will be heading to the dealer shortly.
View 14 Replies
Advertisement
I have had an issue with my GX470 almost since I bought it in 2008. It will sometimes not engage in drive after backing out of a parking space.
It usually happens when it is warm and the car has been driving for awhile then I park for lunch or an errand. I come back start up the car put it into reverse backout of the car space and nothing for a good 5-6 seconds. Seems a lot longer when cars are waiting to take your space and honking.
Anyway I have been reporting it to Lexus at every service and getting a no trouble found. Over time it is occurring more regularly and it even happened at the dealership but of course I was the only one in my car at the time.
View 1 Replies
Overhaul trans, new old pump, but doesn't engage in drive. Reverse and all three low work fine. Drive will only work when rpm's are applied. But without any power.
View 4 Replies
I have a 2015 Lexus rx 350 it is not all wheel drive. When I put the transmission in drive or reverse I have what I would call a double engagement. It feels like it is going into gear twice. It does not slip it shifts smooth.
View 1 Replies
Its a automatic transmission with a v6 4.3 vortec. The front axle will not engage, it is not the acuator (I replaced it and the cable) you can pull the cable and the axle will engage. There is a low buzzing noise(coming from the drivers side) until you give it gas. This noise stops when the front axle is engaged. The transfer case will go from hi to low without any problems.
View 1 Replies
Just a little background, my Ex is a 2000 V10 4x4 with 217,000 miles. I've owned it for a little under a year. Very clean truck, and well maintained by previous owner. Now the issue. Starting about a month after I bought it, it would occasionally hesitate to engage drive from park. I checked fluid and it was full and clean. I had a buddy recommended that I check for chafed wires in the steering column which I did and found nothing. It seemed to get better for a while but now it's back. It's doing it more than half the time I put it in drive and sometimes takes 10-15 seconds to engage. So am I probably looking at a new trans? Or, is there anything that can be done to save the old trans?
View 1 Replies
This transmission shifted smooth and strong through all gears until today when it stopped all of a sudden to engage either Drive or Reverse. No previous signs of slippage, hesitation, stalling or lack of power whatsoever.
We checked the linkage to the transmission and it works as intended, nothing loose or broken, everything is in place. If there was something slightly different with it from other similar vans we have then it had a slightly delayed engagement in Drive (it took a second to engage it after you moved the lever) - on all other vans we have the transmission go into Drive almost instantly.
Van is a '92 Pontiac Trans Sport/Chevrolet Lumina APV with the 3.1L V6 Chevy TBI engine with the 3T40 automatic transaxle. Where we should start tackling this issue?
View 13 Replies
Still having issues with the transmission on my 05 F350. I posted before that it would take a few seconds to go into drive or reverse. The fixes were to change filters and do hot flush. I had the dealer do a hot flush, and then I put about 1000 miles on it. That didn't seem to fix anything, so I went back in and asked for more info. They did not change the filters. I thought they did, but found out they did not after the fact, so I decided to change the filters myself.
The interior filter was easy to change. The fluid was clean, and the magnet had shavings on it but nothing that seemed extraordinary. The exterior filter is impossible to get off. I reviewed posts on here before trying, so first was the impact wrench, then the pipe wrench, then the pipe wrench with a block wedged in to keep the thing from bending, still no luck. The cast nut broke off well before the pipe wrench came out of the drawer. How to get that thing off. I read on here somewhere that no fluid goes through that until 180 degrees, is that correct?
Scanguage says it rarely goes over 160, except for last evening when I was stuck in traffic. It went to 187, with ECT at 208. During this period, traveling under 40 most of the time, the transmission was shifting erratically, to the point I wanted to pull over and allow it to cool down. But traffic broke free, speed went up, and temps went down. Shifting returned to normal, except when trying to engage drive or reverse. The 3-4 second delay persists at any temp, and there doesn't seem to be any slippage. Just delayed and sometimes hard engagements. I'm at a loss for whats wrong.
View 1 Replies
I have a 1999 F250 super duty that blew a front seal on the transmission two weeks ago. I sent it to a shop and they replaced the seal, and torque converter. However when they put it back in it will not engage in drive or reverse. After working on it several days we replaced the transmission with another one from a service company. This replacement came with a 90 day warranty. However once it was installed it does the same thing and will not engage in drive, or reverse. I am not sure what is going on but with two doing the same thing it makes me thing maybe electrical or something else.
View 1 Replies
After I push the switch for the 4 wheel drive, the light on the dash blinks but the front differential won't lock in even after driving around the block.
View 14 Replies
I have a 2006 F250 Lariat super Duty / 6.0 L engine / 143000+ miles / once started and transmission shifted into drive it takes 5 seconds or more for it to engage hard or if I build up the RMS then it jumps into gear hard, after it gets going it feels like I am driving on a washboard until it get warmed up good 10 mile or so. Is it the transmission filter and if so which one, I understand there is a small one on the outside of the transmission if so where? I can't find it.
View 14 Replies
I have a 2002 7.3 e350 quigley 4x4 Sportsmobile with 312k miles. 2nd owner. Bought it with 295k miles 2 years ago. From what I gathered the tranny is original.
After reversing at a downhill angle, stopping, and shifting the lever to Drive, the tranny doesn't seem to put Drive in gear and depending on the angle of the slope, the van will roll back or barely creeps forward even with throttle. Put it in 1st gear, and the tranny engages that in gear and drives forward no issues, then I can shift to 2nd, then Drive and the tranny shifts fine after that.
No weird tranny noises or clunking. Noticed this issue about a month ago or about a couple thousand miles ago. Did tranny service (drain, filter, fill) at the ford dealership at 305k months ago.
I can only replicate this issue when Reversing on a down slope. On a flat surface van Reverses and engages Drive like normal.
View 7 Replies
I have a 2006 Gx 470, which is the wife's car.
Yesterday I couldn't drive the car when 4WD shifter was in neutral.
The transmission would not engage in R or D.
Same thing when the car was put in low for the 4WD shifter.
However, it seems to drive normally when the shifter is in H.
When I went to put the shifter in Park from either the low or Neutral position it would have a high grinding noise.
Car is in the shop as we speak.
View 13 Replies
I have a 2015 Hyundai Elantra SE with only 3880 miles on it. I purchased it new last March. I have noticed when the car is cold when I shift from Park to Drive or Reverse to Drive, the transmission does not always engage immediately. It takes a second or so (not much over a second, but I haven't timed it). The car shifts smooth without any other issues. I have not noticed this concern when the car is warmed up, or seen this when shifting into reverse.
Should I be concerned about this shifting behavior? I have not contacted the dealership yet.
View 7 Replies
I got in my car this morning to drop my sister off to school and when I put the RX in reverse nothing happened for a second or two and then all of a sudden it jerked back. I continued to reverse off the driveway thinking what the heck just happened. When I put the car in drive the reverse camera stayed on as I drove off.
When I noticed this, I pulled over to the side and put the RX back in park and turned it off. I then turned it back on and the area on the dash that shows what gear your in, never turned on. My sister was getting late so I dropped her off and came home.
I turned the car off and waited 30 seconds before turning it back on. This time the reverse camera didn't engage in reverse and the small screen that displays what gear your in, displayed no image. Then a few seconds after that, the check engine light came on and so did the symbol of a car and squiggly lines under it. My RX350 is a 2010, and has just under 85k.
View 8 Replies
Lately, I've been having an issue with my 03 GX. It seems when the engine is cold and I back out of my driveway, when I put the truck into D, I feel the usual bump into drive, then it falls off and then a harder bump before I'm able to roll forward. If I don't pay attention and accelerate at the time the transmission seems to drop out of gear momentarily, the truck slams into gear and feels like I granny dropped it.
The truck is coming up on 120K. I've checked the transmission fluid and it is at the correct level.
View 4 Replies
The transmission went out on my 2006 gs300 it is a rear wheel drive car but i am having a hard time finding anything but an awd transmission for that year. Where I can get one? Or I was talking to a mechanic and he was saying the the only difference between the two trannies is a adapter to go from awd to 2 wheel drive cars so I might be able to use an awd trans and pull the adapter of.
View 1 Replies
I recently bought 2007 ES 350 drove @700+ miles, 2 times I had this incident in this week, the latest is today. In cold morning when I try to drive the vehicle when it is cold when I pull the lever to drive mode the accelerator increases the RPM but the car is not rolling or I should say very very snail pace, so I tried pushing the lever back to park, then reverse drive the vehicle and then engage to drive mode it works fine but I hear lot of fan sound. For initial few min I feel that it is not picking up much speed but then it becomes normal. It really tensed me. What action can be taken to resolve this?
As per the Autocheck report this was manufactured in Jun 2006 and the vehicle service records from Lexus web there is no sign of any transmission problem or fix to transmission. The car has 100K+ miles on it.
View 14 Replies
I have an interesting automatic transmission problem. Hot or cold makes NO difference. When the car is started, put in reverse it will work perfectly 100% of the time. When the car is started, put in Drive the transmission will slip for about 5-10 seconds before working perfectly. When the car is started, if you wait 3-5 minutes, then put it in Drive it will work perfectly.
View 13 Replies
I just purchased a 2013 ES 350, and I love the car!
Whenever I startup the car (engine hot or cold) and put it in drive or reverse,and lightly step on the gas to get the car moving, there is a weird stutter. Sort of like when your driving stick in the same scenario, but you let out the clutch a bit to fast and the engine wants to bog out, but your able to hit the gas just a bit more to keep it from stalling. If this were a manual transmission, I would disregard as we all know that can be a normal characteristic of manual transmission.
This being an automatic, I am worried that something could be off with the tranny or the engine.
View 7 Replies
I always thought the clicking sound I was hearing in the morning was coming from the engine. Then I realized the sound doesn't start until the car is in gear, either reverse or drive. After a few minutes it will go away but until it does, it is a noticeable sound. I still have a warranty. I am wondering what this could be.
View 3 Replies
