Lexus GX 2010+ :: Proper Way To Rotate Tires?
May 4, 2011
What is the proper way to rotate the tires on the GX and how frequent should be done?
View 14 RepliesWhat is the proper way to rotate the tires on the GX and how frequent should be done?
View 14 RepliesWhat is the proper sequence to rotate the stock wheels/tires? Is it front to back only on the same side or does it need to be crossed front to back?
View 6 RepliesSo i need to rotate my tires and i want to know if there a special way to rotate them and if i need to reset the TPM system so the computer know where each tire is? Usually I just switch back to front or, move the driver rear to the front, driver front to passenger rear, passenger rear to front and pass. front to driver rear.
View 14 RepliesCar is a 2000 Corolla CE with 4-spd auto. Is it possible to rotate one side of the front tire while the car is jacked up? How about if it is in neutral with the parking brake on?
View 5 RepliesI have a 2013 RX. This problem just started today. Have I accidentally changed some setting or do I need to take the car to the dealer for repair?
View 5 RepliesI have a new car now, 2004 Grand Prix GTP Comp G, got it at 88k and it now has 167k. Nearly no problems other than routine maintenance, but here I am with an issue I can't seem to figure out.
A few weeks ago, I blew a tire on the highway, ended up getting 2 new tires put on the front and moved the fronts to the back. Tires were then rebalanced and the alignment straightened out.
The guys at the shop said the front tie end rod needed replaced, but I'm pretty sure they were trying to make extra money off a new customer because my bill was going from tires/alignment to tires/alignment, bearings, tie end rods, and speed sensors.
Now, on to my issue. When I'm driving on the interstate, I notice a humming sound that seems to come from the front passenger wheel between 68-80mph. Soon as I go over 80 or under 68, it's gone. I noticed that the noise lessened when I veered to the right, so I assumed it was the bearing.
Took the car to my usual shop, had the bearings checked, got the front driver bearing replaced under warranty. Mechanic said the passenger bearing seemed fine. Got it on the highway again today, noise is still there.
3.8SuperPacer
2004 Grand Prix GTP Comp G with Ram Air
1998 Grand Prix GTP 40th Anniversary Daytona 500 Pace Car Edition
Just bought a 2001 v10 ford excursion limited with 127xxx miles. I have a few questions.
1. I can't get the front tires to rotate while parked and stepping on the brakes. I thought it was caused by the 35 inch BFG goodrich all terrian tires and a lift kit i dont know how tall but apparently i'm just a sucker. From the searches i did, i think the problem is that either the power steering or brakes doesn't have sufficient pressure to power both at the same time. what is the fix to this?
2. I found metal shaving in the rear differential. For lack of picture, the best i can describe it is that it looks like shaving off an ice block. Also, the fluid is gray and consistency of sludge. I searched and some said the shaving is normal and others said fix now. Which is it? I assume that the rear differential fluid needs to be changed.
On my MKVI the tire pressure monitor warning light would go off once the tires were inflated to the proper pressure. Does the MKVII do that or do you need to reset the system after every warning?
View 1 RepliesSo my saga continues with my rear brakes on my 99 Suburban - had a glazing problem that was eventually discovered, glaze knocked off old pads and then glaze came back again. So we replaced the rear drums and pads. A month and a half later I get an irritating squeaking noise.
Noise - when the tires are rotating they make a light squeaking noise, a rotating/pulsing squeak; when the brakes are applied they make a lower pitch squeak and if I apply just the right pressure on the brakes I can get the noise to go away (while also giving it gas to keep moving).
Last night I inspected the rear brakes and found an excessive amount of dust/grime on the pads. The drums we fairly clean. The pads had a heavy layer of rust/grime on them. When I ran my finger over them it left no mark on the pad because it was so heavy, but my finger had this sooty grime on it. The rust covered about a 1/3 to 1/2 of the pads (each pad had a different amount of coverage).
Everything is brand new and I'm not sure what is causing all the dust coverage.
I am inquiring what the proper way to use the A/C would be. Here in Sacramento my car will be hot as hell when I get in the car. I am still figuring out the best way to cool the car down. How does the "LO" compare with the temperature gauge? I am noticing that when I use the 65 instead of the LO that the A/C feels cooler, but that could be just me.
View 19 RepliesI jacked up my car, and found that the two front tires have about 1" to 2" different distance from the ground. Is this a suspension problem? Should I send my car to dealer for inspection?
View 10 RepliesI recently had my 2013 Lexus RX 350 15,000 mile service which included tire rotation and balance. The service was performed at the dealership where I bought the car. Less than two weeks later, both tires on the left side went COMPLETELY flat. The front tire so flat that it was actually coming off the rim when I stopped the car because it was driving funny. The distance was out of my garage and down the driveway. The serviceman initially said it was a slit on the outer edge of the tire. Now they are saying it was a pinhole in both tires. Is it possible something could have gone wrong during the servicing to cause the tires on my brand new car to go flat?
View 18 RepliesMy engine coolant is low, so I just picked some up from toyota to top it off. The bottle says to see the owner's manual for the proper ratio. I don't have mine handy. The best I could find was this PDF posted by Bob. But it doesn't have the ratio. What it should be?
[URL]....
When shifting from reverse to park or drive, the mirror tilts back up but not in the position it was prior. It is actually quite irritating because I would start driving and have to adjust the mirrors back to the desired setting. I've also just sat there and shifted from park -> reverse -> park and recalled the memory setting and I will see it make the adjustments.
View 8 RepliesAlternator on my 2006 GX failed, caused battery to discharge and vehicle stopped. Alternator was replaced, battery (was new) is testing fine. All electronics and indicator lights normal except Nav system. Display reads insert proper disc. I have ejected and reloaded disc multiple times, no change. Disc is OEM, one release back.
View 14 RepliesJust got a set of staggered wheels (first set) they are 19x8.5 and 19x9.5. Just wondering if you actually rotate the wheels or how you go about doing that?
View 13 RepliesAt what pressure the TPMS light is activated? I noticed my daughters tires were low and when I checked they were at 15 PSI and no warning. Its a 2010 MY Prius III .
View 7 RepliesKey batts are good. Car batt charged. Key remote function good.
Do I need to reprogram keys. If so, HOW?
I don't have car book. Could Lock smith fix?
Even after replacing the brake pads, I hear a scraping or grinding sound as the wheels rotate, one scrape/grind per rotation. It's particularly noticeable when I turn left, but the sound seems to disappear when I turn right. The mechanic said he doesn't hear it, but I think that's because he must have driven it on a gravel road. What else could be causing this noise? I worry that I'm making the problem worse by continuing to drive it.
View 5 RepliesI was pulling out from a side road onto a much busier road. I had a small gap, put it in pwr mode, and hit the accelerator. Much to my surprise I actually chirped the tires. I only use eco mode, so I am not used to how quickly it gets into the ICE when in pwr mode. Consider me impressed with how this car can actually do it all
View 2 RepliesRecently had some bad luck and need to get new rims - what's the proper offset for the R? OEM offset is et50 correct? I'm thinking of getting a set of either BBS CHs or RS4s but want to know what the best offset is for the rim.
View 7 Replies