Vsc and check engine lights are on. Took it to the dealer. He indicated that there is corrosion in electrical harness underneath car and suggested to replace the harness !! It is a 2004 with over 100 k miles ...
View 5 RepliesIt all started after I refueled at Mobil after a rainstorm a month ago. Could be coincidence, but right after that the car started jerking wildly and making a howling wind noise from the front. Thought it was the transmission. Brought to Lexus dealership, they told me nothing was wrong as I had low mileage on the car. There are NO Check Engine lights on the dashboard. Car "quieted down" after that, but the noise remains EXCEPT at high speed when it's quiet.
In addition to that, the jerking / misfiring continues at stops, reversing, and slower speeds on occasion only.
I tried Techron FI cleaner, but it has not made a difference. Filled up several times since then.
What's wrong?
On the road today and out of no where I see the 2 lights on. So I get home and find the port for the scanner. plug it in and retrieve the P0037 code.
I cleared the code and I'm hoping it will not come back. What exactly does the code mean? What might I be looking at in my near future?
Car has 109K and I have not had it serviced since 85K except oil changes. I use shell 93 octane gas. car sees lots of highway when I'm using it. 2004 RX 330 AWD.
Tonight, during a short ride, all the sudden the VSC TRAC, VSC OFF and Check Engine came on. Atfter home, I got the P0057 code from a OBDII scanner. The P0057 code indicates O2 sensor on bank 2 lower sensor. However, the interesting thing is I also lost the power seat adjustment on the seat memory. When I switched between L1 and L2 , the mirrors and the steering position changes and the seat did not. However, the adjustment buttons on the seat itself work correctly. I wonder if this problem associates with P0057?
View 4 Replieswent to have an oil change. Standard procedure. Wife drives the 330 away and the check engine and VSC lights come on. I figure it's the maintenance indicator needing reset, but no..... the reset didn't work. Went back to my local mechanic who changed the oil to run codes and see what the problem is. Code P0157 = bad O2 sensor.
Now, I questioned him as to why these lights would come on DIRECTLY after they changed my oil. Is there any correlation there? NO, he says. No reason why these lights would come on immediately after the oil change and we've never seen these two lights come on at the same time before.
I've read every post and thread I can, but it seems like every issue is different. Some times it's a loose gas cap or gas cap that needs replacing. I have to drive 60 miles to the dealer some time soon to have a recall performed, but until then should I worry about this O2 sensor and these lights staying on?
I've struggled all day in my tiny inspection pit fitting the catback, un-resonated A'pexi system which looks and sounds fab. Problem is the engine light and trc off light are now on?
I don't know why given the cats are still there? Have I upset the lambda sensors somehow? How to clear it? Can the fault codes be cleared a certain way?
2014 es350 with a bit over 5000 miles, today suddenly my malfunction indicator lamp and TRAC OFF lights both came on at once... What the causes may be since I can't get to the dealer until Monday. And is it still safe to drive the car???
View 11 RepliesRecently when starting RX350 the check engine light and Check AWD lights went on. Driving the car for a short distance it idled very roughly and had no power (could not exceed 50mph). Drove home, shut car off, and restarted within 5 minutes. All lights went out, and car performed well. No problems since....what could have caused this problem?
View 3 RepliesI have 2006 Lexus GS300 with 95K miles. My check engine, check VSC and traction lights came on. I get an error code: "P2757 Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance or Stuck Off ". I was given the following different solutions that may work: replace the solenoid, service the transmission or replace transmission.
View 14 RepliesI just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 RepliesOur '09 generally gets short trips, though last weekend it had a long one. Last night it was fine my wife drove home from work, but when we tried to head out for the evening the check engine, VSC, ABS and brake lights all came on. Nothing funky on the MFD.
I ran the battery check procedure and the low value was 12.0 volts. The instructions here say it should be above 12, replace if below. Here we are on the edge?
My wife drove it to the dealer and complained that the brakes felt like they weren't working properly. Sounds like she had only hydraulic braking, no regen.
When i was driving my 2005 Toyota Prius the Red Triangle, the ((!)) light, the vsc light, and the check engine light came on. I let it sit for sixteen hours without driving it and everything went back to normal. Three days later i was driving and the same lights came on. I let it sit again for sixteen hours without driving and it was still there.
When i was driving i recognized there was a terrible lag, and if i was driving for awhile it took me about one minute to get up to 45 miles an hour. It felt like i was driving in first gear or something.
I also noticed if i had the Heating and air conditioning off that hot air would pump from my back right, which is the seat behind the passenger, that vent was blasting out hot air.
I took it in to toyota and they said the water pump was bad So they replaced it, after replacing it more codes came up and one of them told them to replace the Hybrid Battery Pack which is 3,419 dollars.
I Drove it out of there today thinking that some of the problem was fixed with the lagging of the acceleration and the heating coming from the vents but it was not. I was reading online and everything pointed to the inverter pump where the engine is not being properly cooled, which would explain the excessive heat and the lagging. They claim it still is the battery, but i was watching the battery on the dashboard navigation system and it seems to be driving and recharging fine.
I was driving last night and my car Triangle Warning Light and Check Engine Light Went on along with on the nav screen a car with a ! mark in it came on. On The info screen the battery level was changing fast from fully charged to just about empty. The car lost almost all power going about 42 miles an hour. I was able to pull to the side and i waited 10 minutes then tried to turn the car on again. I was able to drive home and the warning lights were still on but at least my car had power. What could possible be wrong?
View 19 RepliesAs far as the owner can tell, the car is running fine. He hasn't driven it aside from getting home after the light came on. It seems to give a very informative error message. What it's saying?
View 4 RepliesSome days ago while I was driving, the check engine, red triangle and vsc lights came on and immediately my car slowed down. It would take longer to accelerate and every once in a while upon getting to a stop sign, it would take long to get to 5 from 0. could this be my hybrid battery going out? My regular scanner can't pull up any codes on a prius.
View 11 RepliesMy 2004 Lexus RX 330 with 116,000 miles has a check engine light on. The code was P2198, the problem: Bank2 Sensor1. I replaced the O2 sensor myself, easy, at $180. I erased the code and the check engine was back on the next day. Not sure what to do next.
View 9 RepliesMy 2005 Prius with 116K on it has been having some uneven acceleration lately and today the Triangle warning light, the check engine light and the brake light came on at the same time. I had about 1/2 mile to go, so I proceeded slowly and called the dealership which had performed a routine oil chg two days ago. They said that if the lights weren't flashing then I could drive it. They recommended that I take it to AUTO ZONE and put it on the analyzer. This elicited these codes: P3019: no definition and P0A80: replace Hybrid Battery.
I have an appointment in 2 days and I'm wondering about a salvage HV battery since the car is 7 yrs old and over 116K miles.
I was on my way to work this morning when the car just stopped accelerating (or so it felt), all the dash lights came on, I pulled over to the side of the freeway (I was very lucky). Radio and a/c were still working. Powered off, powered on too soon a couple of times - the red triangle and check engine both came on again. Cooled my jets and gave it a few minutes, powered on and the red triangle was gone, but the check engine was still on. Drives perfectly, no problems w/either gas or hybrid engine.
View 19 RepliesWhile my car was idling in a CVS parking lot, the VCS, Red Exclamation in a triangle, Yellow Exclamation in a circle and the check engine lights all suddenly turned on.
In reading the forums, it seems the two most likely issues would either be the inverter pump (which I had replaced as part of the recall, and I see the fluid moving in the reservoir), or possibly a bad 12v battery (which I had replaced last year with the forum recommended Optima Yellow Top).
I checked for error codes, and there were numerous ones there at first, but I think that might have been related to the old 12v battery dying (I never reset after that). I cleared the codes, and no new codes are generating.
Just got the car last week and now my check engine light is on and VSC lights are on and wont go off? 2006 w/ 75k miles on it...
View 13 RepliesThe car was misfiring and the check engine light codes were all sensor coils were bad. Lexus told me that it was coil6 bad and they fixed it. I should have had no problems, I got a whole 2 miles and I misfired and engine light back on. I drove for a while and light went off and then misfired again. Before I bring it back in I was looking for some insight. I can't understand how it wasn't fixed right the first time but I don't want to go back and get a few thousand bill either. Could fixing one coil cause another to go bad.
View 1 Replies