Ok, I can't seem to get straight info anywhere. I want to replace my turn signals (front) with LEDs because one went out (gives me an excuse). I can't seem to figure out exactly which bulbs to buy nor can I figure out if I need to get anything additional to make them work. I see things on a few websites, which say I may need the resistor (or whatever) to make it blink. But I can't figure out what, exactly, I need.
View 14 RepliesI've driven home from a tree nursery with a utility trailer - hazards on at about 60kph. Took me about twenty minutes to get home. It's a pretty warm day so AC was on. I turned the hazards off to signal turns and then put it back on when it was straight road.
After disconnecting the trailer and later driving to pick up the kids, I noticed the turn signals wouldn't blink but the hazards would still work. The AC would not respond, nor would any of the climate control buttons. The heated seat controls are dead and also the 12V DC outlet next to the seat switches seems to be dead. However, the airbag compressor control still functions normally, the diff lock button still works fine, the headlights and hi-beams still work as well.
I took a few minutes when I reached the first school to check through the fuse box under the hood but there wasn't anything obvious. I'm also considering just removing the negative on the battery to reset the computer. Then, there' s the window thing....
I have been searching the web and can't seem to find any information on replacing the turn signal halogens with LEDs on the 2013 ES350. Is there a hyper-flash issue? The Lexus LED Flasher Turn Signal Relay (81980-50030) doesn't appear to be compatible with the 2013 model. I don't really want to go the resistor route, am I missing something? I would like to install VLEDs Platinum 21 Amber(Front) and Red(Rear).
View 14 Replies2004 Prius here. The turn signals and hazard lights stopped working a few days ago. I found a disconnection in the grounding and repaired it. Also replaced the fuse and the flasher switch. Now the lights work, and I can hear the flasher switch clicking, but they don't blink!
View 13 Replies'04 Jetta Wagon TDI I just bought for my brother and his family. The car is in unbelievable condition even with 206k on it. I have met my match in automotive anal-retentiveness as there's not even a door ding on it. The tech who did the pre-purchase inspection wanted to buy it from me before I'd even paid for it!
The Hubster drove the car home after paying up and found that the "tink-tink-tink" sound from the turn signals continues on after the signal has been turned off. It's much worse when using the right turn signal than the left. It often does it for no logical reason, like when driving on the highway.
I owned a '00 VR6 GTI for 12 1/2 years (bought new) and never had this problem so I'm at a loss. We want to give the family a trouble-free car and are hoping this is an easy and inexpensive fix, not one of those really expensive .
I had a strange experience this week. Monday afternoon I discovered that my turn signals and 4-way flashers weren't working. I booked a repair appt at my Toyota dealer for Friday.
Wednesday evening I had to make a very sharp turn (270 degrees, roughly) and then discovered that my signals were working again. So I canceled my repair appt; the dealer speculates that there's a short circuit somewhere, which certainly sounds reasonable.
I have a 2007 F150 that it's brake lights and turn signals have gone out. What's wrong? I've checked fuses and connections.
View 1 RepliesA few days ago my speedometer stopped working. Then yesterday all of my gauges stopped working, as well as my turn signals. If this is a fuse issue then which fuse it is?
View 9 RepliesVolvo XC90 T6 AWD (2004) Changed my battery and now my turn signals won't work, won't show from display panel (interior) or light up (exterior), and my fog lamps are also not working. Used a memory settings save backup and checked fuses but can't figure out what's wrong. Electrical worked fine before battery change. Battery was aftermarket (non-OEM).
View 2 RepliesI was using a 2004 Heritage F150 and when I connected a trailer to it something got fried. I lost both my turn signals and brake lights. The trailer worked fine on my friends truck so I don't think the issue was there but with the 4-pin round connector that was on the truck.
I found two 10A fuses blown under the hood and replaced them but that didn't work. They were in slots 19 and 20 and are listed as the camper/trailer adapter fuses. The running lights still work. The interior turn signal arrows don't even light up or anything when the turn signal is activated.
I have a 2006 F150 xlt 5.4 3v. I've owned it since Oct. 15'. In approximately Nov. I lost the rear right brake and blinker light, and then around Christmas I lost the rear left brake and blinker. I also have no rear hazards, but the inst cluster flashes at a normal rate when the flashers are engaged. All running lights work, and 3rd brake light works. Front blinkers work and all other electrical works. Have checked all fuses and bulbs with no solution.
View 6 RepliesI have an 05 Freestar with no instrumentation and no error codes. None of the gauges work and most of the warning lights are lit when the truck is running. No A/C and no ABS while driving and turn signals work, but do not display on the dash. It appears that two separate code readers are not acknowledging the computer. The battery and alternator check out good and there is no drain on the battery when ign switch is off.
View 5 RepliesA friend of mine has a 2004 F150. The tail lights and the 3rd brake light are working but the rear brake lights, flasher and turn signals have stopped working. What could be wrong? I googled the problem and did find one person with the same issue in a 2001 F150. There apparently was a recall (#05S28) of the SCDS (Speed Control Deactivation Switch) but that vehicle kept blowing fuse 13. My friend checked his fuses and they were all ok,
View 14 Replies My truck is a 2004 F150 XLT, 4.6L 2 wheel drive extended cab
The truck starts fine. With no lights on, heater/ac blower turned off... my turn signals and hazards work as they should.
If I turn on my headlights, I have no turn signals and the indicators on the dash are slightly lit up along with my highbeam indicators. The actual dash lights do not come on.
The blower does not work at all regardless of whether the lights are on or off. Turning the blower on immediately creates the same issue as the lights. (no turn signals, slightly lit up indicators, etc). The blower does not work on any speed. I can hear the duct work changing direction behind the dash as I move the blower selector from dash to windshield to floor, etc. I can also hear the compressor kicking on for the AC.
What I have done: I have checked all the fuses. I have attempted to remove every one of them while running to see if anything shutting off would let the blower kick on. I have unplugged the blower entirely wondering if there was a dead short. I have removed and unplugged the resistor to see if that might be an issue. I have also removed the right side kick panel and checked the ground wire there that runs to the dash. Everything so far seems to be in good order.
So I have an 04 F250 Super Duty 6.0L and suddenly the turn signals and hazards stopped working. First I replaced the switch on the steering column...no luck. Today I replaced the flasher relay under the dash panel (the blue one)...still no luck. I remember checking fuses in the fuse box but don't remember which ones I checked but I didn't see anything obvious. I also took a quick look under the dash at all the wires for any anomalies...nothing. I'm lost... What to do next!?
View 1 RepliesMy brake lights, turn signals, and flasher are not working in my truck. Is it a fuse and what fuse? Could it be a relay?
View 2 RepliesI have a 2004 350. Turn signals quit working don't come up on dash either but when I turn the flashers on the left turn signal on come on that's on the dash and the lights. I replaced the turn signal relay that's under the radio. The old one would buzz when I turned the turn signal on but nothing would come up the new one clicks as it should but I'm still not getting turn signals lights on dash nor the light it's self. The flasher is still like it was only the left one comes on.
View 1 RepliesMy 2007 F150's turn signals and hazard lights quit working. I checked the fuse and it was blown. Once I pulled the old fuse out the truck wouldn't start at all. What happened?
View 3 RepliesHow to fix or solve front turn signals that are not working? I just realized that both the front signals on my Prius doesn't light or flash when making a turn, the rear are working fine. Is this an easy fix or should I bring it to the dealer?
View 4 RepliesI have a 99 gmc jimmy. Head lights and tails lights work. But not the Hazard and or turn signals. I checked fuses. I'm thinking it might be the plug under the ash tray. But I don't want to pull off the dash to find out it isn't that.
View 4 RepliesI just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?