Lexus GX 2004-09 :: Replaced HID Bulb - Burnt After Three Hours
Aug 2, 2011
So I bought an unused/uninstalled HID kit (Xenondepot) from another member on the board recently and installed it in my GX470. I have had aftermarket HID kits (Toyota OEM ballasts and D2S Philips bulbs w/adapters) in other cars so I know how to install them and what I need to be careful of (don't touch bulbs, good connections, etc).
Well, after about three hours of burn time over a few days with about 6 start up strikes, my drivers side is failing. The bulb did not strike one time so I turned the lights off, waited 10 seconds and turned it back on to restrike the bulbs and the both came on. When I started the car later that evening, the drivers side did not work again. I tried the same restrike process and no dice. The drivers side never came back after that.
I know XenonDepot has no liability to me since I did not buy the kit directly from them but I am not sure where I should buy a single replacement bulb from since it seems like the new bulb was defective (the kit was brand new and uninstalled).
View 11 Replies
Advertisement
I just replaced a burnt out tail/brake lightbulb and found that I had sockets for 5 lights yet only 3 were filled....two were empty. How could this have happened and shouldnt they all be filled? I replaced the blown one but I feel like I should get 2 more per side to make it a full housing. I also am not certain what kind I need . The turn signal bulbs are fine....it's just the tail/brake light bulbs. Why were they not filled? 2002 V6 Passat.
View 7 Replies
So a few months ago my right front HID headlight went out and was replaced by Toyota (under the 50K HID Headlamp warranty). The next day, it was out again. I went back to the dealership and they looked a little deeper and told me it was a burnt terminal. What the report said was: "Found Burnt Terminal #1 connector H5 and head lamp cover, harness. Need to remove right head lamp assembly to:
*Replace Rear Headlight Cover
* Wire harness between cover and ecu
* Replace connector H5
* Repair Terminal #1 at connector H5
The headlamp was fine for a while and then the problem came back recently. The right headlight would be out when I started the car... and then it would usually flick back on after driving for a few minutes.
View 13 Replies
How to get the bulb changed out and what kind to use?
View 5 Replies
The ESP light to come on while cruising on dry pavement and then the burnt bulb light to come on. They both stayed on until the engine is restarted. I had 3 incidents with the same behavior so far in a month and they stayed on for the duration of the trip.
View 1 Replies
The bulb in my overhead dome light has burnt out. I have the 194 wedge bulb. I have a moon roof. The owners manual gives no instructions to replace the bulb. I have looked the area over and do not see any easy way to gain access. Any instructions to replace the bulb?
View 2 Replies
02 Camry, how to I remove the burnt license plate bulb? Took off the underside trunk carpet and disconnected bulb harness, but I don't know how to remove the plastic piece that holds the bulb in place. Does it pull out, or twist out? I don't want to break it!
View 1 Replies
I was changing out the little parking light bulbs outside of the housing with led bulb and it fell into the housing of the headlights!! Wow my luck do I have to remove the whole bumper to get this bulb out of the housing?
View 6 Replies
Lexus IS: How to Replace Your Tail Light Assembly
Step by step instructions for do-it-yourself repairs
Browse all: Lexus IS Lighting Guides
View 7 Replies
How to change the bulb on the rx330 fog lights. It doesn't say it in the manual.
View 14 Replies
One of my headlight is burned out and I would like to replace. I don't want to go with OEM. Looking something better and brighter. 2008 GX....
View 1 Replies
Recently my 05 RX330 had the driver side low beam bulb go out. I took it to a few places and they said take it to the dealership as they have special tools to change it. Of course I took it there and they were ready to charge me an arm and a leg to get 1 little bulb replaced. My question is do you have recommendations as to what I should do to get this fixed and not have my wallet get destroyed?
View 8 Replies
So I started having the issue with my drivers side headlight going out and saw the many threads regarding issues with the bulbs and ballast.
I started out purchasing a new bulb, from ebay TOYOTA PRIUS GENIUNE PART PHILIPS D4R 42406 XENON HID HEADLIGHT LIGHT LAMP OEM
Came in "Toyota" box. Got the bulb in and still had issues with the light turning off... so then I bought the after market ballast and replaced it yesterday. Light still going off.... What to check? Just read the article regarding bulbs, going to pull out the one I just got and have a better look at it.... Not all HID Bulbs are created equal.
View 1 Replies
I have a 1997 ford f-150 flareside 4x4 and the interior lights have not worked since I purchased the truck.I checked the bulb and it was burnt out so I replaced it and still does not work.
The truck was hit on the 3rd door on the passenger side before I bought it and I think they may have done something to keep the interior light from coming on by accident when not shutting the door all the way.
I checked the number 14 fuse which is where I think the interior fuse it on this truck, what I could check to be my problem?
View 14 Replies
I was trying to replace the bulbs in the running board and the first bulb I tried to replace when reinserting the bulb came loose and fell in the housing.
Is there anyway to remove the running board light assembly or how to get the bulb out of there?
View 5 Replies
I have a RX330 and recently noticed that both the RH and LH outer tail lamps bulb sockets are melted.
View 2 Replies
The light bulb just above the interior door handle in the front passenger door is blown on my GX. I'd like to replace it, but I'm not sure how to get access to the bulb.
View 12 Replies
The passenger side HID bulb of my 2005 RX330 need to be replaced, how to? Also there is condensed water in the assembly. I am going to replace it later. Where are other screws beside two on the top?
View 14 Replies
Had rotors and pads replaced 40,000 miles ago at brakes plus. I went in last week to have them checked and the front pads were almost like new but the rear pads were down to 2mm and now they have to be replaced.
View 5 Replies
I spent all day replacing my knock sensors and after getting everything back together now it wants to overheat. The thermostat is not that old before today there were no coolant problems.
View 1 Replies
Original battery died after 5 years service. I replaced battery but discover that certain electronics don't function correctly. Windows and door locks are messed up. Driver control won't operate front passenger window; but rears are OK. Driver door lost "one touch up/down" function. Door locks are sketchy. Question: is there some re-booting or re-programing needed that I can do? Dealer only item?
View 9 Replies