Today I happen to notice that both sides of my running board rear light is loose. Tried a bit and did not figure out how to put them back in place. Since both sides got loose, I guess it is a quite common issue?
View 4 RepliesI was trying to replace the bulbs in the running board and the first bulb I tried to replace when reinserting the bulb came loose and fell in the housing.
Is there anyway to remove the running board light assembly or how to get the bulb out of there?
Just noticed this that my passenger side works perfect but drivers side running board lights (both) do not light up---Is there a fuse to each side, I looked and didn't see anything unless I'm missing something.
View 9 RepliesAlright so the woman finally picked up a GTI but the MFD is saying check rear side lights for both left and right. The car has a euro switch installed and when I turn the lights off completely then back on all the way to the right, the lights come on for about 6-7 seconds before turning back off (making a chime/warning sound). Could it be the Euro switch or maybe the lights going out? Fuses are good.
View 3 RepliesSeveral weeks ago someone backed into my '97 RAV4 in a parking lot. Body shop charged around $900 for the repair (estimate indicates labor for both headlights, but doesn't look like they replaced them). This afternoon one of the low beam headlights burned out. I went to change both sides just to be safe. On both headlight assemblies, grasping the wire assemblies to the low beam bulbs, the headlight assembly on both the left and right side is loose within its housing. I've changed the bulbs in the past, this is something new. Take it back to the body shop? What happened????
View 7 RepliesI just purchased my daughter a used 2006 Prius and we found water in the rear right passenger floor board this morning. We have only had the car 3 days. There are on leaks that I could find inside the car. I looked in the tire well and water was there and also near the 12Volt battery also. The brownish/yellow sealant in the tire well that goes around the bottom is also in my 2010 Prius but I noticed that my daughters 2006 Prius the sealant or what I believe to be bodyflex is cracked. I am going to have a body person look and see if he agrees with me that this bodyflex is cracked.
View 2 RepliesI have 2007 GX 470 and recently I noticed that head lights are running during the day light time and it is set up for Auto Lights (I own this car for the past 5 years and it was never an issue). Is there any quick fix or...?
View 4 RepliesMy inside dome lights and running board lights used to turn off after 30 seconds or so, after closing the door. I noticed this evening, they are staying on for 10 to 15 minutes before shutting off. I thought maybe I left the inside rolling switch on next to the headlight switch, but that was not on. I washed the vehicle earlier and dried out the contact points for the rear window and barn doors using WD-40 and wiping that off, as I noticed they had a little water around them after washing. I have washed the vehicle a few times before (had it only 3 months) with no problems until now. Lights are still staying on an extended period of time.
View 3 RepliesI'm not talking about the attachment of mirror to glass, I mean the mirror arm/neck/pole/thing to its base.
It seems like there's a loose Torx screw (is it? I can't see it clearly).
What tool I need? It's out of warranty....
I have a 2005 Excursion V10 4WD Eddie Bauer edition. Within the past month I have noticed that the interior dome lights and running board lights don't always come on when I open the doors. The dimmer switch is set to the highest level without being turned on and all of the dashboard lights work. I turn the dimmer switch on and sometimes the interior lights work and sometimes they don't. The door switch seems to be in good shape as well. If I turn the dome lights on individually they work so I know that there is not a problem with the bulbs. Where I can look for the problem?
View 3 Replies2002 Exc, 7.3L TD, Some one broke into the truck last week by jaming a screwdriver into the door key lock. Tried to pull the ignition out but failed. Pulled the A/V system out, cutting wires and such. So the dealer (insurance covered it ) installed the new door lock and said nothing is wrong with the ignition. But now the dome lights and running board lights come on at random and kill the batteries.
Could it be the ignition? Or something inside the driver's door? The batteries are brand new.
I just picked up an 01 V10 Limited 4x4 and one thing I noticed is the drivers side running board has a very soft spot right where I step to get in. It seems solid both forward and behind that area. Any suggestions for reinforcing the stock runingboards?
View 6 RepliesI am experiencing a loud clunk sound at the end of the extension cycle. This is on the driver side and it appears to be associated with the back hinge assembly. Is there an adjustment for the length of travel? There appears to be a slight amount of play if I pull up on the aft end of the board. There is zero play in the front hinge on the driver side or in both front and back on hinges on the passenger side.
View 3 RepliesIs there any way to keep the interior lights and running board lights from coming on when you open the doors, really would like to keep them off all the time.
View 7 Repliesif 08 factory running boards will fit on my 15? After ten weeks of waiting she finally in town but the dealer told me I never mentioned running boards so it's either swap my old ones or pay 600 for some after markets similar to the factory running boards.
View 6 RepliesThis bad squeaking, loose rattling and (sometimes) banging noise from the left rear started happening about a couple weeks ago. I've removed all interior panels, even the exterior bumper thinking there was something loose and nothing. I suspect as a last resort it has to be the suspension despite the car having only 17k km.
What is strange is the rattle increases in sound volume and occurs more often the longer you drive and also if temperatures get colder.
In other words, if I have the car parked in my garage overnight (slightly above 0 C) and immediately drive next morning into sub-freezing temps and on bumpy roads, you don't hear it. But after 5-10 minutes of driving, you start to hear it and gets louder and more frequent.
Searched other threads and some have reported the shock as the problem for 2010/2011 models, but none had any sound or video to compare.
The video shows how bad it is : [URL] ....
After a rough winter here in NJ there are a ton of pot holes and I think I may have jolted loose the rear view mirror. It now shakes so bad I can't even look at it. It makes me dizzy. It seems like it is loose where it connects to the windshield, not where the actual mirror connects. I took off the smaller of the two covers but didn't see anything I could tighten. It also doesn't appear that the actual mirror comes apart. I have to point it away from me at night, it's like a strobe light!
View 4 RepliesThe front of the rear bumper on the driver's side is loose from the main body. The clip on the bumper is ripped from where it tore. I've gone ahead and bought the clips and everything from Lexus near me, but need to know the best epoxy or glue to reconnect the clip area on the bumper so I can apply the clips.
Is the bumper on that spot (the back side of it, not the painted exterior, if that makes sense) fiberglass.
Just bought a 2002 F-250 Crew Cab. It has the factory style running boards with the lights at each end. None of them where working so I changed the bulbs and still nothing. I decided to follow the wiring to make sure everything was good and found that neither one of the boards are plugged into anything. They both have about a 2' loomed harness with a plug on the end of each board and it is zipped tied to the frame. But there is no wiring nearby to plug it into, I have checked everywhere. I can run extra wiring no problem if I can find out where they are supposed to plug at.
View 14 RepliesI noticed when I got my CPO 2013 GS350 that the rear view mirror has some "give" - it feels a little loosely attached to the windshield and there is some play before the adjustment actually starts to engage. It also rattles sometimes with road vibration as a result. Is this the usual for GS350 or has mine come loose?
I noticed when I got an ES loaner vehicle that the mirror was firmly attached to the windshield.
The rear spoiler on my 2005 has always had a bit of "flex" to it and I've always been careful not to use it to open or close the hatch. Unfortunately, I can't be sure that others not do that as it really is the place someone would think to grab to close the hatch.
Anyway, the other day I noticed that the spoiler had picked up a nasty rattle whenever the hatch was closed. Looking from the outside in I saw that there appeared to be two plastic fasteners (one on each end) that held the spoiler in place. If I pressed down on one side the other side popped up and vice versa. I was able to get the spoiler back to where it originally was (loose but no real rattle).
The car has never been in an accident and the spoiler doesn't appear to be bent in anyway...it just seems as if the fasteners aren't holding it down as tightly as they should. Is this the norm? Should I replace the fasteners and any instructions on how to do it?