Lexus GX 2004-09 :: 2005 GX470 Stuck In Neutral Or Limp Mode
Jun 12, 2013
My wife started up my 2005 GX470 this morning to go to work and drove maybe a half mile before she noticed a problem. So she turned around and drove it back home in limp mode. She put it in park and got out.
Most of the Warning Lights are on ( VSC OFF, VSC TRAC, Anti Skid, Check Engine etc). I tried moving the shift lever but there was some resistance and some grinding noises. And it now seems to be stuck in neutral.
How to diagnose this myself? We only drive this vehicle in the winter, and it was fine the last time we used it.
View 7 Replies
Advertisement
The 4 wheel stick shift is stuck between H and L and would not engage either .. what can be done..
View 4 Replies
I have a 2005 2.7L Santa Fe that was shifting poorly and getting stuck in limp mode intermittently. I read up on it and found that it was probably an issue with the input/output speed sensors. The codes confirmed my suspicions and I replaced both the input and output sensors. The codes cleared and the tranny shifted like a dream. Unfortunately after 2 days and 100+ miles the car suddenly started down shifting randomly on my way home from work. The CEL came back on and the car went into limp mode. Could the sensor have gone bad again? Or could it be the wiring harness that plugs into one of the sensors? I don't understand why the car would be fine for a few days and then all of a sudden be acting the same way.
View 6 Replies
Wife come home the other day after leaving for work with the truck no going past 20KM to 30KM.. After some investigating it seems to be in Limp - In Mode. There was a Check-Engine light & after further investigation found a Vac hose with a leak, repaired this & test drove. Same issue.... then there was a loud hissing sound from the engine area so I investigate & now found the EGR sensor (DPEF pressure sensor ) had blow a hose & fried the sensor.
New sensor was replace along with 2-hoses cleared the engine light but the truck still will not go more then 20KM or 30KM max.. I checked the EGR valve with vac pump & engine stalls or so the valve is good. I have left the neg cable off the batt to try & clear the Limp-In mode without success. Looking for a way to clear the limp-in mode or do I need to clear it with a scan tool?
View 7 Replies
I have a 2007 Prius and it will be my first car once I get my license. It has a bad traction control computer and is stuck in limp mode. I have a neighbor who has worked on these and will show me how to replace it. Right now I have two questions. I keep coming up with how to disable it not the actual part.
View 1 Replies
I have a 2005 Prius. After driving home from a 95K routine maintenance inspection, the car (with the display indicating 50% in the gas tank) went to limp mode and then stopped entirely and had to be towed back to the dealer. The codes pulled were
P0A0F (Engine failed to start)
P3000 (Battery control system)
B2799 (Immobilizer Malfunction)
P3190 (Poor engine power).
The techs concluded that the car was simply out of gas and the display incorrectly showed I still had gas in the tank due to a broken sender in the tank. They also said they added 1 1/2 gallons, and the car ran fine again.
However, I keep meticulous records of when I get gas, and according to my numbers I had at least 5 gallons left in the tank. Sure enough, the tech topped the tank up, which only took 4 gallons, so clearly my tank was not empty when this happened.
View 8 Replies
Got a 2006 GX throwing a P2445 code and car goes into limp mode. Is this the Air Injection Pump? Where it's located?
View 7 Replies
My wife has a 2006 santa fe 3.5l limited over the winter it started acting up went into limp mode and would only go 20mph so I went and picked up a TP sensor well it went out of limp mode so I never changed the sensor well last month it started doing it again so I changed it out didn't work!!! comes up with 2 codes sometimes p2110 and p2118 but normally its p2110 2 times.
If I hit the break it kinda bogs down and pulsates.i took it to my mechanic since I couldn't figure it out and with advice from a hyundai mech. He changed APS didn't fix it so we changed throttle body with used of course didn't work I checked wires and didn't fined any open circuits what are the chances that i got a bad APS or TPS...
View 3 Replies
My tranny is stuck in limp mode. I can manually shift it, but it won't shift on it's own. The 'automatic' part of the automatic transimission is definitely not working right.
I searched and checked for the usual suspects, low battery or alternator output (measured over 14v at batt. when on), and the range selector switch. I removed the switch, took it apart, cleaned it up, and reinstalled it. It looked like it was in decent shape inside, although it appeared to have had a bit of oil of some sort that had leaked into it. There was a bit of oil on that side of the tranny, around the gear selector and switch, but not enough to actually drip as I don't have any stains on my driveway where I always park. The only thing I haven't checked is the atf fluid level, as I can't seem to find the my wrench that will take off the fill nut. I'll get that figured out tonight.
The tranny hasn't been taken care of like it should, I've had the fluid replaced two or three times over 100k of ownership, but I'm not sure about the filter. Would the need for a filter and fluid change cause it to go into limp mode? Also, it's not throwing any CEL codes either.
View 14 Replies
So yesterday, this had happened for the third time in 3 years owning this car. Unhooking the battery for 20-30 minutes resets the computer and it is ready to go for a while with no issues. This has become annoying though. What is causing the car to enter "limp" mode and stay in third gear? One time it happened, I brought it to AutoZone and they did a scan and came up with the speed sensor. I haven't replaced it because it didn't happen for a while after that.
View 11 Replies
A few months ago, my '00 Sentra developed a rough idle but I ignored it because it wasn't too bad, until recently at least. It had been getting progressively worse so I went out and bought some CRC MAF cleaner, which solved the rough idle altogether for about a day. After doing some errands, I started the car but it was now stuck in limp home mode, not matter how much gas I gave it, she wouldn't top 20 MPH and 2.5k revs.
I bought a new MAF, and that made the problem worse: in any drive gears or reverse, when given any gas, the engine would stall and die but when in neutral, I can rev it as high as I want to. I reset the computer and cleaned the new sensor to no avail. After re-installing the old sensor (which was visibly broken, it was missing an entire wire assembly), it will run poorly but will now drive with some quirks, and I don't trust it further than around the block.
My question is: with the new sensor, do I need an ECU reprogram, did I receive a bad sensor, or is there a compound problem? (I've heard with similar issues: bad alternator, bad TPS, bad IAC module, dirty IAC or TPS, clogged fuel filter, bad fuel pump, dirty air filter, among others.)
View 7 Replies
Have a 2007 GX 470 with 70,000 Miles. Recently we have had problems with the ignition getting stuck. Key will go in, but, will not turn. Happens randomly and unpredictably. Will start after a period of time. Sometimes 30 minutes, sometimes several hours. My not happen for a few weeks or sometimes 2 or 3 times a week. Neither Lexus or Toyota claims to have heard of this problem.
View 14 Replies
I have 1 month left on my AAMCO rebuilt transmission. I took it in a few weeks ago when it went into "limp mode" (Stuck in 1st gear). Eventually, they got an error code of P0730, which I believe is electrical-related. All was pretty good but then today, driving @ high speed on the interstate, I could not get into 4th gear...
View 1 Replies
I am having a problem with my rear suspension. The indicator lights on the dash (for the rear suspension control) are working correctly as are the controls on the center console, however the rear of my vehicle is stuck in a high position.
View 14 Replies
I am the proud new owner of an 2004 GX 470 4X4 with 103K. I don't know how much cross over there is to tundra solutions. But, I own a 2000 Tundra, and I've been over there for a while as Listen Up Sonny. Anyway, I purchased the truck with two issues:
1. The 90K maintenance has been "deferred." I'm getting it into the shop for timing belt, waterpump, pulleys, and seals. I am going to do the spark plugs and fluids.
2. The issue I am still trying to figure out is that the dash shift indicator light for the High/Low gear shifter is stuck in Neutral. By this, I mean no matter where you shift the gear, the light indicates "N." I don't believe the transfer case is actually stuck in neutral since the car drives fine. I can get the center differential to lock and unlock. I am not sure if the transfer case will shift into Low as I couldn't really tell when testing it on a dirt low.
View 4 Replies
I have a 2005 GX 470, I noticed a sound, like that of a belt being loose, the sound came from the front of the truck. A few minutes later the AC stopped cooling, it was blowing really hot air and then the temperature of the engine went really high. I stopped on the side of the road, when we opened the hood, the belt was not broken but there was antifreeze everywhere.
View 5 Replies
I have been battling a big boost upon acceleration at stoplights for approximately 6 months. Now twice I have gone into limp mode and the tech reads: PO700 (Transmission) and PO731 (Gear 1). I just turned over 190,000 miles but only purchased it a year ago. What is the problem(s)?
View 1 Replies
I have a 05 gx470 and I was having trouble with the rear staying bottomed out and not pumping up. I replaced both ride height sensors. Nothing changed until about 1 hour of driving the compressor kicked on. it road better but still bottomed out some. So I raised the sensors about 5mm. it road great for about 10 miles then went back to riding on the axles. No compressor activity. Also when the compressor is not engaging the push buttons do nothing with changing the dash from H-N-L no matter when you push it. If you hear the compressor running all the buttons will work just fine. I have a useless car because it is not safe to drive when its riding on the axle bump stops.
View 8 Replies
2005 GX470 ... My Issue is that when I pump Gas ONLY in Calif it keeps stopping. I have tried all angles of the pump. I have tried holding back rubber on pump, but that will not work. This is something else. I have been to other states such as TX AZ NM & NV and this problem does not exist.
View 9 Replies
I have a 2005 GX470 with about 50K miles. Over the last few weeks it started exhibiting a weird problem. When accelerating above 20-25 MPH it starts shaking. Not the steering wheel. The entire car is shaking as if driving over rocks. It is pretty annoying, and I am now concerned as it seems to have gotten somewhat worse than before.
Tires are rebalanced and rotated, so i dont thing it is that. My wife is freaking out, as she is driving it with 2 small kids.
View 14 Replies
2005 GX470... Long time Toyota owner, first time Lexus with tpms. Light is flashing meaning a bad sensor from what I've read. Lexus wants $ to check and repair one wheel. Discount tire had a hand held checker and it found two bad sensors.
View 9 Replies
