Lexus GS 2013+ :: Wrapping Front Bumper Mid-section Parking Sensors
Mar 15, 2016
So I've seen a lot of people on here wrapping the mid section of the front bumper black to give it a more aggressive look.
For those that have done this, will I need to cut a hole for the sensors or will the sensors still work with the wrap covering them?
View 9 Replies
Advertisement
What sensors are in the front bumper? I slid out on black ice into a snow bank and it crushed in the bottom grille and as I'm clearing out the snow I noticed a sensor dangling with a broken harness that I was wondering what it was for. I have a nonFsport bumper with LED fog lights and both fog lights are operational.
Drivers side close to the fog lights
View 5 Replies
So my gf parked at the mall and when she pulled out the front bumper got stuck on the parking divider and came off on the left side. One of the fastening holes appears to be torn and it appears the bumper just needs to be put back in place.
View 8 Replies
I have a 2008 LS. The buzzer for my front parking assist sensors is significantly louder than when the buzzer sounds for the rear sensors. I have adjusted the buzzer volume to the loudest position (#5), but the volume of the buzzer when the rear sensors activate is still much lower than for the front sensors.
The indicators on the nav screen for all the sensors are working properly. Do you find the volume is different between the front and rear sensors or do I have a problem?
I am asking because I inadvertently backed out of a driveway into a car that was parked directly across the street. I do not recall hearing the sensor sound before I hit the other car. At the time, my sensor volume was set on #3. When I checked, I could barely hear the buzzer from the rear sensors, but could clearly hear the buzzer from the front sensors. Resetting the buzzer volume to #5 has worked a bit, but I still wish the buzzer for the rear was louder.
View 11 Replies
Dealer did repair work on front bumper. Now, after reinstalling a new front bumper, I noticed water starting to form inside the fog light assembly after it has rained. Dealer says this is normal due to our tropical weather. This has never happened prior to the repair work that was done.
View 12 Replies
Where the parking assist sensor is in the front. I placed my license plate too far on the left I am assuming and the sensor is going off. For now I have just turned off the PA until after work. (is the PA a small visible circle?).
View 5 Replies
I have a 2007 Prius 90'000km with new 12V battery from last year. The problem I have is that the front parking sensors won't turn off when I park my car close to an object and shut the engine off. This fully drain my battery and I have to jump start the car everytime I switch it on. The technician from Toyota repair shop couldn't fix it and proposed to switch the front parking sensors off by unplugging the switch under the wheel. That didn't fix the problem at all since it didn't deactivate the front parking sensor but only deactivated the switch.
View 7 Replies
Odd thing is now that the iPhone app updated, whenever I lock/unlock my car via the app the front and rear parking lights flash (DRL and tail lights), once when locking and twice when unlocking. That's never happened before. The doors would just lock/unlock with no lights. Found that a bit weird considering all that was changed was the app software, unless an update was pushed to the module in the car and I didn't know. Not really a concern but odd nonetheless...
View 2 Replies
2006 gs300 AWD , stock everything ,
I am experiencing heavy wobble,front section from 5 to 20 kmh , , like an unbalanced washing machine starting the spin cycle And again milder around 60 to 80 kmh. This is after tire change over to michelin pilot hx mxm4 65% thread .. professionally balanced .
I could still feel it with the blizzaks at low speeds, but way way less. Both sets are 225 50 r17 93v 35psi on original mags as per book
I was wondering if it could have any thing to do with tire wear geometry, or perhaps drive shafts ,but no clicks or noise from them.
View 3 Replies
How is it possible that the 350 F-Sport can track cars that are possibly coming at you while you're backing up, but it can't alert you to when you're getting close to a wall or other car that is stationary (aka parking senors).. Although I did back into a space yesterday and got no beeps as the car got closer to the other cars in the camera.
Another thing is having radar assist cruise control and no front parking assist... what's up with this craziness? The systems are actually installed in the car, but not able to beep at you?!
View 14 Replies
Parking assist & sensors for back is working and show alert in screen but no sound alarm. I need to get more information about the car i just buy it....
View 2 Replies
The front bumper keeps detaching from the clips on the side. Toyota has attempted to fix it 3 times with no success. The clips are not broken or cracked. The clips are the same on late 2012 Camry.
View 3 Replies
Wondered if others have had a problem with spots of paint peeling off front bumper? Bought car new and have 42,000 miles, rest of paint is in great shape. It is not terrible, but like keeping car nice, would be nice if covered under warranty. Been this way for awhile, maybe should have taken it in, haven't even mentioned it to Hyundai.
View 5 Replies
How to remove the rear bumper, I have to drill some holes to install some back up sensors. I rather not but I don't know if anything is behind there.
View 1 Replies
My Excursion had a mangled rear bumper when I bought it recently. I just bought a salvage one to replace it. I had it installed today. I want to salvage the backup sensors in the old bumper along with the license plate lights. How do these come out? They seem locked in there to me.
View 3 Replies
I'd really like to add these to The Beast, but don't want to drill through chrome. My bumper has some plastic running along the top (see pic). Just looking for info for the same bumper mounted the sensors there with success.
View 9 Replies
The front bumper on my L is a bit loose. It looks like there's suppose to be a clip there that may have broke off. What this part is? I'm assuming I have to take the entire bumper off to fix it?
View 7 Replies
I was hoping there were instructions on how to remove the 2010 RX350 front bumper cover somewhere? We had a little fender-bender, and I was planning on trying to replace some of the items myself. I'm handy, but always prefer instructions over trial/error!
View 6 Replies
I bought the car from dealer, there are now FOUR! holes on the front bumper. I don't understand why they couldn't just use the existing holes to put the license plate holder. Now I'm stuck with these holes and I'm looking for a cheap alternative to fill them. I like the clean look of the front end without the plates and don't want to spend a fortune at a body shop, but I also don't want 4 dots either. What I can do/use?
View 3 Replies
I have a 2013 Lexus ES350 and the left edge of the rear bumper keep pops open during the hot summer days. The first time I saw this gap between my bumper and the frame I thought someone has hit my car's bumper. After close inspection, the bumper is smooth as butter just like the first day I brought the car home. I took the car last Saturday to a Lexus dealer for an inspection. The service guy told me there is nothing he can do and maybe bring the car back on a weekday so their diagnostic guy can take a look.
View 6 Replies
I have a 2013 F250 6.7 w/ 96000. I ran over a log and tore the rear section of the exhaust. I was told to buy the OEM version or do the DPF/EGR Delete.
I don't have a lot of $$$$, so which way do I go. Whats the least expensive Delete.
View 14 Replies