Any 1 have their tire that have uneven tire wear? Mines is Dunlop and my front right tire has uneven wear on the outer thread. All other tire don't have uneven wear. I'm getting new tire for all 4 rims and check my alignment. My gs is a f sport rwd.
View 3 RepliesIt is an AWD model. My mother just purchased it used from a Lexus dealer last weekend. At freeway speeds, she noticed a shimmy, and she had one of her friends' husbands check the tires out (she's on a road trip and not near me or a Lexus dealer). He found that the tires are starting to delaminate in the front and thread is quite worn on the outer edges.
The vehicle has a warranty (30 days or 1500 miles) and of course Lexus is saying they will only pay for the front tires. (we don't know if that is the whole cause of the shimmy yet I might add). But to deal with the immediate problem, what is Lexus's recommendation regarding replacement of tires on an AWD 350? Do they really say it's ok to replace tires by axle? Because I know that can screw things up on some other cars. . .
I told her to read the owner's manual and see what it says on the matter.
I have am 01 6.8 two wheel Limited. about 150K. My question is about both the front tires having more wear on both the inner and outer edges. The inner is a bit more but not by much.
I have been keeping very close track of my air pressure because I know the usual suspect is low air pressure but I am running 75psi and the max sidewall reads 80psi. I have never had it below 72psi. The truck tracks and steers down the road very nice with no drift or pull to either side. wheel balance is good.
Front end align is good. I have no issues with how she drives down the road. Everything seems to be checking out to be in spec..?
I just thought I'd mention this observed wear of brake pads...I just replaced all 4 up front after about 128k miles...
@ 114k miles it was observed that 1 of the 2 pads of each front wheel had worn significantly more than the other (the inner more than the outer pad IIRC)....my expert mechanic rotated the two and I got another 14k miles out of them...I could have gotten a LOT more had they been rotated @ 50-80k miles.
I don't know if this is extraordinary, or more typical than I'd have thought...or a function of (failing?) calipers, or just how these (MY) calipers work, or just my driving habits (though I've owned the car for only 30k of the 128k miles on the odometer)....but....
In my case the new pads will get a 50k mile inspection and possible rotation if there is uneven wear between outer and inner pads....
I'd recommend that pads be inspected for (uneven) wear at one of the scheduled tire rotations....rotating the pads isn't much of a job, but it might be something for you to consider to get the most miles from the pads (that and better braking too perhaps).
Why are My Tires Wearing Unevenly?
View 2 RepliesHaving issues with front tires on 2013 Ford F150? I have a 2013 F150 with less than 20,000 miles with significant wear on the outer edges of the front tires. The dealer has alignment it twice rotated the tires 4 or 5 times and the problem isn't solved. I now have 4 tires with outer edge wear. What the root cause might be. The dealer can't figure out what's causing the problem.
View 14 Replies I decided to get an alignment (for the first time since I took delivery of the car). I noticed some unusual wear on the inner and outer tire. I will post a before and after pic of the alignment. As you can see they were unable to correct everything.
The shop says that the prius does not have any way to correct camber in the front nor was there any way to correct the toe in the rear.
I cannot think of anything that would have messed up the rear left. The shop was saying these repairs will need either a new control arm or strut.
I have a 2011 Camry SE which I leased brand new from a dealership in Ottawa. It has about 35,000 KMs on it. After my last regular maintenance at the dealership (32K oil/filter change with tire rotation etc.), I started noticing a sound coming from the tires. The sound is like low pitch boom boom boom boom. I tool it to the dealdership and they told me there is uneven wear on the tire which is normal for Camry SEs because they have wider tires that easily scallop during hard cornering.
Firstly, I do not buy that explanation because it's not the first car I have driven with a little wider tires. Secondly, I do not drive rough as most of the times I have my kids in the car with me. Lastly, I would think that if you are selling sports tuned cars, you would choose appropriate tires for it so buyers can drive it like a sports car.
I wonder why the situation became noticeable after the tire rotation. According to the rep at the dealership, all 4 tires have uneven wear so should I not have noticed it before the rotation?
I have a 1999 Ford Ranger XLT using the Futura GLS 225/70/R15 tires. The vehicle decal in the driver side door listed the recommended tire pressure to be 30 PSI. I have tried to maintain religiously along with proper balance and alignment. However, I've always had the experience of the tires wearing out more along the middle which seemed to indicate over inflation. The sections on either side of the center line seemed to wear out normally. For this reason I've had to turn in the tire prematurely as they become unsafe. These tires were made by Coopers Tire and distributed by Pep Boys. Have i been using poor quality tires all along? Do I need to lower my tire pressure below the 30 PSI recommended? If I do that wouldn't I be risking overheating and/or affecting my gas mileage?
View 13 RepliesMy 2014 Elantra Gt bought in May 2014 and 18000km on it now, the rear tires on both side are worn out pretty bad on the outter side of the tire. I took it to one of the dealer. The mechanic said that's not about the alignment, it's because I drove too hard in the corner..... So, I made an appointment with the other dealership which I bought the GT. I was told that it need the alignment and it's not covered by the warranty. I don't mind to pay for it but just want to make sure they will fix it.
I have the KYB on it right now. should I swap it back to the oem before I go to the dealer??
I noticed this yesterday when swapping out my wheels. What could be the causes?
Pass side
Drivers side
I checked my pads today and noticed that the drivers pad is worn about 50% more than the passenger in the front. What could be the problem??
View 5 RepliesI have a 2006 SC 430 with 20,000 miles on it The (run flat) tires are wearing on the inside and the dealer says that they need replacing The local tire shop agrees, and will sell the tires to me for less, and also throw in an alignment He says that alignment is the reason for the uneven wear But the dealer says that the wheel on my 2006 SC 430 cannot be aligned, and that the new ones will probably wear the same way
View 12 Replies2000 Ranger, see my sig.
Just had to swap out the pads on my truck yesterday. The pedal was pretty mushy and I was getting shaking in the steering wheel when the brakes got warm. Shaking wasn't all the time, only after they had been used quite a bit - say after city use and the brakes had to be applied suddenly. So I popped off the tires and swapped out the pads and replaced the brake fluid - flushed it.
On the driver side front, the pads barely had any real wear and the anti-rattle clip was all messed up. It was installed properly, but it looked like the pads had smashed into it. The rotor appeared to be warped, or at least out of round - but just barely. You could see it wobble slightly in one spot if you spun the hub with the caliper removed. The caliper itself was sticking slightly.
I didn't see any evidence of damage, the brakes flushed just fine although the fluid was incredibly dirty (because I haven't done it in a long while). On the passenger side front, the pads were worn down to the level I would have expected given the mileage. The wear was even.
My question ultimately is this - is the out of round hub the culprit here? Might there be something else going on like a caliper problem? Ultimately I plan on having the rotors surfaced - one of them certainly needs it and with new pads I might as well do it anyway.
My front driver's side Bridgestone Turanza EL400 (225/40R18) has premature wear such that the steel belt is beginning to show through the center of the tread. The front passenger side tire has no such wear and the alignment is good.
View 14 RepliesHaving issues with excessive front tire wear? I have had the alignment checked by two VW garages and a third party garage and all of them confirm that the alignment is good.
The VW garage also confirmed that as far as they can see there is no suspension issues, but the excessive wear on the front tires indicates that something is wrong.
I have owned the car since new in 2008 so know it has a clean history no accidents.
Both front tires look like this.....
I notice that my front passenger tire is getting some inner wear on it. The tire doesn't even have 5k on it. I know I should get an alignment that's a must but is there something that might be wrong with it anyways since its just the front passenger?? Balljoint, tierod end and etc?? I don't really have a local auto shop that I trust 100% so I don't want them to be like, there is 3 balljoints out and etc. I had the inner tierods (both) and a few balljoints fixed last year and then got an alignment done. Any tips??
View 4 RepliesI just bought a used 2007 Santa Fe Limited. It has 78,000 miles on it. I have gone bumper to bumper looking for problems and am pretty happy about the condition. HOWEVER, I have noticed a shuddering/bobbling, fairly faint, when going over slightly rough roads a low speeds. The tires are shot. But they are all exactly the same ... meaning the same wear more so on the outside. I believe they were rotated properly, but something is wearing the outside prematurely. Is the shuddering/bobbling the culprit? What is the most common issue for the Shuddering/bobbling at low speeds on slightly rough roads?
Next, I want a quiet ride. Handling is not a concern. Should I go with a slightly wider tire or slightly taller tire? Lastly, I need new mats. I want them to be the same as what came with the car. Do I have to go to the dealer or are there some vendors with better deals on factory mats.
Right Front Tire has excessive wear on Right INSIDE and car was pulling to the left. I rotated (or is it revolved?) my tires, and now the pulling has stopped......
OPINION: Bad tire that just wore poorly? Slight alignment issue that caused tire wear that then caused car pull? Wheel bearing issue causing tire wear? Or something else?
My '02 Ranger has had tire wear for a while now, and its on the inside of both front tires. I was thinking it was either toe or camber, or maybe both. I havent been able to get an alignment recently. If its the camber, should I get the camber kit from Ford?
As for the squeaking, it first happened last summer, and I sprayed WD-40 on the upper control arm bushing and it went away until last week (obvoiusly temporary). Now its back. Also happens while turning the front wheels.
2014 FX4 F. Got 6000 miles on the truck, front tires are wearing on the outside edge, and also when turning the wheels to the max in either direction I get a loud creaking sound,??
View 14 Replies