This is finally getting too annoying to ignore. The noise sounds like i'm dragging a piece of metal along the ground whenever i turn right. the sharper the turn, the louder the sound.
View 14 RepliesI have a 2000 Toyota Solara with 145,000 miles. When I make a right turn, there is a scraping sound like metal against metal. Its not loud or shrieking. Its hard to hear over talk radio. But in the garage I can hear it, and its been getting louder. I haven't changed or replaced the tires in awhile or had any other work done to the right tire since long before the noise started. Is this something serious that requires immediate attention or is it some loose piece of plastic?
View 2 RepliesI have a problem! I have only had my 07 gs awd for less than 2 months. I noticed this morning when I turn my wheel all the way to the left or right it makes a grinding or like metal on metal noise. My brakes were done only a year ago, and this noise only happens when I'm turned all the way to the right or left.
View 11 RepliesI have been getting this scraping noise coming from my front passenger side tire. At first it would only happen during the winter time and has gotten progressively worse. Now it will do it during left turns and at very low speeds when I'm turning the wheel also.... I checked to see if the tire was getting hot, and if there was anything hanging underneath, and found nothing.
View 1 RepliesI noticed that the driver side front wheel makes a metallic scraping noise while the car is turning right. It sounds like something scraping the rotor or shield behind the rotor ( a rotational/moving kind of scraping noise)
This only happens on a relatively sharp turn (wheel is turned 70~80% to the right). I don't suspect the power steering as there is no noise if the car is not moving even when wheel is turned to extremes. The scraping noise happens at any speed, as long as the car is moving. does not happen when car is turning left.
Note that I am 90% certain it is from the front... my ears may be playing a trick on me (kind of hard to listen precisely while driving). Where to start looking?
I picked my R up three weeks ago tomorrow. I took it in this morning because there has been brake noise from day one. The noise was a scraping, metal on metal sound that diminished a fair amount when the brakes were warm. I only got a very brief conversation with the service agent at the dealership this afternoon, and all he told me is that they had to order in new brakes. I don't know if it's just pads, or calipers or rotors or the whole deal! I'll get the whole scoop tomorrow.
View 5 RepliesI have a base v6. When I turn the steering wheel (for example, to make a left turn), it sounds like there is metal-on-metal rubbing. The wheel is not extended (turned all the way til it stops)...
View 2 RepliesMy 2012 Plug-in spontaneously started making a metal scraping/rattling noise in the middle of a low-speed drive around the neighborhood yesterday. Seems to be coming from the left front wheel area. I've checked thoroughly under the car and in the front wheel wells for anything that could be dragging/rubbing, and I can't find a culprit there.
It occurs while coasting in EV mode, so not ICE/exhaust related. The car doesn't pull to one side or the other. Only 9K miles, so I wouldn't suspect a hub bearing or any other significant wear to be causing this.
Possible clue or red herring: the dealer replaced the the left front tire and did an alignment two days ago, and the noise occurred within 15 miles of driving after that service.
Background: 2003 jetta; just changed rotors and pads on rear wheels a month ago, they are disc brakes
So the other day I was driving in a school zone at about 20 mph when I heard a VERY loud sound, like I'm dragging metal. i might also describe it as two rusty metal plates being rubbed against each other, but really really loud.
The noise is related to speed, it sounds cyclical and speeds up as the wheel turns faster. It occurs when I am NOT braking.
I parked the car and came back to it a few days later move it and the sound disappeared for the first 100 feet and then came back.
We did 2 things - we changed the caliper, and we also noticed that a caliper bolt was missing. I am pretty sure the noise was coming from that missing bolt - i think the caliper became dislodged and was making contact with the rotor. The caliper also seemed to be dragging a little bit so we went ahead and changed it too.
So...I just took my car in last week to replace the TPS and noticed that the car is now making a weird sound when I reverse (out of parking spaces, etc). The sounds seems to be coming from the rear of the car the sound is similar to metal scraping concrete and happens intermittently. I'm wondering if this is a random coincidence or if this could be related to the recent work done on the TPS. If my brakes hadn't been completely replaced a year ago, I'd suspect it might be those. What could cause this sound?
View 5 RepliesI got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 RepliesI recently worked on a 2006 with 140K miles that presented with the following symptoms:
The hybrid battery was at 1 bar; the ICE would not start; the car was in Ready, but there were no codes. As I let it roll off the flatbed wrecker in Neutral, it felt lumpy. If you have ever pushed a car (or run out of gas in one) with a manual transmission that was in a high gear, engine off, it felt just like that.
I popped the hood and could see that the engine crank was turning while the car was being pushed in Neutral. What else turns with the wheels? MG2, or more specifically, the MG2 ring gear. What is the only way that the wheels could turn the ICE crank? The planetary carrier pinions were locked to the ring gear.
Surprisingly, while I was looking at things, it did manage to start the ICE pushing it around must have freed the carrier pinions, so I let it charge the hybrid battery. It was basically the worst metal-to-metal noise that I have ever heard! I pulled the drain plug and saw about a teaspoonful of large metal chips on the magnet. The fluid condition itself was very good, not the black factory fill that I am used to seeing come out.
my '06 Honda CRV makes a short scraping sound when turning. But more interestingly, it only makes this sound when the car has just been started. If I've been driving, the sound will not occur. The sound itself is a short scrape which seems to originate in the rear passenger side of the vehicle. I've researched this problem a bit, but everything I've turned up is related to the AWD model, while my CRV is 2WD. Just had the brakes serviced and checked, so that's out as well.
View 2 RepliesI am having several issues. I got the lexus dealership to service my transmission recently. I got it back with a weird smell. It smells like body odor. I had to reach out to hendrick corporate for them to address the problem without charging me. Turns out it was the fluid they used. I could smell the smell from inside if i wasn't recirculating the air. They changed the fluid again and it still smells. Is my transmission doing this because it is too hot?
This smell was never an issue until after the first transmission service. And now I'm hearing a metal grinding sound in 2nd gear past 4600 rpm. It still shifts smooth but 2nd gear might be slipping. Something just doesn't seem right. o yea they gave me my car back with my brakes sticking after stopping in traffic. I took it back and was told my brake pads in the rear lost 2mm in less than 650 miles.
By the way this sound can be heard in 1st but is more prevalent in 2nd. It is not heard in any other gears. And when in sport mode the sound instantly stops when i shift up into 3rd.
I have been noticing a slight noise when turning left and I cannot recall if this is normal or not. Typically I always play music when driving. It's very faint and sounds like scraping. Seems to come and go depending on the temp....that is when warmer I do not hear it. I got less than 1000 miles left on the warranty and would like to get opinions if it necessary to take into the shop. Btw, the shop wants $125 to walk in the door...hence the hesitation.
Prius 2006 99200 miles. Never had an issue.
When driving in my parking garage, I can hear a slight metal on metal noise. An extreme example would be sharpening a knife on a sharpener, its not as loud or predominate.
-I've checked the lugs, they are secure.
Car has springs and spacers.
Scraping noise in front end when turning left. Have changed brake pads, calipers, and rotors on both front wheels. There was no scraping noise before changing.
View 2 RepliesMy wife drives a 2010 Honda Odyssey. Yesterday she told me that last week it started making occasional sounds like metal scraping. I heard it today and it sounds like a chain dragging, or something going on in the wheel. The sound lasts for less than a minute, and is then gone. The sound changes pitch/frequency with speed. It only happens with the car in motion, and only after it's been driving for awhile. It sounds like it's coming from one of the left side wheels.
There are only 36,000 miles on the car. We live in Northern California where the climate is mild and there's never salt on the road. I'm wondering if this model has problems with wheel bearings, or something else.
I hear a metal on metal scraping/screeching sound with the windows down and only when i drive by guard rails and other stuff sound reflects off of. I saw the traveling hub zerk thread and that's what made me think of it. I've zerked every fitting I've seen, but this ones new to me. Problem is I can't even tell witch wheel (if any) it's coming from. It's consistent with speed.
View 12 RepliesWhen driving at slow speeds and when I go over a bump in the road, I'll hear something like the metal part of the wheel scraping something as its turning. Only comes from the front drivers side wheel. It's audible enough that people usually turn to look when I'm in a parking lot.
Took it to the dealer, they 'test drove' it. Said they couldn't hear anything. Then said that whatever I'm hearing is 'normal suspension noise'. So after leaving it a full day at the dealer, nothing has changed. Since when is ANY suspension noise normal? But I don't think its the suspension. What to do? Take it back? Take it to another dealer?
We have a 2006 Acura MDX, 96K miles, well maintained. It has started making a disturbing scraping/grinding/humming noise from under the car, driver's side. It's random, sporadic, usually for 3 to 5 seconds; doesn't seem to be related to speed, braking or turning; sometimes barely perceptible, sometimes very loud. It drives fine. Wheel bearing maybe?
View 1 Replies