I have 2006 Lexus GS300 with 95K miles. My check engine, check VSC and traction lights came on. I get an error code: "P2757 Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance or Stuck Off ". I was given the following different solutions that may work: replace the solenoid, service the transmission or replace transmission.
View 14 RepliesA few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
During low rpm cruise and light throttle acceleration below 2000rpm the transmission feels like its lagging or doesn't engage until after like a second or two after you press the gas pedal down. Been happening the past couple months and I would like to find a fix for it instead of buying a used trans or new trans.
Just picked up this code the other day as well.
P2757: Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance or Stuck Off
Recently changed the fluid over a year ago with Toyota ATF @ Longo Lexus. Car has 140k+ miles on it.
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 RepliesI just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 RepliesI've struggled all day in my tiny inspection pit fitting the catback, un-resonated A'pexi system which looks and sounds fab. Problem is the engine light and trc off light are now on?
I don't know why given the cats are still there? Have I upset the lambda sensors somehow? How to clear it? Can the fault codes be cleared a certain way?
2014 es350 with a bit over 5000 miles, today suddenly my malfunction indicator lamp and TRAC OFF lights both came on at once... What the causes may be since I can't get to the dealer until Monday. And is it still safe to drive the car???
View 11 RepliesI was driving home and all of a sudden my rpms are at 3.5 4k rpm wont shift to next gear. I put in in tiptronic mode and shift it to 8 it works fine. Then about 10 minutes later check vsc shows on dash traction control light is on check engine light is on and the light next to the check engine i think it is the abs light. I havent pulled the code yet.
View 1 RepliesI got the Check VSC light on today along with the Skid Light and the Emission light. I got garage to read code said P0158 High Voltage on O2 sensor Bank 2 Sensor2.
He said O2 Sensor looks like its gone he Knocked it off and it has not returned as yet but the car still run right
However it went into service at Lexus Sheffield UK about 2 month ago and they said there is a crack in the rear exhaust pipe at the Y junction i said cant you weld it he said no you need new rear boxes as they are one unit.
I have noticed it is starting to blow a little now could this affect the o2 readings
GS300 Gen 3 2006 82000 mls serviced every 12 month...
On the road today and out of no where I see the 2 lights on. So I get home and find the port for the scanner. plug it in and retrieve the P0037 code.
I cleared the code and I'm hoping it will not come back. What exactly does the code mean? What might I be looking at in my near future?
Car has 109K and I have not had it serviced since 85K except oil changes. I use shell 93 octane gas. car sees lots of highway when I'm using it. 2004 RX 330 AWD.
Tonight, during a short ride, all the sudden the VSC TRAC, VSC OFF and Check Engine came on. Atfter home, I got the P0057 code from a OBDII scanner. The P0057 code indicates O2 sensor on bank 2 lower sensor. However, the interesting thing is I also lost the power seat adjustment on the seat memory. When I switched between L1 and L2 , the mirrors and the steering position changes and the seat did not. However, the adjustment buttons on the seat itself work correctly. I wonder if this problem associates with P0057?
View 4 Replieswent to have an oil change. Standard procedure. Wife drives the 330 away and the check engine and VSC lights come on. I figure it's the maintenance indicator needing reset, but no..... the reset didn't work. Went back to my local mechanic who changed the oil to run codes and see what the problem is. Code P0157 = bad O2 sensor.
Now, I questioned him as to why these lights would come on DIRECTLY after they changed my oil. Is there any correlation there? NO, he says. No reason why these lights would come on immediately after the oil change and we've never seen these two lights come on at the same time before.
I've read every post and thread I can, but it seems like every issue is different. Some times it's a loose gas cap or gas cap that needs replacing. I have to drive 60 miles to the dealer some time soon to have a recall performed, but until then should I worry about this O2 sensor and these lights staying on?
One day my VSC, Traction and check engine lights came on. Nothing seems wrong with the car. Took it to a mechanic, they said many things popped up on their computer (emissions, etc, including replacing computer). The car has 48k on it, the warranty ran out at 39k.
View 15 RepliesVSC, Check engine light just came on my 2006 GS300. I only have 50k miles on it. I had this happen a few years back and it was the Gas cap o-ring. This time I changed the gas cap and reset the codes but no luck. After starting the car, with a minute the lights come back on. So checked the code and here is what I'm getting:
P0031
Heated Oxygen
Sensor Heater
Control Circuit Low
Bank 1 Sensor 1
Doing a search for the code yields this: [URL] .....
Changing the sensor vs. checking something else that might be the issue?
I have 07 350 and my check engine light is on, i had it scanned and they told me that the code is BP0013 and bank 1 Cam position sensor is bad. What that code means and where is that sensor located???
View 9 RepliesI've got a 2009 Mazda3 hatchback, 31,000 miles. As I'm sure you know, it's very cold in the Northeast today. It was -12F on my drive in to work! I went out to lunch with a coworker today, and it had warmed up quite a bit to about 25F. As I was driving back to work - 40mph on a dry, straight stretch of road - my check engine light and traction control/stability control light came on. They aren't flashing, just steady. The traction control light will flash if I hit a particularly bad patch of slush, but it's never lit up on a dry road before.
Right after the light came on, the automatic transmission started feeling...funny. It was shifting hard, although downshifting felt okay. My coworker even noticed before I said anything. I don't think it was the traction control - it was specifically as the automatic transmission was shifting, not at any other time. I've read through the TSBs and didn't see anything relevant, and I've already made an appointment for tomorrow at the dealer. I've only got 5,000 miles left in my warranty so I'm a little nervous - the car has been terrific so far.
I would think the traction control light would be unrelated to the transmission, so I'm a little confused. Also, just to rule out a few other things - the last time I got gas was about a week ago and I still have a third of a tank. I don't think this is a gas cap problem or frozen gas, both of which I've experienced before (in other cars).
I have multiple O2 codes on my '02 gti. It is giving me a check engine lights as well as the traction control light on. I received 6 codes all but one of them had to do with the O2 sensor and a short except for one that came in as the MAF. Both O2 sensors have been replaced and the codes still won't clear. I bought it in this condition, it runs really well so i wasn't to concerned about it, but the lights are starting to get annoying.
View 2 RepliesI have a 2006 lexus gs300 rwd and my check engine light came on the code P0021 and the check VSC light is on as well and a knocking noise i checked my engine level and seems to be fine but thats just because im always adding oil since its burning a quart every 500 miles which is a lot so whats going on here? Also my idle seems to drop when at a light any one know about recalls on these cars?
View 4 RepliesI have a11 isf with 38k on it. The other day the check engine and traction control light came on along with a weird Oder in the cabin. secondly I was short the quarts of oil.... I see no leaks.
View 2 RepliesAlright i have a 05 1.8t GLI I just installed a 42 draft designs full 3inch turboback, and a eurojet turbo inlet hose, after I put the stuff on my check engine light came on which I thought was gonna happen and is normal but my traction control light came on as well, the cars running better then ever and pulling harder then ever, but when i hooked it up to the computer I'm throwing 18 codes? Ive triple check to make sure everythings tight and in the right spot? What could be wrong?
View 5 Replies