Lexus GS 2006-11 :: After Replacement Of Right Hub Many Lights Came On?
Apr 2, 2014
Had my rear right hub replaced by a mechanic yesterday Faulty bearing ,and upon leaving his shop ,, my dash lit up like crazy , ABS ,Yellow and Red circle , AFS Flashing ,check 4WD ,Check VSC , Brought it right back ,he took it apart to verify the ABS sensor witch seemed ok visually ,and told me it was the hub that could be faulty.
Can a ABS sensor be damaged ,with the use of an impact driver nearby ? Can this ABS sensor be checked with a simple ohm meter ?
View 1 Replies
Advertisement
I have sonata 2006 v6 3.3. Over the weekend Left rear wheel bearing was replaced. Right after the replacement ABS + ESC OFF lights came on and stayed. I took the battery connection out and restart the car but no difference. There is no affect on driving or performance car drives normally, Cruise operation works normal as well. Mechanic scanned and scanner showed right real wheel sensor malfunction. He claimed that he didn't even open the right rear wheel. I am hoping it's not the sensor.
View 4 Replies
I want to replace the interior reading lights but not sure how to do so. I've taken a flathead screwdriver and popped out the plastic cover and revealed three bulbs. Am I supposed to twist them or pull them straight out? Or am I doing this completely wrong and should i pop out a cover or something?
View 1 Replies
Just had my front shocks replaced (one was leaking) at a local indy shop. The GX rides so much better now!
Problem is when I picked it up this morning, the VCS, ABS, traction lights were all on. Checked the gas cap, but that's okay (actually had the cap replaced recently due to a bad cap causing the same problem).
What would cause the lights to go on after replacing the front shocks? Is it merely a coincidence I wonder or did the tech perhaps forget to connect something?
View 9 Replies
I have an accent 2006 GS Sedan. I bought this as used recently. Noticed that the lights are not powerful at nights. When I turn on the lights there is no changes in the power of the driving / low beam lights.
Whether this is the standard with accent 2006. Other vehicles I have with me changes the power of the light and in this case there is no changes at all. I bought extra powerful bulbs and put them and there was a slight change, but there is no change between the driving lights and the low beam.
View 4 Replies
My 2006 GX470 armrest are needing replacement. I am considering purchasing 7421060200A0 and 7422060200A0, and doing the job myself. Any instructions on how to do this?
View 5 Replies
Just replaced my bulbs with the Garax 6000k and they look good but now my check engine light and VSC light is on. Problem started after changing bulbs? My pops said it should go away but we're not sure. Is there a way to reset it and get rid of the lights?
View 3 Replies
How to replace this light? I haven't found any threads on this as it seems like it's easily overlooked. The light bulb is located at the back of the center console box that lights up when opened. It's very dim and I have a few LEDs hanging around I'd like to replace it with.
View 5 Replies
Which way can I go here for a spare key fob that no longer works? Will I have to buy a brand new one or can I just replace the battery inside?
View 3 Replies
Can the instument cluster on my GX 470 be relaced with a used unit? Will the miles be retained from the computer or will I have to some how have them matched to the old odometer? I do not want to have a mileage unknown unit nor do I want to have to buy a new cluster from the dealer.
View 1 Replies
I have a couple of cracks in my front windshield and I'm thinking of replacing it.
A few years back I had the dealership work on the famous creaks and I know they stuffed felt in between the windshield cowl area. Would that need to be redone?
I would request a factory windshield but I'm concerned if it might make the creaking worse or if it would affect the integrity of the car.
View 9 Replies
I have a 2006 GS300. Changed out the battery today, and immediately after the AC quit working. Pushing the climate control button reveals the message "Check the connection of the air conditioner".
View 3 Replies
I'm having issues with very loud screeching noises on my 08 awd. Sounds like a garbage truck. Lexus said its $625 to replace brake pads and rotors to stop the noise. I'm not really a fan of DIY so is that a fair price for the parts and labor or should I bring it somewhere else?
View 14 Replies
When I am first starting up a cold engine (in 75 deg. F. morning), I get the lights coming on for VSC Off, and ABS Off. When I drive in forward or reverse, the ABS on the right front side starts operating in rapid fire fashion and the car pulls left. There is quite a lot of noise from the ABS operation. Then,as the wheels turn for a few minutes, the lights go out and the car brakes normally. Then it goes into an ABS Off mode and all I have is manual brakes.
The first garage (non-Lexus) says it was a sensor in the right front wheel hub that was coated with "gunk" and grease that was obstructing signals to the ABS system. He cleaned it and it seemed OK for 1/2 a day until the whole sequence started up again. What is it? I don't have a Lexus dealer within 2-hours of home. I do have a Toyota mega-dealer.
View 8 Replies
We all know that it's dim, along with all the other interior lights of the 06 GS300, I've already checked the door light and it's on a circuit board, and the I-JDM ones fit everything but the GS.
View 9 Replies
Parked my car at work and some jackass hit my car and left, fender is the only part showing damage, but somehow my check vsc lights are on and the alignment is way off. Is there anything behind the passenger side fender that would cause this? I'm getting it taken in Monday morning to get it assessed and fixed
View 2 Replies
My steering column lights are very dim. How do i make them brighter?
View 9 Replies
I've tried a couple of different bulbs to match my HID's as close as possible , but can't seem to find anything.
View 14 Replies
I have a 2006 GS3. It's been fine with no issues starting up. I drove it fine yesterday but when I went out to the garage today the car wouldn't start. So here's what happened. I got in to start it up like normal, the green light came on, but the car didn't start. Tried it again but this time there were no lights other than the green light and the brake pedal was hard to press. There were no warning lights of any kind. I figured the battery is dead. Since I live across the street from an Auto Zone I took the battery over there to have it checked (despite the fact that it's only 8 months old). The battery is still good at 12.5 volts and fully charged.
I put the battery back in and the high beams and parking lights came on right away. So figured everything is fine. But when I got in the car the green light still didn't come on, along with none of the door lights or anything else. My car lights are on auto so I turned them off but the lights stayed on. I disconnected the audio in the trunk also to make sure I'm not drawing power from any where else but still the same result. The exterior lights won't go out and the car won't start.
View 4 Replies
Locked the car with remote and went shopping and to dinner(gone about 5 hours), when we came out the headlights and brake lights were on... Does the head and brake lights stay on after the security alarm system goes off?
View 5 Replies
2006 GS430 110K miles. Did Front brake pad change by myself. Now ABS , brake warning lamps come on.
Bring it to Lexus dealer. They found 3 code on it. C1203, C1336, C1345
After performed the Zero Point Calibration, the DTC C1345 remains.
I felt so bad. They want to charged me another $185 in order to find out the problem after I have paid $130. But i am out of pocket. So drive car back to home. I don't think i did anything wrong while changing brake pad. Just remove the caliper and push the piston back.
Detail of the Code:
C1203 engine control system communication fault
C1336 zero point calibration Yaw rate sensor undone
C1345 Linear valve offset not learned.
View 14 Replies
