Lexus GS 2006-11 :: 350 AWD Slip Indicator - Power Loss At 55+ Mph?
Nov 24, 2015
I recently purchased a used GS350 AWD.After purchasing it, I replaced all of the wheel bearing hub assemblies. The rear ones were grinding, and I decided to just do all 4 at the same time.
After swapping the hub assemblies, the slip indicator light comes on when I go 55+ mph. It's usually when I push on the accelerator. It's not always on. It goes on, then turns off for a while. Sometimes when accelerating it doesn't come on at all. When the light turns on, I loose power for a few seconds but I don't hear or feel any braking.
I have tried an alignment, reset the YAW sensor, etc. The mechanic had a very expensive snap on diagnostic computer and he said everything seems to check out. The steering angle is good, acceleration looks good.
I'm thinking that either one of the hub assemblies has a slight defect that affects the ABS sensors, my VSC computer needs replacing, or YAW sensor starting to go bad.
View 3 Replies
Advertisement
When stopping on traffic light, my Slip Indicator is on and flashing...
The Owner's Manual says: If the vehicle is in danger of slipping or rolling backward when starting on an incline, or if any of the drive wheels spins, the slip indicator light flashes to indicate that the VSC/TRAC systems are operating.
Luckily, it only happened once... otherwise, I'll roll back to the dealership in the very first day I picked up my car...
View 10 Replies
2010 ES350... Was detailing interior of car, and didn't realize headlights were on. Eventually, battery drained and car would not start. Had OEM, original battery installed at the time. No dashboard lights lit prior to this.
From what I recall, shortly after replacing the battery and getting vehicle started, my slip indicator was solidly lit on dashboard. No other lights are illuminated, and vehicle appears to behave the same.
Fast forward to today, my OBD II scanner (Innova) does not pick up any current DTC's. There are readiness codes stored, but I understand that these are merely emmission related. However, there are historical codes stored which I am concerned may be possibly contributing to the dashboard light. The codes are P1604 and B2799. These appear to be related to the immobilizer system on my ES. I've tried to clear these codes, but they won't go away, so I suspect something is still tripping this. Keys are fine, just changed the FOB battery out a couple of times. I may try my second set of keys to see if it fixes this mess.
Since my OBD scanner doesn't support ABS, I'd like to see if AutoZone or something of the like can detect if there are any codes being thrown by the ABS system. Not sure if this is what is tripping the SLIP light.
View 4 Replies
My RX350 2012/13 model AWD check system and slip indicator warning light are permanently ON on the dashboard. The car is driving normal. How to clear the indications because I am very uncomfortable with it.
View 1 Replies
I have a 2011 Corolla LE, about 58k miles. The latest work I did was replace the brake pads, rotate the tires and changed the oil a little over 2 weeks ago. Everything was normal so far. Yesterday I drove for about an hour, again everything was fine, but after stopping at a gas station and starting I have several indicator lights come on.
- Slip indicator, flashing
- TRAC OFF, constant
- ABS, flashing
- Electric power steering warning light, flashes but turns off after about 30 seconds.
I tried my OBD scanner with no luck, but figures since there was no Check Engine light.
View 1 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
I have a problem with electric power steering in the Lexus GS300 2006. System indicator does not light up even in the moments after ignition, fuses are OK. Where is the power steering module ?? I looked next to the brake pedal but it is not there...
View 6 Replies
2008 GS460. 100K miles
I have noticed when I accelerate on a entrance ramp to the highway I notice the RPM meter jerks a little like it's trying to suck for gas or something else. I can feel it in the car too. This is the only time I have noticed this. I have replaced the spark plugs about 5K miles ago.
I did bring it into the dealership a few months ago to get the fuel pump replaced as I noticed a hissing noise under the drivers side read door. They said fuel pumps rarely go bad on the Lexus. The mechanic did some fuel pressure tests and said everything looks good. He also said noise is the return line back to the pump.
View 7 Replies
My car, a 2014 Prius TWO, was towed and recovered, but now the slip indicator light is always on (also the steering wheel is way out of alignment). Driving home, the car felt perfectly fine, except for the steering wheel being at a weird angle. What's going on? Can I get this fixed at a mechanic when they fix the wheel alignment, or do I have to take this in to a dealership?
View 6 Replies
I have been very happy with Prius 2012 I got in February. But I have started noticing that the slip indicator light turns on briefly when I start the car. Is it something I need to worry about? It does go off in a second or two.
View 4 Replies
Refilled the wiper fluid on my fiance's 2011 Camry LE today and low and behold the ABS + Slip Indicator lights came on in the dash next time she started the car.
No codes are throwing from the ECU and it drives fine. Only thing I can think to do is Drive it full tilt and see if I lose the back end and/or try braking aggressively from 40+ mph. Just to see if the ABS/Trac Control systems are hosed. Don't want to go to the dealer to have them try the same thing and me pay for it...
View 2 Replies
Anyways, I was driving to school today. Going about 45mph on on off ramp that curves slightly when my Slip indicator light turned on and blinked maybe 10 times or so. I'm taking it to the shop tomorrow as the manual suggest. My car only has 7,500 miles.
View 8 Replies
This morning I was cruising down the highway with cruise control set at 63 mph. All of a sudden the car slowed down and the "Slip Indicator" was displayed and the cruise control was now off.
View 2 Replies
I have the Prius C which when I bought had 3 lights on the dash - ABS, Brake System light and Slip Indicator light ON. What this may be?
View 7 Replies
I am afraid to drive my car on the highway and if I am damaging my car by driving it I want to make sure I hold the auto care shop that put the wrong size tire on my car responsible.
I have Bridgestone Ecopia EP100 BL tires size 185/65R15 on my 2007 Prius that I got in 2010. Because of a nail in one tire I had to replace one of the tires two days ago. The technician said they did not have the exact same tire any more but he would replace it with something comparable.
The next day I drove 2 hours on the interstate and the slip indicator light kept flashing, it felt like the engine was revving a lot and/or the transmission wouldn't shift when I got to highway speeds, and it was a little scary. My first thought was something with the new tire since I had absolutely no problems before.
View 7 Replies
So I noticed this has happened a few times.. If I press on the brake pedal too hard, the indicator light will come on and then turn off a few moments after I depress the brake pedal. This has happened when the car is stationary as well as when I was coming to a stop, it's happened maybe 5 times since I picked the car up a few weeks ago. Is this normal behavior or an indication of a problem? Just an FYI, I'm not talking about when the indicators light up when first starting the car.. This is tied strictly to pressing the brake pedal hard.
View 8 Replies
I had the 2010 Camry I-4 in the dealer last week for the 40K service. They told me I needed fuel injector cleaning and a throttle body housing cleaning which I had done. This afternoon the check engine light came on and at the same time the Slip Indicator light came on.
I ran by Auto-Zone to have them pull the code for the check engine light and it was P0101 which AZ says is Mass or Volume Airflow circuit range and listed probable causes as:Open or short circuit condition, MAF/VAF sensor failure, or Faulty ECM. I called the dealer for an appointment Thursday morning and told him the story and asked if the throttle body or injector cleaning could cause the mass air flow problem. He said "probably not". He also told me that when the Check Engine light comes on the Slip indicator light automatically comes on to show that the VSC is not working while the check engine light is on.
My question is, could the cleaning cause the P0101 and if so what info do I need to argue the case with the dealer? Or, are they unrelated systems?
View 2 Replies
2010 Prius V owner as of last week. All has been going well and got into the car this morning and all of the above noted lights are on at start-up and stay on as I drive. Have made appointment with the dealer but they cannot get me in until late next week. I did make a short drive this morning and all seemed fine with handling and braking. Searched a few threads here and answers are very varied and none that I saw had all of above lights on. I don't think that it is the Hill Start Assist. Safe to drive until we can get into the dealership?
View 14 Replies
My Prius touring had 4 205/55/16 tires. I had the mechanic change the front two tires to 205/50/16 and now, whenever I drive over 60mph, the slip indicator light flashes continuously. When I slow down, it goes away.
Is it because the front and rear tires are mismatched? If so, I'll have the mechanic change the rear to 205/50/16 as well.
View 16 Replies
My 2013 Corolla drove 10 minutes with heavy steering after starting. The slip indicator turned on and stays on after. Would OBD II show the problem? Can one read OBD II without scanner? How to turn off the slip indicator?
View 1 Replies
This morning, I found out that my Camry 2012's backup light did not turn on. When I changed the tranmission shift, there no any letters like D, P, or R appear on the meter panel. Moreover, on the panel, the check engine and slip indicator icon lights turned on. How to fix this problem. I already installed the aftermarket backup camera, and it doesn't work also
View 9 Replies
