Lexus GS 2006-11 :: 2008 AWD - Squeaking Whenever Make Hard Left Turns
Aug 16, 2015
I have an 08 AWD GS350 ...
For the last few months, it has been squeaking whenever I make hard left turns, (into parking spaces etc, usually low speed). I thought it was the brakes, but just replaced all 4 pads and all 4 rotors. So that officially eliminates that.
The car doesn't have any unusual vibration, tracks straight, so I don't think its a wheel bearing or anything. I jacked the car up and tried to shake the tire/wheel to see if there was any play but don't see anything.
View 3 Replies
Advertisement
Back in January I had my right front wheel bearing and u-joint go out, so I replaced them both. At the time I didn't realize my outer stub axle shaft was wore so I just put it back in. After a little driving the right side started to "thump" and "pop" when I would make hard left turns driving around town.
I replaced the outer front stub axle shaft and seal again because the old one was worn down. This eliminated any play in the u-joint. After a bit of driving the thumping and popping noise came back.
I decided to dig into it today so I pulled it all apart. When everything is apart it turns easily, no issue at all. When I assembled the wheel bearing, torqued it to 55 ft/lbs and installed and "locked" the hub I noticed something peculiar. I can barely turn the whole assembly by hand. I have to put a good amount of force to get the whole assembly to turn at all. When I walk to the driver side with all the same parts there i can turn the wheel bearing and locked axle shaft with one finger on the studs.
I have been in this thing 5 times and can not figure out what the heck is wrong. I can't figure out why this stupid axle shaft and wheel bearing are so hard to turn, together or separately, and I can't figure out how to get my front end to stop that thumping and popping.
View 6 Replies
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
I have a 2007 Sonata 3.3 V6 GLS (CDN model) with 102k km (63K miles). Recently, I am noticing a rotational metal-like grinding noise from the front left wheel / engine area when engaging in hard right and left turns - usually a long looped highway on-ramp or sharp 90 degree turns. The interesting thing is this only happens when I am accelerating through the turns - when I left off the gas and cruise I don't hear it anymore.
On the side, I am also getting a single clunk noise when shifting from Park to Drive and vice versa from the same area (front left wheel) - not sure if this is related (i.e. if this is all related to a failing CV joint or wheel bearing).
View 2 Replies
So I've been driving my 3GS 350 and every time i make a right turn the left wheel makes this metal shaking sound? or scraping sound? I've checked it out seems like nothings in the way but I don't know how to tell if i have a bad wheel bearing..
View 9 Replies
I have a 2005 Saturn Ion stalls when I make left hand turns! The engine light comes on and the car goes into limp mode! I stop the car and wait a minute or two and it starts right back up and after driving it for a while the engine light goes out! I took it to a shop and they replaced the throttle body and ignition coil on two different occasions and my car still does the same thing!
View 2 Replies
Just started hearing a thumping/ rubbing sound when I make left turns (nothing moving forward or right turns). Thought it might be a tire rubbing but I can't see anything. Starting to think maybe a bad cv joint. Is their a way to check if a cv joint is bad? How hard would it be to replace a cv joint and shaft?
View 3 Replies
I have a 2006 GMC Yukon XL 4WD 1500 with 95,000 miles. When I make left turns, after coming to a stop, the antilock brake system engages, making a groaning-pumping sort of sound in the upper front left area under the hood. (This does not happen every time I turn after stops, but frequently.) My local GMC dealer mechanic believes that there is a faulty wheel bearing, and that a signal is being sent to the antilock brake system to engage. Not sure whether I should believe that or not. The repair would be expensive.
View 4 Replies
Well my girls car is acting up again. when you make left turns, you can hear this real loud popping, almost cracking noise coming from the passenger side front tire. its a 06 passat with 88k miles on it. What is wrong with it??
View 4 Replies
I have a 2010 Honda Civic with about 32K miles on it. Last fall, at around 23K miles, I needed new brake pads and rotors (because I waited too long on the pads). Got those replaced. A few weeks later (I think), it started making a kind of squealing noise when I make left turns. I mentioned it to my mechanic when I took it in for an oil change shortly thereafter, and he said it was probably the belt, but I could wait a bit on replacing it if I wanted to (as he knows I'm always broke).
Three weeks ago, I took the car in for another oil change and to have him change the belt. He put in a new belt, but alas, after driving the car about a mile the noise returned. I called my mechanic, and he said it might be my tensioner, but that such a new tensioner shouldn't need replacing already and that it would still be under warranty. I needed to take it to the dealer anyway because my window mechanism was broken, so while I was there, I had him check out the tensioner. He also said the tensioner was fine, and said that since the belt wasn't a HONDA belt (naturally), that might be making the noise. Last week, I took the car back to the mechanic, who ordered and installed a Honda factory belt free of charge.
Naturally, a mile later, the noise returned. I resisted every urge to drive into oncoming traffic. I used my phone to record the sound so that I could e-mail it to the dealer and my mechanic, give it a listen: [URL] ....
View 14 Replies
Recognized, that left mirror folds slower than the right one. At hot temperatures, the mirror folds in a kind of "stepping" and makes some squeaking noises. Is it a good Idea to try grease inside of the mirror folding motor?
View 1 Replies
Due to the clicking-ratcheting sound my 1997 Civic makes when I make hard turns or U turns, two mechanics (one drove the car) say that I need two new front axles at a cost of $400 ($200 each). I have driven the car like this for maybe a couple thousand miles before I looking into it. How much longer can I drive it like this before it gets dangerous or fails? I now only make gentle turns and so minimize the clicking-ratcheting sounds that happen only on hard or aggressive turns. The car only has 76,000 miles on it. Is it dangerous to keep driving it?
View 7 Replies
My 2002 Honda Odyssey makes a squealing noise when I make a hard left turn. Could it be related to power steering? Is it an urgent problem? I will take a trip next week (~650 miles each way), and need to know if I should address this first.
View 3 Replies
Basically, when I make a hard left turn I hear a noise out of the front right wheel area. I do not hear anything in any other condition. It sounds like something rubbing up against something else. I know that my rims are in good shape - is this an outer or inner bearing issue? Or is this something completely different?
View 2 Replies
A couple of months back my driver side window began to make this terrible squeaking noise when rolled up and down. I noticed that the noise is not as bad when it is cooler out and when I run my car through the wash with wax (just an option they have at the carwash place).After some internet research I believe that the problem is with a part of window regulator mechanism.
There were a couple of options available to me:1. Replace window regulator mechanism (great instructions on pelicanparts.com). To do it on my own is about $80 (part cost) and 5-6 hours of work or $600 at the dealer's. 2. Locate the motor of window regulator, open it and clean it. Probably 5-6 hours of work, but $0!!!3. Open the door, clean inside and grease the tracks.
I opened the door and cleaned the glass and tracks – no result! I brought it back to the dealer (car is not under warranty anymore) and they were nice enough to open it again for me and grease the tracks – no result except for marks on my window and the verdict that I need to replace the regulator mechanism….
View 8 Replies
2013 model year.....
View 5 Replies
I just replaced the power steering box on my 1979 dodge B200. now when I start it it turns hard to the right and I can't turn it to the left.
View 6 Replies
OK So I just replaced the Passenger side axle on my 03 wagon with a brand new EMPI assembly. It was really easy but on the test spin around the block I'm hearing a flop flop flop sound on hard left turns.
View 3 Replies
My 04 gli makes a rubbing noise when accelerating thru hard left turns.. but weird enough i can take the same turn at the same speed in neutral and have no noise at all. I changed both front wheel bearings and cant seem to find the answer. I brought it to vw and they checked the whole suspension struts springs cv's tie rods ect. and they all checked out good they said. the car used to have a exhaust and i just recently put it back to stock, could the exhaust make the noise perhaps?
View 1 Replies
Like the title says my 08 gs460 is pulling to the left, the steering wheel has to be slightly to the left for me to go straight, if I straighten the wheel out it goes off to the right, it has only been doing this the past two weeks or so. I went to Lexus and they agreed it was pulling and so they did an alignment, drove home, no change whatsoever, so I'm wondering what else it could be.
View 6 Replies
I am suddenly getting noise during left turns in my 2004 F-150 SCrew. I found a video where somebody found out it was the lower steering linkage and replace that.
View 7 Replies
