I can't remove the retaining clip to replace the passenger's side low beam headlight bulb. I was able to, with some difficulty, replace the driver's side but space is tighter on the passenger side.
View 1 RepliesOne of the small bulbs in the corner of the headlight assembly is burned out. does any one know how to replace it?
View 1 Replieshow to replace the front Highlight.
how to replace my head light, on the passenger side.
I have a 2007 F150 XL that has the power windows and locks, I have the sensor on the dash for the auto headlights so I'm curious if I just need the auto headlight switch for this to work on my truck. I need to remove the headlight switch so I can try to connect the DB/OG and the DB/WH wires to see if this will make the circuit complete for the auto headlights. Anyway, I don't have a manual. How to remove the switch so I can get at the wires?
View 3 RepliesI am in middle of "trying to" change the wheel bearing and I have the hub out but I can't figure out how this bearing needs to come out.
I have done it on MKIV Golf and like most other cars there is a C clip, but i can't see a clip in this knuckle.
Is this thing press fit in there without a clip? I have seen a guide for MKIV Jetta and people say Passat is almost the same, but not until I find this C clip.
Because I don't have repair manual, so don't know how to remove the headlight ,
View 1 RepliesI tried to replace my driver side burnt-out bulb today. While I was trying to clip in the new bulb, the metal clip somehow came loose and dropped down into the car. After poking around for an hour, I can't find it. I put back the assembly (without a bulb) and am pondering my next moves. Two big questions:
Is there anywhere I can get a replacement headlight retention clip? Is it safe to drive around without a bulb in one side? Or should I put in the old (or new) bulb and let it jostle around without the clip.
I'm trying to replace my dads 2007 Camry XLE japan built headlight assembly because his are insanely oxidized. Besides OEM's and CAPA's, what else are there? Any good aftermarket headlight assembly and achieve great results?
View 8 Replies2008 Santa Fe. Removed 2 bolts and 1 nut as shown in manual. cleared the clip at the bottom outboard corner. What else am I missing? I'm still Unable to remove the headlight bucket. It will only come out about an inch or so then feels like something else is holding on.
View 8 Replies2007 Sports Trac .. Does the motor need to be removed to replace head gaskets? 4.0 sohc
View 1 RepliesMy headlights suffered from the dreaded condensation problem. I brought them to Lexus after getting the warranty enhancement paperwork and had them replaced. Shortly after the passenger side wheel cover was ripped off after getting caught on some ice during a storm. It was very shortly after that that condensation begin appearing in my passenger side headlight.
At that point I was unaware that the wheel well cover had been ripped off. I brought it back to Lexus to have it looked at since I only had the headlight replaced a few weeks before. I was told it would be at a cost of $2,500 to replace with an additional $400 for the wheel well cover. Needless to say, I did not have the work done that day. While I was waiting them for them to finish the paperwork I bought the wheel well cover for $50 online but since then I've had difficulty locating the headlight.
I brought it to my mechanic and he was unable to find the headlight as well. I have a 2009 rx350 with HID AFS headlights. I have looked on ebay, Amazon and just through the internet to see what I could find but I'm finding only halogen headlights. Most of what I'm seeing on eBay are for non-adaptive lights that are damaged.
Just replaced my bulbs with the Garax 6000k and they look good but now my check engine light and VSC light is on. Problem started after changing bulbs? My pops said it should go away but we're not sure. Is there a way to reset it and get rid of the lights?
View 3 RepliesOne of my headlight is burned out and I would like to replace. I don't want to go with OEM. Looking something better and brighter. 2008 GX....
View 1 RepliesOur 2009 lx just came off warranty. Unless it is immediately re-started, the a/c is not retaining the temperature and fan settings when the vehicle is turned off. When re-started, auto setting for a/c comes on but fan does not. After about 30 seconds, temperature setting reads 75 degrees and fan has to be manually turned on.
View 1 RepliesRecently my 05 RX330 had the driver side low beam bulb go out. I took it to a few places and they said take it to the dealership as they have special tools to change it. Of course I took it there and they were ready to charge me an arm and a leg to get 1 little bulb replaced. My question is do you have recommendations as to what I should do to get this fixed and not have my wallet get destroyed?
View 8 RepliesI finally purchased an RX30 for my wife. The Halogen headlight isn't all that bad, but I am used to drive with HID. Therefore, I am buying HID kits for my RX350 Headlight. Whenever it is shipped to me, I will take pictures of the progress.
1/ Link to buy HID kits, OEM is 55W (no need for extra Hardnes) and 6000k is common factory color.
This will come with everything needed to convert your light bulbs into HID white colors. For more Colors please check out the guide on the website.
I recommend this site, because I have used it, purchased it, and have had no problem with it so far.
2/ According to Manual Book
****Low Beam is H11****
Fog Lights is *****H11*****
****High Beam is H9*****
**** 55W *****
3/ The installation should be Relatively Easy
--Take off engine plastic cover on both side--
--Access the Light Bulb--
--Use the OEM Plugs into the Ballasts input of the HID KID--
--Mount the Ballasts at a convenience locations, I had great success with Plastic ties--
--There is a Plugs output from the Ballast, Plug it into the HID Bulbs--
*****If the lights don't turn on after installation, try to switch Polary, or turn the original plugs around
****** Halogen doesn't care about Polary, but HID Ballast does.
--Install the HID Bulbs the same as regular Halogen Bulb--
--Check the HID carefully, make sure that both will work--
First time Installer common trouble shoots.
1/ Only 1 light is working......Switching the bulbs, or Polary will solve your problem
2/ Lights common for a short time then turn off, until engine restart......You will need the Hardness Relay, which should not occur in our car. The factory hardness is good for 55W
3/ Bulb Visually contain Contaminants, or White particle inside.......HID Bulbs has Special Salt in it, which is required for a longer life in the Bulbs. This is the way the bulbs are.
I hate that orange thing beating me down while I drive! I'm going to get it serviced for the love of god! How do I remove it before I take it in?
View 10 RepliesMost of the times the headlights on my 08 works fine but sometimes one of them won't turn on. It happens to both sides and is happening more often now. Wondering if this is a sign of bulb going bad or the battery...
View 3 RepliesHow to remove the back of the driver seat on ES350? I need to install the headrest DVD player.
View 1 RepliesLooking for the diagram on how to remove the heater blower unit from an ES350 2008, i need to clean out the unit since i can hear rattling when the blower is on, sound like foreight objects inside.
I google a little bit and found this: [URL] ....
The unit i need to clean is 87103B .....
I noticed that driving my LS last weekend that the right headlight was fluttering going down the road. It did not go off but it looked like a loose connection. When I arrived at the golf course, someone told me that he noticed that the right headlight was out. Now I got home and I have checked the headlight and nothing seams to be a problem. Both low beam and high beams go off and on with no problem. My question is : is the headlight bulb going out or do I have a connection problem? I hate to take off the tire and inner wheel cover to change the bulb unless I need to. Second question: If I have to change the bulb what is the best brand to use?
View 14 Replies